• Korean Journal of Culture and Social Issue
• /
• v.20 no.4
• /
• pp.391-414
• /
• 2014

This driving simulation study examined the effect of driver's state driving anger(SDA) on collision avoidance(CA) and situation awareness(SA), as well as the moderating effect of driver's positive and negative affect(PA and NA) on the relationship between the driver's SDA and SA. The results showed the followings. First, high SDA group collided with the leading vehicle more frequently than low SDA group. Second, neither the driver's trait driving anger(TDA) nor PA/NA yielded significant changes in SA after SDA was induced. Third, high SDA tended to lower SA but this tendency was observed only when the driver's NA was high. These results suggested that SDA than TDA is a significant deteriorating factor of the driver's SA, and more importantly, SDA should be considered with other affect-relating variable such as NA in explaining the effect of SDA on driver's SA and CA.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.2D
• /
• pp.233-239
• /
• 2006

Most research for until at now link travel time were research for mean link travel time calculate or estimate which uses the average of the individual vehicle. however, the link travel time distribution is divided caused by with the impact factor which is various traffic condition, signal operation condition and the road conditional etc. preceding study result for link travel time distribution characteristic showed that the patterns of going through traffic were divided up to 2 in the link travel times. therefore, it will be more accurate to divide up the link travel time into the one involving delay and the other without delay, rather than using the average link travel time in terms of assessing the traffic situation. this study is it analyzed transit hour distribution characteristic and a cause using examine to the variables which give an effect at link travel time distribute using simulation program and determinate link travel time distribute ratio estimation model. to assess the distribution of the link travel times, this research develops the regression model and the fuzzy model. the variables that have high level of correlations in both estimation models are the rest time of green ball and the delay vehicles. these variables were used to construct the methods in the estimation models. The comparison of the two estimation models-fuzzy and regression model- showed that fuzzy model out-competed the regression model in terms of reliability and applicability.

• Korean Journal of Culture and Social Issue
• /
• v.15 no.4
• /
• pp.547-563
• /
• 2009

This study was conducted to examine the stress effects of time pressure and induced driver-anger on driving performance. The participants in the four different stress conditions(i.e., control condition, time pressure, induced anger, and mixed condition where induced-anger and time pressure were combined) were asked to drive the driving simulator, and their driving performances(i. e., lane crossing, signal violation, speeding, and deviation form designated path) were measured as the dependent variable. The results can be summarized as followings. (1) Induced-anger alone and the mixed driver stresses tended to yield deteriorated driving performances as well as awareness for designated path, (2) Time pressure alone appeared to have only limited effect both on the driving and path awareness. And (3) the effects of induced-anger alone and the mixed condition on driving performance and path awareness did not show ant significant difference. The results of the present study indicated that drivers' basic vehicle control and keeping awareness to destination could be affected differently by the types of driver stress.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.3
• /
• pp.52-63
• /
• 2009

Recently in Korea, in the case of metropolis, the urban signalized intersections are controlled by traffic information center or ITS center. Cheon-an City also established traffic information center through the 1st.-$\sim$3rd. ITS public construction and has managed this center that includes bus information service, traffic information collection and providing service, parking information service, and traffic responsive control system. In the Cheon-an metropolitan traffic signal operation, traffic signal controllers were grouped by the each main traffic flow axes and performed with coordinated signal timing for the signalized arterials, and also cycle and split changed by realtime traffic demands. Cheon-an urban traffic responsive control system was evaluated by intersection delay and speed, then it was verified that the delay decreased and vehicle speed improved. However, the rural signal control system to connect adjacency town was evaluated to have lower status than urban area due to the unimproved TOD (Time of day) plan. Therefore actuated signal control was examined for substitutive control system in isolated signal intersection. The aim of this article is to compare actuated signal control with TOD mode in the rural intersection of Cheon-an and to fine superiority of these two control mode, with evaluation of vehicle delay by using HCM(2000) method and by micro-simulation CORSlM. The result of field test show that actuated signal control gave better performance in delay comparison than the existing TOD signal control. And simulation outcome verified that non-optimized TOD has higher delay than optimized TOD mode, non-optimal actuated mode, and optimal actuated signal control mode. Particularly, these three modes delays had not different values according to the paired sample t-test. This is because small traffic demands were loaded in each links. This suggested actuated signal control is expected to be more effective than TOD mode in some rural isolated intersections which frequently need to survey for traffic volume.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.43 no.2
• /
• pp.231-238
• /
• 2023

Since there is a limit to the physically visible horizon that sensors for autonomous driving can perceive, complementary utilization of digital map data such as a Local Dynamic Map (LDM) along the probable route of an Autonomous Vehicle (AV) is proposed for safe and efficient driving. Although the amount of digital map data may be insignificant compared to the amount of information collected from the sensors of an AV, efficient management of map data is inevitable for the efficient information processing of AVs. The objective of this study is to analyze the efficiency of information use and information processing time of AV according to the expansion of the active section of LDM-based static road and traffic information. To carry out this objective, a microscopic simulator model, VISSIM and VISSIM COM, was employed, and an area of about 9 km × 13 km was selected in the Busan Metropolitan Area, which includes heterogeneous traffic flows (i.e., uninterrupted and interrupted flows) as well as various road geometries. In addition, the LDM information used in AVs refers to the real high-definition map (HDM) built on the basis of ISO 22726-1. As a result of the analysis, as the electronic horizon area increases, while short links are intensively recognized on interrupted urban roads and the sum of link lengths increases as well, the number of recognized links is relatively small on uninterrupted traffic road but the sum of link lengths is large due to a small number of long links. Therefore, this study showed that an efficient range of electronic horizon for HDM data collection, processing, and management are set as 600 m on interrupted urban roads considering the 12 links corresponding to three downstream intersections and 700 m on uninterrupted traffic road associated with the 10 km sum of link lengths, respectively.

• Korean Chemical Engineering Research
• /
• v.56 no.4
• /
• pp.479-495
• /
• 2018

This study was carried out to research the multimedia fate modeling, concentration distribution and impact assessment of polycyclic aromatic hydrocarbons (PAHs) emitted from automobiles, which are known as carcinogenic and mutation chemicals. The amount of emissions of PAHs was determined based on the census data of automobiles at a target S-city and emission factors of PAHs, where multimedia fugacity modeling was conducted by the restriction of PAHs transfer between air-soil at the impervious area. PAHs' Concentrations and their distributions at several environmental media were predicted by multimedia fugacity model (level III). The residual amounts and the distributions of PAHs through mass transfer of PAHs between environment media were used to assess the health risk of PAHs at unsteady state (level IV), where the sensitivity analyses of the model parameter of each variable were conducted based on Monte Carlo simulation. The experimental result at S-city showed that Fluoranthene among PAHs substances are the highest residual concentrations (60%, 53%, 32% and 34%) at all mediums (atmospheric, water, soil, sediment), respectively, where most of the PAHs were highly accumulated in the sediment media (more than 80%). A result of PAHs concentration changes in S-city over the past 34 years identified that PAHs emissions from all environmental media increased from 1983 to 2005 and decreased until 2016, where the emission of heavy-duty vehicle including truck revealed the largest contribution to the automotive emissions of PAHs at all environment media. The PAHs concentrations in soil and water for the last 34 years showed the less value than the legal standards of PAHs, but the PAHs in air exceeded the air quality standards from 1996 to 2016. The result of this study is expected to contribute the effective management and monitoring of toxic chemicals of PAHs at various environment media of Metropolitan city.

• KDI Journal of Economic Policy
• /
• v.13 no.1
• /
• pp.115-134
• /
• 1991

The role of pension plans in the macroeconomy has been a subject of much interest for some years. It has come to be recognized that pension plans may alter basic macroeconomic behavior patterns. The net effects on both savings and labor supply are thus matters for speculation. The aim of the present paper is to provide quantitative results which may be helpful in attaching orders of magnitude to some of the possible effects. We are not concerned with the providing empirical evidence relating to actual behavior, but rather with deriving the macroeconomic implications for a alternative possibilities. The pension plan interacts with the economy and the population in a number of ways. Demographic variables may thus affect both the economic burden of a national pension plan and the ability of the economy to sustain the burden. The tax transfer process associated with the pension plan may have implications for national patterns of saving and consumption. The existence of a pension plan may have implications also for the size of the labor force, inasmuch as labor force participation rates may be affected. Changes in technology and the associated changes in average productivity levels bear directly on the size of the national income, and hence on the pension contribution base. The vehicle for the analysis is a hypothetical but broadly realistic simulation model of an economic- demographic system into which is inserted a national pension plan. All income, expenditure, and related aggregates are in real terms. The economy is basically neoclassical; full employment is assumed, output is generated by a Cobb-Douglas production process, and factors receive their marginal products. The model was designed for use in computer simulation experiments. The simulation results suggest a number of general conclusions. These may be summarized as follows; - The introduction of a national pension plan (funded system) tends to increase the rate of economic growth until cost exceeds revenue. - A scheme with full wage indexing is more expensive than one in which pensions are merely price indexed. - The rate of technical progress is not a critical element in determining the economic burden of the pension scheme. - Raising the rate of benefits affects its economic burden, and raising the age of eligibility may decrease the burden substantially. - The level of fertility is an element in determining the long-run burden. A sustained low fertility rate increases the proportion of the aged in total population and increases the burden of the pension plan. High fertility has inverse effects.

• International Journal of Highway Engineering
• /
• v.13 no.3
• /
• pp.131-137
• /
• 2011

The development of underground space essentially leads to increase in construction cost and installation of a large structure also acts as a factor deteriorating fine sight of the city. Accordingly, there recently is a trend to make city center structures light and small if possible. In this study, for efficient development of underground space, we analyzed the change in the average delay time in comparison to the existing underpass and the influence thereof using a microscopic simulation software VISSIM 5.20 after controlling heavy vehicles not to use the underpass and to detour using the intersection above the underpass, and gradually increasing the ratio of heavy vehicles in accordance with v/c of the access road in order to examine efficiency of introducing an underpass exclusive to small cars at an underground road installed and being operated in a city road area, and presented installation standard for underpass exclusive to small vehicles adequate to the traffic characteristics. Considering the findings of the study, introduction of underpass exclusive to small cars judged to be beneficial in the aspects of reduction in the economic loss resulting from land purchase, environmental damage due to construction of large traffic structures and environment-friendly green traffic.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.28 no.2
• /
• pp.139-144
• /
• 2015

Recently, to realize sound-absorbing structures, we have to insert sound-absorbing materials into wall. These shapes are taken limitations because sound-absorbing materials should be fixed. Therefore, the sound absorption is changed by environment that used the sound-absorbing materials. On the other hand, we will take same effect without sound-absorbing material, if we change the shape of wall to sound absorbing structure. If we use this sound absorbing structure, we can get benefits by removing limitation of materials. Therefore we suggest perforated plate for effective sound-absorbing structure. We confirmed the function of sound-absorption of this structure using equivalent property. Then, we found the similarity between perforated plate and resonator. Also, we verify these theories through computer simulation by FEM(Finite Element Method). Finally, we validated that perforated plate has function of sound absorption without sound-absorbing material. This perforated plate is used for sound-absorbing material of buildings and transportations such as vehicle, train etc. Also, these results could be further used basic tool for design of sound-absorption structure.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.44 no.12
• /
• pp.1043-1053
• /
• 2016

In this paper, the application of Parallel Distributed Compensation (PDC) controller for fixed pitch rotary wing system was studied. For nonlinear modeling, T-S fuzzy model was utilized to advance system control including the tilt type UAV. PDC controller was designed through the Linear Matrix Inequality (LMI). Experiments for determining the applicability and feasibility of PDC were performed using the 1 axis attitude control equipment and simulation. To verify the performance and characteristics of the controller, Mathworks Co. Simulink was used. After then, the PDC controller performance was verified and the results with developed controller using a 1 axis attitude control equipment were compared. Verification of the feasibility of PDC controller for the fixed pitch rotary wing system and identification of the overall performance and improvement analysis was conducted based on the experimental results.