• Communications for Statistical Applications and Methods
• /
• 제30권6호
• /
• pp.631-652
• /
• 2023

In the two-condition within-subject mediation design, pairs of variables such as mediator and outcome are observed under two treatment conditions. The main objective of the design is to investigate the indirect effects of the condition difference (sum) on the outcome difference (sum) through the mediator difference (sum) for comparison of two treatment conditions. The natural condition variables mean the original variables, while the rotated condition variables mean the difference and the sum of two natural variables. The outcome difference (sum) is expressed as a linear model regressed on two natural (rotated) mediators as a parallel two-mediator design in two condition approaches: the natural condition approach uses regressors as the natural condition variables, while the rotated condition approach uses regressors as the rotated condition variables. In each condition approach, the total indirect effect on the outcome difference (sum) can be expressed as the sum of two individual indirect effects: within- and cross-condition indirect effects. The total indirect effects on the outcome difference (sum) for both condition approaches are the same. The invariance of the total indirect effect makes it possible to analyze the nature of two pairs of individual indirect effects induced from the natural conditions and the rotated conditions. The two-condition within-subject design is extended to the addition of a between-subject moderator. Probing of the conditional indirect effects given the moderator values is implemented by plotting the bootstrap confidence intervals of indirect effects against the moderator values. The expected indirect effect with respect to the moderator is derived to provide the overall effect of moderator on the indirect effect. The model coefficients are estimated by the structural equation modeling approach and their statistical significance is tested using the bias-corrected bootstrap confidence intervals. All procedures are evaluated using function lavaan() of package {lavaan} in R.

• 한국정보과학회논문지:소프트웨어및응용
• /
• 제34권10호
• /
• pp.945-952
• /
• 2007

얼굴 검출은 얼굴 인식을 위한 첫번째 단계로써, 입력 영상에서의 얼굴의 존재 유무와 얼굴의 위치 및 크기를 알아내야 한다. 얼굴의 위치를 찾아내는 것은 크기변화, 조명변화, 회전과 같은 다양한 상황이 발생하기 때문에 쉽지 않다. 본 논문에서는 다양한 문제 중 얼굴이 회전되었을 때 얼굴을 검출하는 방법에 초점을 맞추었다. 먼저, 다인종 얼굴 데이타로부터 얼굴의 존재 유무와 얼굴의 위치 및 크기를 알아낸 뒤, 후보영역에서 두 눈을 검출하다. 두 눈을 이용하여 회전각도를 찾아내고 베이지안 분류기를 이용하여 정면얼굴이 되도록 다시 회전시키는 방법을 이용하였다. 다인종에 데이타를 이용한 회전된 얼굴에 대해서 얼굴검출 알고리즘을 실험하여 결과를 제시하였다.

• 한국지구물리탐사학회:학술대회논문집
• /
• 한국지구물리탐사학회 2008년도 공동학술대회
• /
• pp.57-62
• /
• 2008

탄성파 수치 모형 계산에 있어서 널리 사용되는 엇갈린 격자 방법이 아니라 회전된 엇갈린 격자 방법을 사용하여 탄성파 수치 모사를 수행하였다. 표준 엇갈린 격자 방법에서는 자유 경계조건을 적용하여야 하는 단점이 있지만 회전된 격자 방법에서는 자유 경계조건을 적용할 필요 없이 물성을 부여함으로써 해결될 수 있다. 파동전파에 있어서 유한 경계 조건에서 발생하는 인공 반사파를 제거하기 위하여 최근에 뛰어난 성능을 보이는 PML(Perfectly Matched Layer)법이 많이 적용되고 있다. 이 연구에서는 PML보다 성능이 뛰어나기도 하지만 차분에 있어 파동식을 분리할 필요가 없는 CPML(Convolutional Perfectly Matched Layer)법을 회전된 엇갈린 격자법(RSG : Rotatged Staggered Grid)에 적용하고자 하였다. Cerjan법의 감쇠법과 비교한 결과 매우 효과적으로 인공 반사파를 제거할 수 있음을 알 수 있었다.

• Nuclear Engineering and Technology
• /
• 제38권1호
• /
• pp.69-80
• /
• 2006

Fluid-elastic instability in an air-water two-phase cross-flow has been experimentally investigated using two different arrays of straight tube bundles: normal square (NS) array and rotated square (RS) array tube bundles with the same pitch-to-diameter ratio of 1.633. Experiments have been performed over wide ranges of mass flux and void fraction. The quantitative tube vibration displacement was measured using a pair of strain gages and the detailed orbit of the tube motion was analyzed from high-speed video recordings. The present study provides the flow pattern, detailed tube vibration response, damping ratio, hydrodynamic mass, and the fluid-elastic instability for each tube bundle. Tube vibration characteristics of the RS array tube bundle in the two-phase flow condition were quite different from those of the NS array tube bundle with respect to the vortex shedding induced vibration and the shape of the oval orbit of the tube motion at the fluid-elastic instability as well as the fluid-elastic instability constant.

• 지구물리와물리탐사
• /
• 제12권2호
• /
• pp.183-191
• /
• 2009

탄성파 수치 모형 계산에 있어서 널리 사용되는 엇갈린 격자 방법이 아니라 회전된 엇갈린 격자 방법을 사용하여 탄성파 수치 모사를 수행하였다. 표준 엇갈린 격자 방법에서는 특별한 자유 경계조건을 적용하여야 하는 단점이 있지만 회전된 격자 방법에서는 물성으로 진공 또는 공기층을 부여함으로써 자유 경계조건을 실현가능하다는 것을 확인할 수 있었다. 파동전파에 있어서 유한 경계 조건에서 발생하는 인공 반사파를 제거하기 위해 PML (Perfectly Matched Layer)의 파동식 분해라는 단점을 극복할 수 있고 좋은 성능을 보이는 CPML (Convolutional Perfectly Matched Layer)법을 회전된 엇갈린 격자법(RSG: Rotatged Staggered Grid)에 적용하였다. 회전된 격자 유한 차분법에서 CPML의 고주파수 흡수 특성과 에너지 흡수율 조사, Cerjan법의 감쇠를 비교한 결과 흡수경계조건으로 좋은 성능을 확인하였다. 유체와 고체의 모형에 대한 경계에 대하여서도 매우 효과적으로 경계면에서 발생하는 반사파를 제거할 수 있음을 알 수 있었다.

• 전력전자학회논문지
• /
• 제23권1호
• /
• pp.16-23
• /
• 2018

PM synchronous motor may be rotated to an arbitrary direction and speed by outside wind under natural condition in cases where the fan is applied outside, such as in vehicle radiators and outdoor air-conditioners. Sensorless controls that cannot detect rotor position requires additional sensorless control algorithm because a rotor is rotated by an external load. In this study, the sensorless control of a PM synchronous motor under naturally rotating condition is proposed. The natural rotation conditions are classified as forward high-speed rotation, reverse high-speed rotation, and low-speed rotation. Experiment results verify the performance of the sensorless control, including the rotor speed and position detection at natural rotation mode and switch to the closed-loop sensorless control.

• 한국세라믹학회지
• /
• 제21권3호
• /
• pp.271-277
• /
• 1984

To study interface between crystals grown and molten state in the crusible. Pulling and rotating rate of the shaft were varied in LiF crystal growth by Czochralski method. Lower speed of the pulling and rotating rate increased the degree of convexity in solid-liquid interface and higher speed of the pulling and rotating rate decreased it. Optimum condition of LiF crystal growth obtained as pulling rate was 6.5cm/h when it rotated as 46rpm.

• 근관절건강학회지
• /
• 제17권2호
• /
• pp.142-150
• /
• 2010

Purpose: The purpose of this study was to examine EMG activities and VMO/VL ratio of the vastus medialis oblique, vastus lateralis, and rectus femoris during squat exercise (knee angle: 15, 45, and 60 degrees; tibial rotation: internal rotation, neutral, and external rotation). Methods: Twelve subjects performed squat exercise at each knee angle and tibial rotation while electromyographic (EMG) activity was collected. Statistical analysis consisted of two-way repeated measures analysis of variance with post hoc analysis. Results: There were significant main effects of knee angles and foot positions and interaction effect on EMG activities of vastus medialis oblique and vastus lateralis. VMO/VL ratios were significantly different by tibial rotations and there was an interaction effect. A neutral position produced significantly more VMO/VL activity ratio than that from internally rotated position and externally rotated position at 60 degrees. Conclusion: Considering the interaction effects for EMG activity across quadriceps muscles tested, the 60 degrees knee angle with a neutral foot position may provide the most effective condition for patients with acute patellofemoral syndrome.

• 한국안전학회지
• /
• 제16권2호
• /
• pp.44-50
• /
• 2001

The rotated bending fatigue test was conducted in air md in 3.5% NaCl salt solution to investigate the fatigue fracture behaviour of raw material and F.E.M dual phase steel made from raw material(SS41) by a suitable heat treatment. This study has compared the initial microcrack creation of material by tensile test with that by fatigue test. And the rotated bending test of cantilever type under the condition of 3.5% NaCl salt solution and air has investigated the corrosion fatigue fracture behaviour with the variation of stress concentration factor determined by each of notch shapes. The initial microcrack have been developed in fragile grainboundary with general corrosion occurring in raw material : in the pits built up by corrosion in F.E.M. dual phase steel because pits bring out stress concentration. It is small that the degree of decrease in corrosion fatigue life for F.E.M. dual phase steel compared with raw material because the notch sensitivity of F.E.M. dual phase steel is lower than raw material in reason of characteristics with two-phase construction.

• 산업경영시스템학회지
• /
• 제41권2호
• /
• pp.16-23
• /
• 2018

Postural instability can increase the likelihood of hazardous slip and fall accidents in workplaces. The present study intended to extend understanding of the effect of abnormal neck posture on postural control during quiet standing. The effect of body fatigue on the postural control was also of primary concern. Twelve healthy undergraduate students volunteered to participate in the experiment. Standing on a force platform with the neck neutral, flexed, extended, or rotated, subjects' center of pressures (COP) were measured under the two levels of body fatigue. For the fatigue condition, Subjects exercised in a treadmill to meet the predetermined level of body fatigue. Analyzing the position coordinates of COPs, the length of postural sway path was assessed in both medio-lateral (ML) axis and anterior-posterior (AP) axis. Results showed that, in AP direction, neck extension or rotation significantly increased the sway length as compared with neck neutral. Neck extension led to greater sway length compared to neck rotation. Neck flexion did not differ from neck neutral. The sway length in the AP direction also became significantly larger as the body fatigue accumulated after treadmill exercise. In ML direction, as compared to neutral posture, the neck extension, flexion, or rotation did not significantly affect the length of postural sway path. However, the sway length seemed to increase marginally with the neck extended during the fatigued condition. This study demonstrates that abnormal neck posture may interfere with postural control during standing. The ability to maintain postural stability decreases significantly with the neck extended or rotated. Body fatigue leads to postural instability further.