• Journal of Biomedical Engineering Research
• /
• v.29 no.6
• /
• pp.484-492
• /
• 2008

Sit to stand(STS) movement is one of the most common activity in daily life. In addition, Korean traditionally stand up from various sitting heights in one's daily life compared to other foreigners. As Korea enter rapidly to the aging society, needs of the elderly's independent life are increasing. Therefore the importance of research about the analysis of elderly's activity in daily life is rapidly increasing. In this study, we analyzed joint movements and changes of muscle length during STS(sit-to-stand) at various sitting heights(table seat, bath seat, bottom) in the Korean elderly's daily life by using the motion analysis and musculoskeletal modeling. Ten Korean elderly and young were participated in this experiment. Three heights of sitting posture which could represent typical sitting in Korean daily life were chosen as table seat(42cm), bath seat(21cm) and bottom(0cm). As the results, the elderly showed both smaller knee/hip flexion and larger trunk flexion relatively in comparison to the young during table seat STS. The elderly also showed larger dorsiflexion and smaller ROM of knee, hip, trunk compared to the young during bath seat STS. Additionally, the elderly showed larger plantarflexion, hip flexion, smaller knee flexion and trunk flexion during the first half of bottom STS and larger knee flexion, hip flexion and trunk flexion during the second half of bottom STS. In addition, we could know contraction and relaxation characters of major muscles in lower limb during various STS through the analysis of changes in muscle length by musculoskeltal modeling.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.26 no.10
• /
• pp.1401-1411
• /
• 2002

To Save energy and cost one bath/one step dyeing and finishing on cotton/polyester blends is carried out with disperse dyes in the presence of crosslinking agent. Cotton 100 %, cotton/polyester 70/30, 50/50, 35/65, polyester 100 % fabrics were used. wrinkle recovery angle, tensile strength retention and tearing strength retention were determined in according to the dyebath composition, and also determined while the concentration of DMDHEU, molecular weight and concentration of PEG were varied. Colorfastness to abrasion, washing and light were tested. For cotton and cotton/polyester blends dyed in the presence of DMDHEU/PEG, wrinkle recovery was improved. Tensile strength retention and tearing strength retention were decreased, in compared with dyed fabrics without DMDHEU. Colorfastness to abrasion was good but colorfastness to washing and to light were poor for the fabrics dyed in the presence of DMDHEU/PEG.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.8 no.4
• /
• pp.17-24
• /
• 1971

Laser light which modulated and transmitted through one-meter water bath and one-kilometer transmission distances in atmospheric media is detected by method of direct photo-detection. Also, it is analyzed as a square law detection and the experimental apparatus are designed and constructed. Consequently, in spite that the quantitative analysis remains, the availability of coherent optical communication is understood. The average attenuation with the conditions of weather is about -25dB, and the average attenuation coefficient of water is about 0.4(m-1).

• Journal of Surface Science and Engineering
• /
• v.21 no.2
• /
• pp.76-82
• /
• 1988

The bright nickel electroplatings were carried out the Watt bath containg a solobel saccharin as class I brightner and para substituted benzaldehydes as class II one. Extended Huckel MO calculation was done and polarization was measured to examine between $\pi$-electron density and the brightness. The correlation is also investigated between $\pi$-electron density of oxygen atom of aldehyde group and slope of polarization curve. As a result of the analysis of rate equation of nucleation, the surface energy of the deposited particle was obtained from the slope of the plot of $\ell$nI against 1/η2, and also the reat equation of nucleation found to influnced on the leveling on the basis of adsorption theory. We have proposed the general electroplating mechanism that is applied other to all other electroplating but nickel one. The above elucidated mechanism can be extended can be extended to the all electroplating other than bright nickel electroplating.

• Journal of the Korean Chemical Society
• /
• v.60 no.4
• /
• pp.245-250
• /
• 2016

An improved protocol on the synthesis of thiazolo[3,2-a]pyrimidine-6-carboxylate derivatives are reported. Previously, the thiazolo[3,2-a]pyrimidine-6-carboxylate derivatives were prepared in a two-step procedure. Under the improved procedure, the thiazolo[3,2-a]pyrimidine-6-carboxylate derivatives was readily prepared in a one-step reaction. This procedure was found to be more efficient than the previous protocol and also compared to the ultrasound bath and conventional heating methods in terms of yield and reaction time.

• Journal of Surface Science and Engineering
• /
• v.32 no.3
• /
• pp.219-223
• /
• 1999

A new additive for semi-brightness finish in nickel electroplating, having a quarternary ammonium salt structure, has been developed in this study. The effectiveness of the new additive was tested in laboratory-scale eletroplating tests as well as in a full-scale factory plating line. An examination of the plated surface showed that the new additive is as good as the one produced by the most commonly used additive in the nickel plating industry. The plated surface was examined by SEM, EPMA, and Reflectance Spectroscopy, and was found to be compatible to the one obtained with commercial additives. The new additive has a shelf life comparable with those of other commercially available additives. The additive developed in this study has an excellent potential to be used commercially.

• International Journal of Reliability and Applications
• /
• v.2 no.1
• /
• pp.1-26
• /
• 2001

The purpose of this paper is to introduce a proportional reversed hazard rate model, in contrast to the celebrated proportional hazard model, and study some of its structural properties. Some criteria of ageing are presented and the inheritance of the ageing notions (of the base line distribution) by the proposed model are studied. Two important data sets are analyzed: one uncensored and the other having some censored observations. In both cases, the confidence bands for the failure rate and survival function are investigated. In one case the failure rate is bathtub shaped and in the other it is upside bath tub shaped and thus the failure rates are non-monotonic even though the baseline failure rate is monotonic. In addition, the estimates of the turning points of the failure rates are provided.

• The Journal of Korean Medicine Ophthalmology and Otolaryngology and Dermatology
• /
• v.15 no.1
• /
• pp.276-284
• /
• 2002

Aromatherapy is becoming increasingly popular, however there are few clear indications for its use. To systematically review the clinical studies on aromatherapy, computcrized literature searches were performed from PubMed. Fourteen trials were located. The conclusions were as follows: 1. All the trials were published after 1993. 2. To analyze the publication journals, five of fourteen trials were on nursing, three of them on neuropsychiatry and one on dermatology. 3. Most widely used indications of aromatherapy were on general physical, psychological and physiological field. 4. On the procedure of aromatherapy, eight of them were by massage, three by inhalation, one by massage & inhalation and one by bath additive. 5. To analyze the publication type, all fourteen trials were clinical trials. Twelve of them were randomized controlled trials. Two of them were using single subject design. 6. To observe the sample size, five of them were under 10, four from 10 to 50, two from 50 to 100 and three above 100. 7. Eleven of fourteen trials were using inferential statistics. Eight of the eleven trials were significantly effective, but three had no statistical significance.

• Journal of Surface Science and Engineering
• /
• v.37 no.2
• /
• pp.80-85
• /
• 2004

Chromium-carbon (Cr-C) and chromium-carbon-phosphorus (Cr-C-P) alloy deposits using trivalent chromium sulfate baths containing potassium formate were prepared to study their current efficiency, hardness change and phase transformations behavior with heat treatment, respectively. The current efficiencies of Cr-C and Cr-C-P alloy deposits increase with increasing current density in the range of 15-35 A/dm$^2$. Carbon content of Cr-C and phosphorous of Cr-C-P layers decreases with increasing current density, whereas, the carbon content of Cr-C-P layer is almost constant with the current density. Cr-C deposit shows crystallization at $400^{\circ}C$ and has (Cr+Cr$_{ 23}$$C_{6}$) phases at $800^{\circ}C$. Cr-C-P deposit shows crystallization at $600^{\circ}C$ and has (Cr+Cr$_{23}$ $C_{6}$$+Cr_3$P) phases at $800^{\circ}C$. The hardness of Cr-C and Cr-C-P deposits after heating treatment for one hour increase up to Hv 1640 and Hv 1540 and decrease about Hv 820 and Hv 1270 with increasing annealing temperature in the range of $400～^{\circ}C$, respectively. The hardness change with annealing is due to the order of occurring of chromium crystallization, precipitation hardening effect, softening and grain growth with temperature. Less decrease of hardness of Cr-C-P deposit after annealing above $700^{\circ}C$ is related to continuous precipitation of $Cr_{23}$ $C_{6}$ and $Cr_3$P phases which retard grain growth at the temperature.

• Journal of Fashion Business
• /
• v.20 no.3
• /
• pp.119-132
• /
• 2016

Weighting of silk fabrics have long been practiced in silk fabric trading based on the primary consideration of price-weight, and secondary one of quality improvement in handle, luster, and drape properties. Recent trend of practicing weighting of silk fabrics is, however, focused on the improvement of the handle, luster, drape, and other properties. During the finishing processes of synthetic fiber, nylon, comprising amide structure, include the use of tannic acid, especially in the dyeing. A multitude of studies are being implemented in terms of improving fastness to washing, fastness to light of dyed nylon product, or the light fastness of nylon 6 itself. In this study, the effects of various tannic acid treatments on the physical properties related to the handle of nylon 6 and silk fabrics are examined and reviewed. The effects of treatment condition of the tannic acid, e.g., the concentration of the aqueous tannic acid solution, treatment time, and temperature were investigated. As the concentration of the aqueous solution of tannic acid increased, the bending rigidity values of the silk and nylon 6 fabrics increased. The treated fabrics felt stiff to the touch. Within the mild conditions of bending employed in the bending measurement of KES, nylon 6 treated fabric specimen exhibited a trend of improvement of bending resiliency within the range of small bending deformation. The weight of treated fabrics have all increased. The air-permeability values decreased as the treatment concentration increased. However, the decrease tendency of air permeability values may be alleviated by adjusting the fabric count during the tentering or expanding processes, either by tension adjustment or heat treatment. Optimum conditions of the treatment for nylon 6 are 1.25% tannic acid concentration, bath temperature of $85^{\circ}C$, pH 3.1, and those for silk fabric treatment are 1.25% tannic acid concentration, bath temperature of $85^{\circ}C$, pH 3.1. The treatment conditions will lead to the improvement in the properties of fabrics for summer.