• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.12
• /
• pp.5347-5360
• /
• 2016

In decode and forward relay systems, choosing the duplex mode is an important factor to the performance. To satisfy the performance requirement, self-interference must be mitigated for the full-duplex relay (FDR), and the resource efficiency must be increased for the half-duplex ratio (HDR). Therefore, if a wise scheme to consider these two factors exists, decode and forward relay systems are used more effectively. This study proposes a new duplex selection scheme for decode and forward relay systems. The proposed duplex selection scheme chooses the better duplex mode according to the channel statistical conditions with optimal power allocation. The simulation results show that the proposed duplex scheme with optimal power allocation has lower outage probability than the FDR and the HDR.

• Food Science of Animal Resources
• /
• v.29 no.5
• /
• pp.647-652
• /
• 2009

A duplex PCR technique was applied for specific identification of cow and goat milk in milk products by using primers targeting the mitochondrial 12S rRNA gene. Duplex PCR using primers specific for cow and goat generated specific fragments of 223bp and 326bp from cow and goat milk DNA, respectively. Duplex PCR was applied to 15 milk products purchased from the market to verify label statements. The labeling statements of four market milk products, three yoghurt products, and one whole milk powder product were confirmed in the duplex PCR. The labeling statements of five of seven infant milk powder products were also confirmed by duplex PCR but the other two products were shown to be contaminated with either cow or goat milk. The proposed duplex PCR provides a rapid and sensitive approach to detection of as little as 0.1% cow milk in goat milk and one-step detection of cow or goat milk in milk products.

• Journal of information and communication convergence engineering
• /
• v.9 no.6
• /
• pp.647-651
• /
• 2011

In this letter, non-regenerative Amplify-and-Forward (AF) relay systems based on half and full duplex schemes are investigated and their performance is analyzed and compared in terms of outage probability. Although the AF relay systems have been widely investigated in many previous literatures, most of them adopted a half duplex scheme due to hardware limitation and mathematical tractability. To the best of our knowledge, this letter is the first study to investigate the performance of the full duplex AF relay system considering practical hardware limitations. In full duplex AF relay systems, it is important to secure the isolation between transmit and receive antennas. Our numerical and simulation results show that there exists a threshold point of the isolation gain that the full duplex relay system outperforms the half duplex relay system.

• Journal of Ocean Engineering and Technology
• /
• v.17 no.2
• /
• pp.40-46
• /
• 2003

The corrosion resistance of super duplex stainless steel on both its fibrous and dispersed phase was investigated. These structures consist of various volume fraction and distribution of austenite structure, which were obtained by changing the heat treatment temperature and cycle. The fibrous phase had higher austenite volume fraction than that of the dispersed phase at the same temperature. Corrosion resistance of super duplex stainless steel was evaluated through an immersion test and an impingement test, using 35% HCI and sea water, respectively. Super duplex stainless steel was compared with STS316L and STS304. The corrosion resistance of super duplex stainless steel was superior to ST316L and STS304. The dispersed phase of super duplex stainless steel was more stabilized than the fibrous phase in corrosion. The magnitude of corrosion rate was in order STS304, STS316L, fibrous phase of super duplex stainless steel and dispersed phase of super duplex stainless steel.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.7
• /
• pp.1286-1292
• /
• 2015

In this paper, a multi-input multi-output (MIMO) full-duplex system is addressed, where both the transmitter and receiver have multiple antennas. Fundamental problems of the MIMO full-duplex technique are discussed, and possible solutions are presented. In particular, the transceiver designs that have been reported in the literature are technically reviewed, and their problems are discussed investigating the feasibility of the full-duplex technique in commercialized systems such as LTE and WiFi.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.481-484
• /
• 2009

In this paper, we suggest a precoding algorithm for full-duplex relay with multiple antennas. Because full-duplex relay performs transmission and reception at the same time in the same frequency band another existing half-duplex relay differently, self interference arise between transmit and receive antennas of relay. The proposed precoding algorithm eliminates self interference by block diagonalization algorithm and makes the relay perform full-duplex operation. Also we verify that full-duplex relay have improved channel capacity than existing half-duplex relay by computer simulation.

• KIISE Transactions on Computing Practices
• /
• v.22 no.8
• /
• pp.381-386
• /
• 2016

Recently full-duplex communication in wireless networks is enabled by the advancement of self-interference cancellation technology. Full-duplex radio is a promising technology for next-generation wireless local area networks (WLAN) because it can simultaneously transmit and receive signals within the same frequency band. Since legacy medium access control (MAC) protocols are designed based on half-duplex communication, they are not suitable for full-duplex communication. In this paper, we discuss considerations of full-duplex communication and propose a novel full-duplex MAC protocol. We conducted a simulation to measure the throughput of our MAC protocol. Through the simulation results, we can verify that significant throughput gains of the proposed full-duplex MAC protocol, thus comparing the basic full-duplex MAC protocol.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.7
• /
• pp.1276-1285
• /
• 2015

Full-duplex communications have emerged as a key technology for next-generation wireless local area networks (WLANs). Although the key enabling technology for full-duplex communications is the self-interference cancellation (SIC) technique in the physical layer, the employment of full-duplex communications has huge potentials to substantially increase the throughput at the medium access control (MAC) layer. At the same time, full-duplex communications pose non-trivial challenges to the MAC protocol design. In this article, we first identify salient problems in supporting full-duplex communications in WLAN MAC protocols. After that, we survey the state-of-the art to address those problems and analyze their pros and cons. Finally, we present open research challenges to improve the effectiveness of full-duplex communications in WLANs.

• Economic and Environmental Geology
• /
• v.52 no.5
• /
• pp.395-407
• /
• 2019

The duplex system has been considered as an important slip-transfer mechanism to evaluate the evolution of orogenic belts. Duplexes are generally found in the hinterland portion of fold-thrust belts and accommodate large amounts of total shortening. Thus, understanding its geometric and kinematic evolution can give information to evaluate the evolution of the entire orogenic belt. Duplexes are recognized as closed-loop thrust traces on map view, indicating higher connectivity than imbricate fans. As originally defined, a duplex is an array of thrust horses which are surrounded by thrust faults including the floor and roof thrusts, and imbricate faults between them. Duplexes can accommodate regional layer-parallel shortening and transfer slip from a floor thrust to a roof thrust. However, an imbricate fault is not the only mean for layer-parallel shortening (LPS) and displacement transfer within duplexes. LPS cleavages and detachment folds can also play the same role. From this aspect, a duplex can be divided into three types; 1) fault duplex, 2) cleavage duplex and 3) fold duplex. Fault duplex can further be subdivided into the Boyer-type duplex, which was firstly designed duplex system in the 1980s that widely applied most of the major fold-thrust belts in the world, and connecting splay duplex, which has different time order in the emplacement of horses from those of the Boyer-type. On the contrary, the cleavage and fold duplexes are newly defined types based on some selected examples. In the Korean Peninsula, the Yeongwol area, the western part of the Taebaeksan Zone of the Okcheon Belt, gives an excellent natural laboratory to study the structural geometry and kinematics of the closed-loops by thrust fault traces in terms of a duplex system. In the previous study, the Yeongwol thrust system was interpreted by alternative duplex models; a Boyer-type hinterland-dipping duplex vs. a combination of major imbricate thrusts and their connecting splays. Although the high angled beds and thrusts as well as different stratigraphic packages within the horses of the Yeongwol duplex system may prefer the later complicate model, currently, we cannot choose one simple answer between the models because of the lack of direct field evidence and time information. Therefore, further researches on the structural field investigations and geochronological analyses in the Yeongwol and adjacent areas should be carried out to test the possibility of applying the fold and cleavage duplex models to the Yeongwol thrust system, and it will eventually provide clues to solve the enigma of formation and its evolution of the Okcheon Belt.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2002.11a
• /
• pp.71-79
• /
• 2002

Nuclear design characteristics of duplex burnable poison rod were evaluated based on 24 month cycle fuel for Korean Standard Nuclear Plant. A fuel assembly with duplex burnable poison rod was designed for an equivalent assembly to 16 gadolinia BPs. Duplex BP is composed of inner region of natural U-12wt%Gd$_2$O$_3$ and outer shell of 4.95wt%UO$_2$-2wt%Er$_2$O$_3$. In order to compare this duplex option, assemblies with 140 erbia pins were designed as an alternative option. The variation of k-infinitive, rod worth, pin peaking and MTC were compared. Duplex BP had the better neutronic performance than gadolinia BP in all parameters. However, Duplex BP was worse than erbia BP in the aspect of safety.