• KIEE International Transactions on Electrophysics and Applications
• /
• 제4C권6호
• /
• pp.272-275
• /
• 2004

A balanced single side-band (SSB) mixer employing a sub-harmonic configuration is designed for up and down conversions in K-band. The designed mixer uses anti-parallel diode (APD) pairs to effectively eliminate even harmonics of the local oscillator (LO) spurious signal. To reduce the odd harmonics of LO at the RF port, we employ a balanced configuration for LO. The fabricated chip shows 12$\pm$2dB of conversion loss and image-rejection ratio of about 20dB for down conversion at RF frequencies of 24-27.5GHz. As an up-conversion mode, the designed chip shows 12dB of conversion loss and image-rejection ratio of 20 ～ 25 dB at RF frequencies of 25 to 27GHz. The odd harmonics of the LO are measured below -37dBc.

• ETRI Journal
• /
• 제30권2호
• /
• pp.344-346
• /
• 2008

In this paper, we present a novel oscillator (OSC) design. Bandpass filters, which can suppress harmonics, are incorporated into a co-design with an OSC to improve the OSC phase noise and harmonic rejection. The proposed OSC/bandpass filter co-design achieves a phase noise of -130.1 dBc/Hz/600 kHz and harmonic rejection of 37.94 dB and 40.85 dB for the second and third harmonics, respectively, as compared to results achieved by the OSC before co-design of -101.6 dBc/Hz/600 kHz and 21.28 dB and 19.68 dB. Good agreement between the measured and simulated results is achieved.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2003년도 하계종합학술대회 논문집 V
• /
• pp.2629-2632
• /
• 2003

This paper presents the harmonics rejection technique and the simulation of a active power filter using power operational amplifier. The proposed active power filter consists of CT(current transformer), harmonics detector and harmonics amplifier. The harmonics detector is a high pass filter using a GIC(Generalized Impedance Converter). The harmonics amplifier consists of a power operational amplifier and passive filters. The simulation has been implemented by OR-CAD program. It is examined whether the proposed active power filter can be realized or not through simple experiments.

• Journal of Power Electronics
• /
• 제17권6호
• /
• pp.1672-1682
• /
• 2017

For grid-connected LCL-filtered inverters, the inverter-side current can be used as the control object with one current sensor for both LCL resonance damping and over-current protection, while the grid-voltage feedforward or harmonic resonant compensator is used for suppressing low-order grid current harmonics. However, it was found that the grid current harmonics were high and often beyond the standard limitations with this control. The limitations of the inverter-side current control in suppressing low-order grid current harmonics are analyzed through inverter output impedance modeling. No matter which compensator is used, the maximum magnitudes of the inverter output impedance at lower frequencies are closely related to the LCL parameters and are decreased by increasing the control delay. Then, to improve the grid current quality without complicating the control or design, this study proposes designing the filter capacitance considering the current harmonic constraint and using a PWM mode with a short control delay. Test results have confirmed the limitation and verified the performance of the improved approaches.

• 대한전자공학회논문지TC
• /
• 제48권3호
• /
• pp.68-73
• /
• 2011

본 논문은 평행 결합 선로와 FLCLM(Frquency Locked Controlled Length Method)을 이용하여 저주파의 기생 신호 와 2차 고조파가 억압된 소형 협대역 개방형 스터브 대역통과 필터에 대하여 새롭게 제안 하였다. 평행 결합 선로의 특징은 저파주대역의 기생 신호와 2차 고조파를 억압 할 수가 있다. 최종 설계한 필터의 실험 결과에서 사용되는 대역의 중심 주파수는 5.8 GHz 이고 대역폭 10 % 이며 삽입 및 반사 손실은 각각 1.2 dB 및 14.8 dB 이다. 추가적으로 저주파 및 고조파 억제는 각각 28.9 dB 및 28.8 dB 이다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2020년도 전력전자학술대회
• /
• pp.393-394
• /
• 2020

In this paper, an improved rotor speed estimation in DFIG wind turbine systems based on a cascaded SOGI is proposed. Due to excellent harmonics and DC offset rejection capability of the cascaded SOGI, the accurate rotor speed estimation can be achieved despite the harmonics and sensing offset in DFIG currents. The simulation results have verified the validity of proposed method.

• 한국정보통신학회논문지
• /
• 제20권7호
• /
• pp.1237-1242
• /
• 2016

본 논문은 병렬 결합선로(coupled-line)와 부채꼴(radial) 개방형 스터브(stub)를 이용한 고조파가 억압된 저역통과 여파기에 대해 제안을 한다. 본 제안한 저역통과 여파기의 특징은 병렬 결합선로의 구조 때문에 고조파가 광대역으로 억압되었다는 결과를 얻을 수 있었다. 저역통과 여파기의 개방형 스터브는 부채꼴로 구성되어 있으며 이는 여파기의 크기를 조절 할 수 있다. 제안한 저역통과 여파기의 크기는 $6.98{\times}7.60mm2$이며 차단 주파수는 2.45 GHz 이다. 분포정수소자(distributed element)로 구성되어 있어 단가면에서 경제적이고 제작이 쉬우며 대량 생산이 가능한 이점이 있다. 또한 광대역 고조파 억압에 대한 대역폭은 128 %이며 여파기의 삽입 및 반사 손실은 각각 1.07 dB 및 19.5 dB를 얻었다.

• 조명전기설비학회논문지
• /
• 제29권12호
• /
• pp.83-87
• /
• 2015

This paper presents a simple notch filter, which is so suitable for three-phase unbalanced and distorted power line. In the d-q synchronous transformation, three-phase unbalanced and distorted voltages generate lots of ripple voltages on d-q axes. The ripples make disturbances on controllers such as PLL of phase tracking. Unbalanced state makes ripple of double the frequency of power line. Odd harmonics 5th and 7th on the line make even 4th and 6th ripples on d-q axes due to the rotating reference frame, respectively. Cascaded two comb filters, delay lines 1/4T and 1/8T, are adopted for the ripple rejection. The filter rejects harmonics 2nd, 4th, 6th, 10th and so on. They are very effective to remove the ripples of both unbalance and distortion. The filter, implemented by two FIFOs on an experimental system, is adopted on a PLL controller of power line phase tracking. Through the simulation and experimental results, performance of the proposed comb filter has been validated.

• 한국정보통신설비학회:학술대회논문집
• /
• 한국정보통신설비학회 2003년도 하계학술대회
• /
• pp.293-295
• /
• 2003

In this paper, planar harmonic rejection low-pass filter is proposed to effectively suppress spurious response in stop-band. For suppress the unwanted signal such as spurious and harmonics, we presented a new design method controlled the higher order modes. The proposed low-pass filter was shown to suppress the spurious response by more than $20{\sim}40dB$ compared with conventional microstrip low-pass filters. The filter is evaluated by experiment and simulation with good agreement and shown to have attractive properties such as wide stop band range and low insertion loss.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 영호남학술대회 논문집
• /
• pp.78-81
• /
• 2000

A new type low-pass filter design method based on a coupled line and transmission line theory is proposed to suppress harmonics by attenuation poles in the stop band The design formula are derived using the equivalent circuit of a coupled transmission line. The new low-pass filter structure is shown to have attractive properties such as compact size, wide stop band range and low insertion loss. The seventh-order low-pass filter designed by present method Ins a cutoff frequency of 0.9 GHz with a 0.01 dB ripple level. The coupled line type low-pass filter with stripline configuration was fabricated by using a high-temperature superconducting (HTS ; $YBa_2Cu_3O_{7-x}$) thin film on MgO(100) substrate. Since the HTS coupled line type low-pass filter was proposed with five attenuation poles in stop band such as 1.8, 2.5, 4, 5.5, 62 GHz. The fabricated low-pass filter has improved the attenuation characteristics up to seven times of the cutoff frequency Bemuse of good rejection of the spurious signals and harmonics, our low-pass filter is applicable to mobile base station systems such as cellular, personal communication systems and international mobile telecommunication(IMT)-2000 systems.