• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.361-361
• /
• 2007

A lot of efforts have been paid to develop infrared imaging systems in last decades. Bolometer has a wide range of applications from military to commercial, such as military night vision, medical imaging system and so on. Bolometer is a resistive sensor that detects temperature changes through resistance change. To improve detecting ability, bolometer should have a good resistive film which has high temperature coefficient of resistance (TCR) value. Colossal magnetoresistance (CMR) $L_{1-x}A_xMnO_3$ (where L and A are trivalent rare-earth ions and divalent alkaline earth ions, respectively.) are received attention to apply bolometer resistive film because it has a high TCR property which was discovered in the metal to semiconductor phase transition temperature region. In this work, CMR films were deposited on various substrates in relative low substrate temperature by RF magnetron sputtering. The influence of deposition parameters such as substrate temperature, gas partial pressure, and so on have been studied. The structural and TCR properties of the films were also investigated for applying to microbolometer.

• Proceedings of the SAREK Conference
• /
• 2006.06a
• /
• pp.953-958
• /
• 2006

Perimeter zone has been reinforced by active systems, such as fan-coil units, because it causes an increase in heating and cooling loads, dew condensation in winter, or discomfort with cold-draft to residents in buildings, through poor insulation by light-weighed skin due to progressing multi-storied buildings and skyscrapers. However, because these active systems raise Its capacity so that fossil fuel is used as much as they are added, and ultimately, greenhouse effect is urged, we proposed BIPV system functioned as solar collector which can substitute active system. As an early stage, heat balance equation in steady-state by Fortran was used not only for pre-heating effect and electric power capacity during the day in winter, but also for electric power capacity during day in slimmer and sky radiation effect during night in summer. Especially, we should have considered shading on PV, since even a little bit of it makes the efficiency too low for the PV to work. Still, when the flux of pre-heated air was increased to make air-barrier, its temperature was not enough to make it because the speed of heat exchange was too fast to warm up the air, thus the capacity to meet the condition was evaluated, and electric power from PV was made used for it.

• Journal of Astronomy and Space Sciences
• /
• v.36 no.3
• /
• pp.121-131
• /
• 2019

The ionospheric mid-latitude trough (IMT) is the electron density depletion phenomenon in the F region during nighttime. It has been suggested that the IMT is the result of complex plasma processes coupled to the magnetosphere. In order to statistically investigate the characteristics of the IMT, we analyze topside sounding data from Alouette and ISIS satellites in 1960s and 1970s. The IMT position is almost constant for seasons and solar activities whereas the IMT depth ratio and the IMT feature are stronger and clearer in the winter hemisphere under solar minimum condition. We also calculated transition heights at which the densities of oxygen ions and hydrogen/helium ions are equal. Transition heights are generally higher in daytime and lower in nighttime, but the opposite aspects are seen in the IMT region. Utilizing the Incoherent Scatter Radar (ISR) electron temperature measurements, we find that the electron temperature in the IMT region is enhanced at night during winter. The increase of electron temperature may cause fast transport of the ionospheric plasma to the magnetosphere via ambipolar diffusion, resulting in the IMT depletion. This mechanism of the IMT may work in addition to the simply prolonged recombination of ions proposed by the traditional stagnation model.

• Journal of the Korean Institute of Rural Architecture
• /
• v.21 no.2
• /
• pp.43-51
• /
• 2019

The purpose of this study was to examine the current status of the use of bike parking lots in apartment complexes located in Gwangju Metropolitan City. The results were as follows. While common respondents answered the use of a bike for leisure or health, relatively few respondents answered a means of transportation such as going to school or work. It suggests that systematic plans to expand the range of using a bike should be made such as the connection of an apartment complex with a bike road. The common places to keep bikes were the entrance, the inside of the house, or stairs rather than bike parking lots because of safety problems such as theft or damage. In this regard, it is necessary to prepare clear regulation guidances to complement the safety problems of bike parking lots such as CCTV installation in the parking lots or compulsory installation of night lighting. Based on the findings, the methods to improve a bike parking lot should consider safety solutions and the complement of locations or keeping types. To activate the use of a bike, it is necessary to improve facilities to help residents' use of bike parking lots and expand their size in the future and examine the design of bike racks.

• Journal of East-Asian Urban History
• /
• v.2 no.1
• /
• pp.65-85
• /
• 2020

Examining how the CCP operated social services in Shanghai neighborhood[linong] in early 1950s, this article reveals the hidden relation between social service and rectification of neighborhood organizations in 1954. One of the main purpose of 1954 rectification was to guarantee provision of grassroots level of the city by recruiting local cadres, the implementers of social services. Though series of social service, such as night patrol, cleaning and public charity were indispensable for residents' life and welfare(fuli)[福利] of neighborhood, the social services was the something most of the Shanghai residents were reluctant to do. The result was the shortage of human resource for social service, triggering the "nominal position(gua ming)[掛名] " phenomenon. During political rectification of neighborhood organizations in 1954 Shanghai Municipal government tried to solve this 'decline of human resource in social services' problem by attracting the unemployed to the position of basic level cadre. To be specific, it demanded jobless person in neighborhood to be registered in time if they want a job placement. And it used that registration as the nominee of cadre in re-election process of the rectification campaign. The government measures were closely related to Shanghai people's inclination to rely on party-state when they try to get a job. Hence political rectification in neighborhood organizations become the strategic tool of city governance to mobilize residents in operating social services. So this article suggests that the CCP's urban governance was a complex and nuanced process to induce urban residents' interest and voluntarism beyond the suppression-oriented totalitarian perspective.

• Journal of Astronomy and Space Sciences
• /
• v.38 no.2
• /
• pp.119-134
• /
• 2021

The data set collected during the night of the discovery of a minor body constitutes a too-short arc (TSA), resulting in failure of the differential correction procedure. This makes it necessary to recover the object during subsequent nights to gather more observations that will allow a preliminary orbit to be calculated. In this work, we present a recovery technique based on sampling the admissible region (AdRe) by the constrained Delaunay triangulation. We construct the AdRe in its topocentric and geocentric variants, using logarithmic and exponential metrics, for the following near-Earth-asteroids: (3122) Florence, (3200) Phaethon, 2003 GW, (1864) Daedalus, 2003 BH84 and 1977 QQ5; and the main-belt asteroids: (1738) Oosterhoff, (4690) Strasbourg, (555) Norma, 2006 SO375, 2003 GE55 and (32811) Apisaon. Using our sampling technique, we established the ephemeris region for these objects, using intervals of observation from 25 minutes up to 2 hours, with propagation times from 1 up to 47 days. All these objects were recoverable in a field of vision of 95' × 72', except for (3122) Florence and (3200) Phaethon, since they were observed during their closest approach to the Earth. In the case of 2006 SO375, we performed an additional test with only two observations separated by 2 minutes, achieving a recovery of up to 28 days after its discovery, which demonstrates the potential of our technique.

• Journal of Advanced Information Technology and Convergence
• /
• v.10 no.2
• /
• pp.49-59
• /
• 2020

As technologies have been developing, our lives are getting easier. Today we are surrounded by the new technologies such as AI and IoT. Moreover, the word, "smart" is a very broad one because we are trying to change our daily environment into smart one by using those technologies. For example, the traditional workplaces have changed into smart offices. Since the 3rd industrial revolution, we have used the touch interface to operate the machines. In the 4th industrial revolution, however, we are trying adding the speech recognition module to the machines to operate them by giving voice commands. Today many of the things are communicated with human by voice commands. Many of them are called AI things and they do tasks which users request and do tasks more than what users request. In the 4th industrial revolution, we use smartphones all the time every day from the morning to the night. For this reason, the privacy using phone is not guaranteed sometimes. For example, the caller's voice can be heard through the phone speaker when accepting a call. So, it is needed to protect privacy on smartphone and it should work automatically according to the user context. In this aspect, this paper proposes a method to adjust the voice volume for call to protect privacy on smartphone according to the user context.

• Journal of the Society of Disaster Information
• /
• v.18 no.3
• /
• pp.560-565
• /
• 2022

Purpose: It is intended to prevent similar and similar disasters in advance by classifying the types of industrial accidents by type of distribution center and establishing countermeasures. Method: Development of improvement measures by analyzing in detail the types of occurrences of each type of 5 years in the distribution center. Result: Through the analysis of industrial accidents that occurred in the distribution center, it was possible to find ways to reduce disasters. Conclusion: It is expected to help reduce the disaster rate of the distriution center by presenting a disaster reduction plan through the analysis of industrial accidents in the distribution center.

• Quality Improvement in Health Care
• /
• v.9 no.2
• /
• pp.210-228
• /
• 2002

Background: The purpose of this research was to examine the fall incidence rate and its related factors of fall in inpatients. Methods: The data were collected from the 138 fall incident reports in one tertiary hospital in Seoul from April 1st 1999 to September 30th 2001. The Fall Incident Report Form was originally developed based on that of Massachusetts General Hospital revised in 1995. And this was modified for this survey by the collaborating work of QI team including researcher and department of nursing service of this particular hospital. The contents of Fall Incident Form were general characteristics of patient. factors related to fall. types and places of fall. circumstances, nursing interventions. and outcome. Results: 1) The incidence rate of fall was 0.08% of total discharged patients and 0.081 per 1000 patient-day. This incidence rate is much lower than that of several hospitals in USA. This finding might result from the different incidence report system of each hospital. 2) The characteristics of fall-prone patient were found as follows. They were mostly over 60 years old, in alert mental status, ambulatory with some assistance, and dependent on ambulatory device. The types of diseases related high incidence rate were cerebrovascular disease(3.2), hypertension(1.6), cardiovascular disease(1.4), diabetes(1.3) and liver disease(0.6). 3) The majority of fall events usually occurred m bed. bedside(walking or standing) and bathroom in patient room. Usually they were up on their own when they fell. And there were more falls of elderly occurred during night time than day or evening. 4) 63.8% of fall events resulted in physical injuries such as fracture and usually the patients had diagnostic procedures and some treatment(ex. suture) which caused additional cost to the patients and their families. 5) The found risk factors of fall were drugs(antihypertensive drug, diuretics) and environmental factors like too high bed height, long distance of bedside table and lamp switch, and slippery tile of bathroom floor. Conclusion: Considering these results, every medical and nursing staff should be aware of the risk factors of patients in hospital, and should intervene more actively the preventive managements, specially for the elderly patients during night. Therefore, it is recommended that the development of Fall Prevention Programs based on these results.

• Science of Emotion and Sensibility
• /
• v.24 no.2
• /
• pp.25-38
• /
• 2021

The aim of this study is to protect workers and pedestrians from accidents at night or bad weather by attaching optical fiber to existing safety clothing that is made only with fluorescent fabrics and retroreflective materials. A safety vest was designed and manufactured by applying optical fiber, and energy-harvesting technology was developed. The safety vest was designed to emit light using the automatic flashing of optical fibers attached to the film, and an energy harvester was manufactured and attached to drive the light emission of the optical fiber more continuously. As a result, first, the vest wearer' body was recognized from a distance through the optical fiber and retroreflection, which helped prevent accidents. Thus, this concept helps in saving lives by preventing accidents during night-time work on the roadside or activities of rescue crew and sports activities, or by quickly finding the point of an accident with a signal that changes the optical fiber light emission. Second, to use the wasted energy, a piezoelectric-element power generation system was developed and the piezoelectric-harvesting device was mounted. Potentially, energy was efficiently produced by activating the effective charging amount of the battery part and charging it auxiliary. In the existing safety vest, detecting the person wearing the vest is almost impossible in the absence of ambient light. However, in this study, the wearer could be found within 100 m by the light emission from the safety vest even with no ambient light. Therefore, in this study, we will help in preventing and reducing accidents by developing smart safety clothing using optical fiber and energy harvester attached to save lives.