• Proceedings of the KSME Conference
• /
• 2008.11a
• /
• pp.1788-1793
• /
• 2008

Classical molecular dynamics simulations (MDS) were conducted to simulate nano-sized cluster collisions with a weakly attractive static surface. Energy exchanges associated with the cluster collision and the adhesion probability are discussed. Routes of the energy exchanges and the kinetic energy loss are vastly altered in their mode according to the cluster incident velocity. In the elastic collision regime ($V_0$<0.1), most incident kinetic energy is recovered into the rebounding kinetic energy, but a little loss in the incident kinetic energy causes the cluster adhesion. Dissipated kinetic energy is converted into the rotational energy. In the weakly plastic collision regime (0.1<$V_0$<0.3), the transition from elastic to plastic collision occurs, and a large part of the released potential energy is converted into rebounding translational energy. For strongly plastic collisions ($V_0$>0.3), permanent cluster deformation occurs with extensive collapse of the lattice structure inducing a solid-to-solid phase transition; moreover, most of the cluster kinetic energy is converted into cluster potential and thermal energy.

• Journal of the Korean Solar Energy Society
• /
• v.27 no.3
• /
• pp.107-115
• /
• 2007

The measured solar radiation incident on tilted surfaces has been widely used as important solar radiation data in installing photovoltaic arrays. To optimize the incident solar radiation, the slope, that is the angle between the plane surface in question and the horizontal, and the solar azimuth angles are needed for these solar photovoltaic systems. This is because the performance of the solar photovoltaic systems is much affected by angle and direction of incident rays. The expert system can predict the optimum installation angle of photovoltaic arrays with those factors.

• Journal of Ocean Engineering and Technology
• /
• v.23 no.6
• /
• pp.1-6
• /
• 2009

An Overtopping Wave Energy Convertor (OWEC) is an offshore wave energy convertor used for collecting overtopping waves and converting the water pressure head into electric power through hydro turbines installed in a vertical duct affixed to the sea bed. A numerical wave tank based on the commercial computational fluid dynamics code Fluent is established for the corresponding analysis. The Reynolds Averaged Navier-Stokes equation and two-phase VOF model are utilized to generate the 2D numerical linear propagating waves, which are validated by the overtopping experiment results. Calculations are made for several incident wave conditions and shape parameters for the overtopping device. Both the incident wave periods and heights have evident effects on the overtopping performance of the OWEC device. The computational analysis demonstrates that the present overtopping device is more compatible with longer incident wave periods.

• Transactions of the Korean hydrogen and new energy society
• /
• v.12 no.1
• /
• pp.51-63
• /
• 2001

In this paper molecular dynamics simulations were employed to investigate the structural and dynamic properties of hydrogen ions impacted on the Ni (100) surface with the $45^{\circ}$ incident angle. The initial kinetic energies of the hydrogen ion range from 100 to 1,600 eV. Together with the trajectory visualization of hydrogen ions, we computed scattering and penetration yields, mean energies and angles, and probability and energy distributions as a function of longitudinal and azimuthal directions. In the case of lower energy scattering ions, the multiple collision effects were found to be important to the third layers or lower. For higher energy penetrating ions, compared with the normal incident angle, it was significant the effective channeling effects through the Ni layers and the angle dependencies were indicated both in the longitudinal and the azimuthal angle directions.

• Journal of Ocean Engineering and Technology
• /
• v.35 no.4
• /
• pp.296-304
• /
• 2021

Research on the development of marine renewable energy is actively in progress. Various studies are being conducted on the development of wave energy converters. In this study, a numerical analysis of wave-energy extraction performance was performed according to the body shape and scale of the sloped oscillating water column (OWC) wave energy converter (WEC), which can be connected with the breakwater. The sloped OWC WEC was modeled in the time domain using a two-dimensional fully nonlinear numerical wave tank. The nonlinear free surface condition in the chamber was derived to represent the pneumatic pressure owing to the wave column motion and viscous energy loss at the chamber entrance. The free surface elevations in the sloped chamber were calculated at various incident wave periods. For verification, the results were compared with the 1:20 scaled model test. The maximum wave energy extraction was estimated with a pneumatic damping coefficient. To calculate the energy extraction of the actual size WEC, OWC models approximately 20 times larger than the scale model were calculated, and the viscous damping coefficient according to each size was predicted and applied. It was verified that the energy, owing to the airflow in the chamber, increased as the incident wave period increased, and the maximum efficiency of energy extraction was approximately 40% of the incident wave energy. Under the given incident wave conditions, the maximum extractable wave power at a chamber length of 5 m and a skirt draft of 2 m was approximately 4.59 kW/m.

• Journal of the Korean Society for Heat Treatment
• /
• v.18 no.4
• /
• pp.229-234
• /
• 2005

Effect of incident ion beam energy on microstructure and adhesion behavior of TiN thin films were studied. Without ion beam assist, TiN film showed (111) growth mode which was thought to have the lowest deformation energy. As the ion beam assist energy increased, TiN film growth mode was changed from (111) to (200) mode. On the Si(100) substrate the critical incident energy for growth mode change was 100 eV/atom, however the critical assist energy was 121 eV/atom on the STD61 substrate. Grain size of TiN films increased with the assist ion beam energy. Finally, adhesion strength of TiN films bombarded above the critical ion assist energy showed 4~5 times higher values than that with lower bombard ion energy.

• Journal of the Korean Solar Energy Society
• /
• v.27 no.1
• /
• pp.11-17
• /
• 2007

The amount of incident rays over inclination according to direction has been widely utilized as important data in installing photovoltaic systems. This is because the performance of the photovoltaic systems in much affected by angle and direction of incident rays. Recognizing that factors mentioned above are of importance, actual experiment on the moving route of the sun have been performed in this research to obtain the angle of inclination with which the maximum incident rays can be absorbed. After all, the standard for designing highly optimized photovoltaic systems will be provided for designers and employees working in the photovoltaic module related industries.

• Journal of the Korean Vacuum Society
• /
• v.8 no.1
• /
• pp.55-62
• /
• 1999

Monte Carlo ion scattering program is improved with the single scattering methods where the total cross section and the mean free path are calculated as a function of atomic density during ion scattering in matter. The relations among the parameters of incident ions and substrate materials are investigated to the sputtering phenomena. The sputtering yield has been analyzed with the dependence on the incident ion species and energy, incident angle, and surface binding energy. The energy distribution of sputtered particles is discussed.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.15 no.3
• /
• pp.177-185
• /
• 2012

Wave field measurements were made over a period of 18 days to study the spatial distribution of incident wave on seaweed tarm field around Gumil-up Sea, Wando, Korea. These measured data were compared with data from the Geomun-do ocean weather/wave observation buoy. A numerical simulation model that combined the offshore design wave with the seasonal normal incoming wave was used to study the incident wave distribution surrounding a seaweed farm. The results are summarized as follows. (1) On-site wave measurements showed that the major relationship between maximum and significant wave height was $H_{max}=1.6H_{1/3}$. (2) Offshore incident wave energy reaching the coast was greatly influenced by the wind direction. A north wind reduced the incident wave energy and a south wind increased it. (3) The calculated maximum wave height under the design wave boundany conditions was in the range of 4~5 m and the reduction in the incident wave height ratio ranged from approximately 38.1% to 47.6% at Gumil-up Sea. Under normal wave conditions, the maximum wave heights were 3.6~4.0 m in summer and 2.3~2.7 m in winter while the reduction in the incident wave height ratio was about 41.8% to 49.1%. (4) The sea state in the southern area of Gumil-up was the most affected by ocean waves, whereas the sea state in the northern area was very stable. The significant wave ratio in the south was about six times that in the north.

• Proceedings of the Korean Society of Medical Physics Conference
• /
• 2002.09a
• /
• pp.411-414
• /
• 2002

The CdTe semiconductor detector has a higher detection efficiency for x-rays and $\square$amma rays and a wider energy band gap compared with Si and Ge semiconductor detectors. Therefore, the size of the detector element can be made small, and can be operated at room temperature. The interaction between a CdTe detector and incident x-rays is mainly photoelectric absorption in the photon energy range of up to 100 keV. In this energy range, Compton effects are almost negligible. We have developed a 256 channel CdTe array detector system for monochromatic x-ray CT using synchrotron radiation. The CdTe array detector system, the element size of which is 1.98 mm (h) x 1.98 mm (w) x 0.5 mm (t), was operated in photon counting mode. In order to improve the spatial resolution, we tilted the CdTe array detector against the incident parallel monochromatic x-ray beam. The experiments were performed at the BL20B2 experimental hutch in SPring-8. The energy of incident monochromatic x-rays was set at 55 keV. Phantom measurements were performed at the detector angle of 0, 30 and 45 degrees against the incident parallel monochromatic x-rays. The linear attenuation coefficients were calculated from the reconstructed CT images. By increasing the detector angle, the spatial resolutions were improved. There was no significant difference between the linear attenuation coefficients which were corrected by the detector angle. It was found that this method was useful for improving the spatial resolution in a parallel monochromatic x-ray CT system.