• Proceedings of the KIEE Conference
• /
• 2001.07c
• /
• pp.1829-1831
• /
• 2001

A novel multi-section power divider configuration is proposed to obtain wide-band frequency performance up to microwave frequency region. Design procedures for the proposed microwave broadband power divider are composed of a planar multi-section three-ports hybrid and a waveguide transformer design procedures. The multi-section power divider is based on design theory of the optimum quarter-wave transformer. Furthermore, in order to obtain the broadband isolation performance between the two adjacent output ports, the odd mode equivalent circuit should be matched by using the lossy element such as resistor. The derived design formula for calculating these odd mode matching elements is based on the singly terminated filter design theory. The waveguide transformer section is designed to suppress the propagation of the higher order modes such as waveguide modes due to employing the metallic electric wall. Simulation and experiment show excellent performance of multi section power divider.

• Journal of the Korean Institute of Navigation
• /
• v.22 no.2
• /
• pp.39-45
• /
• 1998

CATV(Cable Television) 및 MATV(Master Antenna TV) 시스템용 신호분기기(Tap-Off)의 광대역설계법을 새로운 방법으로 제안한다. 먼저 결합선로형 방향성결합기의 이론을 도입하여 변성기형 방향성결합기에 적용하여 해석하였다. 제안한 해석방법의 타당성을 입증하기 위하여 시뮬레이션한 결과와 실험결과를 비교 검토하였고 전송선로의 임피던스를 매칭시켜 반사계수 20dB, isolation 25dB(5∼1600MHz)을 만족하는 신호분기기(14dB)의 광대역화(5∼2150MHz)를 실현하였다.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.23 no.5
• /
• pp.109-114
• /
• 2023

In this paper, a 2-channel Image-Reject receiver using a 65-nm CMOS process is presented for Ka-band compact radars. The designed receiver consists of Low-Noise Amplifier (LNA), IQ mixer, and Analog Baseband (ABB). ABB includes a complex filter in order to suppress unwanted images, and the variable gain amplifiers (VGAs) in RF block and ABB have gain tuning range from 4.5-56 dB for wide dynamic range. The gain of the receiver is controlled by on-chip SPI controllers. The receiver has noise figure of <15 dB, OP1dB of >4 dBm, image rejection ratio of >30 dB, and channel isolation of >45 dB at the voltage gain of 36 dB, in the Ka-band target frequency. The receiver consumes 420 mA at 1.2 V supply with die area of 4000×1600 ㎛.

• Food Science and Biotechnology
• /
• v.14 no.4
• /
• pp.503-508
• /
• 2005

Screening for antilisterial activity was performed in about three thousand isolates of lactic acid bacteria (LAB) from Chinese cabbage kimchi, and finally based on the relatively stronger antilisterial activities eight bacterial strains were selected. The bacteria were further characterized in terms of their tolerance to artificial gastric juice, pH 2.5, bile salts (0.3% oxgall), and to the different NaCl concentrations. Of the isolates, YK005 was especially investigated for its physiological characteristics due to its inhibitory activity against gram-positive Listeria monocytogenes as well as gram-negative Escherichia coli O157:H7, as they have been constantly reported to be resistant against bacteriocins produced by a number of LAB strains. YK005 was found to be rod-shaped, $3.8\;{\mu}m$ long ${\times}\;0.5\;{\mu}m$ wide, non-sporeforming, non-motile, catalase-negative, and produced gas from glucose (heterolactic). Based on the biochemical data obtained by API 50 CHL medium, the isolate was tentatively identified as Lactobacillus brevis. To validate the result obtained by the biochemical identification, rRNA-based PCR experiments using a pair of species-specific primers for L. brevis were conducted and a single band of 1400 bp was observed, which strongly indicated that YK005 belongs to L. brevis. The LAB isolates are potentially exploited as human probiotic organisms and are employed to control some food-borne pathogens like L. monocytogenes.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.13 no.1
• /
• pp.16-22
• /
• 1976

Broadband operation of Y-junction microstrip circulator withlnonreciprocal device is predicteg by Rosenbaum using Bosma's Green function analysis. The anslysis has been modified to enable the scattering matrix and therefore the circulator bandwidth, to be found. The width of the coupling transmission lines is found to be a significant design parameter${\psi}$. A comparison of experimental and theoretical results for the 3-port junction shows that wide lines and a smaller 7.5U than usual disk radius can be used to obtain broadband operation. Circulator operates in the frequency band 5-11 GHz. The obtained maximum insertion loss is 0.5dB and the isolation is more than 15dB.

• Applied Microscopy
• /
• v.43 no.4
• /
• pp.146-154
• /
• 2013

Capillaria hepatica (syn. Calodium hepatica) is a parasite found mainly in rodent liver. But, it has also been found in a wide variety of mammals, including humans. This worm is unique as it is the only nematode parasite that is embedded in the liver parenchyma of the host even during the adult stage of the life cycle. They produce eggs that elicit a marked granulomatous reaction that eventually destroys the worms. Fibrosis and lymphoplasmacytic inflammatory infiltration are often observed around adult nematodes embedded in the liver parenchyma of the host. For this reason, complete isolation of this slender worm and observation of the intact ultrastructure is very difficult. In this study, 10 intact whole worms (C. hepatica) were isolated from the liver of 3-week-old mouse after inoculation of artificially embryonated eggs collected from house rats (Rattus norvegicus). Their external structure of was observed with light and scanning electron microscopy. The length of the isolated female and male C. hepatica was approximately 69.60 mm and 36.92 mm, respectively. More detailed ultrastructure, including bacillary band, eggs and vulva in female and spicule and spicule sheath in male C. hepatica was also described.

• ETRI Journal
• /
• v.30 no.4
• /
• pp.526-534
• /
• 2008

This paper presents a fully integrated 0.13 ${\mu}m$ CMOS MB-OFDM UWB transmitter chain (mode 1). The proposed transmitter consists of a low-pass filter, a variable gain amplifier, a voltage-to-current converter, an I/Q up-mixer, a differential-to-single-ended converter, a driver amplifier, and a transmit/receive (T/R) switch. The proposed T/R switch shows an insertion loss of less than 1.5 dB and a Tx/Rx port isolation of more than 27 dB over a 3 GHz to 5 GHz frequency range. All RF/analog circuits have been designed to achieve high linearity and wide bandwidth. The proposed transmitter is implemented using IBM 0.13 ${\mu}m$ CMOS technology. The fabricated transmitter shows a -3 dB bandwidth of 550 MHz at each sub-band center frequency with gain flatness less than 1.5 dB. It also shows a power gain of 0.5 dB, a maximum output power level of 0 dBm, and output IP3 of +9.3 dBm. It consumes a total of 54 mA from a 1.5 V supply.

• Structural Engineering and Mechanics
• /
• v.82 no.4
• /
• pp.417-434
• /
• 2022

In this work, a review of mechanical metamaterials and seismic protection systems that use them is carried out, focusing on passive protection systems. During the last years, a wide variety of classical systems of seismic protection have demonstrated to be an effective and practical way of reducing the seismic vulnerability of buildings, maintaining their health and structural integrity. However, with the emergence of metamaterials, which allow obtaining uncommon mechanical properties, new procedures and devices with high performance have been developed, reducing the seismic risk through novel approaches such as: seismic shields and the redirection of seismic waves; the use of stop band gaps and the construction of buried mass resonators; the design of pentamodal base isolators. These ideas are impacting traditional areas of structural engineering such as the design and building of highly efficient base isolation systems. In this work, recent advances in new seismic protection technologies and researches that integrate mechanical metamaterials are presented. A complete bibliometric analysis was carried out to identify and classify relevant authors and works related with passive seismic protection system based on mechanical metamaterial (pSPSmMMs). Finally, possible future scenarios for study and development of seismic isolators based on mechanical metamaterials are shown, identifying the relevant topics that have not yet been explored, as well as those with the greatest potential for future application.

• Journal of IKEEE
• /
• v.2 no.1 s.2
• /
• pp.1-14
• /
• 1998

In this paper, Antenna, LNA, Mixer, VCO, and Modulation/Demodulation in Baseband processor which are the RF main components in Wireless LAN system for ultra high-speed communications network are studied. Antenna bandwidth and selective fading due to multipath can be major obstacles in high speed digital communications. To solve this problem, wide band MSA which has loop-structure magnetic antenna characteristics is designed. Distributed mixer using dual-gate GaAs MESFET can achieve over 10dB LO/RF isolation without hybrid, and minimize circuit size. As linear mixing signal is produced, distortions can be decreased at baseband signals. Conversion gain is achieved by mixing and amplification simultaneously. Mixer is designed to have wide band characteristics using distributed amplifier. In VCO design, Oscillator design method by large signal analysis is used to produce stable signal. Modulation/Demodulation system in baseband processor, DS/SS technique which is robust against noise and interference is used to eliminate the effect of multipath propagation. DQPSK modulation technique with M-sequences for wideband PN spreading signals is adopted because of BER characteristic and high speed digital signal transmission.

• Journal of the Korean Chemical Society
• /
• v.19 no.5
• /
• pp.325-330
• /
• 1975

Complex formation between ferric ion and phosphoric acid has been studied in the wide range of the acid concentration(0${\sim}40{\%}$) by uv-visible spectroscopy and by characterization of the isolated products. The electronic spectra of Fe(III)-containing phosphoric acid solutions exhibit two visible bands at 19.2 and 24.1 kK, which are characteristic of Fe(III)-phosphate complex formation. The measurements of acid concentration dependence of the opical density of the 24.1 kK band indicates the presence of two distinct forms of Fe(Ⅲ)-phosphate complexes possibly $[Fe(H_xPO_4)]^{x+}\;and\;[Fe_2 (H_xPO_4)]^{(3+x)+}$. The 1:1 complex has been isolated for characterization, and the phosphate ion was found to be coordinated to the metal in monobasic state whereas the isolation of the dimeric species was unsuccessful.