• Journal of the Korean Geotechnical Society
• /
• v.28 no.10
• /
• pp.17-25
• /
• 2012

Shotcrete, rockbolt, and steel rib are installed to support ground after tunnel was excavated. These are important supports for NATM applied tunnels. Recently, lattice girder is increasingly used because it is easily installed. In this study, we developed a new lattice girder by increasing contacting area between spider and rod. To verify the effect of the new lattice girder, the 3-point and 4-point flexural strength tests were carried out for LG-$50{\times}20{\times}30$, LG-$70{\times}20{\times}30$, LG-$95{\times}22{\times}32$. As a result, in case of contacting area, strength of new SGS lattice girder is 17.95% higher than that of original lattice girder. In case of weakness point, strength of new SGS lattice girder is 19.37% higher than that of original lattice girder.

• The Journal of the Korea Contents Association
• /
• v.6 no.2
• /
• pp.27-33
• /
• 2006

Boolean matrices are applied to a variety of areas and used successfully in many applications, and there are many researches on boolean matrices. Most researches deal with the multiplication of boolean matrices, but all of them focus on the multiplication of two boolean matrices and very few researches deal with the multiplication between many n$\times$m boolean matrices and all m$\times$k boolean matrices. The paper discusses the existing optimal algorithms for the multiplication of two boolean matrices are not suitable for the multiplication between a n$\times$m boolean matrix and all m$\times$k boolean matrices, establishes a theory that enables the efficient multiplication of a n$\times$m boolean matrix and all m$\times$k boolean matrices, and shows the execution results of a multiplication algorithm designed with this theory.

• Journal of the Institute of Convergence Signal Processing
• /
• v.13 no.1
• /
• pp.50-55
• /
• 2012

This paper proposes an optima] many-core processor architecture that meets the requirements of low power and high performance for different ultrasonic image resolutions in hand-held ultrasonic devices. To identify the optimal many-core architecture, seven different PE configurations are simulated for processing ultrasonic images in terms of execution performance and energy consumption. Experimental results indicate that the highest energy efficiencies are achieved at PEs=1,024, 64, and 256 for ultrasonic images at $256{\times}256$, $320{\times}240$, and $800{\times}480$ resolutions, respectively. In addition, the maximum area efficiencies are obtained at PEs=256 (for $256{\times}256$ and $800{\times}480$ image resolutions) and 64 (for $320{\times}240$ image resolution).

• Analytical Science and Technology
• /
• v.15 no.5
• /
• pp.393-398
• /
• 2002

A method to determine simultaneously fluorene and anthracene in aqueous solution by synchronous fluorescence spectrometry has been studied. The emission characteristics and optimum wavelength interval (${\Delta}{\lambda}$) for synchronous spectra of fluorene and anthracene in aqueous solution were investigated. The optimum wavelength interval (${\Delta}{\lambda}$) was found to be 50 nm. The calibration curve for fluorene and anthracene in the synthetic mixture solution of both compounds was linear over the range from $5.0{\times}10^{-8}M$ to $1.0{\times}10^{-3}M$ and from $5.0{\times}10^{-8}M$ to $1.0{\times}10^{-3}M$ for fluorene and anthracene, respectively. The detection limit was $3.0{\times}10^{-9}M$ and $7.0{\times}10^{-9}M$, for fluorene and anthracene, respectively under the optimal wavelength interval.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.16 no.1
• /
• pp.67-74
• /
• 1998

This paper performed terrain analysis using DTM(digital terrain model) with TIN/ GRID structure on PC environment. Contour layer from 1:5,000 scale map was used to produce DTM. DTHs were produced with and without considering breakline for each data structure. Processing time, file size, mean elevation and standard variation were analyzed for each DTM. slope map, aspect map were analyzed for grid structure with consideration of TEX>$5\times{5m},\;l0\times{10m},\;15\times{15m},\;l0\times{30m},\;45\times{45m},\;60\times{60m}$ cell size respectively. The results suggest following; The incorporation of breakline does improve mapping accuracy for highly disturbed landscape, Mean elevation doesn't increase as the grid size increases, while processing time, storage room is significantly lessened. Thus, the optimal grid size must be determined in advance for efficient application. slope decreases, while aspect increases as grid size is increasing.

• The Korean Journal of Applied Statistics
• /
• v.29 no.1
• /
• pp.231-242
• /
• 2016

X-13-ARIMA (a popular time series analysis software) provides $3{\times}3$, $3{\times}5$, $3{\times}9$, $3{\times}15$ moving average filters for seasonal adjustment. However, there has been questions on their performance and the need for new filters is a constant topic due to Korean economic time series often containing higher irregularity and more various seasonality than other countries. In this study, two newly developed seasonal moving average filters, $3{\times}7$ and $3{\times}11$, are introduced. New filters were implemented in X-13-ARIMA and applied to 15 economic time series to demonstrate their suitability and reliability. The result shows that some series are more stable when using new seasonal moving average filters. More accurate time series analyses would be possible if newly proposed filters are used together with existing filters.

• Journal of Korean Society of Steel Construction
• /
• v.10 no.2 s.35
• /
• pp.153-160
• /
• 1998

The sectional dimensions and initial crookedness of the RHS(rectangular hollow section, ${\boxe}-75{\times}75{\times}3.2,\;{\boxe}-100{\times}100{\times}4.2,\;{\boxe}-125{\times}125{\times}6.0$) were measured. The axial compressive strength tests for columns with slenderness $46{\sim}84$ were performed as well as stub tests and tensile tests. FEM analysis was also used. The measurement shows that the errors of sectional dimensions are negligible. For the column length corresponding to ${\lambda}=100$, the initial crookedness with the 2.5% probability estimated from the measured results is 1/490, 1/1121 1/1395 for each section respectively. The yield strengths obtained from tensile test are higher than the specified minimum value by more than 30%. The column test shows that the maximum axial resistances are almost same as, or a little higher than the FEM results and the specified strength curves of AISC Specification and Eurocode, when the maximum strengths from the stub tests are used as the yield strength of the steel. But the test results show much higher column strength than those specified in the Standard and Code, when the specified minimum yield strength of the steel is used.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2003.11a
• /
• pp.584-589
• /
• 2003

The hot cell facility which is designed to permit safe handling of source materials with radioactivity levels up to 1,385 TBq, is planned to be built. To meet this goal, the facility is designed to keep gamma and neutron radiation lower than the recommended dose-rate in normally occupied areas. The calculations performed with QAD-CGGP and MCNP-4C are used to evaluate the proposed engineering design concepts that would provide acceptable dose-rates during a normal operation in hot cell facility. The maximum effective gamma dose-rates on the surfaces of the facility at operation area and at service area calculated by QAD-CGGP are estimated to be $2.10{\times}10^{-3}$, $2.97{\times}10^{-2}$ and $1.01{\times}10^{-1}$ mSv/h, respectively. And those calculated by MCNP-4C are $1.60{\times}10^{-3}$, $2.99{\times}10^{-3}$ and $7.88{\times}10^{-2}$ mSv/h, respectively The dose-rates contributed by neutrons are one order of magnitude less than that of gamma sources, and penetration and toboggan will be partly reinforced by lead shield.

• Journal of Plant Biology
• /
• v.15 no.1
• /
• pp.33-41
• /
• 1972

Nine shrub layer communities under two relatively well conserved natural summer green forests in the central region of Korean Peninsula were studied for the pattern of stem distribution in terms of Greig-Smith's multiple split-plot experiment and for the association between the population of the two main species in terms of Kershaw's covariance analysis respectively. Four contiguous belt transects, $4{\times}64m size with 1{\times}1m$ basic unit, were set in each shrub layer communities. Significant primary clumps with $1{\times}1m or 1{\times}2m$ dimension wer observed consistently throughout the nine study sites. The primary clumps themselves were significantly distributed either regularly or at random. The association between the two principal species of each shrub layer is highly significantly either positive or negative in $1{\times}1m or 1{\times}2m$ dimension. As the plot size increases from $1{\times}1m to 8{\times}8m$ the associational trends were changed from negative to positive direction in one forests. But the change from positive to negative direction and the consistent negative association were also observed from the other forest. All of the association trends were observed only from $1{\times}1m to 4{\times}4m$ dimension. These results are suggestive that the distributional pattern of the shrub layer species under the summer green forest is simple mosaic fashioned with $1{\times}1m or 1{\times}2m$ dimension. The rest of the principal species are located in that matrix. The simple mosaic pattern of two principal species are located in that matrix. The simple mosaic pattern of two principal species seems to be controlled by change in micro-environmental pattern. Differences between the primary random group and clumped group among sites also suggest that competition exists for light or/and soil between primary clumped groups.

• Journal of Korean Ophthalmic Optics Society
• /
• v.17 no.4
• /
• pp.435-440
• /
• 2012

Purpose: The purpose of this study is developing the dot sight with a $2{\times}$ magnification. Methods: To magnify the target when we see the far through the non-magnified dot sight, we develop the new optical device which is detachable to the non-magnified dot sight. A new optical device is designed to facilitate the transition of an existing non-magnification ($1{\times}$) dot sight to the $2{\times}$ magnification dot sight. Results: We could design and fabricate the $2{\times}$ afocal optical system which is detachable to the non-magnified dot sight and be composed by a pair of doublet. When the system developed in this study was used, we could aim the external target by twice magnification, so we could further improve the accuracy of aim. Conclusions: We could design and manufacture the $2{\times}$ afocal optical system which can be detachable to the non-magnified dot sight. With the results, we could aim the external target by twice magnification, so we could further improve the accuracy of aim.