• Korean Chemical Engineering Research
• /
• v.52 no.6
• /
• pp.695-700
• /
• 2014

Proton Exchange Membrane Fuel Cells (PEMFC) can generate hydrogen and oxygen from water by electrolysis. But the electrode and polymer electrolyte membrane degrade rapidly during PEM water electrolysis because of high operation voltage over 1.7V. In order to reduce the rate of anode electrode degradation, unsupported $IrO_2$ catalyst was used generally. In this study, Pt/C catalyst for PEMFC was used as a water electrolysis catalyst, and then the degradation of catalyst and membrane were analysed. After water electrolysis reaction in the voltage range from 1.8V to 2.0V, I-V curves, impedance spectra, cyclic voltammograms and linear sweep voltammetry (LSV) were measured at PEMFC operation condition. The degradation rate of electrode and membrane increased as the voltage of water electrolysis increased. The hydrogen yield was 88 % during water electrolysis for 1 min at 2.0V, the performance at 0.6V decreased to 49% due to degradation of membrane and electrode assembly.

• Korean Journal of Materials Research
• /
• v.31 no.6
• /
• pp.325-330
• /
• 2021

Bi₂MoO₆ (BMO) via the structure-directing role of CO(NH₂)₂ is successfully prepared via a facile solvothermal route. The structure, morphology, and photocatalytic performance of the nanoflake BMO are characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), fluorescence spectrum analysis (PL), UV-vis spectroscopy (UV-vis) and electrochemical test. SEM images show that the size of nanoflake BMO is about 50 ~ 200 nm. PL and electrochemical analysis show that the nanoflake BMO has a lower recombination rate of photogenerated carriers than particle BMO. The photocatalytic degradation of tetracycline hydrochloride (TC) by nanoflake BMO under visible light is investigated. The results show that the nanoflake BMO-3 has the highest degradation efficiency under visible light, and the degradation efficiency reached 75 % within 120 min, attributed to the unique hierarchical structure, efficient carrier separation and sufficient free radicals to generate active center synergies. The photocatalytic reaction mechanism of TC degradation on the nanoflake BMO is proposed.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.10
• /
• pp.3039-3045
• /
• 2013

Dual-frequency ultrasound assisted photocatalysis (DUAP) method was proposed to degrade a stable organic model effluent, cresol red (CR), using the prepared $Fe^{3+}$-doped $TiO_2$ with active carbon fiber loading ($Fe^{3+}-TiO_2/ACF$) as photocatalyst. The influence of key factors, including Fe doping amount and power density of dual-frequency ultrasounds (20/40 kHz), on the degradation efficiency was investigated. The degradation efficiency rises to 98.7% in 60 min accompanied by the color removal of CR liquid samples from yellow to colorless transparent at optimal conditions. A synergy index of 1.40 was yielded by comparison with single ultrasound assisted photocatalysis (SUAP) and the photocatalysis without ultrasound assisted (UV/$TiO_2$), indicating that a clear synergistic effect exists for the DUAP process. Obvious enhancement of degradation efficiency for the DUAP process should be attributed to production of large amount of free radicals by strong cavitational effects of dual ultrasounds.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.10
• /
• pp.883-892
• /
• 2009

We evaluated the degradation properties of various alkanolamine absorbents (MEA, AMP, DEA, and MDEA) having different chemical structures for $CO_2$ capture. The degradation of $CO_2$ absorbent in general was known to be caused by oxygen which is in flue gas and by heat source, respectively. To analyze the effect of $CO_2$ and $O_2$ on degree of degradation, we conducted a variety of experiments at $30^{\circ}C$ and $60^{\circ}C$ (oxidative degradation) and $130^{\circ}C$ and $150^{\circ}C$ (thermal degradation), respectively. DEA showed the worst property for oxidative degradation in the presence of oxygen among the alkanolamine absorbents. In the case of thermal degradation, the degradation of absorbent was occurred for most of absorbents at $150^{\circ}C$. Among these absorbents, MEA and DEA gave the worst results. As a result, AMP which is a primary amine and having a steric hindrance showed the best result through the degradation test. But, the degradation of absorbent proceeded easily in the case of DEA which is a secondary amine and having 2 OH groups in terminal position. Consequently, we have evaluated the degree of degradation of various absorbents having different chemical structures to give the basic data for the development of alkanolamine absorbent.

• Journal of Industrial and Engineering Chemistry
• /
• v.67
• /
• pp.164-174
• /
• 2018

The purpose of this work designed hybrid-structured and plasma effect photocatalyst of $Ag/In_2O_3/TiO_2/HNTs$ via sol-gel and photo-reduction methods. The structures, morphologies, optical and photoelectric performances of as-prepared photocatalysts were characterized via XRD, TEM, XPS, BET, UV-vis DRS, PL and photocurrents. The photocatalytic activity was evaluated by degradation of TC. The results showed that the hybrid-structure and plasma effect can effectively cause the multi-transfer of electrons and increase the separation rate of electron and hole pairs which obtained high photocatalytic activity. The photocatalytic degradation processes reveal that $^{\bullet}O_2{^-}$ and $h^+$ are major active species.

• Environmental Engineering Research
• /
• v.25 no.3
• /
• pp.316-323
• /
• 2020

The degradation of aqueous oxytetracycline (OTC) from an aqueous solution antibiotic using H₂O₂/Fe²⁺ process was studied in one 1 L batch chemical reactor. The extent of OTC degradation (20 mg/L) was investigated from a known initial pH solution, temperature and the type of catalyst (Fe²⁺, Fe³⁺) and for various initial concentrations of OTC, H₂O₂ and Fe²⁺. The degradation efficiency achieved was found to be very important (90.82% and 90.63%) at initial pH solution of 3 and 4, respectively. However, the type of catalyst and the reaction temperature had a slight impact on the final degradation of OTC. The results showed that the OTC removal increased with increasing initial H₂O₂ concentration in the range of 70 to 150 mg/L and initial Fe²⁺ concentrations in the range of 2 to 5 mg/L. The highest degradation efficiency obtained at ambient temperature was 90.95% with initial concentration of OTC of 10 mg/L, H₂O₂ = 150 mg/L and Fe²⁺ = 5 mg/L. Moreover, biodegradability improved from 0.04 to 0.36 and chemical oxygen demand degradation was 78.35% after 60 min of treatment. This study proved that Fenton process can be used for pretreatment of wastewater contaminated by OTC before a biological treatment.

• Advances in environmental research
• /
• v.4 no.1
• /
• pp.25-38
• /
• 2015

Wastewaters of textile industry cause high volume colour and harmful substance pollutions. Photocatalytic degradation is a method which gives opportunity of reduction of organic pollutants such as dye containing wastewaters. In this study, photocatalytic degradation of C.I. Basic Yellow 28 (BY28) as a model dye contaminant was carried out using Degussa P25 in a photocatalytic reactor. The experiments were followed out at three different azo dye concentrations in a reactor equipped UV-A lamp (365 nm) as a light source. Azo dye removal efficiencies were examined with total organic carbon and UV-vis measurements. As a result of experiments, maximum degradation efficiency was obtained as 100% at BY28 concentration of $50mgL^{-1}$ for the reaction time of 2.5 h. The photodegradation of BY28 was described by a pseudo-first-order kinetic model modified with the langmuir-Hinshelwood mechanism. The adsorption equilibrium constant and the rate constant of the surface reaction were calculated as $K_{dye}=6.689{\cdot}10^{-2}L\;mg^{-1}$ and $k_c=0.599mg\;L^{-1}min^{-1}$, respectively.

• Korea-Australia Rheology Journal
• /
• v.20 no.4
• /
• pp.245-251
• /
• 2008

Two polysiloxanes having different chemical structures were blended with polycarbonate (PC) under ultrasonic irradiation in solution. The polysiloxanes used were poly(methylphenyl siloxane) and vinyl-terminated poly(dimethyl siloxane). It was of primary interest to investigate the effect of polysiloxane structure on the rheological properties of PC/polysiloxane blends. It was found that a small amount (1.5 phr) of polysiloxanes greatly altered the melt viscosities and elasticity of PC. In particular, incorporation of poly(methylphenylsiloxane) led to a notable increase in elasticity with greater shear sensitivity of PC. The observed rheological behaviors of PC/polysiloxane blends were partly explained in conjunction with the tendencies found in ultrasonic degradation of polysiloxanes. Thermal stability and morphology in sonicated blends of PC/polysiloxane blends were also discussed.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.11
• /
• pp.3686-3690
• /
• 2012

Photochemical degradation of dimethyl phthalate (DMP) in Fe(III)/tartrate/$H_2O_2$ system was investigated utilizing fluorescent lamps as the primary light source. Effects of initial pH, light source, and initial concentration of each reactant on DMP photodegradation was examined. The results show that the system was able to effectively photodegrade DMP utilizing visible light. Fluorescent lamp, halide lamp, UV lamp and sunlight could all be used as the light sources. The optimal pH ranged among 3.0-4.0 for the system. Increases of the initial concentrations of Fe(III) and $H_2O_2$ accelerated the photodegradation of DMP, whereas excessively high initial tartrate concentration resulted in the decrease of photodegradation efficiency and rate of DMP.

• Korean Chemical Engineering Research
• /
• v.61 no.4
• /
• pp.635-644
• /
• 2023

Due to the rapid development of the livestock industry, particularly due to residual pharmaceutical antibiotics, environmental populations have been negatively affected. Herein, we report a ZnO/melamine-functionalized carboxylic-rich graphene oxide (ZFG) photocatalyst for visible light-driven photocatalytic degradation of tetracycline hydrochloride in aqueous solutions. The properties of the photocatalysts were evaluated by XRD, FTIR, XPS, Fe-SEM, HR-TEM, TGA, Raman spectroscopy, UV-Vis spectroscopy, zeta potential, and electrochemical measurements. The photocatalytic activity was measured using high-performance liquid chromatography. The photocatalytic properties of the ZFG photocatalyst evaluated against the tetracycline hydrochloride (TCH) antibiotic under visible light irradiation showed superior photodegradation of 96.27% within 60 min at an initial pH of 11. The enhancement of photocatalytic degradation was due to the introduction of functionalized graphene, which increases the light-harvesting capability and molecular adsorption capability in addition to minimizing the recombination rate of photogenerated charge carriers due to its role as an electron acceptor and mediator.