• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.9
• /
• pp.2390-2395
• /
• 2009

In the condition of GHSV=$30000\;hr^{-1}$, $NO_x$ removal yield was higher as mole ratio of $SiO_2/Al_2O_3$ for Fe/ZSM-5 was lower regardless of preparation method such as CVD (chemical vapor deposition) and dry impregnation. In addition to this, Fe/ZSM-5 catalyst showed about 50% $NO_x$ removal yield between $350^{\circ}C$ - $400^{\circ}C$ while CO formed significantly. To remove newly formed CO over Fe/ZSM-5, Co-Pt/ZSM-5 was used in conjunction with Fe/ZSM-5 in the series and this demonstrated over 90% removal yield of both NOx and CO at $250^{\circ}C$ and GHSV=$30000\;hr^{-1}$.

• Journal of Advanced Marine Engineering and Technology
• /
• v.30 no.3
• /
• pp.420-427
• /
• 2006

This paper describes design and characteristic analysis of the 200[kW], 3000[rpm] induction motor for gearless turbo machine. It was designed by the loading distribution method and the results of characteristics obtained by the equivalent circuit method are compared with the results of circle diagram. To verify the validation of design 2D finite element method is used and also 3D finite element method is used to calculate the current density curve of the rotor bars when they are broken.

• 한국생물공학회:학술대회논문집
• /
• 2002.04a
• /
• pp.317-320
• /
• 2002

To search for antioxidant compounds from plant resources, ethanol extracts of 10 plants species were investigated using DPPH method and SOD activity by NBT method. The highest activity was shown in the ethanol extracts of Schizandra Chinesis Baillon. And than, antioxidant effects and total polyphenol concentration were investigated in solvent fraction of ethanol extracts from Schizandra Chinesis Baillon. The DPPH inhibitory activity and SOD activity of ethyl acetate fraction (DPPH 51.6%, SOD 66.2%) and butanol fraction(DPPH 60.7%, SOD 67.4%) showed strong biological activities.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.5
• /
• pp.1-8
• /
• 2000

Fatigue and data retention characteristics of the Pt/PZT/Pt structure using single grain PZT thin films by PZT seeding method were investigated. In case of fatigue, there is no loss in switched polarization up to 2$\times$10$^{11}$ cycles using 1MHz square wave form at $\pm$10V and no data loss after 30000sec of memory retention at room temperature. From the activation energy measured at high temperatures, the time required 20% loss in remanent polarization is estimated to be 6.6$\times$10$^{7}$ years at room temperature.

• Applied Chemistry for Engineering
• /
• v.24 no.3
• /
• pp.333-336
• /
• 2013

Experimental investigation to estimate the feasibility of fast selective catalytic reduction (SCR) or oxidation catalyst combined ammonia SCR system to abate NOx in low temperature condition ($150{\sim}250^{\circ}C$) is reported. Because the conversion of NO to $NO_2$ is pre-requisite of the fast SCR process, the effect of the amount of oxidation catalyst to NO conversion to $NO_2$ was tested. 37, 45 and 51% of conversion rates were obtained for the OCV of 563000, 375000 and 281000 h, respectively. $De-NO_x$ performance in the case of $NO_2/NO_x$ ratio of 45% showed the best result in all tested temperature conditions. Comparison of the fast SCR and standard SCR with the condition of $NO_2/NO_x$ ratio of 45%, $200{\sim}250^{\circ}C$ and space velocity of 10000~30000 h showed that the fast SCR does not show much difference according to the variance of space velocity. Also it was shown that using the fast SCR, the volume of SCR catalyst can be reduced less than half of the standard SCR condition by increasing space velocity without the loss of $De-NO_x$ performance.

• Proceedings of the IEEK Conference
• /
• 1999.06a
• /
• pp.825-828
• /
• 1999

A Viterbi Decoder for IMT2000 Mobile Station based on cdma200 is implemented in this paper. There are fundamental traffic channel, supplemental traffic channel for user data transmission and dedicated control channel for signal transmission in cdma2000. This decoder can decode these channels simultaneously, and support l/2, l/3, 1/4 code rate decoding. In case of fundamental channel decoding, it needs about 1100 logic cells and 30000 bit memory block.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 1995.10a
• /
• pp.130-135
• /
• 1995

본 연구에서는 30000rpm으로 회전하는 진공청소기 원심팬의 유동장을 임펠러, 디퓨저, 케이싱을 모두 고려하여 해석하였다. 또한 삼차원으로 배출되는 출구를 간단한 sink 패널로 모델하여 출구의 효과를 충분히 고려하였다. 해석된 유동장 자료를 이용하여 먼 거리에서의 음압을 예측하였다. 예측된 음압자료는 FFT를 이용하여 측정된 값과 주파수 영역에서 비교하였다. 또한 진공청소기 원심팬의 측정자료에서 보이는 광역소음특성이 임펠러에서 흘려지는 후류와류의 교란에 의한 임펠러와 디퓨저 깃의 비정상 힘이 주된 원인임을 밝혔다.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.17 no.5
• /
• pp.15-21
• /
• 1980

An engine control system in which the conventional mechanical ignition system is studied. The contact point of the breaker is replaced by the contactless magnetic pick up sensor from which the information of the speed and the position of the crankshaft is extracted , and further an electronic High Energy Ignitim System Is designed, implemented and tested . The High Energy Igniticwl System increases the secondary spark voltage of the ignition coil from the conventional 10000~15000 volts to the 30000~40000 volts resulting in improving the combustion efficiency. Also, instead of the conventional advimce mechanism forigniliontiming control, a microprocessorbased timinng mechanisn is installed to determine the ignition timing data in response to the engine rpm and the intake manifold vacuum.

• Polymer(Korea)
• /
• v.38 no.6
• /
• pp.714-719
• /
• 2014

Bio-based nylon 6-morpholinone random copolymers were prepared by the anionic ring opening polymerization of ${\varepsilon}$-caprolactam and morpholinone, both of which were prepared from lysine and glucose, respectively. From this work, a new biomass based nylon 6 with improved hydrophilicity was prepared. Optimizing the polymerization condition, copolymer with a viscosity-average molecular weight of 30000 g/mol was prepared, with a yield of 80%. It was possible to improve the hydrophilicity of nylon 6 by its copolymerization with morpholinone. The prepared nylon 6-morpholinone random copolymers were then characterized using several analytical methods such as DSC, TGA, XRD, viscosity measurement with U-shaped glass capillary viscometer and contact angle measurement.

• KSBB Journal
• /
• v.26 no.5
• /
• pp.400-406
• /
• 2011

This study was investigated to improve the saccharification yield of Ulva pertusa Kjellman by the high pressure homogenization process. It was found that the high pressure homogenization pretreatment effectively destructed the cell wall structures only by using water. The high pressure homogenization process was operated under various conditions such as 10000, 20000 or 30000 psi with different recycling numbers. The optimal condition was determined as 30000 psi and 2 pass of recycling numbers and the sugar conversion yields were 16.02 (%, w/w) of glucose and 14.70 (%,w/w) of xylose, respectively. In the case of enzymatic treating the hydrolyzates with 5 FPU/glucan of celullase and 100 units/mL of amyloglucosidase, 65.8% of carbohydrates was converted into glucose. Using the hydrolysates of Ulva pertusa Kjellman, 48.7% of ethanol was obtained in the culture S.cerevisiae. These results showed that the high pressure homogenization process could efficiently hydrolyze the marine resource by using only water for bioethanol production.