• Geomechanics and Engineering
• /
• 제15권6호
• /
• pp.1193-1205
• /
• 2018

A footing located on slopes possess relatively lower bearing capacity as compared to the footing located on the level ground. The bearing capacity further reduces under seismic loading. The adverse effect of slope inclination and seismic loading on bearing capacity can be minimized by proving sufficient setback distance. Though few earlier studies considered setback distance in their analysis, the range of considered setback distance was very narrow. No study has explored the critical setback distance. An attempt has been made in the present study to comprehensively investigate the effect of setback distance on footing under seismic loading conditions. The pseudo-static method has been incorporated to study the influence of seismic loading. The rate of decrease in seismic bearing capacity with slope inclination become more evident with the increase in embedment depth of footing and angle of shearing resistance of soil. The increase in bearing capacity with setback distance relative to level ground reduces with slope inclination, soil density, embedment depth of footing and seismic acceleration. The critical value of setback distance is found to increase with slope inclination, embedment depth of footing and density of soil. The critical setback distance in seismic case is found to be more than those observed in the static case. The failure mechanisms of footing under seismic loading is presented in detail. The statistical analysis was also performed to develop three equations to predict the critical setback distance, seismic bearing capacity factor ($N_{{\gamma}qs}$) and change in seismic bearing capacity (BCR) with slope geometry, footing depth and seismic loading.

• Steel and Composite Structures
• /
• 제19권2호
• /
• pp.309-325
• /
• 2015

A convenient procedure for seismic retrofit of existing buildings is to use passive control methods, like using friction dampers in steel frames with bracing systems. In this method, reduction of seismic demand and increase of ductility generally improve seismic performance of the structures. Some of its advantages are development of a stable rectangular hysteresis loop and independence on environmental conditions such as temperature and loading rate. In addition to friction dampers, masonry-infill panels improve the seismic resistance of steel structures by increasing lateral strength and stiffness and reducing story drifts. In this study, the effect of masonry-infill panels on seismic performance of a three-span four-story steel frame with Pall friction dampers is investigated. The results show that friction dampers in the steel frame increase the ductility and decrease the drift (to less than 1%). The infill panels fulfill their function during the imposed drift and increase structural strength. It can be concluded that infill panels together with friction dampers, reduced structural dynamic response. These infill panels dissipated input earthquake energy from 4% to 10%, depending on their thickness.

• Design & Manufacturing
• /
• 제17권2호
• /
• pp.27-32
• /
• 2023

Liquid silicon rubber (LSR) has fine thermal compatibility and is widely used in various fields such as medical care and automobiles because it is easy to implement products with good fluidity. With the recent development of flexible sensors, the focus has been on manufacturing conductive elastomers, such as silicone as elastic materials, and carbon black, CNT, and graphene are mainly used as nanomaterials that impart conductive phases. In this study, mechanical behavior and curing behavior were measured and analyzed to manufacture a CB-LSR complex by adding Carbon Black to LSR and to identify properties. As a result of the compression test, the elastic modulus tended to increase as carbon black was added. When the swelling test and the compression set test were conducted, the swelling rate tended to decrease as the content of carbon black increased, and the compression set tended to increase. In addition, DSC measurements showed that the total amount of reaction heat increased slightly as the carbon black content increased. It is considered that carbon black was involved in the crosslinking of LSR to increase the crosslinking density and have a positive effect on oil resistance reinforcement.

• 한국표면공학회지
• /
• 제37권6호
• /
• pp.350-359
• /
• 2004

Stress corrosion cracking(SCC) characteristics of shot-peened stainless steel containing Ti (0.09 wt%-0.92 wt%) fabricated by the vacuum furnace were investigated using SCC tester and potentiostat. The homogenization and the sensitization treatment were carried out at $1050^{\circ}C$ for 1hr and $650^{\circ}C$ for 5 hr. The samples for SCC were shot-peened using $\Phi$0.6 mm steel ball for 4 min and 10 min. Intergranular and pitting corrosion characteristics were investigated by using EPR and CPPT. SCC test was carried out at the condition of$ 288^{\circ}C$, 90 kgf pressure, water with 8 ppm dissolved oxygen, and $8.3xl0^{-7}$/s strain rate. After the corrosion and see test, the surface of the tested specimen was observed by the optical microscope, TEM and SEM. Specimen with Ti/C ratio of 6.14 showed high tensile strength at the sensitization treatment. The tensile strength decreased with the increase of the Ti/C ratio. Pitting and intergranular corrosion resistance increased with the increase of Ti/C ratio. Stress corrosion cracking strength of shot-peened specimen was higher than that of non shot- peened specimen. Stress corrosion cracking strength decreased with the increase of the Ti/C ratio.

• Journal of Nutrition and Health
• /
• 제32권6호
• /
• pp.644-653
• /
• 1999

Background : Excessive intakes of $\omega$6 polyunsaturated fatty acid (PUFA) can increase oxidative stress, which may increase insulin resistance and could be the cause of metabolic syndrome X such as diabetes mellitus. One of the ways to reduce oxidative stress is the consumption of antioxidants such as vitamin E. It is controversial that vitamin E intakes may alleviate insulin resistance. The purpose of the study was whether high vitamin E intake may influence whole body glucose disposal rate(GDR), glycogen deposites, triglyceride content, lipid peroxide levels and antioxidant enzyme activities in Sprague Dawley rats fed high $\omega$6 PUFA diest. Methods : Sprague Dawley rats were divided into three groups. The control group consumed chow diet. High and low vitamin E groups consumed 40% PUFA of total energy intakes. One kilogram of diet mixture contained 300IU of $\alpha$-tocopherol in high vitamin E group, while it had 30 IU in low vitamin E group. Diets were given for 8 weeks. After 7 were of diet consumption, indwelling catheters were inserted in carotid artery and jugular vein of all rats so that GDR could be measured in awake and unstressed state. Results : Daily PUFA intakes were lower in the control group than others. Daily vitamin E intake of high vitamin E group was about ten times higher than those of low vitamin E group and the control group(p<0.0001). $\alpha$-tocopherol content in lier was highest in the high vitamin E group. GDR of the control group was 24% higher than others, and vitamin E intakes did not affect GDR. Glycogen deposit of liver in the control group was significantly higher than others, and it was not altered by vitamin E supplementation. Muscle glycogne content showed a similar tendency as liver glycogen in different diet groups. Triglyceride deposit in muscle was not different among groups. Lipid peroxide content of liver in the high vitamin E group was lower than the low of glutathione peroxidase were lowered in low vitamin E group than others, however, those of superoxide dismutase and catalase were not different. Conclusions : High vitamin E intakes can decrease oxidative stress in rats fed high (())-6 PUFA diet, but they cannot alleviate insulin resistance. Thus, increased oxidative stress through high (())-6 PUFA diet may be minimal for influencing insulin resistance.

• The Plant Pathology Journal
• /
• 제34권5호
• /
• pp.403-411
• /
• 2018

This study takes strawberry-fruits as the test material and discusses the effect of Burkholderia contaminans B-1 on preventing postharvest diseases and inducing resistance-related substances in strawberry-fruits. Soaking and wound inoculating is performed to analyze the inhibitory effects of different treatment solutions on the gray mold of postharvest strawberry-fruits. The count of antagonistic bacteria colonies in the wound is found, and the dynamic growth of antagonistic bacteria and the pathogenic fungus is observed by electron microscopy. The results indicated that, either by soaking/wound-inoculating, the fermentation and suspension of antagonistic bacteria significantly reduced the incidence of postharvest diseases of strawberry-fruits. With wound inoculation, the inhibition rate of antagonist fermentation and suspension ($1{\times}10^{10}cfu/ml$) respectively reached 77.4% and 66.7%. It also led to a significant increase in the activity of resistance-related enzymes, i.e., phenylalanine ammonia lyase (PAL), 4-coumarate coenzyme A ligase (4CL), cinnamate-4-hydroxylase (C4H) and chalcone isomerase (CHI). On 1 d and 2 d post-treatment, the activity of 4CL was respectively 3.78 and 6.1 times of the control, and on 5 d, the activity of PAL was increased by 4.47 times the control. The treatment of antagonistic bacteria delayed the peaking of cinnamyl-alcohol dehydrogenase (CAD) activity and promoted the accumulation of lignin and total phenols. The antagonistic bacteria could be well colonized in the wounds. On 4-5 d post-inoculation, the count of colonies was $10^8$ times of that upon inoculation. Electronmicroscopy indicated that the antagonistic bacteria delayed the germination of pathogenic spores in the wounds, and inhibited further elongations of the mycelia.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2009년도 추계 학술논문 발표대회
• /
• pp.113-116
• /
• 2009

This study analyzed fire-resistant characteristics according to changes in repair methods of PFH mixed high-strength concrete roof structures having undergone fire damage. The results of the study are as follows. First, as a repulsive characteristics of structures, the remaining repulsion was shown to increase following fire-resistance tests according to increases in depth of coverings. The results of the relationship between depth of coverings and remaining repulsion rates following fire-proofing tests showed a high correlation. At a covering depth of 67.3mm, remaining repulsion rate was estimated to be 100%. For fire-resistant characteristics following repairs of structure, as for spalling, severe separation was shown in the case of general plaster while general plaster + Metal Lath showed overall superior spalling prevention. For internal structure temperatures, general plaster showed max temperatures of 705℃, average temperatures of 636℃ while general plaster + metal lath showed max temperature of 660℃ and average temperature of 520℃, demonstrating lower temperature distributions than use of only general plaster. In conclusion, after removing the covering of structures damaged due to high temperatures of fires within high-strength concrete installations, the use of fire-resistant mortars and applying metal laths on surfaces of general plaster will provide superior fire-resistance performance in the occurrence of a 2nd fire.

• Elastomers and Composites
• /
• 제33권3호
• /
• pp.193-200
• /
• 1998

고무소재는 다양한 종류별로 구조에 따라 다른 물성을 갖는 것으로 알려져 있다. 일반적으로 EPDM 고무는 내후성과 내오존성이 뛰어나고 열이나 냉기, 습기의 노출에도 잘 견디는 것으로 밝혀진 바 있다. 한편 crosslinked IIR은 물과 기체투과에 대한 저항성이 큰 것으로 알려져 두가지 성분의 장점을 갖도록 EPDM/crosslinked IIR의 블렌드를 새로운 형태의 소재로 추천할 수 있다. 따라서 본 실험에서는 EPDM과 crosslinked IIR의 블렌드비를 변화시키면서 가교시간과 블렌드후 물리/화학적 특성의 개선을 목표로 하였다. 결과적으로 30wt.%의 crosslinked IIR 조성을 갖는 블렌드소재가 내후성, 내오존성 및 내기체투과 특성이 뛰어나, O-링이나 전기관련 제품에 상업적으로 응용가능한 것으로 판단되었다.

• 한국토양동물학회지
• /
• 제6권1_2호
• /
• pp.33-36
• /
• 2001

작약계통에 대한 당근뿌리혹선충의 저항성검정에서, 의성작약, 태백작약 도서종, EP368, EP512는 효충의 밀도가 토양 300m1당 121-173마리로 높았으며 사벌종, 웅수종, 김천종, Pl23에서는 21-60마리로 타계통 보다 기생밀도가 낮았다. 공신된 계통별 작약 뿌리의 부패정도는 용수종, 김천종에서 경징하였으며, 선충의 기생이 많았던 의성작약, 태백작약 Ep368, Ep512는 선충의 기생밀도도 높았으며 뿌리 부패율이 아주 높았다. 작약계통별 당근뿌리혹선충에 대한 저항성정도를 보면 의성작약, 태백작약 용수종, 도서종, EP368, EP512는 난낭의 형성이 많아 당근뿌리혹선충에 감수성이였고, 사벌종과 김천종, Pl23, EP337, EP425는 난낭형성이 매우 낮아 저항성을 나타내었다.

• 한국결정성장학회지
• /
• 제28권2호
• /
• pp.80-84
• /
• 2018

AZ31과 AZ91 Mg 합금을 Na-P 및 Na-Si 전해질을 사용하여 전해질의 농도, 인가전압, 처리시간에 따라 여러가지 조건에서 PEO 처리하여 5%의 농도를 갖는 염수분무법으로 내부식성 연구를 하였다. 일반적으로 산화피막 코팅 두께가 증가하면 내부식성이 증가하였다. 코팅두께보다 산화피막 표면의 기공크기가 커지면 장기 내부식성은 나빠지는 경향을 보인다. 산화피막의 전체적인 산화물 결정상이 증가할수록, 또 MgO 결정상 대신 $Mg_2SiO_4$ 상과 같은 다른 결정상이 증가할수록 내부식성이 월등히 증가하는 것을 알 수 있었다.