• Proceedings of the Korea Concrete Institute Conference
• /
• 1999.04a
• /
• pp.187-190
• /
• 1999

This study is intended to present the properites of planting concrete using the light-weight aggregate and crushed aggregate. According to the result of experiment, the concrete using orchid stone shows a better performance in voids volume, unit weight, absorbtion, thermal conductivity and pH, which are helpful for planting and heat isolation. Therefore, if planting concrete used with orchid stone are utilized to be the planting base on the building's roof, it will be effective to reduced the cost of construction and heating due to the redution of building's self weight and heat isolation effection.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2009.11a
• /
• pp.69-72
• /
• 2009

This research is focused on the applying of the foaming agent which can make the independent pore in the concrete structure in order to make a lightweight concrete structure. This lightweight foamed concrete can satisfy both the required strength and the mechanical properties as structural members. In addition, anti freezing-thawing properties also required. As a result of the unit volume-weight measurement, when the foaming agent mixed at 0.5% to 1%, the lightweight foamed concrete can be applied for the structural member. Also the density and compressive strength measurement results reveals that it will be suitable as structural member with 21MPa strength, when the density is betweenity8 to 1.9 and foaming agent quantities are 0.5% to 1%. Finally the result of freezing-thawing experiment, the effect freezing-thawing damage reduced according to adding foaming agent because those foaming agent make micro-pores in the structure which are not seen in the ordinary concrete structure.

• The Journal of Engineering Geology
• /
• v.19 no.4
• /
• pp.493-499
• /
• 2009

Recently, the construction of Concrete Faced Rockfill Dam (CFRD) is increasing because rock material resources are plenty in Korea. Bedding zone in the CFRD is necessary enough bearing capacity to support the concrete face slab uniformly and enough impermeability to prevent the loss of fine soils in case of leakage from the concrete slab face. Therefore, cut-off the water leakage in bedding zone securely is the key factor influencing the safety of CFRD. Tested materials satisfied with the specification of particle size distribution at the Bedding Zone area are chosen for conducting permeability tests, which are done to evaluate the property of cut off the materials. Based on the test results, the effects of cut off the materials are investigated by considering the coefficient of permeability, the soil particle distribution, and the dry unit weight. Especially, the relationships between coefficient of permeability with effective size(D10), dry unit weight, and weight passing percent the No.4 sieve are suggested, and also the variation of coefficient of permeability with time are proposed.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1991.10a
• /
• pp.140-145
• /
• 1991

Tests were conducted to get a mix proportioning of high strength concrete between σ28 and (C/W) using low quality materials easily purchased in situ. Superplasticizer was used as a chemical admixture to compensate low slump of base concrete keeping it up about 15±2㎝. General material properties such as modulus of elasticity, poisson's ratio, unit weight and stress-strain characteristic of high strength concrete were obtained. Test results show that mix proportioning of high strength concrete proposed in this paper have reasonable validity and these can be used as a design criteria in high strength concrete construction.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1997.04a
• /
• pp.210-219
• /
• 1997

This research which lays emphasis on ready mixed concrete standard 25-210~240kgf/$\textrm{cm}^2$ shows the influence caused by the ratio of ingredients of superplasticized concrete, and the flowing and strength development of mortar and concrete according to the ratio of ingredients. This research shows that flowability, compactability, and segregation resistivity are the best condition under the following ratio of ingredients: fly ash 30%, unit binders 490~510kg/$\textrm{m}^3$, unit weight of water 184~194kg/$\textrm{m}^3$, fine aggregate ratio 49~51%, and superplasticizer 1.1~1.5%. Following this ratio of ingredients, the reinforced concrete structures to need design strength 25-210~240kgf/$\textrm{cm}^2$ can apply to complicated constructions.

• Journal of the Korean Society of Industry Convergence
• /
• v.10 no.4
• /
• pp.207-211
• /
• 2007

The durable lifetime of RC structures is shortened by various reasons, which are the generation of cracks in construction and service term, the exterior deterioration according to climatic condition, the surface damage due to chloride attack and the corrosion of reinforced bars. The durability of concrete structures is nevertheless able to be increased by the method and the material of reinforcement and repair. The epoxy resin is widely used for reinforment and repair of concrete because of the superiority in mechanical property, adhesive property, abrasion resistance, impact resistance and chemical resistance. The epoxy cement mortar with hardening agent has a lot of disadvantages that are troublesome mixing work, weakened weatherability and high cost for hardening agent. In this study, the mix proportion of mortar is presented just only with epoxy resin and some admixtures, and the test result of mortar without hardening agent shows the higher strength than the mortar with hardening agent. In the mix proportion, the weight of epoxy resin must be less than 15% of the unit weight of cement, and 10% of unit weight of cement is adequate for the weight of admixtures.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.05a
• /
• pp.582-585
• /
• 2006

Recently, many methods to evaluate the water content in concrete were developed. In this study, using a commercially avaliable equipment by the unit volume weight method, the water content in concrete was estimated when the moisture content in sand was changed. In order to evaluate the accuracy and the usefulness of the method, the designed water content and the measured water content were compared. The compressive strength of concrete with the variation of moisture content in sand was measured as well. As a result, it appears that in order to predict the water content in concrete, the adjustment coefficient of aggregate should be exactly estimated. It is shown that the equipment tends to underestimate the water content in concrete.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.51 no.1
• /
• pp.21-26
• /
• 2009

This study was performed to evaluate the physical and mechanical properties of concrete using waste activated carbon. Materials used were ordinary portlant cement, crushed coarse aggregate, natural fine aggregate, waste activated carbon, and superplasticizer. The substitution ratios of waste activated carbon were 0,1,2,3,4,5,6,7,8,9 and 10%. The unit weight was decreased and water absorption ratio was increased with increasing the waste activated carbon content, respectively. When the substitution ratio of waste activated carbon was 3%, compressive strength, flexural strength and dynamic modulus of elastisity were more higher than that of the ordinary portland cement (OPC), and it was decreased with increasing the waste activated carbon content, respectively. The most effective contents of waste activated carbon was 2% in performance and 4% in practical use Accordingly, waste activated carbon can be used for concrete material.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.05a
• /
• pp.319-324
• /
• 2001

Recently new practical use way of industry product is required. In this study, to find flowing property of slump, unit weight, the air amount, compressive strength etc. Compressive strength 240, 270kgf/$cm^{2}$, slump 8$\pm$2.5(I), 152$\pm$.5(II)cm, mixing ratio of copper smelting slag decided by 0, 25, 50, 75, 100% gradually, The result of this study was follows ; 1. Unit weight increased 2.2%~4.4% according as mixing ratio of copper smelting slag increases. 2. Slump increased about 2~5% as the mixing ratio increased gradually 3. Compressive strength was increased about 4~28% in copper smelting slag mixing ratio 25~50% and 8~20% decreased more than mixing ratio 75%.

• Journal of the Korea Institute of Building Construction
• /
• v.7 no.2 s.24
• /
• pp.77-83
• /
• 2007

This study investigated the fundamental properties of the lightweight foamed concrete depending on various admixtures, and the results were summarized as following. When 20% of cement kiln dust(CKD) and 0.002% of stabilizing agent were mixed to lightweight foamed concrete, it was necessary to use a superplasticizer because flowability was decreased. However, it could reduce sinking depth which were the extensive trouble of lightweight foamed concrete. Bulk density was divided into '0.4' and '0.5' grades on KS according to unit volume weight. The compressive strength was less than that of plain concrete when admixtures were applied, but the results exceeded the minimum strength of the each grades on KS. Totally, it is found that the combination of 20% of CKD and 0.002% of stabilizing agent makes it possible to reduce a sinking depth, recycle resources, and save cost when were mixed.