• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.4
• /
• pp.97-107
• /
• 2013

Underwater wireless communication systems can be useful for underwater environment observation, catastrophe prevention, ocean resources exploration, ocean organism research, vessel sinking exploration, and so on. However, unlike terrestrial wireless communication, underwater wireless communication should consider factors such as long propagation delay, limited transmission capacity, high bit-error rate due to potential loss in power, ambient noise, man-made noise, multi-path, etc., because of the inherent characteristics of water. Thus, in this paper, we propose a suitable media access control(MAC) protocol that applies a combination of the ALOHA MAC protocol and the CSMA/CA MAC protocol to underwater environment. We further propose a mathematical analysis model to evaluate performance. We also verify performance improvement in the proposed scheme in comparison with existing MAC protocols.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.19 no.1
• /
• pp.25-36
• /
• 2016

Heavy metals in the stream sediments around Shihwa Lake were studied not only to investigate the characteristics of spacio-temporal distribution but also to assess the pollution degree and ecological risk using various pollution indices. Among metals, Zn had the highest values (1,311 mg/kg) and Hg showed the lowest value (0.261 mg/kg). The order of mean concentrations (mg/kg) of metals was Zn>Cu>Pb>Cr>Ni>Co>As>Cd>Hg in stream sediments around Shihwa Lake. Metal concentrations showed different pollution pattern with industrial region, indicating that these metals originated from different sources and industrial region had higher metal concentration than rural/urban regions. The results of geoaccumulation index (Igeo) showed that the stream sediments were significantly polluted with Cd, Cu, Zn and Pb, indicating moderately to highly polluted by these metals. According to PLI consideration, industrial region was more seriously polluted by metals whereas an rural/urban region was not polluted. About 85% of sampling site for Cr, Ni, Cu, Zn and Pb from industrial regions were exceeded the PEL values. The mPELQ and SQI values derived from PEL of industrial region were classified as 'highly toxic' and 'very poor' and metal pollution level tend to be worse in wet season. This indicates that the industrial activities and stromwater runoff represents an important sources of heavy metals around Shihwa Lake.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.15 no.3
• /
• pp.177-185
• /
• 2012

Wave field measurements were made over a period of 18 days to study the spatial distribution of incident wave on seaweed tarm field around Gumil-up Sea, Wando, Korea. These measured data were compared with data from the Geomun-do ocean weather/wave observation buoy. A numerical simulation model that combined the offshore design wave with the seasonal normal incoming wave was used to study the incident wave distribution surrounding a seaweed farm. The results are summarized as follows. (1) On-site wave measurements showed that the major relationship between maximum and significant wave height was $H_{max}=1.6H_{1/3}$. (2) Offshore incident wave energy reaching the coast was greatly influenced by the wind direction. A north wind reduced the incident wave energy and a south wind increased it. (3) The calculated maximum wave height under the design wave boundany conditions was in the range of 4~5 m and the reduction in the incident wave height ratio ranged from approximately 38.1% to 47.6% at Gumil-up Sea. Under normal wave conditions, the maximum wave heights were 3.6~4.0 m in summer and 2.3~2.7 m in winter while the reduction in the incident wave height ratio was about 41.8% to 49.1%. (4) The sea state in the southern area of Gumil-up was the most affected by ocean waves, whereas the sea state in the northern area was very stable. The significant wave ratio in the south was about six times that in the north.

• Ocean and Polar Research
• /
• v.37 no.2
• /
• pp.107-117
• /
• 2015

Thorpe scale analysis was performed using two sets of 25-hour-long hourly CTD data. Raw density profiles collected on the continental slope of the southwestern East Sea were post-processed to reduce instrument noises and measurement errors. Density inversions were detected by applying the overturn ratio test proposed by Gargett and Garner (2008). The value of $K_z$ below the main thermocline estimated with the Osborn parameterization was $5.3{\times}10^{-4}(1.1{\times}10^{-4})m^2s^{-1}$ and that with the Shih parameterization was $5.9{\times}10^{-5}(2.4{\times}10^{-5})m^2s^{-1}$during the spring (neap) tidal period. This result suggests that internal tides can enhance vertical mixing in the observation region.

• Journal of Navigation and Port Research
• /
• v.32 no.3
• /
• pp.245-250
• /
• 2008

Recently the numerical prediction technique is applied to many fields, because numerical models are developed so much for last decades. The real-time ocean prediction system is one of them and is capable of providing the real-time marine information for users to promote the safety af maritime traffic and preservation of marine resources. The system is composed of observing system, data distribution system and modelling system. In this study authors develop the modelling system and show the results as preliminary study for establishing the real-time ocean prediction system in Busan port. The system test is performed only for M2 tidal modelling due to the lack qf observation data, thus a full-scale test is required in future if enough data are provided Also observing system and data distribution system will be constructed continuously in future, then service for real-time data for users will be initiated.

• Korean Journal of Remote Sensing
• /
• v.26 no.2
• /
• pp.167-173
• /
• 2010

This paper introduces Geostationary Ocean Color Imager, IMage Pre-processing Subsystem (GOCI IMPS) of Communication, Ocean, and Meteorological Satellite (COMS), and describes its functions, development states, and operational concepts. The primary and backup systems of GOCI IMPS have been installed in Korea Ocean Satellite Center (KOSC) and Satellite Operation Center (SOC) and the system are the prelaunch test phase after completing all required tests. It is expected that the GOCI data observed continuously over the Korea Peninsular in the geostationary orbit will be usefully utilized in marine environment research fields such as sea surface temperature changes or marine ecosystems.

• Journal of Environmental Science International
• /
• v.19 no.11
• /
• pp.1397-1405
• /
• 2010

Mass mortalities of cultivated organisms have occurred frequently in Korean coastal waters causing enormous losses to cultivating industry. The preventive measures require continuous observation of farm environment and real-time provision of data. However, line hanging aquaculture farm are generally located far from monitoring buoys and has limitations on installation of heavy equipments. Substituting battery pack for solar panels and miniaturizing size of buoy, newly developed system can be attached to long line hanging aquaculture farm. This system could deliver measured data to users in real-time and contribute to damage mitigation and prevention from mass mortalities as well as finding their causes. The system was installed off Gijang and Yeongdeck in Korea, measuring and transmitting seawater temperature at the sea surface every 30 minutes. Short term variation of seawater temperature, less than one day, in Gijang from June to July 2009 corresponded tidal period of about 12 hours and long term variation seemed to be caused by cold water southeast coast of Korea, particularly northeast of Gijang. Seawater temperature differences between Gijang station and the other station that is about 500 m away from Gijang station were $1^{\circ}C$ on average. This fact indicates that it is need to be pay attention to use substitute data even if it is close to the station. Daily range of seawater temperature, one of crucial information to aquaculture, can be obtained from this system because temperature were measured every 30 minutes. Averages of daily range of temperature off Gijang and Yeongdeok during each observation periods were about $2.9^{\circ}C$ and $4.7^{\circ}C$ respectively. Dominant period of seawater temperature variation off Yeongdeok was one day with the lowest peak at 5 a.m. and the highest one at 5 p.m. generally, resulting from solar radiation.

• Ocean and Polar Research
• /
• v.32 no.4
• /
• pp.337-350
• /
• 2010

This study conducted sedimentological and geophysical surveys for 3 years (2006-2008) in southern Gyeonggi Bay, Korea to elucidate temporal changes in subaqueous dune morphology on a sand ridge trending northeast to southwest that has been excavated by marine sand mining. The sand ridge (~20 m in height, ~2 km in width and 3~4 km in length) has a steep slope on the NW side and a gentle slope on the SE side, creating an asymmetric profile. Large (10~100 m in length) and very large (>100 m in length) dunes occurring on the SE side of the ridge show a northeastward asymmetrical shape, whereas dunes on the NW side destroyed by marine sand mining display a southwestward asymmetry. The comparison between Flemming (1988)'s correlation and the height-length correlation of this study indicates that tidal current and availability of sand sediment are major controlling factors to the development and maintenance of dunes. Depth and sedimentary characteristics (grain size) are not likely to be major controlling factors, but indirectly influence dune growth by hydrological and sedimentary processes. The length and the height of dunes decrease toward the southeastern trough away from the crest of the ridge. These features result from the decrease of tidal current and sediment availability. The length and the height of dunes on the southeast side decrease gradually over time. This is a result of the interaction between tidal current and the decrease in sediment availability due to sediment extraction by marine sand mining. Marine sand mining has destroyed the dunes directly, causing irregular shapes of shorter length and lower height. The coarse fraction of suspended sediments is transported and deposited very close to the sand pit. By contrast, relatively fine sediments are transported by the tidal current and deposited over a wide range by the settling-lag effect, resulting in a decrease of sediment grain size in the area where suspended sediments are deposited. In addition, marine sand mining, decreases the height of dunes. Therefore, morphological and sedimentological characteristics of dunes around the sand pits will be significantly changed by future sand mining activities.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.7
• /
• pp.209-220
• /
• 2014

In this paper, we analyze the discriminability of features for the classification of transient signals with an ambient noise in a shallow water. For the classification of the transient signals, robust features for the variance of a noise are required due to a low SNR under a marine environment. In the modelling the ambient noise in shallow water, theoretical noise model, Wenz's observation data from the shallow water, and Yule-walker filter are used. Discrimination of each feature of the transient signals with an additive ambient noise is analyzed by utilizing a Fisher score. As the analysis of a classification accuracy about the transient signals of 24 classes using the selected features with a high discriminability, the features selected in the environment without a noise relatively have a good classification accuracy. From the analyzed results, we finally select a total 16 features out of 28 features. The recognition using the selected features results in the classification accuracy of 92% in SNR 20dB using Multi-class SVM.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.15 no.3
• /
• pp.208-218
• /
• 2012

Numerical simulation technique has been developed to calculate microwave backscattering from water surface. The simulation plays a role of a substitute for experiments. Validation of the simulation was shown by comparing with experimental results. Water area observations by microwave radar have been simulated to evaluate algorithms and systems. Furthermore, the simulation can be used to understand microwave scattering mechanism on the water surface. The simulation has applied to the various methods for water area observations, and the utilizations of the simulation are introduced in this paper. In the case of fixed radar, we show following examples, 1. Radar image with a pulse Doppler radar, 2. Effect of microwave irradiation width and 3. River observation (Water level observation). In addition, another application (4.Synthetic aperture radar image) is also described. The details of the applications are as follows. 1. Radar image with a pulse Doppler radar: A new system for the sea surface observation is suggested by the simulation. A pulse Doppler radar is assumed to obtain radar images that display amplitude and frequency modulation of backscattered microwaves. The simulation results show that the radar images of the frequency modulation is useful to measure sea surface waves. 2. Effect of microwave irradiation width: It is reported (Rheem[2008]) that microwave irradiation width on the sea surface affects Doppler spectra measured by a CW (Continuous wave) Doppler radar. Therefore the relation between the microwave irradiation width and the Doppler spectra is evaluated numerically. We have shown the suitable condition for wave height estimation by a Doppler radar. 3. River observation (Water level observation): We have also evaluated algorithms to estimate water current and water level of river. The same algorithms to estimate sea surface current and sea surface level are applied to the river observation. The simulation is conducted to confirm the accuracy of the river observation by using a pulse Doppler radar. 4. Synthetic aperture radar (SAR) image: SAR images are helpful to observe the global sea surface. However, imaging mechanisms are complicated and validation of analytical algorithms by SAR images is quite difficult. In order to deal with the problems, SAR images in oceanic scenes are simulated.