• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 한국정보통신학회 2015년도 춘계학술대회
• /
• pp.598-599
• /
• 2015

For the wireless mesh networks, efficient routing protocol is required to transmit data from source to destination node through multi-hop transmission. Multipath routing enable the stable data transmission even in the case of traffic congestion or unstable link. In this paper, we propose partial multipath routing which does not make a full multipath but partial for some parts of unstable links. This partial multipath routing reduce the number of nodes for routing and minimized the required power.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• 제37권5B호
• /
• pp.327-337
• /
• 2012

There have been lots of researches on the optimal relay selection in relay-based systems. However, most researches have been focused on the maximization of transmission capacity with a constraint of sum power at both transmitter and relays. In Ad-hoc networks where relays have batteries of limited power, it is imperative to minimize the energy consumption while maintaining the required quality-of-service (QoS). In this paper, we propose an optimal relay selection strategy to minimize the relay power consumption while satisfying the required signal-to-noise ratio (SNR). Through intensive simulations, we show the proposed method is more effective in terms of energy consumption and guarantee lower transmission failure probability in multi-hop Ad-hoc environments.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제16권8호
• /
• pp.2666-2687
• /
• 2022

As a new alternative communication scheme in 5G, unmanned aerial vehicle (UAV) is used as a relay in the remote base station (BS) for assistant communication. In order to ameliorate the quality of the backhaul link, a UAV backhaul transmission scheme based on improved Nash equilibrium (NE) strategy is proposed. First, the capacity of air-to-ground (A2G) channel by the link preprocess is maximized. Then, the maximum utility function of each UAV is used as the basis of obtaining NE point according to the backhaul channel and the backhaul congestion. Finally, the improved NE strategy is applied in multiple iterations until maximum utility functions of all the UAVs are reached, and the UAVs which are rejected by air-to-air (A2A) link during the process would participate in the source recovery process to construct a multi-hop backhaul network. Simulation results show that average effective backhaul rate, minimum effective backhaul rate increases by 10%, 28.5% respectively in ideal A2G channel, and 11.8%, 42.3% respectively in fading channel, comparing to pure NE strategy. And the average number of iterations is decreased by 5%.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• 제22권2호
• /
• pp.142-147
• /
• 2008

In wireless sensor networks, one of the most important issue is improvement of network lifetime with an efficient energy consumption. we repose effective multi-hop routing algorithm which increases the number of nodes alive at any time. In our algorithm we use the dynamic selection of cluster head and short distance transmission method. We simulated the proposed algorithm by using Network Simulator 2 and compared its performance with LEACH. The experimental result shows that the number of the nodes alive is increased up to 39.71[%] during the simulation time.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• 제29권1호
• /
• pp.18-25
• /
• 2006

In mobile ad-hoc networks(MANETs), nodes are mobile and network topology changes very frequently. The mobility of nodes does affect the system performance. There has been considerable attention on the mobility models, however, most work is confined to the simulation or test-bed. In this paper, we propose an analytical method to evaluate the performances of MANETs such as the average radio range dwell time of mobile nodes, link holding time, and transmission failure probability considering the node's mobility. In the proposed model, MANETs consist of the multi-hop and multicasting routing paths. A simulation is done to validate our proposed analytical model.

• Proceedings of the KIEE Conference
• /
• 대한전기학회 2007년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.503-504
• /
• 2007

The most Important thing in Sensor Network Design is a Energy Efficiency. Limited sources of Sensor Mote tan occur merging of Protocol. In this paper, we proposed Cross Layer Protocol for Energy Efficienty. The proposed protocol can increase the network life time using multi hop transmission. sensor network should use multi hop communication and small radius because radio in wireless communication is the most spendable thing in sensor network.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• 제44권3호
• /
• pp.37-42
• /
• 2007

This paper reconsiders established power conservation models for ubiquitous sensor networks that use relay nodes instead of direct communication and proposes novel network power consumption model with consideration of the channel level and radio chip level simultaneously. We estimate the effect of minimum hop-count policy in terms of network power consumption through simulation of various situations for low power RF module CC2420. It is observed that maximum RF power and minimum hop-count results in lower energy consumption relatively. Also, in total network energy consumption, which is included re-transmission, minimum hop count policy presents decrease by 33.1% of energy consumption in compare with the conventional model.

• ETRI Journal
• /
• 제40권5호
• /
• pp.582-591
• /
• 2018

In this paper, we present a performance analysis of large-scale multi-input multi-output (MIMO) systems for wireless backhaul networks. We focus on fully connected N nodes in a wireless meshed and multi-hop network topology. We also consider a large number of antennas at both the receiver and transmitter. We investigate the transmission schemes to support fully connected N nodes for half-duplex and full-duplex transmission, analyze the achievable ergodic sum rate among N nodes, and propose a closed-form expression of the achievable ergodic sum rate for each scheme. Furthermore, we present numerical evaluation results and compare the resuts with closed-form expressions.

• Journal of Digital Convergence
• /
• 제12권1호
• /
• pp.339-345
• /
• 2014

This study has a purpose that improves efficiency of energy management and adaptation followed by movement of node better than the various early studied routing techniques. The purpose of this paper is the technique that uses RSSI value and location of sensor that is received by each sensor node to routing. This sduty does not save node information of 1-hop distance. And it solves energy-inefficient traffic problem that happens during data exchange process for middle node selection in close range multi hop transmission technique. The routing protocol technique that is proposed in this study selects a node relevant to the range of transmission which is set for RSSI value that is received by each node and selects the closest node as a middle node followed by location data. Therefore, it is for not exhaustion of node's energy by managing energy efficiently and cutting data transmission consuming until the destination node.

• Journal of Communications and Networks
• /
• 제18권5호
• /
• pp.796-805
• /
• 2016

In many wireless sensor network (WSN) applications, the information transmitted by an individual entity or node is of limited use without the knowledge of its location. Research in node localization is mostly geared towards multi-hop range-free localization algorithms to achieve accuracy by minimizing localization errors between the node's actual and estimated position. The existing localization algorithms are focused on improving localization accuracy without considering efficiency in terms of energy costs and algorithm convergence time. In this work, we show that our proposed localization scheme, called DV-maxHop, can achieve good accuracy and efficiency. We formulate the multi-objective optimization functions to minimize localization errors as well as the number of transmission during localization phase. We evaluate the performance of our scheme using extensive simulation on several anisotropic and isotropic topologies. Our scheme can achieve dual objective of accuracy and efficiency for various scenarios. Furthermore, the recently proposed algorithms require random uniform distribution of anchors. We also utilized our proposed scheme to compare and study some practical anchor distribution schemes.