• Mass Spectrometry Letters
• /
• v.15 no.1
• /
• pp.62-68
• /
• 2024

The Suspension Trapping (S-Trap) method has been a prominent sample preparation technique since its introduction in 2014. Its capacity to induce protein aggregation using organic solvents has significantly improved protein purification and facilitated peptide identification. However, its full potential for automation has been limited by the lack of a suitable liquid handling system until recently. In this study, we aimed to enhance the automation of S-Trap sample preparation by optimizing the S-Trap digestion process, incorporating triethylammonium bicarbonate (TEAB) and CaCl₂. The utilization of TEAB buffer conditions in this innovative process led to a noteworthy 12% improvement in protein identification. Additionally, through careful observation of various incubation conditions, we streamlined the entire sample preparation workflow into a concise 4 hours timeline, covering reduction, alkylation, and trypsin incubation stages. This refined and expedited automated S-Trap digestion process not only showcased exceptional time efficiency but also improved trypsin digestion, resulting in increased protein identification.

• Transactions on Electrical and Electronic Materials
• /
• v.15 no.6
• /
• pp.328-332
• /
• 2014

Thin film transistors (TFTs) with an amorphous silicon zinc tin oxide (a-2SZTO) channel layer have been fabricated using an RF magnetron sputtering system. The effect of the change of excitation electron on the variation of the total interfacial trap states of a-2SZTO systems was investigated depending on sputtering power, since the interfacial state could be changed by changing sputtering power. It is well known that Si can effectively reduce the generation of the oxygen vacancies. However, The a-2SZTO systems of ZTO doped with 2 wt% Si could be degraded because the Si peripheral electron belonging to a p-orbital affects the amorphous zinc tin oxide (a-ZTO) TFTs of the s-orbital overlap structure. We fabricated amorphous 2 wt% Si-doped ZnSnO (a-2SZTO) TFTs using an RF magnetron sputtering system. The a-2SZTO TFTs show an improvement of the electrical property with increasing power. The a-2SZTO TFTs fabricated at a power of 30 W showed many of the total interfacial trap states. The a-2SZTO TFTs at a power of 30 W showed poor electrical property. However, at 50 W power, the total interfacial trap states showed improvement. In addition, the improved total interfacial states affected the thermal stress of a-2SZTO TFTs. Therefore, a-2SZTO TFTs fabricated at 50 W power showed a relatively small shift of threshold voltage. Similarly, the activation energy of a-2SZTO TFTs fabricated at 50 W power exhibits a relatively large falling rate (0.0475 eV/V) with a relatively high activation energy, which means that the a-2SZTO TFTs fabricated at 50 W power has a relatively lower trap density than other power cases. As a result, the electrical characteristics of a-2SZTO TFTs fabricated at a sputtering power of 50 W are enhanced. The TFTs fabricated by rf sputter should be carefully optimized to provide better stability for a-2SZTO in terms of the sputtering power, which is closely related to the interfacial trap states.

• Korean journal of applied entomology
• /
• v.52 no.4
• /
• pp.341-348
• /
• 2013

We desinged and evaluated a remote-sensing sex pheromone trap for real-time monitoring of Mythimna separata (Lepidoptera: Noctuidae), a migratory insect in Korea. The system consisted of a modified cone-trap with a sex pheromone lure, a sensing module based on light interruption, a signal transmission module based on code division multiple access, a main electronic board for system control, a power supply based on a solar collector, a stainless steel-pole supporting the system, and a signal collection and display system based on an internet web page. The ratio (>92%) of the actual number of insects to the signal number in the remote-sensing trap was improved by sensing only within a limited period at night on the basis of the insect's circadian rhythm, control of signal sensitivity on the basis of sensing software programming, 1-h interval for signal transmission, and adjustment of the signal transmission program. The signal occurrence pattern in the remote-sensing trap was conclusively similar (correlation coefficient, >0.98) to the actual pattern of adult occurrence in the trap. The result indicated that the remote-sensing trap based on the attraction of the sex pheromone lure for M. separata has a promising potential for practical use. Occurrence of M. separata adults was observed several times in 2011 and 2012, and the peaks were sharp.

• Journal of Korean Society for Atmospheric Environment
• /
• v.25 no.6
• /
• pp.523-538
• /
• 2009

Recently, there has been a keen demand for real-time automatic monitoring of VOCs not only in Korea but other developed countries. We carried out this study to evaluate and to optimize the performance of a continuous automatic monitoring system for hazardous VOCs (HVOCs) in the ambient atmosphere, using an on-line GC system. The online system normally consisted of a Nafion dryer prior to a cold trap of an automatic thermal desorption apparatus and a GC system equipped with two detectors, i.e. PID and ECD. Preliminary tests conducted to check out any contamination of the system revealed an evidence of significant artifact formation of benzene, and it was found that the Nafion dryer (even brand new one) is the source of the benzene artifact. Thus, all the subsequent experiments in this study was carried out inevitably by removing the Nafion dryer. The on-line GC method was investigated with a variety of QC/QA performance criteria such as repeatability, linearity, lower detection limits, and accuracy. In order to find out the best operating condition for the on-line GC system, three different types (in terms of adsorption strength) of cold trap combinations were tested, i.e. (i) Tenax-TA and Carbopack-B combination (weak and hydrophobic); (ii) Tenax-TA, Carbopack-X and Carboxen-1000 combination (strong and hydrophilic); and (iii) Tenax-TA and Carbopack-X combination (medium and hydrophobic/hydrophilic). The USEPA TO-17 manual method was selected as a reference method to evaluate the performance of the on-line method. A series of experiments revealed that the system performance was superior to others when a cold trap packed with hydrophilic adsorbents (Tenax-TA/Carbopack-X/Carboxen-1000 combination) was used and operated at $25^{\circ}C$. However, the system with a cold trap packed with a combination of Tenax-TA and Carbopack-X is more recommended for field applications since the carboxen-1000 adsorbent is too sensitive to water vapor, and hence the performance of the system might be very unstable to humid samples or during rainy days. Furthermore, the precision and accuracy criteria of the Tenax-TA/ Carbopack-X combination were generally compatible with the triple adsorbents cold trap. The continuous automatic monitoring method is, thus, considered very useful to real-time monitoring to understand the variations of VOCs concentrations in ambient air, as it adopts much simpler procedures in sampling, analysis, and data integration steps than manual monitoring methods. However, it should be noted that there is a high possibility of benzene artifacts formation through the Nafion dryer, which is often installed to remove water vapor in air samples before being adsorbed onto the cold trap. Therefore, if a Nafion dryer is used in any studies of monitoring VOCs, the benzene contamination should be carefully examined before carrying out obtaining the data.

• Proceedings of the Plant Resources Society of Korea Conference
• /
• 2018.10a
• /
• pp.43-43
• /
• 2018

Mutation breeding by radiation is useful for improving various crop species. Up to now, a total of 170 soybean mutant varieties have been released in the world, which is the second most registered varieties after rice. Despite the economic importance of soybean, there have been no TRAP marker system studies on genetic relationships between/among mutant lines. To develop a strategy of Mutant Diversity Pool (MDP) conservation, a study on the genetic diversity of 210 soybean mutant lines (8 cultivars and 202 mutants) was performed through a TRAP analysis. Sixteen primer combinations amplified a total of 551 fragments. The highest (84.00%) and lowest (32.35%) polymorphism levels were obtained with primers MIR157B + Ga5 and B14G14B + Ga3, respectively. The mean PIC values 0.15 varied among the primer combination ranging from 0.07 in B14G14B + Sal2 to 0.23 in MIR157B + Sa4. Phylogenetic, principal component analysis (PCA) and structure analysis indicated that the 210 lines belong to four groups based on the 16 combination TRAP markers. AMOVA showed 21.0% and 79.0% variations among and within the population, respectively. Overall, the genetic similarity of each cultivar and its mutants were higher than within other mutant populations. Our results suggest that the TRAP marker system may be useful for assessing the genetic diversity among soybean mutants and help to improve our knowledge of soybean mutation breeding.

• Journal of Life Science
• /
• v.16 no.3 s.76
• /
• pp.540-545
• /
• 2006

T-DNA-mediated transformation is a common method for generating transgenic plants with insertional mutagenesis. In order to identify important genes involved in shoot development, a system of promoter trap insertional mutagenesis was employed in Arabidopsis thaliana. For this system, an efficient promoter trap vector, pFGL561 was developed. The pFGL561 includes a basta-resistant gene, an intron with multiple splicing donor and acceptor sites, and a promoter-less GFP reporter gene. Using floral-dipping method, we made total 300 $T_1$ promoter-trap lines which were screened for GFP expression. GFP signals in the $T_1$ plants were detected with high frequency, 26.7%, and the signals were reconfirmed in $T_2$ plants. To isolate the genes that are involved in shoot development, phenotypes were analyzed in $T_2$ plants of the 19 $T_1$ lines that had GFP signals in shoot apex, and 6 $T_1$ lines were selected that had abnormal shoot development. These lines will be very useful for the investigation of shoot development.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.29A no.8
• /
• pp.56-62
• /
• 1992

This paper is analyzed the charge trapping and electrical properties of 0(Oxide), NO(Nitrided oxide) and ONO(Reoxidized nitrided oxide) as dielectric films in MIS structures. We have processed bottom oxide and top oxide by the thermal method, and nitride(Si$_{3}N_{4}$) by the LPCVD(Low Pressure Chemical Vapor Deposition) method on P-type(100) Silicon wafer. We have studied the charge trapping properties of the dielectrics by using a computer controlled DLTS system. All of the dielectric films are shown peak nearly at 300K. Those are bulk traps. Many trap densities which is detected in NO films, but traps. Many trap densities which is detected in NO films. Varing the nitride thickness, the trap densities of thinner nitride is decreased than the thicker nitride. Finally we have found that trap densities of ONO films is affected by nitride thickness.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.3 no.6
• /
• pp.41-54
• /
• 1995

A mathematical model for wall-flow monolith ceramic diesel particulate filter was developed in order to describe the processes which take place in the filter during regeneration. The major output of the model comprises ceramic wall temperature and regeneration time(soot reduction). Various numerical tests were performed to demonstrate how the gas oxygen concentration, flow rate and the initial particulate trap loading affect the regeneration time and peak trap temperature. The model is shown to b in reasonable agreement with the published experimental results. This model can be applied to predict the thermal shock failure due to high temperature during combustion regeneration process.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2002.11a
• /
• pp.575-578
• /
• 2002

In this paper, we discuss carrier trapping model and trap characteristics of nitrided oxide thin film. Based on the experimental results, the carrier trapping model for system having multi-traps is proposed and is fitted with experimental data in order to determine trap parameter of nitride oxide and O2 annealed nitrided oxide. As a results of curve fitting, the heavy nitridation of oxide introduces three kinds of traps with capture cross section $\sigma$n1=1.48$\times$10$^{-17}$ $\textrm{cm}^2$, $\sigma$n2=1.51$\times$10$^{-19}$ $\textrm{cm}^2$, $\sigma$p=1.53$\times$10$^{-18}$ $\textrm{cm}^2$ and corresponding trap densities Nnl=2.66$\times$10$^{12}$ Cm$^{-2}$ , Nn2=1.32$\times$10$^{12}$ Cm$^{-2}$ , Np=8.35$\times$10$^{12}$ Cm$^{-2}$ .

• Proceedings of the Korean Society of Machine Tool Engineers Conference
• /
• 2004.04a
• /
• pp.530-537
• /
• 2004

Development of a versatile nanomanipulation tool is an overarching theme in nanotechnology. Such a tool will likely revolutionize the field given that it will enable fabrication and operation of a wealth of interesting nanodevices. This study seeks funding to create a novel nanomanipulation system with the ultimate goal of using this system for nanomanufacturing at the molecular level. The proposed design differs from existing approaches. It is based on a nanoscale ion trap integrated to a scanning prove microscope (SPM) tip. In this design, molecules to be assembled will be ionized and collected in the nanoscale ion trap all in an ultra high vacuum (UHV) environment. Once filled with the molecular ions, the nanoscale ion trap-SPM tip will be moved on a substrate surface using scanning probe microscopy techniques. The molecular ions will be placed at their precise locations on the surface. By virtue of the SPM, the devices that are being nanomanufactured will be imaged in real time as the molecular assembly process is carried out. In the later stages, automation of arrays of these nanomanipulators will be developed.