• Journal of Advanced Navigation Technology
• /
• v.6 no.2
• /
• pp.130-137
• /
• 2002

We present Space-Time Trellis Coded Code Division Multiple Access systems, which maintain the full diversity and coding gain of Space-Time Trellis Codes(STTC) and have the immunity to performance degradation caused by multipath fading. These STTC CDMA systems are constructed by adding the spreading and despreading processes of PN codes to STTC systems. In multipath fading channels, delay spreaded signals are detected and combined, then decoded. According to the combining and decoding methods, there are four decoding methods. There are optimum ML decoding without combining, adding multipath signals in each receive antenna before decoding, combining multi path signals in each antenna before decoding, and combining all received signals before decoding. Performance of these methods is proportional to complexity. Besides, all methods are shown to compensate the irreducible error rate which appears in multipath fading channels.

• Journal of the Institute of Convergence Signal Processing
• /
• v.8 no.3
• /
• pp.222-226
• /
• 2007

In this paper we composed the dual fuzzy rules using each region of specific points and $e-{\Delta}e$ phase plane In order to make dual fuzzy rule base. We composed the fuzzy control rules which can decrease rise time, delay time, maximum overshoot than basic fuzzy control rules. proposed method is alternately use at specific points of $e-{\Delta}e$ phase plane with two fuzzy control rules that is one control rule occruing the steady state error in transient region and another fuzzy control rule use to decrease the steady state error and rapidly converge at the convergence region. Also, two fuzzy control rules in the $e-{\Delta}e$ phase plane decide the change time according to response characteristics of plants. In order to confirm thef proposed algorithm. As the results of experiments through the hydraulic servo motor control system with a DSP processor, We verified that proposed dual fuzzy control rules get the good response compare with the basic fuzzy control rule.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.38 no.5
• /
• pp.671-683
• /
• 2018

The flood damage caused by heavy rains in urban watershed is increasing, and, as evidenced by many previous studies, urban flooding usually exceeds the water capacity of drainage networks. The flood on the area which considerably urbanized and densely populated cause serious social and economic damage. To solve this problem, deterministic and probabilistic studies have been conducted for the prediction flooding in urban areas. However, it is insufficient to obtain lead times and to derive the prediction results for the flood volume in a short period of time. In this study, IDNN, TDNN and NARX were compared for real-time flood prediction based on urban runoff analysis to present the optimal real-time urban flood prediction technique. As a result of the flood prediction with rainfall event of 2010 and 2011 in Gangnam area, the Nash efficiency coefficient of the input delay artificial neural network, the time delay neural network and nonlinear autoregressive network with exogenous inputs are 0.86, 0.92, 0.99 and 0.53, 0.41, 0.98 respectively. Comparing with the result of the error analysis on the predicted result, it is revealed that the use of nonlinear autoregressive network with exogenous inputs must be appropriate for the establishment of urban flood response system in the future.

• The Journal of the Acoustical Society of Korea
• /
• v.33 no.1
• /
• pp.48-53
• /
• 2014

The underwater acoustic communication (UAC) is characterized by doubly spread channel. It is included in the time-variant doppler shift and delay-time spreads due to multiple paths. To compensate such distorted signals, various techniques including time-reversal processing, spatial diversity, phase estimator, and equalizer are being applied. In this paper, a spatial filter based on the beamforming is proposed as a method to mitigate such inter-symbol interferences that are generated in time-varying multipath channels. The proposed technique realizes coherent communications by steering the direction of the desired signals and improves the performance of UAC by increasing the signal-to-interference plus noise ratio using the array gain.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.6B
• /
• pp.601-609
• /
• 2002

In multi-path wireless channels with time-variant delay profile, a mobile station measures the received signal strength and report it to network which performs network control function such as handover. In order to improve the maximum ratio combining (MRC) gain, it also should search the strongest signal paths and measure their time offsets fast and exactly. This paper proposes some methods of fast and exactly measuring the multi-path signal strength and time offset. Since the W-CDMA system adopts antenna diversity technique for the next generation high speed packet access (HSDPA) service, we derive the optimum design parameter values for the proposed methods through computer simulations under the HSDPA conditions o( low speed of mobile, of no power control, and of multi-path wireless environment with transmit and receive antenna diversity. Finally, we prove the validity of the proposed methods by showing the improvement of the bit error rate (BER) performance.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.14 no.4
• /
• pp.463-470
• /
• 2014

A Verilog model is proposed for transmission lines to perform the all-Verilog simulation of high-speed chip-to-chip interface system, which reduces the simulation time by around 770 times compared to the mixed-mode simulation. The single-pulse response of transmission line in SPICE model is converted into that in Verilog model by converting the full-scale analog signal into an 11-bit digital code after uniform time sampling. The receiver waveform of transmission line is calculated by adding or subtracting the single-pulse response in Verilog model depending on the transmitting digital code values with appropriate time delay. The application of this work to a USB 2.0 high-speed PHY interface reduces the simulation time to less than three minutes with error less than 5% while the mixed-mode simulation takes more than two days for the same circuit.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.1
• /
• pp.31-36
• /
• 2014

Security of chaos communication system that has characteristic of sensitive initial conditions is superior to digital communication systems, but BER(Bit Error Rate) performance is evaluatied badly. So, studies in order to improve the BER performance is important. existing studies, BER performance of proposed chaos transceiver is possible to improve than the CDSK(Correlation Delay Shift Keying) system because it has characteristic that has very few addition elements like noise signal except for the desired signal. Chaos communication system has many symbols because it spreads according to characteristic of chaos map. Therefore, study that can have the good data rate in chaos communication system is required. Information bits of existing chaos modulation system are modulated as -1 and 1 on the basis of BPSK system. However, instead of BPSK system, if chaos communication system is applied high level modulation systems such as QPSK system and 16QAM system, it is possible to have good data rate because more data are transmitted at a time. In the paper, when QPSK system and 16QAM system are applied to proposed chaos transceiver in existing study, we evaluate the SER(Symbol Error Rate) performance and compare the each performance. Also, when QPSK system and 16QAM system are applied to proposed chaos transceiver, we evaluate the anti-jamming performance of proposed system.

• Journal of the Korean Society for Precision Engineering
• /
• v.25 no.10
• /
• pp.58-66
• /
• 2008

In the development of intelligent vehicles, path tracking of unmanned vehicle is a basis of autonomous driving and automatic navigation. It is very important to find the exact position of a vehicle for the path tracking, and it is possible to get the position information from GPS. However the information of GPS is not the current position but the past position because a vehicle is moving and GPS has a time delay. In this paper, therefore, the moving distance of a vehicle is estimated using a direction sensor and a velocity sensor to compensate the position error of GPS. In the steering control, optimal fuzzy rules for the path tracking can be found through the simulation of Simulink. Real driving experiments show the fuzzy rules are good for the steering control and the position error of GPS is well compensated by the proposed estimation method.

• Journal of the Korean Institute of Navigation
• /
• v.24 no.5
• /
• pp.443-450
• /
• 2000

Before some experiments were carried out with analog bandpass filter which used for filtering the noise included in sound source signal. And this filter was constituted by condenser, register and operational amplifier. Hut these elements made the phase characteristics to differentiate in each sensing channel and cause a little of measurement error. We made new measurement system that was substituted digital filter for the analog filter in order to develop the optimal system which could find the time delay between each sensors with high accuracy. This paper describes the new system's constitution and the function of each parts. Specially three digital filters were designed and applied to the digital signal processing Part. And a series of experiments were carried out with the source＇s distance 9.53meters and the random bearing interval within the limits of $0^{\circ}$ ~ $180^{\circ}$. As a result, we have recognized that the accuracy of measurements were differentiated by the methods what kind of digital filter were adopted. And we have confirmed the facts that IIR LPF was suitable for sound source's bearing measurement and FIR LPF reduced the range measurement error.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.4
• /
• pp.35-42
• /
• 2008

Since Bianchi's 2-D Markov Chain Model considers collision problem only in ideal channel condition, it does not reflect real channel impaired by fading, interference, and noise. Distributed Coordination Function(DCF) doubles its contention window(CW) when transmission fails regardless of collision or transmission error. Increase of CW caused by transmission error degrade throughput and increase the delay. In this paper, we present quantitative analysis of the impact of the parameters such as contention window size(CW), transmission probability for a given time slot(${\Im}$), transmission failure probability($p_f$), on the system performance and provide a method how to decrease the initial CW to achieve equivalent performance.