• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.5
• /
• pp.1-10
• /
• 1998

A GaAs MMIC composed of VCO (voltage controlled oscillator) and mixer for PCS receiver has been developed using 1.mu.m ion implanted GaAs MESFET process. The VCO consists of a colpitts-type oscillator with a dielectric resonator and the circuit configuration of the mixer is a dual-gate type with an asymmetric combination of LO and RF FETs for the improvement of intermodulation characteristics. The common-source self-biasing is used in all circuits including a buffer amplifier and mixer, achieving a single power supply (3V) operation. The total power dissipation is 78mW. The VCO chip shows a phase noise of-99 dBc/Hz at 100KHz offset. The combined VCO/mixer chip shows a flat conversion gain of 2dB, the frequency-tuning factor of 80MHz/volts in the varacter bias ranging from 0.5V to 0.5V , and output IP3 of dBm at varactor bias of 0V. The fabricated chip size is 2.5mm X 1.4mm.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.575-576
• /
• 2006

It was analyzed qualitatively the light extraction in GaN-on-sapphire LEDs based on a simple model. The light extraction efficiency in the LEDs is simulated numerically by using ray tracing method. In the present study, the extraction efficiency was simulated on three different types of LEDs, which a have a different pattered sapphire substrate. And, the role of the patterned sapphire substrate are analyzed and discussed. Based on the analysis, the improvements of extraction efficiency in the LED structures were discussed and these analyses are helpful in the design of high brightness GaN LEDs.

• ETRI Journal
• /
• v.39 no.5
• /
• pp.737-745
• /
• 2017

A 6-GHz-to-18-GHz monolithic nonuniform distributed power amplifier has been designed using the load modulation of increased series gate capacitance. This amplifier was implemented using a $0.25-{\mu}m$ AlGaN/GaN HEMT process on a SiC substrate. With the proposed load modulation, we enhanced the amplifier's simulated performance by 4.8 dB in output power, and by 13.1% in power-added efficiency (PAE) at the upper limit of the bandwidth, compared with an amplifier with uniform gate coupling capacitors. Under the pulse-mode condition of a $100-{\mu}s$ pulse period and a 10% duty cycle, the fabricated power amplifier showed a saturated output power of 39.5 dBm (9 W) to 40.4 dBm (11 W) with an associated PAE of 17% to 22%, and input/output return losses of more than 10 dB within 6 GHz to 18 GHz.

• Journal of the Korean Vacuum Society
• /
• v.13 no.2
• /
• pp.86-91
• /
• 2004

Transiton-metal gallides attract wide interest as a candidate for high-temperature structural materials. In a wide composition range, in which it was known that Co-Ga alloy have CsCl (B2) crystallographic structure, a systematic study on the correlation between physical properties and electronic structures of Co-gallides was performed. $Co_{l-x}Ga$ $_{x}$ alloys ($0.35\leq$x$\leq0.55$) were prepared by arc-melting method and were annealed at $1000 ^{\circ}C$ for 48hour to increase the homogeneity. In this composition range all the prepared alloys have the CsCl (B2) structure. The chemical states and the electronic structure were studied by using x-ray photoemission spectroscopy (XPS), and x-ray absorption near-edge structure (XANES), and exhibit different physical properties depending on the composition. During the annealing, a significant oxidation has happened and all the oxygen atoms are incorporated with the Ga atoms to form a $Ga_2O_3$ phase. In a view point of electronic structure, the $Co_{l-x}Ga$ $_{x}$ alloys were formed by the Ga(p) - Co(d) hybridization.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.5
• /
• pp.521-526
• /
• 2003

This paper describes performance data and design information on a reflection-type analog phase shifter used in Ka-band. Arranging a couple of GaAs hyperabrupt junction varactor diode parallel in a circuit, and applying reactance matching method accordingly, it is possible to 831 a large the phase shift. Design equation is formulated theoretically. Since the assembly process is important in Ka-band, this paper also includes the assembly process that is essential to minimize the generation of parasitic elements during the assembly process. It is obtained variable phase shift 220$^{\circ}$${\pm}$7$^{\circ}$ and insertion loss 5 dB${\pm}$1 dB as a measured result larger than the existing figure in Ka-band.

• Journal of Life Science
• /
• v.25 no.4
• /
• pp.390-396
• /
• 2015

This study was carried out to investigate the action of phytohormones which influence the adventitious root formation of calli originating from the leaves of Persicaria perfoliata. The optimal medium condition for callus formation was ½-strength MS, 1% sucrose, and 4.5 μM 2,4-D. In order to determine which phytohormones had an effect on the adventitious root formation, the calluses were cultured in various media with different kinds of phytohormones. As a result, the medium with GA₃ or IAA was shown to induce root formation. To deeply investigate the effects of GA₃ and IAA, calli were cultured in 0.1, 1, and 10 mg/l levels of phytohormones. Numbers of roots formed per callus were 10.9, 14.2, 22.6 in GA₃, 5.8, 3.9, 1.1 in IAA, respectively. Therefore, the higher GA₃ or the lower IAA concentration, the more roots formed. To confirm this role of GA₃ we tested with inhibitors PBZ and NPA. GA₃ with PBZ resulted in reduction by 52.4~69.4% compared to GA₃ alone. In contrast, GA₃ with NPA resulted in an increase by -8~45.6% compared to GA₃ alone in root formation. Also, results were determined on the effect of GA₃ with other phytohormones on root formation. Kinetin, 2iP and ABA with GA₃ had a negative effect, but IAA with GA₃ showed a similar result to GA₃ alone. From these results we infer GA plays a key role and auxin has subsidiary activity on adventitious root formation. This is the first report that indicates GA₃ promotes adventitious root formation from calli in P. perfoliata.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.30 no.4
• /
• pp.368-374
• /
• 1985

This study was carried out to obtain the basic information for the shortening of emergence period of ginseng by treatment of growth regulators. Seedlings that removed and non-removed bud sac were treated at 10, 50 and 100ppm of GA$_3$, Kinetin and 2,4-D in early December, and investigated the characteristics of new bud emergence and growth vigor in 2-year-old ginseng. GA treatment showed the most desirable effects in shortening of emergence period of new bud, and elevating its emergence rate with increasing of the GA concentration. In addition, GA treatment especially accelerated the growth of stem and petiole length and early finished the growth of aerial parts of ginseng. On the other hand, root weights were mainly increased by formation of a lot fine roots in GA 50, 100ppm plots.

• Proceedings of the Optical Society of Korea Conference
• /
• 1990.02a
• /
• pp.136-140
• /
• 1990

A hybrid wideband amplifier having bandwidth from 5MHz to 2000MHz with a gain of 10db$\pm$3dB is designed and implemented by using a lossy matched network and GaAs FET. The implemented amplifier circuit operates as a capacitor-resistor(C-R) coupled amplifier circuit in the low frequency range (below 800 MHz) in which {{{{ LEFT $\mid$ S_{21 } RIGHT $\mid$ }} for the GaAs FET is constant. It also operates as a lossless impedance matching circuit in the microwave frequency range in which S21 for the GaAs FET has a slope of approximately -6dB/octave. Using this configuration technique, Two stage GaAs FET amplifier implemented is measured to 10dB gain within a 3dB fluctuation over the frequency band from 5 to 2000MHz.

• 한국태양에너지학회:학술대회논문집
• /
• 2012.03a
• /
• pp.149-152
• /
• 2012

$Cu(In,Ga)Se_2$ (CIGS) is one of the most promising photovoltaic materials because of large conversion efficiency which has been achieved with an optimum Ga/(In+Ga) composition in $CuIn_{1-x}Ga_xSe_2$ (X~0.3). The Ga/(In+Ga) content is important to determine band gap, solar cell performances and carrier behaviors at grain boundary (GB). Effects of Ga/(In+Ga) content on physical properties of the CIGS layers have been extensively studied. In previous research, it is reported that GB is not recombination center of CIGS thin-film solar cells. However, GB recombination and electron-hole pair behavior studies are still lacking, especially influence of with different X on CIGS thin-films. We obtained the GB surface potential, local current and I-V characteristic of different X (00.7 while X~0.3 showed higher potential than 100 mV on GBs. Higher potential on GBs appears positive band bending. It can decrease recombination loss because of carrier separation. Therefore, we suggest recombination and electron-hole behaviors at GBs depending on composition of X.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.31-31
• /
• 2010

The growth of the high-quality GaN epilayers is of significant technological importance because of their commercializedoptoelectronic applications as high-brightness light-emitting diodes (LEDs) and laser diodes (LDs) in the visible and ultraviolet spectral range. The GaN-based heterostructural epilayers have the polar c-axis of the hexagonal structure perpendicular to the interfaces of the active layers. The Ga and N atoms in the c-GaN are alternatively stacked along the polar [0001] crystallographic direction, which leads to spontaneous polarization. In addition, in the InGaN/GaN MQWs, the stress applied along the same axis contributes topiezoelectric polarization, and thus the total polarization is determined as the sum of spontaneous and piezoelectric polarizations. The total polarization in the c-GaN heterolayers, which can generate internal fields and spatial separation of the electron and hole wave functions and consequently a decrease of efficiency and peak shift. One of the possible solutions to eliminate these undesirable effects is to grow GaN-based epilayers in nonpolar orientations. The polarization effects in the GaN are eliminated by growing the films along the nonpolar [$11\bar{2}0$] ($\alpha$-GaN) or [$1\bar{1}00$] (m-GaN) orientation. Although the use of the nonpolar epilayers in wurtzite structure clearly removes the polarization matters, however, it induces another problem related to the formation of a high density of planar defects. The large lattice mismatch between sapphiresubstrates and GaN layers leads to a high density of defects (dislocations and stacking faults). The dominant defects observed in the GaN epilayers with wurtzite structure are one-dimensional (1D) dislocations and two-dimensional (2D) stacking faults. In particular, the 1D threading dislocations in the c-GaN are generated from the film/substrate interface due to their large lattice and thermal coefficient mismatch. However, because the c-GaN epilayers were grown along the normal direction to the basal slip planes, the generation of basal stacking faults (BSFs) is localized on the c-plane and the generated BSFs did not propagate into the surface during the growth. Thus, the primary defects in the c-GaN epilayers are 1D threading dislocations. Occasionally, the particular planar defects such as prismatic stacking faults (PSFs) and inversion domain boundaries are observed. However, since the basal slip planes in the $\alpha$-GaN are parallel to the growth direction unlike c-GaN, the BSFs with lower formation energy can be easily formed along the growth direction, where the BSFs propagate straightly into the surface. Consequently, the lattice mismatch between film and substrate in $\alpha$-GaN epilayers is mainly relaxed through the formation of BSFs. These 2D planar defects are placed along only one direction in the cross-sectional view. Thus, the nonpolar $\alpha$-GaN films have different atomic arrangements along the two orthogonal directions ($[0001]_{GaN}$ and $[\bar{1}100]_{GaN}$ axes) on the $\alpha$-plane, which are expected to induce anisotropic biaxial strain. In this study, the anisotropic strain relaxation behaviors in the nonpolar $\alpha$-GaN epilayers grown on ($1\bar{1}02$) r-plane sapphire substrates by metalorganic chemical vapor deposition (MOCVO) were investigated, and the formation mechanism of the abnormal zigzag shape PSFs was discussed using high-resolution transmission electron microscope (HRTEM).