• Tunnel and Underground Space
• /
• v.26 no.5
• /
• pp.441-453
• /
• 2016

This study aimed to develop a two-component TSL suitable for reducing dust and guaranteeing homogeneous qualities during its spraying. Its performance was evaluated by a series of laboratory and field tests. High ductility of two-component TSL prototypes resulted in increasing their elongation at break even though their tensile strengths were slightly lower than those of one-component powder TSLs. One prototype of the two-component TSLs developed in this study was verified to satisfy every criterion specified by EFNARC (2008). Especially, it increased the average compressive strength of mortar specimens by 50% even when it coated them only with the thickness of 3 mm. From a preliminary spraying test, a spraying machine suitable for the developed TSL prototype was derived and modified. After its field application, dust and rebound generated during its spraying works were found to be very minimal. Its spraying rate was recorded to be approximately $60m^2/hr$. In addition, it showed a very rapid hardening characteristic compared with general sprayable waterproofing membranes.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.4 no.1
• /
• pp.45-55
• /
• 2002

From the early 1980's, the New Austrian Tunnelling Method (NATM) has been developed as one of the standard tunnelling methods in Korea. Approximately 10 years ago, wet-mix shotcrete with sodium silicate (waterglass) accelerator was introduced and widely used to tunnel lining and underground support. However, this accelerator had some disadvantages due to the decrease of long-term strength compared to plain concrete (without accelerator) and low quality of the hardened shotcrete. In order to compensate for these disadvantages, recently developed alkali-free accelerator has been successfully demonstrated in numerous projects and applications as a new material to make tunnels more durable and safer. An experimental investigation was carried out in order to verify the strength behavior of wet-mix Steel Fiber Reinforced Shotcrete (SFRS) with alkali-free accelerator. Compressive strength, flexural strength, and flexural toughness were measured by testing specimens extracted from the shotcrete panels. From the results, wet-mix SFRS with alkali-free accelerator exhibited excellent strength improvement compared to the conventional shotcrete accelerator.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.12 no.4
• /
• pp.285-294
• /
• 2010

As there are increasing number of tunneling works these days, shotcrete is used as primary supports in order to secure the stability of tunnels. The quality of shotcrete has a direct influence on tunnels, because it is a primary support which secures the stability of completed tunnels as well as the stability of tunnels under excavation. Especially in case that ordinary shotcrete is used under weak rock conditions or at water gushing sections, more shotcrete is needed and rebound ratio increases. As a result, it is hard to keep economic feasibility. In addition to it, in subway construction, there are cases of separated excavation and it may have a bad influence on construction period or quality. Therefore, in this study, we are going to evaluate the early strength of powder type accelerator.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.16 no.2
• /
• pp.135-148
• /
• 2014

This study was performed to evaluate the performance about Improved C12A7 based mineral accelerator (ICM) increased in initial and long-term strength. ICM was developed to overcome the long-term strength decrease in existing accelerator. To evaluate the performance of ICM according to addition rate, setting time, compressive strength, and flexural strength tests were conducted in laboratory. In results, initial setting time was slower, final setting time was faster than existing $C_{12}A_7$ based mineral accelerator (CM) when usage of ICM 6%. In compressive and flexural strength, existing CM was higher than ICM at 3hours and 1day. After 7days, strength of shotcrete using ICM was increased. Rebound test, compressive strength and flexural strength test with optimum addition rate through the laboratory test were conducted in field. Field experiment results were the same as laboratory test. Long-term strength performance of ICM was superior to existing accelerator.

• Journal of the Korea Society of Computer and Information
• /
• v.25 no.7
• /
• pp.135-142
• /
• 2020

Basketball is a highly complex sport, analyses offensive and defensive rebounds, free throw percentages, minutes played and an efficiency rating. These statistics can have a large bearing and provide a lot of pressure on players as their every move can be analysed. Performance analysis in sport is a vital way of being able to track a team or individuals performance and more commonly used resource for player and team development. Discovering information such as this proves the importance of these types of analysis as with post competition video analysis a coach can reach a far more accurate analysis of the game leading to the ability to coach and correct the exact requirements of the team instead of their perceptions. A significant difference was found between winning and losing performances for different types of turnovers supporting current research that states that turnovers are not a valid predictor of match outcomes and that there is no specific type of turnover which can predict the outcome of a match as briefly mentioned in Curz and Tavares (1998). Significant differences were found between winning and tied and losing and tied performance for some types of turnovers, however due to the lack of data collected in this area they cannot be considered valid. Further research could also be conducted in other areas relating to performance indicators where there is currently minimal research in some areas such as assisted baskets, stated about the performance indicators in their own study the performance indicators are inadequate for explaining the complexities of the game suggesting that one indicator will not be constant in every game an research into performance analysis areas would be more appropriate.

• Composites Research
• /
• v.29 no.2
• /
• pp.73-78
• /
• 2016

In this paper, The concept of a wheel with carbon fiber composite is to replace the conventional material used for a wheel hub, such as plastic, with a disk-type hub made of carbon fabric and epoxy resin. The impact load from the ground under real conditions was considered; a low-velocity impact test was conducted to evaluate the impact performance of the carbon wheel and compare it with that of a conventional plastic wheel. This study applied a 70 J impact load as a test condition. The impact energy was controlled in the test by adjustment of height and weight of impactor. The use of a carbon disk wheel hub was confirmed to reduce weight and generate an excellent repulsive force at low energy under conditions similar to real driving conditions. The results showed that the maximum load increased proportionally depending on the impact load, but the growth of the maximum load was reduced at a 20 J impact load and tended to decrease at a 45 J impact load. The carbon wheel showed excellent properties ; the level of rebounding was 35.3% and 19.1% of the total impact energy at impact loads of 5 J and 10 J, respectively. On the other hand, the carbon disk wheel rebounded less than 5% of the total energy due to crack generation of the thin carbon hub for impact loads of more than 20 J.

• Journal of the Society of Disaster Information
• /
• v.8 no.3
• /
• pp.223-233
• /
• 2012

Steel fiber is high stiffness and large weight. So, Pumping hose to rupture of the safety management is difficult. Steel fiber caused by corrosion of the deterioration of durability and high-rebound losses are needed for the improvements. Thus, the revised regulations in 2009 by a steel fiber to reinforce other materials is possible. Variety of fiber reinforcement material for concrete review of applicability is needed. Steel fiber strength than the other fibers is large and by the geometry of the fibers are attached to improve performance. However, compared to steel fiber organic fibers and low modulus of elasticity and tensile strength of fiber and agglomeration occurs in the concrete to be used as reinforcement material is difficult. In this regard, the present study as a single object in the micro-fiber bouquet sharp entanglement through make muck attach surface area, distributed fibers from surfactant of the surface enhanced polyamide fibers, steel fiber and PP fiber reinforced concrete by comparing the scene to provide a basis for the use.

• The Korean Journal of Vision Science
• /
• v.20 no.4
• /
• pp.589-596
• /
• 2018

Purpose : We compared intraocular pressure (IOP) values measured by two types of tonometers in condition of normotensive and glaucomatous rat model. We tried to determine which of tonometer can more easily and accurately measure the IOP of animal model. Methods : Glaucomatous eyes were induced by intracameral injections of hyaluronic acid in right eyes of six-week-old male Spargue-Dawley (SD) rats. Normotensive contralateral eyes were left eyes of the SD rats. IOP was measured using a rebound tonometer (Tonolab) and a immersive tonometer ($Tonopen^{(R)}$ XL) about 3:00 pm. Results : The mean IOP values of normotensive control eyes were $10.80{\pm}1.03mmHg$ by Tonopen, and $15.10{\pm}0.73mmHg$ by Tonolab. They were statistically insignificant (p = .1). The mean IOP values of glaucomatous experimental eyes were $30.20{\pm}2.67mmHg$ by Tonopen, and $37.90{\pm}2.73mmHg$ by Tonolab. They were statistically insignificant (p = .95). High IOP values of glaucomatous eyes by two types of tonometers had strong positive correlation each other (r = .904, p < .01). Conclusion : This is the first study to compare IOP values using two types of tonometers between normotensive and glaucomatous model made by intracameral injection of hyaluronic acid. Tonopen should be used carefully when the IOP is within normal range, and both Tonopen and Tonolab can be used reliably when the IOP is high.

• Fire Science and Engineering
• /
• v.13 no.4
• /
• pp.38-55
• /
• 1999

In order practically to use fire-defective glazing materials for the compartment wall where a fire-protection rating is mandated, there have been many trials internationally, This research focuses on a feasibility that, if certain water film covered all surface of glass, the glazing system can endure without breaking out under the compartment fire. First of all, a water film spray system was specially designed to wet the entire surface of the glass and also to have tiny small amount of water rebounded from the surface after emitted from nozzles. After this system has proven to have perfect performance, small-scale tests were done to find out if the water film covered glazing system react to the high temperature curve in a small furnace room. Finally, on basis of the obtained data, full-scale experiments were done so that water-film covered glazing system can pass the Korean Standard (KS) test for fire resistance, KS F2257.

• Journal of the Korea Society of Computer and Information
• /
• v.25 no.7
• /
• pp.103-111
• /
• 2020

Performance indicators have often investigated and developed in order to identify foundational elements and factors for an enhancement of performance in sports. In order to identify the valid performance indicators it is important that the indicators used within a performance analysis system discriminate between the winning and losing performances within a match (Hughes and Bartlett, 2002). However, the performance indicators proposed in research studies on basketball performance have not been used for real-time analysis and feedback within a coaching context. Such real-time support for the coach and players has been described within research on other sports (Choi et al., 2004; O'Donoghue, 2001; Palmer et al., 1997). Within the process of real-time feedback, the identification of relevant performance indicators that distinguish winning and losing performances should be the first stage of the development of a real-time analysis system. Therefore, this study investigated the differences between winning and losing teams in terms of a set of performance indicators gathered during the analysis of 10 English National Basketball League matches. Winning and losing teams were compared using whole match data (N=10) as well as individual quarters (N=40). A series of Wilcoxon Signed Ranks tests was used to identify the relevant performance indicators that discriminate between winning and losing performers within whole matches and individual quarters. The tests found that 3 point shots made (p<0.05) and Assists (p<0.05) were significantly different between winning and losing teams within matches. However, 2 point shots made (p<0.05), 2 point shots attempted (P<0.05), percentages of 2 point shots scored (p<0.05), 3 point shots made (p<0.05), Defensive Rebounds (p<0.05) and Assists (p<0.05) were significantly different between winning and losing performance within quarters. The analysis task should be based on relevant performance indicators which explain the current performances to performance analysts and coaches. Within a real-time analysis and feedback scenario, this will have the additional benefit of supporting a decision based on immediate performance within the most recent quarter. Consequently, the real-time analysis system would use performance indicators which have the property of construct validity to support the decisions of the coach.