• Proceedings of the Korea Institute of Applied Superconductivity and Cryogenics Conference
• /
• 2003.10a
• /
• pp.127-130
• /
• 2003

An RSFQ (Rapid Single Flux Quantum) counter can be used as a frequency divider that was an essential part of a programmable voltage standard chip. The voltage standard chip is composed of two circuit parts, a counter and an antenna Analog signal of tens to hundreds ㎓ may be applied to a finline antenna part. This analog signal can be converted to the stream of SFQ voltage pulses by a DC/SFQ circuit. The number of voltage pulses can be reduced by 2n times when they pass through a counter that is composed of n T Flip-Flops (Toggle Flip-Flop). Such a counter can be used not only as a frequency divider, but also to build a programmable voltage standard chip. So, its application range can be telecommunication, high speed RAM, microprocessor, etc. In this work, we have used Xic, WRspice, and L-meter to design an RSFQ counter. After circuit optimization, we could obtain the bias current margins of the T Flip-Flop circuit to be above 31％ Our RSFQ counter circuit designs were based on the 1 ㎄/$\textrm{cm}^2$ niobium trilayer technology.

• Journal of the Semiconductor & Display Technology
• /
• v.10 no.3
• /
• pp.29-33
• /
• 2011

Film growth rate and composition variation are numerically analyzed during the selective area growth of InGaN on the GaN triangular stripe microfacet in this study. Both the vapor phase diffusion and the surface diffusion are considered to determine the In composition on the InGaN surface. To obtain the In composition on the surface, flux of In atoms due to the surface diffusion is added to the concentration determined from the Laplace equation which is governing the gas phase diffusion. The solution model is validated by comparing the growth rates from the analyses to the experimental results of GaN and InN films. The In composition and resulting wave length are increased when the surface diffusion is considered. The In content is also increased according to the increasing mask width. The effect of mask width to the In content and wave length is increasing in the case of a small open region.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.26 no.1
• /
• pp.45-50
• /
• 1981

Diurnal changes in leaf stomatal resistances were measured on leaf positions and both surfaces to investigate the stomatal response to irradiance in wheat, var. Chokwang and barley, var. Dongbori 1. Stomatal frequency and size were also determined to explain the control mechanism of gas exchanges in two species. The leaf diffusive resistances of two species decreased, as the sun rose, to minimum at 10 to 11 o'clock a.m. and increased gradually in the afternoon, even faster at sunset. As the adaxial irradiance increased, stomatal resistances decreased sensitively in the range of 30uEm$^{-2}$ㆍsec$^{-1}$ to 150uEm$^{-2}$ㆍsec$^{-1}$ quantum flux density. The stomatal opening of the abaxial surface began at lower irradiance and was completed earlier than the adaxial surface. The adaxial irradiances decreased in order of leaf position, flag, the 2nd, the 3rd leaf, and the stomatal resistances increased in the same order. Even under the same irradiance, the stomatal resistance of lower leaves were higher than those of upper leaves. The stomatal frequencies of lower leaves were less, but the stomatal size was greater than those of upper leaves. Consequently, the relative leaf area occupied by stomatal pores were constant among leaf positions in two species.

• Nuclear Engineering and Technology
• /
• v.37 no.1
• /
• pp.25-78
• /
• 2005

As a key and core knowledge for the design of various types of nuclear reactors, the discipline of reactor physics has been advanced continually in the past six decades and has led to a very sophisticated fabric of analysis methods and computer codes in use today. Notwithstanding, the discipline faces interesting challenges from next-generation nuclear reactors and innovative new fuel designs in the coming. After presenting a brief overview of important tasks and steps involved in the nuclear design and analysis of a reactor, this article focuses on the currently-used design and analysis methods, issues and limitations, and current activities to resolve them as follows: (1) Derivation of the multi group transport equations and the multi group diffusion equations, with representative solution methods thereof. (2) Elements of modem (now almost three decades old) diffusion nodal methods. (3) Limitations of nodal methods such as transverse integration, flux reconstruction, and analysis of UO2-MOX mixed cores. Homogenization and related issues. (4) Description of the analytic function expansion nodal (AFEN) method. (5) Ongoing efforts for three-dimensional whole-core heterogeneous transport calculations and acceleration methods. (6) Elements of spatial kinetics calculation methods and coupled neutronics and thermal-hydraulics transient analysis. (7) Identification of future research and development areas in advanced reactors and Generation-IV reactors, in particular, in very high temperature gas reactor (VHTR) cores.

• Nuclear Engineering and Technology
• /
• v.56 no.3
• /
• pp.1002-1012
• /
• 2024

To remove insoluble fission products, which could possibly cause reactor instability and significantly reduce heat transfer efficiency from primary system of molten salt reactor, a helium bubbling method is employed into a passive molten salt fast reactor. In this regard, two-phase flow behavior of molten salt and helium bubbles was investigated experimentally because the helium bubbles highly affect the circulation performance of working fluid owing to an additional drag force. As the helium flow rate is controlled, the change of key thermal-hydraulic parameters was analyzed through a two-phase experiment. Simultaneously, to assess the applicability of numerical model for the analysis of two-phase flow behavior, the numerical calculation was performed using the OpenFOAM 9.0 code. The accuracy of the numerical analysis code was evaluated by comparing it with the experimental data. Generally, numerical results showed a good agreement with the experiment. However, at the high helium injection rates, the prediction capability for void fraction of helium bubbles was relatively low. This study suggests that the multiphaseEulerFoam solver in OpenFOAM code is effective for predicting the helium bubbling but there exists a room for further improvement by incorporating the appropriate drag flux model and the population balance equation.

• Journal of Bio-Environment Control
• /
• v.27 no.3
• /
• pp.231-238
• /
• 2018

Chlorophyll fluorescence, chlorophyll content, graft-taking and growth of grafted cucumber seedlings as affected by photosynthetic photon flux (PPF) of LED lamps were analyzed in this study. Four PPF levels, namely 25, 50, 100, $150{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ were provided to investigate the effect of light intensity on the chlorophyll fluorescence, chlorophyll content, graft-taking and growth of grafted cucumber seedlings. Air temperature, relative humidity, and photoperiod for graft-taking were maintained at $25^{\circ}C$, 90%, $16h{\cdot}d^{-1}$, respectively. Maximum quantum yield (Fv/Fm) of rootstock as affected by PPF was found to be 0.84-0.85 and there was no significant change in Fv/Fm. Even though Fv/Fm of scion measured at 2 days after grafting was lowered to 0.81-0.82, after then it gradually increased with increasing PPF. At 4 days after grafting, the chlorophyll content extracted from scion increased with increasing PPF. Graft-taking ratio of grafted cucumber seedlings was 90-95% as PPF was ranged from $25{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ to $100{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$. However, the graft-taking ratio of grafted seedlings healed under PPF of $150{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ was decreased to 80%. Maximum PPF measured required for smooth joining of rootstock and scion was assumed to be $100{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$. At healing stage of grafted cucumber seedlings, Fv/Fm of scion decreased and at least two days after grafting were required for rooting of grafted seedlings. Chlorophyll fluorescence response of rootstock and scion was linked to light irradiation. Therefore, it was concluded that physical environment including light and humidity during healing process of grafted seedlings should be controlled more precisely to facilitate root formation and to prevent scion from lowering Fv/Fm. Further studies are required to investigate the effects of root development and joining of vascular bundles of grafted seedlings on the chlorophyll content of scion.

• Journal of the Korean Vacuum Society
• /
• v.22 no.2
• /
• pp.86-91
• /
• 2013

The optical properties of InAs quantum dots (QDs) grown on GaAs substrates grown by molecular beam epitaxy have been studied using photoluminescence (PL) and time-resolved PL measurements. InAs QDs were grown using an arsenic interruption growth (AIG) technique, in which the As flux was periodically interrupted by a closed As shutter during InAs QDs growth. In this study, the shutter of As source was periodically opened and closed for 1 (S1), 2 (S2), or 3 s (S3). For comparison, an InAs QD sample (S0) without As interruption was grown in a pure GaAs matrix for 20 s. The PL intensity of InAs QD samples grown by AIG technique is stronger than that of the reference sample (S0). While the PL peaks of S1 and S2 are redshifted compared to that of S0, the PL peak of S3 is blueshifted from that of S0. The increase of the PL intensity for the InAs QDs grown by AIG technique can be explained by the reduced InAs clusters, the increased QD density, the improved QD uniformity, and the improved aspect ratio (height/length). The redshift (blueshift) of the PL peak for S1 (S3) compared with that for S0 is attributed to the increase (decrease) in the QD average length compared to the average length of S0. The PL intensity, PL peak position, and PL decay time have been investigated as functions of temperature and emission wavelength. S2 shows no InAs clusters, the increased InAs QD density, the improved QD uniformity, and the improved QD aspect ratio. S2 also shows the strongest PL intensity and the longest PL decay time. These results indicate that the size (shape), density, and uniformity of InAs QDs can be controlled by using AIG technique. Therefore the emission wavelength and luminescence properties of InAs/GaAs QDs can also be controlled.

• Journal of Astronomy and Space Sciences
• /
• v.25 no.4
• /
• pp.435-444
• /
• 2008

High energy charged particles are trapped by geomagnetic field in the region named Van Allen Belt. These particles can move to low altitude along magnetic field and threaten even low altitude spacecraft. Space Radiation can cause equipment failures and on occasions can even destroy operations of satellites in orbit. Sun sensors aboard Science and Technology Satellite (STSAT-l) was designed to detect sun light with silicon solar cells which performance was degraded during satellite operation. In this study, we try to identify which particle contribute to the solar cell degradation with ground based radiation facilities. We measured the short circuit current after bombarding electrons and protons on the solar cells same as STSAT-1 sun sensors. Also we estimated particle flux on the STSAT-l orbit with analyzing NOAA POES particle data. Our result clearly shows STSAT-l solar cell degradation was caused by energetic protons which energy is about 700keV to 1.5MeV. Our result can be applied to estimate solar cell conditions of other satellites.

• Korean Journal of Environmental Agriculture
• /
• v.3 no.1
• /
• pp.63-70
• /
• 1984

The terrestrial UV flux rapidly increased in late spring, as measured by the chemical actinometry at two elevations (near sea level and 1,100m above sea level) on Jeju Island. More intense UV fluxes were observed at higher altitudes. Any harmful effects of solar UV-B on the growth of soybean were not detected in UV-B-exclusion experiment. To ascertain the effect of UV radiation on vegetative growth, intact (㏖ wt 124000) and large (${\sim}120000$) phytochromes were irradiated with UV-B radiation. In intact phytochrome, the Pfr form accounts for 60% of the total phytochrome under stationary state conditions, whereas it accounts for 50% in large phytochrome. Calculated quantum yields for the forward and the backward phototransformations of phytochrome by UV were ${\phi}r=0.016$ and ${\phi}fr=0.010$ in intact phytochrome, and ${\phi}r={\phi}fr=0.012$ in large phytochrome, respectively.

• Food Science and Preservation
• /
• v.22 no.6
• /
• pp.804-810
• /
• 2015

Salvia miltiorrhiza has been used for treating heart and liver disease. In the present study, the influences of temperature on photosynthetical capacity of S. miltiorrhiza under controlled cultivation environment using growth chamber were investigated because of providing information about growth and secondary metabolite synthesis. And effect of harvesting time on growth properties and constituents such as salvianolic acid B, cryptotanshinone, tanshinone I, tanshinone IIA were evaluated. Maximum photosynthesis rate ($5.102{\mu}mol\;CO2/m2/s$) and net apparent quantum yield ($0.147{\mu}mol\;CO2/m2/s$), stomatal conductance (0.035 mmol/m2/s) and water use efficiency ($7.108{\mu}mol\;CO2/mmol\;H2O$) was highest at $20^{\circ}C$. Results of chlorophyll fluorescence showed that elevated temperature had contributed to reduce a quantum yield and electron flux in photosystem. This result demonstrated that favorable temperature condition was determined at $20^{\circ}C$. Contents of salvianolic acid B, cryptotanshinone, tanshinone I and tanshinone IIA was highest in root sample harvested at 20 March, whereas growth and yield of S. miltiorrhiza had no significant differences with harvesting time. Therefore, this study shows that temperature play an important role in photosynthetic activity and harvesting time have influence upon accumulation of constituents in root of S. miltiorrhiza.