• Fibers and Polymers
• /
• v.7 no.3
• /
• pp.295-304
• /
• 2006

High-bulk worsted yams with different shrinkable and non-shrinkable acrylic fibers blend ratios are produced and then single jersey weft knitted fabrics with three different structures and loop lengths are constructed. The physical properties of produced yams and compression properties of produced fabrics at eight pressure values (50, 100, 200, 500, 1000, 1500 and $2000 g/cm^2$) were measured using a conventional fabric thickness tester. Then, weft-knitted fabric compression behavior was analyzed using a two parameters model. It is found that at 40 % shrinkable fibre blending ratio the maximum yam bulk, shrinkage, abrasion resistance and minimum yarn strength are obtained. It is also shown that high-bulk acrylic yarn has the highest elongation at 20 % shrinkable fibre blend ratio. The statistical regression analysis revealed that the compression behavior of acrylic weft-knitted fabrics is highly closed to two parameter model proposed for woven fabrics. It is also shown that for weft-knitted structure, there is an incompressible layer (V') which resists against high compression load. Acrylic weft-knitted fabrics with knit-tuck structure exhibit higher compression rigidity and lower softness than the plain and knit-miss structures. In addition, at 20 % shrinkable fibre blend ratio, the high-bulk acrylic weft-knitted fabrics are highly compressible.

• Fashion & Textile Research Journal
• /
• v.5 no.3
• /
• pp.273-282
• /
• 2003

Effect of fixation methods and relaxation treatment on the flame retardant(FR) and physical properties of MDPP/HMM treated cotton weft-knitted fabrics were studied. Combination of four different fixation methods - relaxation, swelling agent treatment, pad dry cure fixation, and wet fixation - were applied to flame retardant finish of cotton weft-knitted fabric with MDPP/HMM. As the results, 1. Swelling agent and wet fixation method helps FR agent penetrate the fiber efficiently. Interlock showed relatively higher values of LOI than single jersey. 2. Interlock showed relatively higher values of bending rigidity(B), shear rigidity(G) and coefficient of friction(MIU) than those of single jersey before and after flame resistant treatment. 3. An increase in internal volume of cotton fiber by relaxation treatment increased the bending rigidity(B), shear rigidity(G) and compressional energy(WC). 4. The cotton weft-knitted fabric treated wet fixation, which crossliked FR agent efficiently, showed higher bending rigidity, shear rigidity(G) and lower compressional energy(WC). Retention of swelling ability of cotton weft-knitted fabrics treated with MDPP/HMM, which increased the internal volume of cotton weft-knitted fabric, showed lower bending rigidity.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.21 no.1
• /
• pp.170-181
• /
• 1997

The purpose of this study was to determine the effect of knit structure and knit density (machine tightness factor) on the dimensional properties and K1-4 values of weft-knitted fabrics followed over eleven cycles of mechanical relaxation to provide the basic data for constructing weft-knitted fabrics for outwear with excellent dimensional stability The eighteenth weft-knitted fabrics were produced with different knit structure (1$\times$1 rib, half-cardigan rib, half-milano rib, interlock, single pique, crossmiss interlock) and machine tightness factor (loose, medium, tight) for this study. Dimensional properties such as width, lengh, area shrinkage and dimensional parameter (K) of eighteenth knitted fabrics including thickness and bulk property were measured. The results were as follows; 1. The dimensional behavior of the Ix1 rib and interlock in relaxation cycles was anisotropic, i.e., length shrinkage was usually associated with a width expansion, whereas the other weft-kntted fabrics which have tuck or miss loops in the knit structure behaved isotropically, i.e., length and width shrinkages were usually found. It was proposed that the difference in dimensional behavior between these structures was due to the dissimilar nonrelaxed geometrical shapes of the individual structural units forming these weft-knitted structures. The mechanical relaxation shrinkage of weft-knitted cotton fabrics was dependent on the tightness of construction. For a range of fabrics knitted on this study, an increase in fabric tightness caused a decrease in the length shrinkage of the fabric accompanied by an increase in its width shrinkage.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.30 no.6 s.154
• /
• pp.870-879
• /
• 2006

In this study, the difference in the mechanical properties of silver and cotton weft knitted fabrics was studied. Six silver fabrics for the summer ladies' knit outwear were knitted varying knit structure and fabric density. Two commercial cotton knitted fabrics were selected to compare the properties. subjective sensation of hand of the fabrics was also studied. Mechanical properties of the fabric samples were measured by KES-FB system. From these, primary hand values(HV) were evaluated by the conversion equation (KW-403-KTU) and the total hand value(THV) was carried out according to the KW-304 Summer. The result of the research show that silver weft knitted fabrics had lower LT, RT, G, 2HG and higher EM, W, LC, WC, RC than cotton weft knitted fabrics. The use of silver yam contributed to increase in surface roughness of knitted fabrics. As the silver knitted fabrics became thicker compressional energy increased. The use of silver yarns contributed to much better fabric handle compared with the use of cotton yam only. It appeared that coefficient of friction of tuck stitch was larger than that of plain and interlock stitch. KOSHI and FUKURAMI values of the tuck samples were significantly higher than those values of the plain and interlock samples, while SHARI values were low in general. The total hand value of tuck stitch was higher than those of interlock and plain stitch.

• Journal of the Korean Society of Industry Convergence
• /
• v.9 no.4
• /
• pp.337-341
• /
• 2006

The tensile properties of Poly(trimethylene terephthalate, PTT) $1{\times}1Rib$ knitted fabrics were experimentally studies, and the specimens has $1{\times}1$ rib stitched structure which are weft knitted fabrics with various lengths of loop. The $1{\times}1$ rib weft knitted fabric showed larger tensile linearity, tensile energy and tensile resilience in the direction of courses. The tensile properties increased with increasing the loop density in all directions, and perfectly increased with the course directions than the wale directions.

• Journal of Ocean Engineering and Technology
• /
• v.14 no.2
• /
• pp.89-98
• /
• 2000

Using conventional textile techniques such as weaving braiding knitting and stitching it is possible to produce a wide range two and three dimensional fiber preforms, however so far only a limited attention has been given to knitted fabrics in composite industry. This is mainly due to the opinion that knitted fabric reinforced composites posses low mechanical properties owing to their looped fiber architecture. But it is possible to obtain desired mechanical properties by selecting proper knitted fabric structure, In this paper mechanical characteristics of kevlar plain weft knitted fabrics reinforced plastics(KFRP) are evaluated for th development of intrusion beam of car side door. Tensile bending impact properties of KFRP are measured experimentally and crush demands of Americal Federal Motor Vehicle Safety Standard No.214(FMVSS 214) compared with the bending load and displacement of KFRP by quasi-static test method. The applicability and limitation of bending load and displacement of KFRP according to specimen size has been discussed.

• Fashion & Textile Research Journal
• /
• v.11 no.3
• /
• pp.460-464
• /
• 2009

The purpose of the study was to investigate the changes of drapability and mechanical properties with folded yarn conditions. The samples were knitted 100% cotton yarn with hand-knitting machine. Mechanical properties were measured by Instron and Kawabata tester. Drapability was measured by Drapemeter. The differences in each sample were observed in the experimental results. This study showed that folded conditions were important conditions for fabric handle and properties.

• Fashion & Textile Research Journal
• /
• v.10 no.5
• /
• pp.756-761
• /
• 2008

In this paper, silver slit yarns combined with cotton yarns were used to produce weft knits. The purpose of this study was to investigate the physical properties as well as the functional properties of weft knit with silver slit yarns. The six different weft knit fabrics were made from silver slit yarns varying knit structure and fabric density. One cotton weft knit was also knitted to compare the properties. Weft knits made from silver slit yarns were characterized by excellent antibacterial properties, electric magnetic shielding properties, UV-cut properties, anti-static properties, and air permeability. Although there were significant differences in the physical properties of different knit structure and the fabric density, weft knits with silver slit yarns were seen to have better end use properties and ideal for apparel than the cotton weft knits.

• Journal of the Korea Fashion and Costume Design Association
• /
• v.14 no.1
• /
• pp.111-121
• /
• 2012

This study focused on the plane and side drape coefficients of weft knitted fabrics as a function of knit structure, stitch density, and stiffness. Fifteen weft knitted fabrics are produced with five different structures (interlock, single pique, royal interlock, cross miss interlock, and mock royal interlock) and three different gauges (7G, 10G, and 12G). Five knit structures were the application of knit, tuck, and miss stitch on the basis of interlock of the double knit fabric For this purpose, three-dimensional shapes of the draped sample were obtained by using a drapability tester which can record the contour line coordinates of a projected plane drape. Then, projected shapes of the plane and side drape were derived from those three-dimensional ones to review the relationship between plane drape coefficients and side ones. It was found that the theoretical values of plane and side drape coefficients depending on the change of deflection angles fit to their experimental ones. A5 a result of a regression analysis of the relationship between plane and side drape coefficients, the relationship could be expressed as $y=0.5838x-0.0065x^2+9.03{\times}10^{-5}x^3$. In case of mean of drape coefficient, it was increased according to the rule of that the more tuck and miss stitch overlap. A high degree of correlation was found between stiffness and drape coefficient. The regression equation of drape coefficient($y$) can be represented by $y=y=\sqrt[3]{Stiffness}-10.72$.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.28 no.8
• /
• pp.1153-1164
• /
• 2004

The purpose of this study was to knitted nine kinds of single knit and examined mechanical properties and hand to provide the fact that knit, tuck and miss stitch applied to various structure have an effect on hand of weft knitted fabrics. It was good to use tuck stitch rather than miss stitch to increase elasticity of knitted fabrics. As tuck stitch and miss stitch were double or triple overlaps, tensile resilence(RT) decreased by increase of friction contacted among stitch. As cross tuck stitch and cross miss stitch were knitted double or triple, bending rigidity(B), hysteresis of bending moment(2HB) and shearing(G) properties increased by jamming of stitch. As tuck stitch and miss stitch were overlap, thickness increased and they became thicker than miss stitch. Also, as they became thicker by these tuck stitch and miss stitch, compressional energy(WC) increased. It appeared that coefficient of friction(MIU) of cross tuck stitch was larger than coefficient of cross miss stitch. Mean deviation of surface roughness(SMD) had a tendency to be larger as tuck stitch and miss stitch increased. As cross tuck stitch and cross miss stitch were overlaps double or triple, KOSHI and FUKURAMI increased, total hand value(TIV) and NUMERI appeared high in double cross tuck stitch and double cross miss stitch.