• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.7
• /
• pp.1247-1251
• /
• 2016

This study aims to investigate the effect of sampling frequency to the time domain and frequency domain analysis of pulse rate variability (PRV). Typical time domain variables - AVNN, SDNN, SDSD, RMSSD, NN50 count and pNN50 - and frequency domain variables - VLF, LF, HF, LF/HF, Total Power, nLF and nHF - were derived from 7 down-sampled (250 Hz, 100 Hz, 50 Hz, 25 Hz, 20 Hz, 15 Hz, 10 Hz) PRVs and compared with the result of heart rate variability of 10 kHz-sampled electrocardiogram. Result showed that every variable of time domain analysis of PRV was significant at 25 Hz or higher sampling frequency. Also, in frequency domain analysis, every variable of PRV was significant at 15 Hz or higher sampling frequency.

• 전기의세계
• /
• v.31 no.6
• /
• pp.450-456
• /
• 1982

This paper proposes a new method for eliminating periodic interference corrupting a signal. The method proposed herein uses a variable notch filter by sampling frequency control to eliminate the interference. This method is applicable when an auxiliary reference input is available containing the interference alone. The sampling frequency is determined by the fundamental frequency of the periodic interference. Also, this paper proposes a design procedure so that it can be easily applied.

• Journal of Broadcast Engineering
• /
• v.18 no.1
• /
• pp.106-114
• /
• 2013

This paper deals with the effect of the internal sampling frequency and core band down sampling ratio on the overall performance of the MPEG USAC. Here, the internal sampling frequency is the sampling frequency of a signal actually coded. The core band down sampling ratio is the ratio of the width of the core band over that of the coded band. The performance was measured on 6 different test sound sources by the MUSHRA test with 10 subjects. The experiments showed that 1/3 or 1/4 core band down sampling ratio could yield the better performance than the conventional 1/2 ratio, especially at low rates.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.6
• /
• pp.1175-1182
• /
• 2021

The receiver of each radio telescope of KVN, has a sampler that converts astronomical radio signal to digital data. The ability of this sampler (the bandwidth, sampling frequency, and sampling bits) is improved by sqrt(n), if the bandwidth is increased by n times, and the number of observable objects increases exponentially in the case of continum spectrum radio sources. As the bandwidth increases, there are the more spectrum lines that can be simultaneously monitored in the radio source. This will greatly expand the research area in astronomical radio observation. For this reason, we are trying to independently develop the technology of the fast digital sampler. Therefore, based on the research experience and technology accumulated so far, An ability of sampling up to 3.5 GHz, that can vary the sampling frequency and can observe in a wider band, was designed and made for proto-type. In this study, we introduce the development details and test results for new sampling system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.7
• /
• pp.545-551
• /
• 2013

Timing recovery loop composed of the Timing Error Detector(TED), loop filter and resampler is widely used for the timing synchronization in MQASK receivers. Since TED is sensitive to the delay between the symbol period of the signal and sampling period, the output is averaged out when the symbol rate and sampling rate are quite different the recovery loop cannot work at all. This paper presents a sampling frequency discriminator (SRD), which detects the frequency offset of the sampling clock to the symbol clock of the MQASK data transmitted. Employing the SRD, the closed loop timing recovery scheme performs the frequency-aided timing acquisition and achieve the synchronization at extremely high sampling frequency offset, which can be used in variable symbol rate MQASK receivers.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.12
• /
• pp.138-146
• /
• 2010

On wind turbine generators, the speed and volume of the wind affect the turbine angle speed which finally determines the output level of the electric power. However it is very difficult to forecast correctly the future power output and quality based on previous fixed sampling methods. This paper proposes a variable sampling method based on Buneman frequency estimation algorithm to reflect the variations of the frequency and amplitude on wind power outputs. The proposed method is also verified through the performance test by comparing with the results from previous fixed sampling methods and the real measurement data.

• Journal of the Korean Data and Information Science Society
• /
• v.16 no.3
• /
• pp.639-650
• /
• 2005

Theoretical and numerical comparison have shown that variable sampling interval (VSI) charts are substantially more efficient than fixed sampling interval(FSI) charts in term of ATS(average time to signal). But the frequency of switching between different sampling intervals is a complicating factor in VSI procedures. VSI EWMA charts for monitoring mean vector of related qualify characteristics are investigated. To compare the efficiencies of the proposed charts, the performances are evaluated for matched FSI and VSI charts in terms of average time to signal(ATS) and average number of samples to signal(ANSS). For the switching behavior of the proposed VSI charts, average number of switches(ANSW) are also investigated.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.2
• /
• pp.168-174
• /
• 2016

In this paper, current control using PI controller in the synchronous reference frame is analyzed through the relationship among bandwidth, resonance frequency, and sampling frequency in the grid-connected inverter with LCL filter. Stability is investigated by using bode plot in frequency domain and root locus in discrete domain. The feedback variable is the grid current, which is regulated by the PI controller in the synchronous reference frame. System delay is modeled as 1.5Ts, which contains computational and PWM modulator delay. Two resonance frequencies are given at 815 Hz and 3.16 kHz from LCL filter parameters. Sufficient phase and gain margins can be obtained to guarantee stable current control, in case that resonance frequency is above one-sixth of the sampling frequency. Unstable current control is performed when resonance frequency is below one-sixth of the sampling frequency. Analysis results of stability from frequency response and discrete response is the same regardless of resonance frequency. Finally, stability of current control based on theoretical analysis is clearly verified through simulation and experiment in grid-connected inverters with LCL filter.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.28 no.3
• /
• pp.274-285
• /
• 1992

Among various Power converters, a variable voltage variable frequency (VVVF) three-phase PWM inverter is regarded as most promising power converter due to its capabilities, which permits the control of voltage, frequency and harmonic contents in a single power stage employing only on DC source. As a modulating technique of the PWM inverter, the regular sampling technique has rendered possible the on-line computation and generation of PWM control waveforms with a reasonably high switching frequencies. In this paper, microprocessor based three-phase regular samping PWM inverter with real-time control algorithm and control circuits for driving three phase AC motor has been developed. Harmocic components of PWM waveform were analized theoretically in terms of Bessel function series and then calculated by digital computer and observed with spectrum analyzer.

• Journal of Electrical Engineering and Technology
• /
• v.11 no.3
• /
• pp.618-628
• /
• 2016

Active power filter (APF) has been proved as a flexible solution for compensating the harmonic distortion caused by nonlinear loads in power distribution power systems. Digital repetitive control can achieve zero steady-state error tracking of any periodic signal while the sampling points within one repetitive cycle must be a known integer. However, the compensation performance of the APF would be degradation when the grid frequency varies. In this paper, an improved repetitive control scheme with frequency adaptive capability is presented to track any periodic signal with variable grid frequency, where the variable delay items caused by time-varying grid frequency are approximated with Pade approximants. Additionally, the stability criterion of proposed repetitive control scheme is given. A three-phase shunt APF experimental platform with proposed repetitive control scheme is built in our laboratory. Simulation and experimental results demonstrate the effectiveness of the proposed repetitive control scheme.