• 대한화학회지
• /
• 제15권2호
• /
• pp.55-63
• /
• 1971

In this study, several nickel catalysts for the steam-hydrocarbon reforming process were prepared from various nickel salt, magnesium oxide, alumina and kaolinite. The activity and strength of the catalysts were investigated. 1. The proper composition of the calcined catalysts are: NiO (5-15%)-MgO(10-20%)-$Al_2O_3$(10-40%)-Kaolinite(50-80%). 2. The admixed or cosedimented ingredients of the catalysts was pelletized and calcinated at 1000 or $1150^{\circ}C$. Calcination at $1150^{\circ}C$ for an hour was optimum. 3. The water to oil ratio (W/O) for reforming of hexane should be above 7 mole/mole. As the W/O increases, more carbon dioxide and hydrogen, but less carbon monoxide was produced. Also carbon deposition become lessen at higher W/O. 4. Maximum conversion had attained at about $850^{\circ}C$. As the reaction temperature increases, more carbon monoxide and hydrogen, but less carbon dioxide and lower hydrocarbon was produced. 5. The percent conversion at $850^{\circ}C$ was about 80%, using a catalyst which the nickel oxide content are 5%.

• 자원리싸이클링
• /
• 제12권1호
• /
• pp.18-24
• /
• 2003

무전해 Ni-Cu-B 폐 도금액의 재사용에 대해 소정의 조건에서 조사하였다. 아연화처리한 후 니켈 촉매의 처리는 니켈 촉매처리를 하지 않았을 때 보다 도금시간이 연장되었다. Batch type에서 새로 제조한 도금액에 폐 도금액을 40% 첨가하여도 무전해 Ni-Cu-B 폐 도금액의 재사용이 가능하였다. 새로 제조한 도금액에 소모된 도금액의 성분을 연속적으로 보충하여 도금하면(continuous type), 보충하지 않았을 경우(batch type) 보다 도금시간이 6배 연장되었다. 새로 제조한 도금액에 폐 도금액 40%를 첨가하여 소모된 도금 액의 성분을 연속적으로 보충할 경우(continuous type)의 도금시간은 보충하지 않았을 경우(continuous type)의 도금시간 보다 2배 연장되었다. 도금층의 불량과 급격한 도금속도의 감소는 도금층의 Ni과 Cu의 성분 변화에 큰 영향을 미쳤다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2000년도 제18회 학술발표회 논문개요집
• /
• pp.210-210
• /
• 2000

Vertically well aligned multi-wall carbon nanotubes (CNT) were grown on nickel coated glass substrates by plasma enhanced hot filament chemical vapor deposition at low temperatures below 600$^{\circ}C$. Acetylene and ammonia gas were used as the carbon source and a catalyst. Effects of growth parameters such as pre-treatment of substrate, plasma intensity, filament current, imput gas flow rate, gas composition, substrate temperature and different substrates on the growth characteristics of CNT were systematically investigated. Figure 1 shows SEM image of CNT grown on Ni coated glass substrate. Diameter of nanotube was 30 to 100nm depending on the growth condition. The diameter of CNT decreased and density of CNT increased as NH3 etching time etching time increased. Plasma intensity was found to be the most critical parameter to determine the growth of CNT. CNT was not grown at the plasma intensity lower than 500V. Growth of CNT without filament current was observed. Raman spectroscopy showed the C-C tangential stretching mode at 1592 cm1 as well as D line at 1366 cm-1. From the microanalysis using HRTEM, nickel cap was observed on the top of the grown CNT and very thin carbon amorphous layer of 5nm was found on the nickel cap. Current-voltage characteristics using STM showed about 34nA of current at the applied voltage of 1 volt. Electron emission from the vertically well aligned CNT was obtained using phosphor anode with onset electric field of 1.5C/um.

• 한국가스학회지
• /
• 제26권2호
• /
• pp.14-20
• /
• 2022

본 연구에서는 메탄올 수증기 개질 반응을 이용하여 수소를 제조할 수 있는 촉매 반응 특성을 조사하였다. 메탄의 수증기 개질 반응시 자주 사용되는 니켈, 그리고 메탄올 합성 시 자주 사용되는 구리를 주 활성금속으로 사용하였으며, 지지체로는 다공성 및 열적 안정성이 우수하고, 높은 비표면적, 약한 루이스 산점과 염기성을 가지고 있는 하이드로탈사이트를 이용함으로서 높은 활성을 가지는 촉매와 그 특성에 대해서 파악하였다. 본 연구에서는 환원성이 높은 구리금속의 촉매에서 높은 반응성을 나타내었으며, 각각의 촉매에서는 함침량이 높아질수록 메탄올 전환율 및 높은 수소 선택도를 보여 주었다.

• 한국재료학회지
• /
• 제28권8호
• /
• pp.466-473
• /
• 2018

Nickel oxide(NiO) thin films, nanorods, and carbon nanotube(CNT)/NiO core-shell nanorod structures are fabricated by sputtering Nickel at different deposition time on alumina substrates or single wall carbon nanotube templates followed by oxidation treatments at different temperatures, 400 and $700^{\circ}C$. Structural analyses are carried out by scanning electron microscopy and x-ray diffraction. NiO thinfilm, nanorod and CNT/NiO core-shell nanorod structurals of the gas sensor structures are tested for detection of $H_2S$ gas. The NiO structures exhibit the highest response at $200^{\circ}C$ and high selectivity to $H_2S$ among other gases of NO, $NH_3$, $H_2$, CO, etc. The nanorod structures have a higher sensing performance than the thin films and carbon nanotube/NiO core-shell structures. The gold catalyst deposited on NiO nanorods further improve the sensing performance, particularly the recovery kinetics.

• Bulletin of the Korean Chemical Society
• /
• 제28권7호
• /
• pp.1159-1166
• /
• 2007

New unsymmetrical trans-stilbenes have been prepared by the sequential coupling reactions of bromobenzenesulfonate with formylarylboronic acids, benzylphosphonates and arylmagnesium bromides and characterized. The nickel-catalyzed reactions of stilbenesulfonates with aryl Grignard reagents produced the corresponding stilbenes via the nucleophilic aromatic substitution of the neopentyloxysulfonyl group by aryl nucleophiles. The great chemoselectivity of the alkyloxysulfonyl group allows the stepwise construction of unsymmetrical trans-stilbenes possessing terphenyl moieties. This procedure appears to be a promising and conceptually straightforward route for the parallel synthesis of various unsymmetrical stilbenes as well as other highly conjugated hydrocarbons.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2010년도 하계학술대회 논문집
• /
• pp.262-262
• /
• 2010

To investigate the effect of the amount of hydrogen on CVD grown-graphene, the flow rate of hydrogen was changed, while other process parameters were kept constant during CVD synthesis. Substrate which consists of 300nm-nickel/$SiO_2$/Si substrate, and methane gas mixed with hydrogen and argon were used for CVD growth. Graphene was synthesized at $950^{\circ}C$. The thickness and the defect of graphene were analyzed using raman spectroscopy. The synthesized graphene shows non-uniform and more defective below a certain amount of hydrogen.

• 대한화학회지
• /
• 제46권2호
• /
• pp.139-144
• /
• 2002

니켈 착물을 촉매로 사용한 1,1´-Bis(dimethylsilyl)ferrocene [1]과 carbonyl 화합물 -benzaldehyde, 4-cyanobenzaldehyde, trimethylacetaldehyde, acetophenone과 benzophenone-은 3-oxa-2,5-disilacyclo-1,1′-ferrocene을 생성하였다. 이와 대비되게 동일한 반응조건에서 화합물 [1]과 isobutyraldehyde의 반응에는 1,1′-bis(dimethylsilyl)ferrocene의 Si-H 결합에 2개의 aldehyde ligand가 이중 삽입된 생성물이 형성되었다.

• Bulletin of the Korean Chemical Society
• /
• 제28권2호
• /
• pp.281-284
• /
• 2007

Neopentyl arenesulfonates react with secondary alkylmagnesium chlorides in the presence of dppfNiCl2 to produce the corresponding arenes via the reductive cleavage of carbon-sulfur bond. Highest yield is obtained by using three equivalents of Grignard reagent to a mixture of arenesulfonate and dppfNiCl2 in Et2O at room temperature. This reaction represents a novel method allowing the efficient hydrogenolysis of sulfur-containing groups in aromatic compounds.

• Bulletin of the Korean Chemical Society
• /
• 제31권12호
• /
• pp.3765-3770
• /
• 2010

Selective oxidation of olefins has been carried out in water medium with tert-butylhydroperoxide (TBHP, 70% aqueous) as an oxidant using polymer-anchored Ni(II) complex as a catalyst. Several parameters were varied to optimize the reaction conditions. Under the optimized reaction conditions olefins gave selectively allylic oxidation products. The present polymer anchored Ni(II) complex can be recycled five times without any appreciable loss in catalytic activity.