• Current Applied Physics
• /
• 제18권12호
• /
• pp.1600-1604
• /
• 2018

This paper reports on a systematic and quantitative assessment of light induced degradation (LID) and regeneration in full Al-BSF and passivated emitter rear contact cells (PERC) along with the fundamental understanding of the difference between the two. After LID, PERC cells showed a much greater loss in cell efficiency than full Al-BSF cells (~0.9% vs ~0.6%) because the degradation in bulk lifetime also erodes the benefit of superior BSRV in PERC cells. Three main regeneration conditions involving the combination of heat and light ($75^{\circ}C/1\;Sun/48h$, $130^{\circ}C/2\;Suns/1.5h$ and $200^{\circ}C/3\;Suns/30s$) were implemented to eliminate LID loss due to BO defects. Low temperature/long time ($75^{\circ}C/48h$) and high temperature/short time ($200^{\circ}C/30s$) regeneration process was unable to reach 100% stabilization. The intermediate temperature/time ($130^{\circ}C/1.5h$) generation achieved nearly full recovery and stabilization (over 99%) for both full Al-BSF and PERC cells. We discussed the effect of temperature, time and suns in regeneration mechanism for two cells.

• 대한방사선기술학회지:방사선기술과학
• /
• 제9권1호
• /
• pp.73-81
• /
• 1986

This paper carried out an experiment on the characteristics of time, temperature, electric field and the dependense of electrode materials and gap length by the conduction current of the insulating oil used for x-ray tube housing. The obtained results can be summarized as following: 1. In the x-ray tube housing insulating oil with vacuum condition, conduction current is declined more than the x-ray tube housing insultaing oil with the air, and is held stable states. 2. At the low electric field the higher temperature of the x-ray tube housing insulating oil is increased, the more conduction current. 3. The dependence of electrode material is appeared at the low electric field and the short gap length than the high and the long with Fe> Cu >Al. 4. At the I-E characteristics, the low electric field than 1000 [V/cm] is appeared Ohm's law region, and the high become saturation region. 5. At the same electric field, the longer gap length become, the more conduction current is increased, and the same applied voltage, the longer, the less conduction current is decreased, the less low than high temperature x-ray tube housing insulating oil.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2006년도 6th International Meeting on Information Display
• /
• pp.357-362
• /
• 2006

OLEDs are becoming established as a commercially viable flat panel display technology of choice of the $21^{st}$ century because of its lightweight, fast response time, lower thickness than LCD's and potentially low cost (1-2). For the OLEDs to function effectively, highly thermally stable materials, which offer high efficiency and long operational lifetimes are required. To achieve long lifetime, highly stable charge (both holes and electrons) transporters are essential. OLED-T provides these materials as well as fluorescent and phosphorescent dopants. This paper reports a unique patented hole injector (E9363) and an electron transporter (E246) that increases the lifetime and efficiency and reduces operating voltage. Further, an electron injector, EEI-101, which evaporates at a very low temperature of $300^{\circ}C$ as opposed to the conventional LiF, which requires $580^{\circ}C$, is also presented.

• Applied Science and Convergence Technology
• /
• 제26권5호
• /
• pp.133-138
• /
• 2017

We investigated the interface defect engineering and reaction mechanism of reduced transition layer and nitride layer in the active plasma process on 4H-SiC by the plasma reaction with the rapid processing time at the room temperature. Through the combination of experiment and theoretical studies, we clearly observed that advanced active plasma process on 4H-SiC of oxidation and nitridation have improved electrical properties by the stable bond structure and decrease of the interfacial defects. In the plasma oxidation system, we showed that plasma oxide on SiC has enhanced electrical characteristics than the thermally oxidation and suppressed generation of the interface trap density. The decrease of the defect states in transition layer and stress induced leakage current (SILC) clearly showed that plasma process enhances quality of $SiO_2$ by the reduction of transition layer due to the controlled interstitial C atoms. And in another processes, the Plasma Nitridation (PN) system, we investigated the modification in bond structure in the nitride SiC surface by the rapid PN process. We observed that converted N reacted through spontaneous incorporation the SiC sub-surface, resulting in N atoms converted to C-site by the low bond energy. In particular, electrical properties exhibited that the generated trap states was suppressed with the nitrided layer. The results of active plasma oxidation and nitridation system suggest plasma processes on SiC of rapid and low temperature process, compare with the traditional gas annealing process with high temperature and long process time.

• 한국멀티미디어학회논문지
• /
• 제22권2호
• /
• pp.242-249
• /
• 2019

Old people and patients with cardiovascular disease could die of a heart attack in the bath with heated water for a long time. Various researches have been studied to prevent these accidents from happening such as measuring the ECG signal when taking bath. However, these devices are hard to use and the higher price is not easily accepted by the public. In this paper, a low-cost and use-friendly, real time high precision water temperature monitoring device to prevent heart attack in the bath was developed. The device with waterproof design that lets the device can float on the surface of the water, and an accurate way to make water temperature measurement method was proposed by this paper that is immerging the sensor into water with 4cm depth to measure the temperature of underwater. The manufactured device was conducted to two experiments; one was to verify the basic functions of the device, and another one was for compare the proposed device with commercial products for monitoring the water temperature in the bathtub. As the experimental results shown, the proposed device has stable performance for the water temperature measurement and communicating with laptop in wireless.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1995년도 봄 학술발표회 논문집
• /
• pp.154-159
• /
• 1995

Cold weather concrete presents the many characteristic variation of quality, according to the mixing and cooling point, the cooling time and the quantity of air besides the compressive strength of concrete. Thus, in this study to verify the character of cold-weather concrete we make the concrete specimens at laboratory and cool them at cooling-melting machine and then test the 7days compressive strength of them, with the variation of compressive strength of concrete, cooling point, cooling time, cooling weather and air quantity. At the results, the compressive strength of concrete decrease in the case of early cooling point, long cooling time, low cooling temperature and the low design compressive strength

• Plant Biotechnology Reports
• /
• 제3권1호
• /
• pp.103-109
• /
• 2009

In this study we established reliable methods for conservation of seeds of Phaius tankervilleae as an orchid genetic resource. The seeds, which were dehydrated to 5% water content and preserved at $4^{\circ}C$, showed no decrease in viability and germinability after three months. After storage for six months, however, the seeds showed a drastic decrease in germinability, even though survival rate was high. For long-term preservation of seeds of P. tankervilleae, cryopreservation is applied to the freshly harvested seeds. When the seeds were cryopreserved by the vitrification method for up to 12 months there was no apparent deterioration effect of storage time. These results indicate that cryopreservation by the vitrification method is useful for long-term conservation of P. tankervilleae seeds, which are difficult to preserve for more than three months under dry and low-temperature conditions.

• 한국조리학회지
• /
• 제20권2호
• /
• pp.54-64
• /
• 2014

레토르트 처리한 양파의 조직감(견고성)을 향상시키기 위하여 칼슘용액에서 장시간 저온(LTLT)블랜칭을 실시하였다. 칼슘용액에서 예비 열처리한 양파는 일반적인 블랜칭과 비교시 고온 멸균한 후 양파의 조직감이 의미있게 향상되었다. LTLT 블랜칭에 의한 견고성의 향상은 양파 조직의 pectin methylesterase(PME) 작용으로 carboxyl 그룹과 2가 양이온($Ca^{2+}$)간의 강한 가교결합과 관련이 있다. 0.5% 칼슘용액에서 $70^{\circ}C$, 120분동안 예비 열처리를 행하였을 때 가장 높은 견고성을 가진 레토르트 처리된 양파를 얻을 수 있었다. 이 같은 결과는 양파에서 PME의 활성도와 결합된 칼슘의 함량이 $70^{\circ}C$에서 가장 높았다는 것을 의미한다. 또한, $Mg^{2+}$와 같은 여러 2가 양이온을 함유하고 있는 알칼리 계통 칼슘이 펙틴 분자를 상온에서 가수분해하는 기작이 효소 작용에 더해져 여러 칼슘용액 중에서 레토르트 처리된 양파의 조직감을 가장 견고하게 하였다. 향후 여러 가지 레토르트 처리된 야채들의 조직 연화 방지를 위한 최적조건 실험이 야채별로 더 많이 수행되어야 할 것이다.

• 산업식품공학
• /
• 제23권1호
• /
• pp.69-75
• /
• 2019

본 연구에서는 다양한 온도 및 시간에 따른 데치기에 의한 우엉, 연근 및 마늘종의 특성 변화를 평가하였다. 우엉은 데치기에 의한 조직 연화 효과를 얻기 어려웠으며, 저온 데치기에 따른 변색이 심하게 발생하는 현상을 보여주었다. 따라서 효과적인 우엉의 데치기는 90℃ 이상에서 단시간(1분) 실시해야 품질의 저하를 억제할 수 있을 것으로 판단된다. 반면 연근은 80℃에서 5분간 데치는 경우 고온에서 단시간 데친 연근에 비해 수분함량이 높고 연도는 차이를 보이지 않아 저온 데치기를 효과적으로 적용할 수 있는 농산물로 판단되었다. 마늘종은 고온 데치기에 의해 조직 연화 효과를 얻을 수 있지만, 색도 변화를 수반하기 때문에 품질 측면에서 바람직하지 않았으며, 80℃에서 3-5분 데치기를 통해 연화효과를 얻을 수 있을 것으로 기대되었다.

• 전자공학회지
• /
• 제37권8호
• /
• pp.50-59
• /
• 2010

$0.18-{\mu}m$ high voltage technology 13.5V high voltage well-based symmetric EDMOS isolated by MTI was designed and fabricated. Using calibrated process and device model parameters, the characteristics of the symmetric and asymmetric EDMOS have been simulated. The asymmetric EDMOS has higher performance, better $R_{sp}$ / BVDSS figure-of-merit, short-channel immunity and smaller pitch size than the symmetric EDMOS. The asymmetric EDMOST is a good candidate for low-power and smaller source driver chips. The low voltage logic well-based EDMOS process has advantages over high voltage well-based EDMOS in process cost by eliminating the process steps of high-voltage well/drift implant, high-temperature long-time thermal steps, etc. The specific on-resistance of our well-designed logic well-based EDMOSTs is compatible with the smallest one published. TCAD simulation and measurement results show that the improved logic well-based nEDMOS has better electrical characteristics than those of the conventional one. The improved EDMOS proposed in this paper is an excellent candidate to be integrated with low voltage logic devices for high-performance low-power low-cost chips.