• Journal of KIISE:Information Networking
• /
• v.27 no.2
• /
• pp.109-122
• /
• 2000

As the full-motion videos in MPEG are widely available nowadays, an editor that could easily edit such kind of media data is required to develop various multimedia applications. In order to concatenate and apply a transition effect to two video streams encoded in MPEG, they should be decoded first since there are dependencies in the frames in MPEG-encoded video stream. Since this decode-edit-encode process requires a huge amount of computing/storage resources, a new editing scheme that could apply various transition effects to MPEG video streams directly while keeping the quality of video data is strongly required. This paper proposes a new editing scheme that could apply three transition effects (such as fade-in, fade-out, and dissolve) to MPEG video streams in a compressed domain. In the proposed scheme, an extension of previous method in which the frames are partially decompressed and transition effects are applied is adopted for I- and P-frames. In addition, a new processing scheme for B-frame that could apply the transition effects in DCT domain directly using an approximation of motion compensation based on the motion vector to reference frames. Since this processing scheme could apply the transition effects in a compressed domain directly, the editing process could be speed-up about $3{\sim}4$ times faster than previous decode-edit-encoding method while keeping the quality of video data as good as the source data. The proposed scheme could be used to build a software-only MPEG video editing system that helps to edit MPEG video data even on a low-cost desk-top computer.

• Asian Journal of Turfgrass Science
• /
• v.26 no.2
• /
• pp.129-134
• /
• 2012

Research was focused on the improvement of poor drainage problems on golf course fairway which had not been performed soil test or properly amended during the course construction. The analysis of the drainage problem basically was caused by a deterioration of soil physical properties by the top layer compaction. The soil hardness reached about 3,000 Kpa around 5~6 cm of soil profile. The slow infiltration speed to subsoil by the compaction was caused directly a poor drainage capacity. However, the properly amended sand soil showed an apparent value of 1,500 Kpa through the subsoil. The water content test showed a similar result that higher rate of 20~30% and ideal rate of 8~12% at poor drainage area and successfully amended area, respectively. However, an imported topsoil media which had higher content of silt and clay from a trans-planted sod had made a heterogeneous soil profile and that caused a poor drain capacity by a low infiltration rate. Those drainage problems triggered to buildup a reduced soil layer by poor soil gas exchange. The soil environment of deoxidation enhanced anaerobic microbial population and induced methane gas build-up to 55 ppm, and that resulted an adverse effect on turf growth by root growth retardation, consequently.

• Journal of Satellite, Information and Communications
• /
• v.2 no.2
• /
• pp.41-47
• /
• 2007

The first geostationary satellite made by Korea, COMS, has the three different payload ; Meteorological sensor, Oceanographic sensor and Ka-band communication payload. There are Meteorological & Ocean Data Communication Subsystem(MODCS) and Telemetry, Command and Ranging Subsystem(TC&R) as other RF radiation sources. MODCS transmits and receives Meteo and Ocean measurement data from/to earth using L-band and TC&R using S-band. The Ka-band communication payload will provide high-speed multimedia services and communication services for natural disaster such as prediction, prevention, and recovery services in the government communications network.Ka-band beacon is for the earth antenna pointing and the experiment of rain fading. This paper gives the analysis results about the mutual radiation effect on Ka-band communication payload, Ka-band beacon, MODCS and TC&R. Up/Down link power and coupling factor including the geometrical position and distance of antenna, filter rejection and degradation factor due to the different polarization are considered. The results show MODCS and TC&R are compatible for Ka-band communication payload and Ka-band beacon does not interfere with MODCS and TC&R normal operation.

• Journal of the Microelectronics and Packaging Society
• /
• v.21 no.4
• /
• pp.97-103
• /
• 2014

Among various lead-free solders, the Sn-58Bi solders have been considered as a highly promising lead-free solders because of its low melting temperature and high tensile strength. However, Sn-58Bi solder has the poor ductility. To enhance the mechanical property of Sn-58Bi solder, epoxy-enhanced Sn-58Bi solders have been studied. This study compared the microstructures and the mechanical properties of Sn-58Bi solder and Sn-58Bi epoxy solder with aging treatment. The solders ball were formed on the printed circuit board (PCB) with organic solderability preservative (OSP) surface finish, and then the joints were aged at 85, 95, 105 and $115^{\circ}C$ for up to 100, 300, 500 and 1000 hours. The shear test was conducted to evaluate the mechanical property of the solder joints. $Cu_6Sn_5$ intermetallic compound (IMC) layer grew with increasing aging time and temperature. The IMC layer for the Sn-58Bi epoxy solder was thicker than that for the Sn-58Bi solder. According to result of shear test, the shear strength of Sn-58Bi epoxy solder was higher than that of Sn-58Bi solder and the shear strength decreased with increasing aging time.

• Journal of Environmental Science International
• /
• v.22 no.6
• /
• pp.745-759
• /
• 2013

The characteristics of meteorological conditions and air pollution were investigated in a valley city (Yangsan) on bad visibility days (from 05:00 to 09:00 LST) of the cold half year (November 2008 to April 2009). This analysis was performed using the hourly observed data of meteorological variables (temperature, wind speed and direction, relative humidity, and 2 m and 10 m temperature) and air pollutants ($NO_2$, $SO_2$, $PM_{10}$, and $O_3$). In addition, visibility data based on visual measurements and a visibility meter were used. The bad visibility days were classified into four types: fog, mist, haze, and the mixture (mist+haze). The results showed that the bad visibility days of the four types in the valley city were observed to be more frequently (about 50% of the total study period (99 days except for missing data)) than (27%) those near coastal metropolitan city (Busan). The misty days (39%) in the valley city were the most dominant followed by the hazy (37%), mixture (14%), and foggy days (10%). The visibility degradation on the misty days in Yangsan was closely related to the combined effect of high-level relative humidity due to the accumulation of water vapor from various sources (e.g. river, stream, and vegetation) and strong inversion due to the development of surface radiative cooling within the valley. On the hazy days, the visibility was mainly reduced by the increase in air pollutant (except for $O_3$) concentrations from the dense emission sources under local conditions of weaker winds from the day before and stronger inversion than the misty days. The concentrations of $NO_2$, $PM_{10}$, and $SO_2$ (up to +36 ppb, $+25{\mu}g/m^3$, and +7 ppb) on the hazy days were a factor of 1.4-2.3 higher than those (+25 ppb, $+14{\mu}g/m^3$, and +3 ppb) on the misty days.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.7
• /
• pp.567-578
• /
• 2015

Single droplet-wall collision heat transfer characteristics on a heated plate above Leidenfrost temperature were experimentally investigated considering the effects of impact velocity. The collision characteristics of the droplet impinged on the heated wall and the changes in temperature distribution were simultaneously measured using synchronized high-speed video and infrared cameras. The surface heat flux distribution was obtained by solving the three-dimensional transient heat conduction equation for the heated substrate using the measured surface temperature data as the boundary condition for the collision surface. As the normal impact velocity increased, heat transfer effectiveness increased because of an increase in the maximum spreading diameter and a decrease in the vapor film thickness between the droplet and heated wall. For We < 30, droplets stably rebounded from a heated wall without breakup. However, the droplets broke up into small droplets for We > 30. The tendency of the heat transfer to increase with increasing impact velocity was degraded by the transition from the rebounding region to the breakup region; this was resulted from the reduction in the effective heat transfer area enlargement due to the breakup phenomenon.

• Journal of Energy Engineering
• /
• v.25 no.4
• /
• pp.159-169
• /
• 2016

In this study, the effects of MTBE contents as oxygenates in gasoline on exhaust emissions and fuel economy in MPI and GDi vehicles have been investigated. Various oxygen contents have been selected such as 0, 1.0, 2.3 and 2.7 wt%. FTP-75 and HWFET modes as fuel economy test methods which are widely used in Republic of Korea and US were applied to investigate exhaust emissions from the test vehicles. Emissions of CO, NMHC and NOx did not show significant correlation with oxygen contents in gasoline fuels, although having slight difference with these contents. In addition, CO2 emissions were not significantly changed with respect to oxygen content. But in case of warm-up and FTP-75 and HWFET modes including high speed regimes, CO2 emissions showed inverse correlation with oxygen contents. Particulate number concentration was inversely proportional to the oxygen contents, having the minimum value at the condition of 2.3 wt%. In case of fuel economy through carbon balance method, the highest value has been obtained at 2.3 wt% and there was positive correlation with oxygen contents and fuel economy.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.24 no.3
• /
• pp.271-278
• /
• 2014

In spite of that stop line and crosswalk should be aware of the most basic objects in transportation system, its features extracted are very limited. In addition to image-based recognition technology, laser and RF, GPS/INS recognition technology, it is difficult to recognize. For this reason, the limited research in this area has been done. In this paper, the algorithm to recognize the stop line and crosswalk is designed and implemented using image-based recognition technology with the images input through a vision sensor. This algorithm consists of three functions.; One is to select the area, in advance, needed for feature extraction in order to speed up the data processing, 'Region of Interest', another is to process the images only that white color is detected more than a certain proportion in order to remove the unnecessary operation, 'Color Pattern Inspection', the other is 'Feature Extraction and Recognition', which is to extract the edge features and compare this to the previously-modeled one to identify the stop line and crosswalk. For this, especially by using case based feature comparison algorithm, it can identify either both stop line and crosswalk exist or just one exists. Also the proposed algorithm is to develop existing researches by comparing and analysing effect of in-vehicle camera installation and changes in recognition rate of distance estimation and various constraints such as backlight and shadow.

• Journal of The Korean Society of Grassland and Forage Science
• /
• v.33 no.2
• /
• pp.100-104
• /
• 2013

Zoysiagrass (Zoysia japonica Steud.) is an important forage and turfgrass that spreads by stolons and rhizomes. Zoysiagrass stolon can be used directly for Agrobacterium-mediated genetic transformation by exploiting the potential of direct shoot formation. However, surface sterilization of field-grown stolons is difficult and remains to be explored. We developed an effective surface sterilization and culture method using the stolon explant for infection with Agrobacterium tumefaciens. Among various treatments, sequential disinfection in 30% bleach for 15 min followed by 0.1% mercuric chloride for 25 min resulted in the highest number of clean stolons. The efficacy of mercuric chloride was increased under vacuum conditions by incubating at 800 mbar for 5 min. The inclusion of 2.5 mg/l amphotericin B further prevents fungal growth in in vitro cultures. This protocol would speed up the development of transgenic plants by utilizing field-grown stolon nodes.

• Journal of The Korean Society of Integrative Medicine
• /
• v.1 no.2
• /
• pp.23-35
• /
• 2013

Purpose : We intend to make the study date for an effect of therapy by comparing the functional level both before and after conducting handwriting training and strength training as a part of treatment to improve muscle strength and function of the patient's non-dominant hand. Method : 8 subjects in writing training group conducted hand writing training 30 minutes at once and three times a week for 4 weeks in total 12 times, and 8 subjects in muscle training group conducted muscle training program of putty and Rolyan ergonomic hand exerciser for 15 minutes respectively in sum up 30 minutes at once and three times a week for 4 weeks in total 12 times. 8 subjects in control group are not applied any training for 4 weeks. Results : It was much more effective in handwriting training than muscle strength training by Grooved pegboard because this study showed the speed decrease from 67.11 to 58.26 seconds in handwriting compared with muscle strength training which showed 5.22 seconds decrease from 67.54 to 62.32(P<.05). It showed about 1.34 muscle strength improvement from 6.60 to 7.94 in handwriting training and 0.92 improvement of muscle strength from 7.04 to 7.96 in muscle strength training by 3-jaw chuck pinch, so handwriting training was more effective(P<.05). It showed 11.58 seconds decrease in handwriting training from 26.62 to 18.01 seconds and 10.93 seconds decrease from 27.43 to 16.50 seconds in muscle strength training, so it was significantly shortened both in handwriting and muscle strength training(P<.05). Conclusion : Dexterity, muscle strength, and handwriting ability of non-dominant hand could improve both the handwriting training and the muscle strength training.