• Proceedings of the Optical Society of Korea Conference
• /
• 2004.02a
• /
• pp.298-299
• /
• 2004

We propose and theoretically analyze multi-functional integrated optical device based on figure-eight shaped birefringent Sagnac loops. Our analysis shows that the propose device exhibit many unique features which allows it to operate as a tunable high-Q comb filter with a good channel isolation, and the intensity transmission of the filter can be varied from zero to 100 percent.

• Membrane Journal
• /
• v.2 no.2
• /
• pp.104-111
• /
• 1992

A curved channel duct is designed, built and used specifically to produce Dean vortices as a result of flow around a $180^{\circ}C$ curve. We present evidence using optical reflection of the existmace of the vortices in the curved section and following flat section. Also, three different feed soludons(DI water, a monodispersed styrene-divinyl-benzene latex particle suspension and a yeast suspension) were used to determine the effectiveness of Dean instabilities to destabilize polarization layers. For each suspension, the flux data were compared as a function of time for flow conditions with and without Dean vortices, for a $0.2{\mu}m$ microfiltration membrane. Any permeation flux improvement was not sustained for $2.0De_c$ due to the vortex-decay in the flat section after the curved channel, but a 15~30% permeation improvement was obtained for $3.8De_c$.

• ETRI Journal
• /
• v.45 no.4
• /
• pp.581-593
• /
• 2023

This paper proposes four-ring slot resonator-based MIMO antennas of 75×150 mm² without and with CSRR structures in the sub-6-GHz range. These orthogonal-fed antennas have shown diverse characteristics with dual polarization. L-shaped parasitic structures have increased the isolation (i.e., >40 dB) in the single-element antenna over the band of 3.4 GHz-3.8 GHz. A set of three CSRR structures in the MIMO antenna reduced the coupling between antenna ports placed in an inline arrangement and enhanced the isolation from 12 dB to 20 dB and the diversity characteristics. The S-parameters of both MIMO antennas are measured and used to evaluate MIMO parameters like ECC, TARC, MEG, and channel capacity loss. The simulation results show the variations in the gain and directivity on exciting linear and dual polarizations. The diversity performance of the reported MIMO antennas is suitable for 5G applications.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.21 no.4
• /
• pp.31-36
• /
• 1984

Various efforts have been dedicated to obtain the negative impedances in microwave frequencies with semiconductor devices by many scientists for f: some passed decades, and as a result, many solid state microwave devices have been developed. But they all have much less maximum power ratings with respect to the vaccum tubes. In this paper, a MOSFET is proposed and studied, which have a periodic structure of multigates on the semiconductor via insulator. The hish electric field in the channel induces a voltage distribution on the gates by electrostatic coupling, and the polarization so induced between the gates is able to give a space modulation of the velocity of carriers or the current density in the channel, and as a natural consequence, a microwave amplifier with higher power ratings can be expected.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.2
• /
• pp.232-238
• /
• 2004

In this paper, radio propagation in a subway tunnel is investigated using fan beam antennas, circular polarization antennas and directional antennas at 2.4㎓ and 5.8㎓ band, respectively. The results of narrowband channel measurements show that received power level for NLOS(Non-Line-Of-Sight) path is decreased drastically as compared with LOS(Line-Of-Sight) path. Wideband channel measurements are obtained using a PN sliding correlation method. The parameters of the channel such as mean access delay and RMS delay spread are compared as to different types of directional beam at IEEE 802.11 WLAN(Wireless Local Area Network) band including 2.4㎓ and 5.8㎓ bands, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.5 s.347
• /
• pp.162-168
• /
• 2006

Understanding of propagation characteristics is very important for the wireless communication system design and wireless communication service construction. In this paper, propagation characteristics is measured and analyzed at 2.45Ghz frequency band under curved subway tunnel environment. We constituted channel measurement system with sliding correlation and five different kind of antennas. The purpose of five different type of antennas is to compare propagation characteristics according to beam shape of antennas. The path loss under tunnel environment is average $4.38^{\sim}14.41dB$ lower than free space and circular polarization antenna marked smallest path loss. Also, path loss is smallest when the receiver antenna located outside of tunnel in th curved section. 90% of delay components of all antennas measured within 20ns and directional antenna has more wide coherence bandwidth than omni-directional antenna. According to measured result, when we consider path loss and delay characteristics, circular polarization antenna is most suitable under tunnel environment.

• ETRI Journal
• /
• v.36 no.2
• /
• pp.206-213
• /
• 2014

This paper presents a novel 90 GHz band 16-quadrature amplitude modulation (16-QAM) orthogonal frequency-division multiplexing (OFDM) communication system. The system can deliver 6 Gbps through six channels with a bandwidth of 3 GHz. Each channel occupies 500 MHz and delivers 1 Gbps using 16-QAM OFDM. To implement the system, a low-noise amplifier and an RF up/down conversion fourth-harmonically pumped mixer are implemented using a $0.1-{\mu}m$ gallium arsenide pseudomorphic high-electron-mobility transistor process. A polarization-division duplex architecture is used for full-duplex communication. In a digital modem, OFDM with 256-point fast Fourier transform and (255, 239) Reed-Solomon forward error correction codecs are used. The modem can compensate for a carrier-frequency offset of up to 50 ppm and a symbol rate offset of up to 1 ppm. Experiment results show that the system can achieve a bit error rate of $10^{-5}$ at a signal-to-noise ratio of about 19.8 dB.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.12
• /
• pp.2741-2746
• /
• 2012

In this study, we propose a novel structure based on AlGaN substrate or buffer layer to implement a normally-off mode transistor that was difficult to be realized by conventional AlGaN/GaN heterojunction structures. The channel under the gate can be selectively depleted by growing an upper AlGaN barrier with a higher Al mole fraction and a top GaN charge elimination layer on AlGaN substrate or buffer layer. The proposed AlGaN heterojunction field effect transistor can achieve a threshold voltage of > 2 V, which is generally required in power device specification.

• Journal of the Korean Society for Precision Engineering
• /
• v.23 no.5 s.182
• /
• pp.190-196
• /
• 2006

Transparent materials are widely used in the fields of optic parts and bio industry. We have experiment to find out the characteristics of the micromachining inside transparent materials using femtosecond laser pulses. With its non-linear effects by very high peak intensity, filament (plasma channel) was formed by the cause of the self-focusing and the self-defocusing. Physical damage could be found when the intensity is high enough to give rise to the thermal stress or evaporation. At the vicinity of the power which makes the visible damage or modification, the structural modification occurs with the slow scanning speed. According to the polarization direction to the scanning direction, the filament quality is quite different. There is a good quality when the polarization direction is parallel to the scanning direction. For fine filament, we could suggest the conditions of the high numerical aperture lens, the short shift of focusing point, the low scanning speed and the low power below 20 mW. As the examples of optics parts, we fabricated the fresnel zone plate with the $225{\mu}m$ diameter and Y-bend optical wave guide with the $5{\mu}m$ width.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.3
• /
• pp.261-268
• /
• 2016

In this paper, dual-polarized monopulse cassegrain antenna for W-band millimeter-wave seeker was proposed and the performances were verified by the measured results of the fabricated antenna. Dual-polarized monopulse Cassegrain antenna consists of main/subreflector, dual-polarized feed horn and monopulse comparator. The proposed feed horn has $2{\times}2$ array square waveguide feeding structure to make monopulse signals and it was designed using 90 degree rotational symmetric structure to receive dual-polarized signals. At the sum and difference channel, the measured vertical and horizontal polarization radiation pattern were similar. Measurement gains are 35.1 dBi for v-pol. and 35.6 dBi for h-pol. at the center frequency with 0.5dBi difference between each polarization and the side lobe level is below -21.6 dB.