• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.2
• /
• pp.47-55
• /
• 2010

The power line communication channel has characteristic variation problems which are caused by load. The spread spectrum technique has been used to overcome these problems. One of that is the direct sequence spread spectrum(DS/SS) system which is not necessary to additional hardwares. The BER of DS/SS system is decreased by longer length of PN code, but data transfer rate is decreases, so data transfer rate is hard to satisfies their own specifications especially in narrowband PLC systems. Spread Spectrum system with Dual-processing Gain tries to reflect cyclic characteristics of power line noise. But that system assumes that shapes of power line channel are symmetrical with respect to the 1/4 point of main frequency(60Hz in Korea), therefore cannot achieves various shapes of real power line noise. Thus in this paper, noise adaptive DS/SS system which PN code is changed by noise levels for various channel noises is proposed and simulated. The different kinds of noises are modeled and measured for simulation, the proposed system is verified that has lower data transfer rate and lower error rate than conventional system by simulation results.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.3
• /
• pp.55-61
• /
• 2000

This paper presents an efficient hardware architecture of frame memory interface in MPEG-2 video encoder. To reduce the size of memory buffers between SDRAM and the frame memory module, the number of clocks needed for each memory access is minimized with dual bank operation and burst length change. By allocating the remaining cycles not used by SDRAM access, to the random access cycle, the internal buffer size, the data bus width, and the size of the control logic can be minimized. The proposed architecture is operated with 54MHz clock and designed with the VT $I^{тм}$ 0.5 ${\mu}{\textrm}{m}$ CMOS TLM standard cell library. It is verified by comparing the test vectors generated by the c-code model with the simulation results of the synthesized circuit. The buffer area of the proposed architecture is reduced to 40 % of the existing architecture.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.4
• /
• pp.276-285
• /
• 2003

In this paper, we present real-time implementation of a R2MFC/DTMF (R2 Multi Frequency Combinations/Dual Tone Multiple Frequency) tone receiver/sender using a high performance DSP (Digital Signal Processor) and apply it to a carrier class VoIP (Voice over Internet Protocol) gateway system. The Receiver utilizes the Goertzel filter and the sender adopts the harmonic resonant filter. We describe, in detail, the techniques of multi-channel real-time implementation on a Texas Instruments TMS320C62x DSP such as effective PCM (Pulse Code Modulation) in/out by means of DMA (Direct Memory Access) and McBSP (Multi Channel Buffered Serial Port) and message communication via HPI (Host Port Interface), etc. From experimental results, we confirmed that the optimized code provided 780 channel capacity at 250㎒ C6202, and the our R2MFC/DTMF receiver/sender met ITU-T (International Telecommunication Union-Telecommunication) specifications.

• The Korean Journal of Mycology
• /
• v.40 no.2
• /
• pp.73-77
• /
• 2012

Nomenclatural code for fungi was dramatically modified in the 18th International Botanical Congress (IBC) held in Melbourne, Australia in July 2011. Its name was changed into International Code of Nomenclature for Algae, Fungi and Plants (ICN), which was formerly called as International Code of Botanical Nomenclature (ICBN) of the Vienna Code of 2005. The most important change for fungi is abandoning dual nomenclature and introducing one fungus/one name system (2013. 1). Since more than 10,000 species of fungal names should be renamed based on this new classification system (one fungus/one name system), it is challenging to both mycologists and taxonomic users such as plant pathologists and food scientists. Here, we introduced background, progress and future plan for its transition into one fungus/one name system. The new code is allowing electronic-only publication of names of new taxa (2102. 1) and the requirement for a Latin validating diagnosis was changed to allow either English or Latin for the publication of a new name (2011. 1). Furthermore, pre-publication deposit of key nomenclatural information in a recognized repository is mandatory in ICN (2013. 1). The aims of this manuscript are to introduce new code of fungal nomenclature and recent trends in one fungus/one name system to Korean mycological society.

• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.38-42
• /
• 2017

This paper introduces the concept of a dual hash function to amplify security in a quantum key distribution system. We show the use of the relationship between quantum error correction and security to provide security amplification. Also, in terms of security amplification, the approach shows that phase error correction offers better security. We describe the process of enhancing security using the universal hash function using the BB84 protocol, which is a typical example of QKD. Finally, the deterministic universal hash function induces the security to be evaluated in the quantum Pauli channel without depending on the length of the message.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.3 no.1
• /
• pp.88-101
• /
• 2004

The Third Generation (3G) cellular mobile communication systems aim at providing higher data rates, improved quality of service, support for multimedia applications and global roaming. Cdma2000 and Universal Mobile Telecommunication System (UMTS) have emerged as two leading 3G standards in USA and European countries, respectively. Both the standards are capable of delivering high bandwidth data, voice and multimedia services to users of mobile equipment, but are not directly interoperableand are not available across different geographic areas, due to which global roaming is not possible in true sense of using single mobile equipment. However, both UMTS and cdma2000 are based on wideband code division multiple access (WCDMA) as the access method. Due to this, there exist some inherent commonalities between them. In this paper we will try to exploit the commonalities between the two standards in order to design an ASIC, which can provide dual standard capability. This paper discusses the physical layer aspects of the two standards and proposes an approach to design an ASIC which can be mapped to baseband processing part of the physical layer and is capable of delivering for either of the two aforementioned standards.

• Journal of the Society of Disaster Information
• /
• v.6 no.2
• /
• pp.67-85
• /
• 2010

The purpose of this consideration is to present fundamental data for understanding and development the historical approach of Korea Protection by re-examining Royal guarding system through the history in Early Chosun Dynasty. This paper initiated from this critical mind seeking to understand the changing phase of Korea Guarding system, and fundamentally to find the future-oriented ways for the Guarding system. The main materials of history in Early Chosun Dynasty were re-examined, investigated and analyzed and the main references are a code of laws and official as well as private documents such as Kukjo-Oreyeui. Guards system for Royal prince has been found in Byung-jeon of Kyungguk-daejon. he Guards organization has dual system, one was Gumgun which was a private military man and the other was Wuibyung which was a Central military man. On the contrary, central military man were normally protected the royale palaces, but when the King come and go they accompanied and protected the King in safety zone. But just in case they did a job as a member of capital protection military affairs. A question of finance was the reason why there had been dual protection system due to financial matter. If it increased number of man it would pay much money, therefore central military man who has no relevance to national finance were supplied as members of military affairs for the protection of king.

• Journal of electromagnetic engineering and science
• /
• v.6 no.3
• /
• pp.147-154
• /
• 2006

In this paper, we propose and present implementation results of a high-speed turbo decoding algorithm. The latency caused by (de) interleaving and iterative decoding in a conventional maximum a posteriori(MAP) turbo decoder can be dramatically reduced with the proposed design. The source of the latency reduction is come from the combination of the radix-4, dual-path processing, parallel decoding, and rearly-stop algorithms. This reduced latency enables the use of the turbo decoder as a forward error correction scheme in real-time wireless communication services. The proposed scheme results in a slight degradation in bit-error rate(BER) performance for large block sizes because the effective interleaver size in a radix-4 implementation is reduced to half, relative to the conventional method. Fixed on the parameters of N=212, iteration=3, 8-states, 3 iterations, and QPSK modulation scheme, we designed the adaptive high-speed turbo decoder using the Xilinx chip (VIRTEX2P (XC2VP30-5FG676)) with the speed of 17.78 Mb/s. From the results, we confirmed that the decoding speed of the proposed decoder is faster than conventional algorithms by 8 times.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.9C
• /
• pp.891-897
• /
• 2003

Partial response maxim likelihood (PRML) is a powerful and indispensable detection scheme for perpendicular magnetic recording channels. The performance of PRML can be improved by incorporating a noise prediction scheme into branch metric computations of Viterbi algorithm (VA). However, the systems constructed by VA have shortcomings in the form of high complexity and cost. In this connection, a new simple detection scheme is proposed by exploiting the minimum run-length parameter d=1 of RLL code. The proposed detection scheme have a slicer instead of Viterbi detector and a noise predictor as a feedback filter. Therefore, to improve BER performance, the proposed detection scheme is extended to dual detection scheme for improving the BER performance. Simulation results show that the proposed scheme has a comparable performance to noise-predictive maximum likelihood (NPML) detector with less complexity when the partial response (PR) target is (1,2,1).

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.35 no.4
• /
• pp.417-424
• /
• 2011

A fuel assembly consists of five major components, i.e., a top end piece (TEP), a bottom end piece (BEP), spacer grids (SGs), guide tubes (GTs) and an instrumentation tube (IT); in addition, it also includes fuel rods (FRs). The TEP/BEP should satisfy stress intensity limits according to the conditions A and B of ASME, Section III, Division 1-Subsection NB. In a dual-cooled fuel assembly, the array and position of fuel rods are different from those in a conventional PWR fuel assembly; these changes are necessary for achieving power uprating. The flow plates of the TEP and BEP have to be modified accordingly. The pattern and shape of the flow holes were newly designed. To verify the strength compatibility, the Tresca stress limit according to the ASME code was investigated in the case of an axial load of 22.241 kN. In this paper, the stress linearization procedure for strength evaluation of a newly designed TEP is presented.