• 한국수소및신에너지학회논문집
• /
• 제17권1호
• /
• pp.39-46
• /
• 2006

Highly ordered Li dispersed nickel oxide nanotubes were prepared with anodic aluminum oxide (AAO) template for hydrogen storage. Electron microscope results showed that uniform length and diameter of nickel oxide nanotubes were obtained. The wall thickness and outer diameter of nickel oxide nanotubes are about 40 - 50 nm and 200 - 400 nm, respectively. It was observed that the diameter of nickel oxide nanotubes is bigger than the pore diameter of AAO template. Li dispersed nickel oxide were consisted of nanoflakes and had structures of nanotubes and nanorods. For increasing the hydrogen adsorption and desorption capacity, the Li dispersed nickel oxide nanotubes were fluorinated. The fluorinated Li dispersed nickel oxide nanotubes showed 1.65 wt% of the hydrogen adsorption capacities at 77 K under 47 atm.

• Membrane and Water Treatment
• /
• 제2권1호
• /
• pp.39-49
• /
• 2011

We investigated about the utilization improvement of the PDMS and fluoropolymers by mutual application in environmental analysis. We were conducted the direct fluorination with mild condition on the PDMS films and analyzed its surfaces before and after fluorination. The results of FTIR and SEM analysis on the PDMS films showed that the film surfaces were fluorinated without irreversible deformation by the fluorination. During the fluorination, the measured contact angles of water and several alcohols on the PDMS films decreased with time and that of most alcohols decreased to 0 after 30 minutes. The surface energy of fluorinated PDMS films has increased by 2 times. Also, we investigated the influence factors on the change of permeation rate of water through PDMS tubes with time. It was observed that the change of permeation rate of water through PDMS tube was affected by temperature, water phase and spatial distribution of water. From these results, we could verify the principal causes of the decrease of permeation rate of water through PDMS tube with time and proposed a new experimental setup for reducing the variation of permeation rate of water less than 2%.

• 한국진공학회지
• /
• 제20권4호
• /
• pp.276-279
• /
• 2011

약밀려남/잡아당김/급냉각의 연속적인 압출 공정을 이용하여 대면적 불화 고분자 막을 제작하였다. 제안한 방법으로 형성된 불화 고분자 박막은 $C_i=2.9\;nF/cm^2$의 전기용량밀도가 측정되었고, 1kHz에서의 ${\varepsilon}_r$=56의 높은 유전상수를 나타내었다. $1.5406{\AA}$의 파장에서 Bruker AXS X-ray 회절분석기를 통해 $18.0^{\circ}$에서 최고점을 나타내어 전기변형 성능에 적합한 ${\beta}$ 상태를 확인하였다. 본 연구는 넓은 면적의 인공근육에 응용 가능한 전기변형 불화고분자막의 새로운 박막 형성 기술로 이용될 수 있다.

• Journal of Korean Vacuum Science & Technology
• /
• 제7권2호
• /
• pp.33-38
• /
• 2003

Fluorinated amorphous carbon thin films (a-C:F) for the use of low dielectric constant intermetallic layer dielectrics are deposited by plasma enhanced chemical vapor deposition with $C_4$F$_{8}$ and Si$_2$H$_{6}$/He gas mixture as precursors. To characterize and improve film properties, we changed various conditions such as deposition temperature, and RF power, and we measured the thickness and refractive indexes and FT-IR spectrum before and after annealing. At low temperatures the film properties were very poor although the growth rate was very high. On the other hand, the growth rate was low at high temperature. The growth rate increased in accordance with the deposition pressure. The dielectric constants of samples were in the range of 1.5∼5.5∼5.

• 폴리머
• /
• 제29권4호
• /
• pp.380-384
• /
• 2005

Sodium montmoillonite 혹은 sodium montmorillonite가 삽입된 macromer의 존재 하에서 fluoroalkyl methacrylate와 아크릴산을 라디칼 공중합하여 불소화 아크릴계 이온성 고분자/sodium montmorillonite 복합재료를 제조하고, 이들의 X-선 회절 특성, 인장물성, 수분흡수율 등 물리적 성질을 조사하였다. 또, 이들을 이용하여 이온성 고분자-백금 복합재료(IPMC)를 제조하여 수 볼트의 외부 전위에 의한 전류 흐름 및 변위 거동을 측정한 결과, sodium montmorillonite가 이온의 이동을 방해하여 전류 및 변위량의 감소를 초래함을 관찰하였다.

• 센서학회지
• /
• 제13권3호
• /
• pp.182-187
• /
• 2004

The fluorinated amorphous carbon thin films (a-C:F) were deposited by PECVD(plasma enhanced chemical vapor deposition). The precursors were $C_{4}F_{8}$ which had a similar ratio of target film's carbon to fluorine ratio, and $Si_{2}H_{6}$/He for capturing excessive fluorine ion. We varied deposition condition of temperature and working pressure to survey the effect of each changes. We measured dielectric constant, composition, and etc. At low temperature the film adhesion to substrate was very poor although the growth rate was very high, the growth rate was very low at high temperature. The EDS(energy dispersive spectroscopy) result showed carbon and fluorine peak for films and Si peak for substrate. There was no oxygen peak.

• 대한화학회지
• /
• 제8권4호
• /
• pp.135-141
• /
• 1964

아밀아이오다이드를 디메칠홀움아마이드 存在下에서 弗化加里와 低溫反應시켜 본 結果 弗化物과 데칸을 生成하였음. ${\alpha}$, ${\beta}$-디크로로-${\beta}$-페닐-푸로피온酸과 같은 多鹽素化物은 ${\alpha}$-크로로스타이렌, 弗化스타이렌 及 弗化酸을 生成하였음. 이 酸의 에칠에스텔은 弗化物을 生成하지 않고 各種 쌍合物의 混合物을 얻었음. 디부롬스타이렌은 부롬스타이렌과 弗化物을 生成하고 沃度를 含有한 有機酸, 메-타요드벤젠익酸은 有機酸의 鹽과 微量의 쌍合物을 生成하였음. 메타요드토류엔 及 1-아미노-4-요-드-2-메칠벤젠과 같은 沃化物은 弗化物은 弗化加里에 對하여 反應을 나타내지 않었음. 本報에는 各 反應條件과 弗化反應, 脫炭酸反應 及 쌍合反應에 關하여 論義하였음.

• Transactions on Electrical and Electronic Materials
• /
• 제8권4호
• /
• pp.174-177
• /
• 2007

We fabricated organic field-effect transistors (OFETs) based a fluorinated copper phthalocyanine ($F_{16}CuPC$) and copper phthalocyanine (CuPc) as an active layer. And we observed the surface morphology of the $F_{16}CuPC$ thin film. The $F_{16}CuPC$ thin film thickness was 40 nm, and the channel length was $50{\mu}m$, channel width was 3 mm. And we also fabricated the $F_{16}CuPc/CuPc$ double layer FET and with different $F_{16}CuPc$ film thickness devices. We observed the typical current-voltage (I-V) characteristics and capacitance-voltage (C-V) in $F_{16}CuPc$ FET and we calculated the effective mobility. From the double layer FET devices, we observed the higher drain current more than single layer FET devices.

• Bulletin of the Korean Chemical Society
• /
• 제34권2호
• /
• pp.615-621
• /
• 2013

Solvolyses of isobutyl chloroformate (4) in 43 binary solvent mixtures including highly aqueous media, water, $D_2O$, $CH_3OD$, 2,2,2-trifluoroethanol (TFE) as well as aqueous 1,1,1,3,3,3-hexafluoro-isopropanol (HFIP) solvents were performed at $45^{\circ}C$, in order to further investigate the recent results of D'Souza, M. $J^1$. et al.; solvolyses of 4 are found to be consistent with the proposed mechanism ($Ad_E$). The variety of solvent systems was extended to comprise highly ionizing power solvent media ($Y_{Cl}$ > 2.7 excepted for aqueous fluorinated solvents and pure TFE solvent) to investigate whether a mechanistic change occurs as solvent compositions are varied. However, in case of 18-solvent ranges having aqueous fluorinated solvent systems (TFE-$H_2O$ and HFIP-$H_2O$) and/or having $Y_{Cl}$ > 2.7 solvent systems, the solvent effect on reactivity for those of 4 are evaluated by the multiple regression analysis as competition with $S_N2$ - type mechanism. And in pure TFE and 97 w/w % HFIP solvents with high $Y_{Cl}$ and weak $N_T$, these solvolyses are understood as reactions which proceed through an ionization ($S_N1$) pathway.

• 대한방사성의약품학회지
• /
• 제1권2호
• /
• pp.80-87
• /
• 2015

Carbon-fluorine (C-F) bonds have been found ubiquitously in pharmaceuticals, radiopharmaceuticals, agrochemicals, and material science due to their unique properties such as thermal and oxidative stability and lipophilicity to improve bioavailability. For the past five years, there have been significant advances in F-18 fluorination of aromatic complex molecules combined with the development of late-stage fluorination reactions. More recently, direct incorporation of F-18 to fluorinated aromatic molecules via borylation of C-F bonds has been developed by Niwa and Hosoya. In this minireview, we will discuss the progress of C-F bondborylation of fluorinated arenes utilizing transition metal catalysts and the impact on the development of F-18 radiotracers for positron emission tomography (PET).