• Journal of Species Research
• /
• v.7 no.2
• /
• pp.135-150
• /
• 2018

Eleven bacterial strains 17SD2_15, 17Sr1_23, 17SD2_13, 17Sr1_31, 17gy_18, 16B15D, 16B02D, 16B04G, 16B01D, 17U4-2 and 17J28-10 assigned to the phylum Proteobacteria were isolated from soil samples collected from Seoul Women's University, in South Korea. The Belnapia species, strain 17SD2_15 was cocci-shaped and pink-colored. The Methylobacterium species, strain 17Sr1_23, 17SD2_13, 17Sr1_31, and 16B15D were short rod-shaped and pink-colored. The Microvirga species, strain 17gy_18, and 16B02D were short rod-shaped and pink-colored. The Oxalicibacterium species, strain 16B04G was short rod-shaped and pink-colored. The Sphingomonas species, strain 16B01D was short rod-shaped and yellow-colored. The Variovorax species, strain 17U4-2 was cocci-shaped and yellow-colored. The Paracoccus species, 17J28-10 was cocci-shaped and orange-colored. Phylogenetic analysis based on 16S rRNA gene sequence showed that strains 17SD2_15, 17Sr1_23, 17SD2_13, 17Sr1_31, 17gy_18, 16B15D, 16B02D, 16B04G, 16B01D, 17U4-2 and 17J28-10 were most closely related to Belnapia soli (with 99.9% similarity), Methylobacterium gregans (99.1%), Methylobacterium isbiliense (99.6%), Methylobacterium oxalidis (99.9%), Microvirga aerilata (98.7%), Methylobacterium aerolatum (99.0%), Microvirga vignae (100.0%), Noviherbaspirillum canariense (100.0%), Sphingomonas desiccabilis (100.0%), Variovorax humicola (99.6%), and Paracoccus acridae (99.1%), respectively. This is the first report of these eleven species in Korea.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.10
• /
• pp.1731-1736
• /
• 2008

In this paper, singly fed circularly polarized nearly-square patch antenna for receiving S-DMB is presented. It used teflon substrate of relative dielectric constant ${\in}_{\gamma}=2.2$ and the sire is $40{\times}40{\times}15[mm]$. Experimental results of fabricated antenna show that input return loss and axial ratio are about 22MHz, 25MHz at the center resonant frequency, respectively. And fabricated LNA has gain of 27.5 [dB], NF of 1.27 [dB], input return loss of -15.4 [dB] and output return loss of -18.9 dB, respectively. Simulation results and experimental results are good agreements. This proposed antenna is well able to handheld gadgets for receiving S-DMB.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.7
• /
• pp.1255-1260
• /
• 2009

Microstrip interdigital filter is designed with the width and length of a resonator, the gap distance between resonators and the location of a tap. When designing filters, it is a benefit to design with few design parameters comparing to many design parameters. In this paper we design and implement two microstrip interdigital filters operating in the UWB(Ultra Wide-Band) frequency band, one using a fixed width of a resonator and the other using a different width of resonators. The test results of the implemented filters show that the low-band high filter with a fixed width has the insertion loss of 1.49dB, -10dB band width of 720MHz, -35.7dBattenuation at 4.8GHzand below -13dB of S11. The filter with a different width of resonators has the insertion loss of 1.6dB, -10dBbandwidth of 1.63GHz and below-8dBof S11.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.641-644
• /
• 1998

In this paper, wideband MMIC LNA's were designed using low Q matching network. gains of 23.6~25.4dB $(24.5\pm0.9dB),$ noise figures of 0.9~2.8 dB were obtained from the designed wideband MMIC LNA in the frequency ranges of 1.2~2.8㎓. And, P1dB of 10.13 dBm, IP3 of 12.25 dB were obtained at the center frequency of 2 ㎓. A chip size of the designed wideband MMIC LNA is 1.4mm$\times$1.4mm.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.7
• /
• pp.1160-1164
• /
• 2008

This paper presents an wideband stripline balun. And, the proposed balun is composed of one power divider and two phase converters on stripline substrate. The target characteristics of the proposed balun is the combination loss of below -0.05 dB, an amplitude imbalance of ${\pm}0.5\;dB$ and a phase imbalance of $180{\pm}10$ degrees, with the reflection coefficient(S11) of below -10 dB over frequencies ranging from 500 to 1500 MHz. The fabricated balun occupies the area of $12(W){\times}220(L){\times}2.3(T)\;mm3$. Experimental measurement shows that the fabricated balun has an amplitude imbalance of ${\pm}0.7\;dB$, a phase imbalance of $180{\pm}8$ degrees and an insertion loss of about -2 dB with the reflection coefficient(S11) of below -10 dB over frequencies ranging from 500 to 1,500 MHz.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.41 no.10
• /
• pp.69-75
• /
• 2004

This work proposes an 8b 220 MS/s 230 mW 3-stage pipeline CMOS ADC with on-chip filers for temperature- and power- insensitive voltage references. The proposed RC low-pass filters improve switching noise performance and reduce reference settling time at heavy R & C loads without conventional off-chip large bypass capacitors. The prototype ABC fabricated in a 0.25 um CMOS occupies the active die area of 2.25 $\textrm{mm}^2$ and shows the measured DNL and INL of maximum 0.43 LSB and 0.82 LSB, respectively. The ADC maintains the SNDR of 43 dB and 41 dB up to the 110 MHz input at 200 MS/s and 220 MS/s, respectively, while the SNDR at the 500 MHz input is degraded as much as only 3 dB than the SNDR at the 110 MHz input.

• Journal of information and communication convergence engineering
• /
• v.11 no.3
• /
• pp.147-152
• /
• 2013

A novel balun being the structure of a Wilkinson power divider is suggested and fabricated. One of the power dividing paths in the suggested balun uses a conventional ${\lambda}/4$ transmission line for $-90^{\circ}$ phase shifting, and the other path uses a composite right/left-handed -${\lambda}/4$ transmission line for $+90^{\circ}$ phase shifting with four series capacitors and three parallel inductors. In addition, the suggested balun uses two $50-{\Omega}$ resistors and a conventional $50-{\Omega}$ transmission line of ${\lambda}/2$ electrical length between the two output ports, achieving good isolation and reflection values of two balanced ports. The suggested balun is simulated by the advanced design system simulation program and fabricated on TLX-9 20-mil substrate. The fabricated balun has a very good values of $S_{11}$ = -27.46 dB, $S_{21}$ = -3.40 dB, and $S_{31}$ = -3.28 dB, a phase difference of $-179.5^{\circ}$, a magnitude difference of 0.12 dB, and a delay difference of 0.1 ns, with $S_{22}$ = -36.28 dB, $S_{33}$ = -27.19 dB, and $S_{32}$ = -25.2 dB at 1 GHz, respectively.

• Journal of Advanced Navigation Technology
• /
• v.4 no.2
• /
• pp.182-190
• /
• 2000

In this paper, interference effects between NGSO and HAPS in the feeder link have been simulated and analyzed by means of calculating excess time percent and duration below the ell protection ratio. As the results, in the case of HAPS interference into NGSO, it can be obtained that the lowest C/I values are 20.42dB in 50km and 12.73dB in 20km of HAPS altitudes, respectively. And in the case of NGSO interference into HAPS, it can be obtained that the lowest ell values are 13.94dB and 10.42dB respectively. HAPS system has more interference reception from other systems or effects more interference into other systems as its altitude is lower. Also, the lowest ell values are appeared at difference time with its altitude.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2000.11a
• /
• pp.34-38
• /
• 2000

In this paper, interference effects between NGSO and HAPS in the feeder link have been simulated and analyzed by means of calculating excess time percent and duration below the C/I protection ratio. As the results, in the case of HAPS interference into NGSO, it can be obtained that the lowest C/I values are 27.42dB in 50km and 12.73dB in 20Km of HAPS altitudes, respectively. And in the case of NGSO interference into HAPS, it can be obtained that the lowest C/I values are 13.94dB and 10.42dB respectively. HAPS system has more interference reception from other systems or effects more interference into other systems as its altitude is lower. Also, the lowest C/I values are appeared at difference time with its altitude.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.873-876
• /
• 2005

A low noise amplifier(LNA) using electro-magnetic field simulator is designed in standard 0.25um CMOS process. Integrated spiral inductor is simulated using EM field solver. Then LNA is simulated with active device, capacitor and simulated inductor by EM field solver. A S11 and S21 of -15.45dB and 17.8dB at 2.3GHz as simulation results was achieved. A Noise Figure is 2.92dB. And Measurements show a S11 and S21 of -12.4dB and 17.8dB at 2.3GHz. A Noise Figure of 3.3dB was achieved.