• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.12
• /
• pp.24-30
• /
• 2003

In this paper, we proposed an adaptive ATC(Automatic Threshold Control) circuit with more decreased settling time by improving the structure of the peak detector. We showed that it could reduce a good deal of the settling time because it showed less than half the error voltage ratio that the ATC circuit with conventional structure showed in analysis. We also designed a burst-mode ATC circuit for the 1.25Gbps EPON system using a commercial foundry. It produced the reference levels in very short time, 6㎱ in 40 ㏈ input dynamic range.

• 제어로봇시스템학회:학술대회논문집
• /
• 1991.10a
• /
• pp.951-956
• /
• 1991

굴삭기 엔진 펌프시스템을 실험결과에 근거해서 모델링하여 수치적으로 시뮬레이션을 행하였다. 엔진.펌프시스템은 그 구성이 복잡할 뿐만 아니라 시스템자체의 비선형성,작업에 따라 시스템에 가해지는 불확실한 외란, 파라미터의 변동으로 인하여 정확한 모델링을 행하기는 다소 어려움이 있었다. 비례제어만을 사용시는 정상상태오차의 발생,초기의 회전수저하등으로 인하여 적합하지 않았다. 이를 개선하기 위하여 PID제어를 사용하였을 경우 정상상태오차는 제거할 수 있으나 정착시간이 길어지는 것을 볼 수 있었다. 슬라이딩모우드에 의한 제어법을 적용하였을 경우 정상상태오차,정착시간,최대회전수저하량을 모두 만족하였으나 과도상태에서 오실레이션이 발생하는 현상을 볼 수 있었다.

• Journal of IKEEE
• /
• v.22 no.2
• /
• pp.384-392
• /
• 2018

A multiple-output LDO regulator is a good choice in terms of the efficiency in embedded systems requiring various supply voltages. A small feedback factor in LDO incurs the long settling time, resulting in large ripples in the time-multiplexing strategy. A new proposed topology enhances the settling time, and hence the ripples by incorporating the constant feedback factor with different reference voltages. The simulation results of a prototype design in a standard $0.35{\mu}m$ CMOS process verify that the proposed strategy enhances the settling time and ripple characteristic by more than doubled than a conventional circuit using the feedback factor of less than 0.4.

• Journal of Radiation Protection and Research
• /
• v.8 no.2
• /
• pp.36-40
• /
• 1983

Uranium radionuclides are electrodeposited on inexpensive stainless steel cathode from a mixed oxalate-chloride electrolyte. The factors affecting the optimum condition for the deposition are determined by studying the effects of deposition time, initial current, electrode spacing, pH of electrolyte and uranium concentration in the electrolyte at fixed cathode area. The experiment which was repeated 3 times at each uranium concentration with 60 minutes of deposition time, gave an error of less than 4% standard deviation at the 90% confidence level with average yield greater than 99%.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.36C no.5
• /
• pp.57-66
• /
• 1999

This paper describes a 12b, 50 Msample/s CMOS AID converter using an acquisition-time minimization technique for the high-speed sampling rate of 50 MHz level. The proposed ADC is implemented in a $0.35\mu\textrm{m}$ double-poly five-metal n-well CMOS technology and adopts a typical multi-step pipelined architecture to optimize sampling rate, resolution, and chip area. The speed limitation of conventional pipelined ADCs comes from the finite bandwidth and resulting speed of residue amplifiers. The proposed acquisition-time minimization technique reduces the acquisition time of residue amplifiers and makes the waveform of amplifier outputs smooth by controlling the operating current of residue amplifiers. The simulated power consumption of the proposed ADC is 197 mW at 3 V with a 50 MHz sampling rate. The chip size including pads is $3.2mm\times3.6mm$.

• Proceedings of the Korean Information Science Society Conference
• /
• 2005.11a
• /
• pp.880-882
• /
• 2005

MEMS 저장 장치는 기존의 디스크 저장 장치와는 다른 물리적 특성을 가지고 있는 차세대 저장 장치이다. 때문에 MEMS 저장 장치의 물리적 특성을 고려하는 디스크 스케줄링과는 다른 관리 기법이 필요하다. 본 연구에서는 MEMS 저장장치의 물리적 특성을 고려한 트랙 기반 스케줄링 방법에 대하여 제안하였다. 트랙 기반 스케줄링 기법은 스케줄링에서의 문제 상태 공간과 스케줄링을 위한 연산 횟수를 줄이고 상대적으로 정착시간에 많은 크기를 갖는 물리적 특성을 고려하여 정착시간의 추가 횟수를 줄임으로서 요청에 대한 빠른 서비스를 가능하게 해주고 요청에 대한 대기 시간을 고려함으로서 동시에 기아상태를 방지한다.

• Proceedings of the Korea Technical Association of the Pulp and Paper Industry Conference
• /
• 2002.11a
• /
• pp.218-226
• /
• 2002

제지분야에서 중성 사이즈제로 광범위하게 사용되어지는 AKD emulsion의 사이징 효과의 발현속도가 낮은 단점을 보완하기 위하여, 기존 AKD emulsion에 추가 투입 사용함으로써 발현속도를 높여줄 수 있는 AKD 급속 반응형 정착제, 그리고 정착제를 사용하지 않는 초지 시스템에서도 급속 경화가 가능한 급속 반응형 AKD emulsion을 개발 하였다. AKD 급속 반응형 정착제의 투입량 및 종이 건조시간에 따른 사이징 효과를 상용화된 정착제와 비교하였으며 이 결과로부터 보다 빠른 사이징 효과발현을 확인하였다. 정착제를 사용하지 않는 시스템에서 급속반응형 AKD emulsion의 사이즈도 급속발현 효과를 확인하기 위하여 상용화된 emulsion과 사용량에 따른 사이징 효과와 건조시간에 따른 사이징효과를 비교함으로서 사이즈도의 급속 발현을 확인 할 수 있었다.

• Korean Journal of Remote Sensing
• /
• v.31 no.6
• /
• pp.501-512
• /
• 2015

Landfast sea ice (LFI) in Terra Nova Bay, East Antarctica where the Jangbogo Antarctic Research Station is located, has significant influences on marine ecosystem and the sailing of an icebreaker. Therefore, it is essential to analyze the spatio-temporal variation of the LFI in Terra Nova Bay. In this study, we chose interferometric pairs with the temporal baseline from 1 to 9 days out of a total of 62 COSMO-SkyMed synthetic aperture radar (SAR) images over Terra Nova Bay obtained from December 2010 to January 2012, and then constructed the coherence image of each pair. The LFI showed coherence values higher than 0.3 even in the interferometric SAR (InSAR) pairs of up to 9-days of temporal baseline. This was because the LFI was fixed at coastline and thus showed low temporal phase decorrelation. Based on the characteristics of the coherence on LFI, We defined the areas of LFI that show spatially homogeneous coherence values higher than 0.5. Pack ice (PI) and open water showed low coherence values due to large temporal phase decorreation caused by current and wind. Distinguishing PI from open water in the coherence images was difficult due to their similarly low coherence values. PI was identified in SAR amplitude images by investigating cracks on the ice. The extents of the LFI and PI were estimated from the coherence and SAR amplitude images and their temporal variations were analyzed. The extent of the LFI increased from March to July (maximum extent of $170.7km^2$) and decreased from October. The extent of the PI increased from February to May and decreased from May to July when the LFI increases dramatically. The extent of the LFI and air temperature showed an inverse correlation with a time lag of about 2 months, i.e., the extent of the LFI decreases after 2 months of the increase in the air temperature. Meanwhile the correlation between wind speed and the extent of the LFI was very low. This represents that the extent of LFI in Terra Nova Bay are influenced more by the air temperature than wind speed.

• The Journal of Engineering Geology
• /
• v.32 no.2
• /
• pp.271-280
• /
• 2022

Landfast sea ice forms near coastlines in polar regions. Continuous monitoring of this sea ice is important, as it plays a key role in the marine ecosystem and affects the operation of nearby research stations. This study detected landfast sea ice around Jang Bogo research station in East Antarctica by stacking interferometric coherence images of Sentinel-1 synthetic aperture radar (SAR) data with 6-, 12- and 18-day temporal baselines. A total of 50 landfast sea ice maps were generated covering July 2017 to June 2018. The time series revealed regional differences in the timing of the maximum extent as well as growth rate of landfast sea ice. Overall, detecting landfast sea ice using interferometric SAR coherence seems promisingly feasible; however, limitations remain owing to low backscattering coefficients from new and smooth sea ice surfaces and subtle movements of sea ice in contact with the Campbell Glacier Tongue.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.12
• /
• pp.31-38
• /
• 2003

In this paper, we proposed a new structural AGC(Automatic Gain Control) circuit with extremely short settling time using high speed operation characteristics of a clipper. We investigated its operation characteristics in analysis. We also designed a burst-mode preamplifier for 1.25Gbps EPON systems using commercial foundry and investigated its characteristics by comparing the results of the designed and those of the analyzed. The characteristics of the designed circuit are in good agreement with those of the analyzed. As a result, it is shown that it is possible to realize extremely short settling time of under 1㎱.