• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.55 no.1
• /
• pp.26-29
• /
• 2006

Transparent ZnO thin films were prepared by KrF pulsed laser deposition (PLD) technique and applied to a bottom-gate type thin film transistor device as an active channel layer. A high conductive crystalline Si substrate was used as an metal-like bottom gate and SiN insulating layer was then deposited by LPCVD(low pressure chemical vapour deposition). An aluminum layer was then vacuum evaporated and patterned to form a source/drain metal contact. Oxygen partial pressure and substrate temperature were varied during the ZnO PLD deposition process and their influence on the thin film properties were investigated by X-ray diffraction(XRD) and Hall-van der Pauw method. Optical transparency of the ZnO thin film was analyzed by UV-visible phometer. The resulting ZnO-TFT devices showed an on-off ration of $10^6$ and field effect mobility of 2.4-6.1 $cm^2/V{\cdot}s$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.5
• /
• pp.467-475
• /
• 2004

ZnO epilayer were synthesized by the pulsed laser deposition(PLD) process on $Al_2$ $O_3$substrate after irradiating the surface of the ZnO sintered pellet by the ArF(193 nm) excimer laser. The epilayers of ZnO were achieved on sapphire(A $l_2$ $O_3$) substrate at a temperature of 400 $^{\circ}C$. The crystalline structure of epilayer was investigated by the photoluminescence and double crystal X-ray diffraction(DCXD). The carrier density and mobility of ZnO epilayer measured with Hall effect by van der Pauw method are 8.27${\times}$$10^{16}$$cm^{-3}$ and 299 $\textrm{cm}^2$/Vㆍs at 293 K, respectively. The temperature dependence of the energy band gap of the ZnO obtained from the absorption spectra was well described by the Varshni's relation, $E_{g}$(T)= 3.3973 eV - (2.69 ${\times}$ 10$_{-4}$ eV/K) $T^2$(T＋463k). After the as-grown ZnO epilayer was annealed in Zn atmospheres, oxygen and vaccum the origin of point defects of ZnO atmospheres has been investigated by the photoluminescence(PL) at 10 K. The native defects of $V_{Zn}$ , $V_{o}$ , Z $n_{int}$, and $O_{int}$ obtained by PL measurements were classified as a donors or accepters type. In addition, we concluded that the heat-treatment in the oxygen atmosphere converted ZnO thin films to an optical p-type. Also, we confirmed that vacuum in ZnO/A $l_2$ $O_3$did not form the native defects because vacuum in ZnO thin films existed in the form of stable bonds.s.s.s.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.7
• /
• pp.567-571
• /
• 2009

Polycrystalline ZnO and Ga doped ZnO (GZO) films are deposited on glass substrate by RF magnetron sputtering at room temperature. The characteristics of ZnO and GZO films are investigated with X-ray diffraction measurement, UV-VIS-NIR spectrophotometer $(250{\sim}1200nm)$ and hall measurement. The post-growth thermal treatment of these films is carried out in N2 ambient at $500^{\circ}C$ for 30 min and an hour. ZnO and GZO films have different changing behavior of structural and optical properties by annealing. To use transparent conductive films for solar cell, films should have not only high transmittance but also good electrical property. Although as deposited GZO films have electrical properties than ZnO films, GZO films have not good transmittance properties. Consequently, we succeed that the high transmittance of GZO films is improved by annealing process.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.21 no.4
• /
• pp.137-146
• /
• 2011

Vertically well-aligned ZnO nanowire (NW) arrays were synthesized directly on GaN/sapphire and Si substrate from Zn vapor deposition without catalysts. Experimental results showed that the number density, diameter, crystallinity and degree of the alignment of ZnO NWs depended strongly on both the substrate position and kind of the substrates used for the growth. The photoluminescence (PL) characteristics of the grown ZnO NW arrays exhibit a strong and sharp ultraviolet (UV) emission at 379 nm and a broad weak emission in the visible range, indicating that the obtained ZnO NWs have a high crystal quality with excellent optical properties. The as-grown ZnO NWs were characterized by using scanning electron microscopy (SEM), high resolution transmission electronic microscopy (HR-TEM), and X-ray diffraction (XRD).

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.414-414
• /
• 2008

Vertically well-aligned Ga-doped ZnO nanorods with different Ga contents were grown by thermal evaporation on a ZnO template. The Ga-doped ZnO nanorods synthesized with 50 wt % Ga with respect to the Zn content showed maximum compressive stress relative to the ZnO template, which led to a rapid growth rate along the c-axis due to the rapid release of stored strain energy. A further increase in the Ga content improved the conductivity of the nanorods due to the substitutional incorporation of Ga atoms in the Zn sites based on a decrease in lattice spacing. The p-n diode structure with Ga-doped ZnO nanorods, as a n-type, displayed a distinct white light luminescence from the side-view of the device, showing weak ultraviolet and various deep-level emissions.

• Korean Journal of Materials Research
• /
• v.22 no.11
• /
• pp.575-580
• /
• 2012

The purpose of this study is to investigate the crystalline structure and optical properties of (GaZn)(NO) powders prepared by solid-state reaction between GaOOH and ZnO mixture under $NH_3$ gas flow. While ammoniation of the GaOOH and ZnO mixture successfully produces the single phase of (GaZn)(NO) solid solution within a GaOOH rich composition of under 50 mol% of ZnO content, this process also produces a powder with coexisting (GaZn)(NO) and ZnO in a ZnO rich composition over 50 mol%. The GaOOH in the starting material was phase-transformed to ${\alpha}$-, ${\beta}-Ga_2O_3$ in the $NH_3$ environment; it was then reacted with ZnO to produce $ZnGa_2O_4$. Finally, the exchange reaction between nitrogen and oxygen atoms at the $ZnGa_2O_4$ powder surface forms a (GaZn)(NO) solid solution. Photoluminescence spectra from the (GaZn)(NO) solid solution consisted of oxygen-related red-emission bands and yellow-, green- and blue-emission bands from the Zn acceptor energy levels in the energy bandgap of the (GaZn)(NO) solid solutions.

• Electrical & Electronic Materials
• /
• v.8 no.1
• /
• pp.21-26
• /
• 1995

Highly sensitive and mechanically stable gas sensors have been fabricated using the microfabrication and micromaching techniques. The sensing material used to detect the offensive trimethylarnine ((CH$_{3}$)$_{3}$N) gas is 6 wt% $Al_{2}$O$_{3}$-doped, 1000.angs.-thick ZnO deposited by r. f. magnetron sputtering. The optimum operating temperature of the sensor is 350.deg.C and the corresponding heater power is about 85mW. Excellent thermal insulation is achieved by the use of a double-layer structure of 0.2.mu.m -thick silicon nitride and 1.4.mu.m-thick phosphosilicate glass(PSG) prepared by low pressure chemical vapor deposition(LPCVD) and atmospheric pressure chemical vapor deposition(APCVD), respectively. The sensors are mechanically stable enough to endure at least 43, 200 heat cycles between room temperature and 350.deg. C.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.391-391
• /
• 2010

The stability enhancement of Znic oxide thin film transistor deposited by PLD-DBD has been reported here using the bias temperature stress test. Znic oxide (ZnO) thin films were deposited on $SiO_2$/Si (100) by pulsed laser deposition method with and without dielectric barrier discharge (DBD) method. The DBD is the efficient method to adopt the nitrogen ions into the thin films. The TFT characteristics of ZnO TFTs with and without Nirogen (N) doping show similar results with $I_{on/off}$ of $10^5{\sim}10^6$. However. the bias temperature stress (BTS) test of N-doped ZnO TFT with DBD shows higher stability than that of ZnO TFT.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2010.05a
• /
• pp.28.1-28.1
• /
• 2010

다양한 반도체 재료 중 ZnO는 3.2 eV의 넓은 밴드 갭을 통한 고효율의 단파장 전기광학 소자 응용 개발에 대한 연구가 진행중에 있으며, 60 meV의 넓은 엑시톤 결합 에너지로 인해 높은 기계적, 열적 안정성을 가진다. 또한 높은 투과성과 굴절율(n=2)을 가지며 이방성 성장을 통한 텍스처 코팅이 가능함으로 PV(photovoltaics)용 유전체 ARC(anti-reflection coating) 재료로 유망하다. 텍스처된 표면은 빛을 차단시키며, 광대역에서 반사를 억제 시킨다. 또한 나노 구조를 통한 나노 다공성 표면은 광대역에서 빛을 모으는 장점이 있으며 태양전지 효율을 극대화 시킬 수 있다. 본 연구에서는 저온 공정이 가능한 hydrothermal 방법으로 다양한 ZnO 나노 구조를 합성하였다. 사용된 합성 재료로 사용되는 zinc nitrate($Zn(NO_3)_2.6H_2O$), hexamethyltetramine(HMT, $C_6H_{12}N_4$)의 농도 및 합성 온도 변화를 통해 다양한 나노구조(나노선, 나노막대, 나노시트 등)의 형태 및 크기를 제어하였다. 이러한 구조적인 변화를 토대로 텍스처된 다공성 나노구조를 형성시키고, 그 형상과 크기 차이에 따른 AR 특성을 평가하였다. ZnO 나노 구조의 결정학적 특성은 XRD(x-ray diffractometer)를 이용하여 분석하였으며, SEM(scanning electron microscope)을 통해 나노 구조의 모양과 크기를 관찰하였다. 또한 UV-Vis spectrophotometer를 통해 나노 구조의 흡수도와 반사도를 측정하였다.

• Proceedings of the KIEE Conference
• /
• 2003.10a
• /
• pp.72-74
• /
• 2003

Rf magnetron sputtering을 이용하여 InP, GaAs 기판위에 ZnO 박막을 증착시켰다. 진공 ampul 및 $Zn_3P_2$ 분위기 하에서 열처리 과정을 통해 P와 As을 ZnO 박막내에 도핑하였으며, 박막의 전기적 특성 측정 결과 정공의 농도가 $10^{16}cm^{-3}-10^{19}cm^{-3}$ 으로서 p-형 전기전도도를 나타내었다. XRD 측정을 통하여 ZnO 박막의 내부에 이상이 존재하지 않는다는 것을 확인하였다. 또한 FESEM을 이용하여 p-형 ZnO 박막의 표면을 관찰하였으며 그 위에 n-형 ZnO 박막을 sputtering을 이용하여 증착시켜 I-V 특성을 관찰하였다. 본 실험을 통해 P 및 As의 확산을 통한 p-형 ZnO 박막의 성장이 가능하였으며, I-V 특성으로부터 ZnO의 발광소자 및 자외선 검출기로의 응용이 가능함을 확인하였다.