• Journal of the Korean Institute of Gas
• /
• v.20 no.6
• /
• pp.16-22
• /
• 2016

Coating pipe(PLP) has been generally used in buried site for protecting the corrosion. To prevent the damage by occurring the defect, other construction or execution works, an anti-oxidation environment was forcibly made by using protective potential. Coating and protective potential are applied simultaneously, but corrosion rate or defects are not easy to observe because soil composition has many uncertainty. Also, defect of coating pipe can not be directly observed. A corrosion coupon can easily measure a corrosion rate directly. The corrosion rate was measured with 6 scenarios using corrosion coupon during about 1 year(6 scenarios are based on soil type and protective potential or not in this research. Resultingly, the corrosion coupon has not occurred in the case of protected by potential current, but corrosion has occurred in a non-protected site. The corrosion rate was measured at least in the clay, and the propensity of corrosion rate was similar in other soil(sand and loams). The local corrosion has occurred in the clay because of high water content. On the other hand, general corrosion was occurred in sand and loams. Commonly, sand is not to corrosive soil. Although, corrosion occurred in sand can be estimated by chemical component and valid with chemical analysis report.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.58 no.1
• /
• pp.71-77
• /
• 2013

The world demand of renewable bioenergy as an alternative transportation fuel is greatly increasing. Research for bioethanol production is currently being progressed intensively throughout the world. Therefore it will be necessary to develop bioethanol production with cellulosic materials. In this study, the yield of ethanol production was evaluated by simultaneous saccharification and fermentation (SSF) using sodium hydroxide pretreated sorghum ${\times}$ sudangrass hybrids. Composition analysis of 11 varieties of sorghum ${\times}$ sudangrass hybrids was performed for selection of excellent variety to efficiently produce bioethanol. The content of cellulose, hemicellulose, lignin and ash of these varieties were 32~39%, 19~24%, 17~22% and 6~11%, respectively. Among these varieties, 4 varieties of sorghum ${\times}$ sudangrass hybrids were selected for the evaluation of ethanol yield and those were pretreated with 1 M NaOH solution at $150^{\circ}C$ for 30 min using high temperature explosion system. After pretreatment, samples were neutralized with tap water. It contained 52~57% of cellulose. Simultaneous saccharification and fermentation (SSF) was carried out for 48 h at $33^{\circ}C$ by Saccharomyces cerevisiae CHY1011 using Green star variety. The yield of ethanol was 92.4% and the amount of ethanol production was estimated at 6206 L/ha.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.8 no.3
• /
• pp.207-213
• /
• 2010

The effect of temperature on swelling pressure was observed with a Korean domestic Ca-bentonite which has been considered as a potential buffer material in the engineering barrier of a high level radioactive waste (HLW) disposal system. The Ca-bentonite was compacted to a dry density of 1.6 g/$cm^3$, and then de-ionized water was supplied into it with a constant pressure of 0.69 MPa. The equilibrium swelling pressures were measured with different temperatures of $25^{\circ}C$, $30^{\circ}C$, $40^{\circ}C$, $50^{\circ}C$, $60^{\circ}C$, $70^{\circ}C$, respectively. The Ca-bentonite showed a sufficiently high swelling pressure of 5.3 MPa at room temperatures. Then it was clearly showed that the equilibrium swelling pressure was decreased with an increase of temperature. Interestingly, there were some differences in temperature effect on the equilibrium swelling pressure when the environmental temperature is increasing or decreasing. For further clarifying the swelling behaviour of a Korea domestic Ca-bentonite, the change of a compaction level, and the composition variation of a supplied water would be needed to use in conceptual design of HLW disposal system.

• Journal of Integrative Natural Science
• /
• v.4 no.1
• /
• pp.38-43
• /
• 2011

The recent global warming may be estimated to give lots of impacts to the human society and biosphere of influencing climate change included by the natural climate variations through the human activity which can directly and/or indirectly play a major role of total atmospheric composition overall. Therefore it currently appears evidences such as hot wave, typhoon, and biosphere disturbance, etc. over the several regions to be influenced by global warming due to increasing the concentration of greenhouse gases in the atmosphere through inducing forest destruction, fossil fuel combustion, greenhouse gases emission, etc. since industrial revolution era. Through the working group report of IPCC (Intergovernmental Panel on Climate Change) for climate change was analyzed by the individual country's current status and figure out the important issues and problems related to the future trend of climate change science with advanced countries preparedness and research, In this study, the first working group report of IPCC focuses on those aspects of the current understanding of the physical science of climate change that are judged to be most relevant to policymakers. As this report was assessed and analyzed by including the progress of climate change science, the role of climate models and evolution in the treatment of uncertainties. This consists of the changes in atmospheric constituents(both aerosols and gases) that affect the radiative energy balance in the atmosphere and determine the Earth's climate, considering the interaction between biogeochemical cycles that affect atmospheric constituents and climate change, including aerosol/cloud interactions, the extensive range of observations snow available for the atmosphere and surface, for snow, ice, and frozen ground and for the oceans, respectively and changes in sea level, the paleoclimate perspective and assessment of evidence for past climate change and the extension, the ways in which physical processes are simulated in climate models and the evaluation of models against observed climate, the development plans and methods of improving expert and building manpower urgently and R&D fund expansion in detail for climate change science in Korea will be proposed.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.2
• /
• pp.443-450
• /
• 2019

We studied to find the optimal manufacturing conditions of coffee grounds sludge RDF with oil drying method. We expanded the lab scale to pilot scale to compare the efficiency of the oil-drying equipment and The selection of the ratio of coffee grounds and oil, the setting temperature, and the temperature change and water content with time were measured. In order to analyze the characteristics of the research results, characteristics of solid fuels produced(Coffee grounds of oil-dried) by calorimeter, TGA, combustion equipment, and combustion gas measuring instrument were analyzed. As a result, the ratio of oil to coffee grounds was 4: 1, and when the setting temperature was set to $300^{\circ}C$, the water content reached 10wt.% or less within 20 minutes. ln addition, it showed high calorific value of 6,273kcal/kg. However, coffee grounds had a similar composition to wood and showed high luminance and produced a lot of CO in combustion gas. As a result, it is considered to be unsuitable for thermoelectric power plant and camping fuel, but the initial ignition speed is high and the heat generation is high, so it is considered that it can replace the fuels for current use.

• Journal of Climate Change Research
• /
• v.3 no.3
• /
• pp.195-209
• /
• 2012

There are four differentiated levels to quantify the amount of greenhouse gas emissions from a facility, which are Tier 1 to 4 based on the IPCC guidelines. In this study, the emission estimates from all tier levels were calculated to compare their total $CO_2$ emission results among themselves for seven facilities, including three sectors of electricity generation, municipal solid waste incineration, and cement manufacturing for three months between February and May 2011. Generally the measured $CO_2$ emissions by Tier 4 were higher than the calculated $CO_2$ emissions by Tier 3, which had been also observed for the power plants in the USA. It was found out that to obtain more reliable estimation for Tier 3, accurate analysis of the composition of the fuel used should be carried out. It was suggested that further refinement on the administrative guidelines be made to make it more robust.

• Journal of the Korean Applied Science and Technology
• /
• v.36 no.1
• /
• pp.165-173
• /
• 2019

Hydrazine[$N_2H_4$] is a typical propellant for a rocket fuel in the field of aerospace. Since it is very toxic and harmful to the environment, various environmentally-friendly propellants have been developed. In this study, relatively a safe propellant, hydroxylammonium nitrate[$NH_3OHNO_3$], was prepared via a neutralization reaction of hydroxylamine[$NH_2OH$] and nitric acid[$HNO_3$]. FT-IR was used to analyze the chemical composition, chemical structure and functional groups of HAN. Thermogravimetric analysis showed the decomposition temperature of HAN. Ion chromatography was also used to evaluate the content of nitrate ions. It was proved that the peaks of FT-IR at $3161cm^{-1}$ and $1324cm^{-1}$ indicates the functionalities of N-H and N-O present in HAN. The decomposition temperature of HAN synthesized at pH 5 to 7 was $120-140^{\circ}C$, and pH 8 resulted in higher decomposition temperature than $140^{\circ}C$. Meanwhile, the sample obtained from pH 6-7 showed the concentration of nitric acid ion with 70%.

• Journal of Life Science
• /
• v.31 no.5
• /
• pp.520-526
• /
• 2021

Microbial protein is one of the sources of protein in the rumen and can also be the source of glutamate production. Glutamic acid is used as fuel in the metabolic reaction in the body and the synthesis of all proteins for muscle and other cell components, and it is essential for proper immune function. Moreover, it is used as a surfactant, buffer, chelating agent, flavor enhancer, and culture medium, as well as in agriculture for such things as growth supplements. Glutamic acid is a substrate in the bioproduction of gamma-aminobutyric acid (GABA). This review provides insights into the role of glutamic acid and glutamic acid-producing microorganisms that contain the glutamate decarboxylase gene. These glutamic acid-producing microorganisms could be used in producing GABA, which has been known to regulate body temperature, increase DM intake and milk production, and improve milk composition. Most of these glutamic acid and GABA-producing microorganisms are lactic acid-producing bacteria (LAB), such as the Lactococcus, Lactobacillus, Enterococcus, and Streptococcus species. Through GABA synthesis, succinate can be produced. With the help of succinate dehydrogenase, propionate, and other metabolites can be produced from succinate. Furthermore, clostridia, such as Clostridium tetanomorphum and anaerobic micrococci, ferment glutamate and form acetate and butyrate during fermentation. Propionate and other metabolites can provide energy through conversion to blood glucose in the liver that is needed for the mammary system to produce lactose and live weight gain. Hence, health status and growth rates in ruminants can be improved through the use of these glutamic acid and/or GABA-producing microorganisms.

• Journal of Environmental Science International
• /
• v.33 no.9
• /
• pp.633-643
• /
• 2024

Hereunder, the eco-friendly photocatalytic CO₂ transformation capability of Cu-deposited black TiO₂ (Cu/BTiO₂) was evaluated to investigate if this photocatalyst proceeds the thermodynamically- and kinetically-satisfactory CO₂ transformation into CH₄. The clustered Cu-deposited BTiO₂ (Cu/BTiO₂) and Cu/BTiO₂ architectures revealed noticeable photocatalytic CO₂ transformation abilities, whereas the pristine TiO₂ and BTiO₂ catalysts displayed no significant photocatalytic CO₂ transformation abilities. Especially, the photocatalytic CO₂ transformation rates of a representative Cu/BTiO₂ architecture were 104, 209, 272, 322, and 361 μmol/g at the irradiation times of 2, 4, 6, 8, and 10 h, respectively, while the photocatalytic CO₂ transformation rates of Cu/BTiO₂ were 61, 139, 217, 270, and 309 μmol/g at the same irradiation times, respectively. The promoted photocatalytic CO₂ transformation ability of the Cu/BTiO₂ architecture was assigned to the excellent electron-hole separation tendency, which was verified by the photoluminescence analysis. The composition ratio of Cu incorporated into BTiO₂ in the Cu/BTiO₂ architectures was crucial in CH₄ generation. In addition, the Cu/BTiO₂ architecture displayed eminent photodurability, which was verified by the consecutive experiment cycle, and the mechanistic process for CO₂ transformation into CH₄ via the Cu/BTiO₂ architecture was established. The electronic framework of the Cu/BTiO₂ architecture was established on the basis of its band gap and valence band value. Conclusively, the Cu/BTiO₂ architecture is an outstanding tool for thermodynamically- and kinetically-satisfactory photocatalytic CO₂ transformation into CH₄ that application under simulated sunlight irradiation.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.7 no.1
• /
• pp.1-7
• /
• 2009

This study has been focused on determining the chemical composition of $^{14}C$ - in terms of both organic and inorganic $^{14}C$ contents - in reactor coolant from 3 different PWR's reactor type. The purpose was to evaluate the characteristic of $^{14}C$ that can serve as a basis for reliable estimation of the environmental release at domestic PWR sites. $^{14}C$ is the most important nuclide in the inventory, since it contributes one of the main dose contributors in future release scenarios. The reason for this is its high mobility in the environment, biological availability and long half-life(5730yr). More recent studies - where a more detailed investigation of organic $^{14}C$ species believed to be formed in the coolant under reducing conditions have been made - show that the organic compounds not only are limited to hydrocarbons and CO. Possible organic compounds formed including formaldehyde, formic acid and acetic acid, etc. Under oxidizing conditions shows the oxidized carbon forms, possibly mainly carbon dioxide and bicarbonate forms. Measurements of organic and inorganic $^{14}C$ in various water systems were also performed. The $^{14}C$ inventory in the reactor water was found to be 3.1 GBq/kg in PWR of which less than 10% was in inorganic form. Generally, the $^{14}C$ activity in the water was divided equally between the gas- and water- phase. Even though organic $^{14}C$ compound shows that dominant species during the reactor operation, But during the releasing of $^{14}C$ from the plant stack, chemical forms of $^{14}C$ shows the different composition due to the operation conditions such as temperature, pH, volume control tank venting and shut down chemistry.