• 한국세라믹학회지
• /
• 제41권12호
• /
• pp.900-906
• /
• 2004

현재까지 개발되어 온 고체산화물 연료전지는 전해질로 사용되는 산소이온전도성 산화물의 저온에서의 낮은 전도도로 인해 그 사용영역이 제한되어 왔으며, 기판재료가 연료가스 확산층으로 사용되어야 한다는 점 때문에 저온작동을 위한 박막화 역시 명확한 한계를 가지고 있다. 이러한 문제점은 고도의 평활도를 갖는 균일한 나노기공성 기판재를 도입함으로써 해결될 수 있으며, 본 연구에서는 나노기공성 기판에 비정질 금속박막을 증착/산화하는 방안을 제시한다. 초박막형 성공정으로서, 산화 후 산소이온전도성 산화물을 구성하는 합금 타겟을 장착한 DC-magnetron sputter를 사용하여 $20{\sim}200nm$의 기공크기를 갖는 나노기공성 양극산화 알루미나 기판에 비정질 금속합금막을 형성하여 산화/열처리 과정을 거쳐 초박막 산화물 전해질의 제조공정을 실현하였다. 얻어진 박막의 가스투과특성, 입자/입계의 관찰, 상전이에 따른 결정구조/미세구조변화를 관찰하여 초박막 증착 및 전해질의 나노구조제어에 필요한 제반 기본물성데이터를 확보하였다.

• 한국세라믹학회지
• /
• 제48권4호
• /
• pp.316-322
• /
• 2011

Tin oxide thin films were deposited by rf reactive sputtering and annealed at $400^{\circ}C$ for 1 h in vacuum. To minimize the influence such as reduction, oxidation, and doping on tin oxide thin films during annealing, a vacuum ambient annealing was adopted. The structural, optical, and electrical properties of tin oxide thin films were characterized by X-ray diffraction, atomic force microscope, UV-Vis spectrometer, and Hall effect measurements. After vacuum annealing, the grain size of all thin films was slightly increased and the roughness ($R_a$) was improved, however irregular and coalesced shapes were observed from the most of the films. These irregular and coalesced crystal shapes and the possible elimination of intrinsic defects might have caused a decrease in both carrier concentration and mobility, which degrades electrical conductivity.

• 한국재료학회지
• /
• 제17권6호
• /
• pp.308-312
• /
• 2007

Chromium oxide thin films have been deposited on silicon substrates using a tabletop 9kJ mathertyped plasma focus (PF) device. Before deposition, pinch behavior with gas pressure was observed. Strength of pinches was increased with increasing working pressure. Deposition was performed at room temperature as a function of working pressure between 50 and 1000 mTorr. Composition and surface morphology of the films were analyzed by Auger Electron Spectroscopy and Scanning Electron Microscope, respectively. Growth rates of the films were decreased with pressure. The oxide films were polycrystalline containing some impurities, Cu, Fe, C and revealed finer grain structure at lower pressure.

• 한국재료학회지
• /
• 제23권9호
• /
• pp.477-482
• /
• 2013

We investigated the detection properties of nitrogen monoxide (NO) gas using transparent p-type $CuAlO_2$ thin film gas sensors. The $CuAlO_2$ film was fabricated on an indium tin oxide (ITO)/glass substrate by pulsed laser deposition (PLD), and then the transparent p-type $CuAlO_2$ active layer was formed by annealing. Structural and optical characterizations revealed that the transparent p-type $CuAlO_2$ layer with a thickness of around 200 nm had a non-crystalline structure, showing a quite flat surface and a high transparency above 65 % in the range of visible light. From the NO gas sensing measurements, it was found that the transparent p-type $CuAlO_2$ thin film gas sensors exhibited the maximum sensitivity to NO gas in dry air at an operating temperature of $180^{\circ}C$. We also found that these $CuAlO_2$ thin film gas sensors showed reversible and reliable electrical resistance-response to NO gas in the operating temperature range. These results indicate that the transparent p-type semiconductor $CuAlO_2$ thin films are very promising for application as sensing materials for gas sensors, in particular, various types of transparent p-n junction gas sensors. Also, these transparent p-type semiconductor $CuAlO_2$ thin films could be combined with an n-type oxide semiconductor to fabricate p-n heterojunction oxide semiconductor gas sensors.

• 한국전기전자재료학회논문지
• /
• 제28권7호
• /
• pp.433-438
• /
• 2015

Zinc tin oxide transparent thin film transistors (ZTO TTFTs) were fabricated by using $n^+$ Si wafers as gate electrodes. Indium (In), aluminum (Al), indium tin oxide (ITO), silver (Ag), and gold (Au) were employed for source and drain electrodes, and the mobility and the threshold voltage of ZTO TTFTs were observed as a function of electrode. The ZTO TTFTs adopting In as electrodes showed the highest mobility and the lowest threshold voltage. It was shown that Ag and Au are not suitable for the electrodes of ZTO TTFTs. As the results of this study, it is considered that the interface properties of electrode/ZTO are more influential in the properties of ZTO TTFTs than the conductivity of electrode.

• Bulletin of the Korean Chemical Society
• /
• 제32권4호
• /
• pp.1331-1335
• /
• 2011

We report the results of the characterization of Cu oxide thin films deposited by radio frequency (r.f.) magnetron sputtering at different annealing temperatures. The deposited Cu oxide thin films were investigated by scanning electron microscopy, spectroscopic ellipsometry, X-ray diffraction, atomic force microscopy, Xray photoelectron spectroscopy, and contact angle measurements. The thickness of the films was about 180 nm and the monoclinic CuO phase was detected. The $CuO_2$ and $Cu(OH)_2$ phases were grown as amorphous phase and the ratio of the three phases were independent on the annealing temperature. The surface of Cu oxide films changed from hydrophilic to hydrophobic as the annealing temperature increased. This phenomenon is due to the increase of the surface roughness. The direct optical band gap was also obtained and laid in the range between 2.36 and 3.06 eV.

• 한국세라믹학회지
• /
• 제43권12호
• /
• pp.751-757
• /
• 2006

Recently, a new type of solid oxide fuel cells has been developed employing extremely thin oxide electrolyte. These fuel cells are expected to operate at significantly reduced temperature compared to conventional solid oxide fuel cells. Accordingly, they may resolve the stability and material selection issues of high temperature fuel cells. Furthermore, they may eliminate the limitations of polymer membrane fuel cells whose operation temperature is under $100^{\circ}C$. In this paper, we review the electrolytes for intermediate temperature operation. Then, we discuss the current development of thin film solid oxide fuel cells that possibly operated at low temperatures.

• Journal of information and communication convergence engineering
• /
• 제8권4호
• /
• pp.453-456
• /
• 2010

Tantalum oxide ($Ta_2O_5$) films are of considerable interest for a range of application, including optical waveguide devices, high temperature resistors, and oxygen sensors. In this paper, we establish an anode oxidation process of tantalum thin film. The voltage drop in the electrolyte is affected not in voltage change but in current change. If the voltage drop in the electrolyte is same with cathode oxidation voltage, the current changes logarithmically in proportion to the voltage drop in interface of tantalum oxide and electrolyte. As a result of the measurement on the electrical property of tantalum oxide thin film, when the thickness of the insulator film is $1500{\AA}$, the breakdown voltage is 350volts and dielectric constant is 29.

• Transactions on Electrical and Electronic Materials
• /
• 제4권6호
• /
• pp.32-37
• /
• 2003

In this paper, the trap characteristics of thin silicon oxides is investigated in the ULSI implementation with nano structure transistors. The stress and transient currents associated with the on and off time of applied voltage were used to measure the distribution of high voltage stress induced traps in thin silicon oxide films. The stress and transient currents were due to the charging and discharging of traps generated by high stress voltage in the silicon oxides. The transient current was caused by the tunnel charging and discharging of the stress generated traps nearby two interfaces. The stress induced leakage current will affect data retention in electrically erasable programmable read only memories. The oxide current for the thickness dependence of stress current, transient current, and stress induced leakage currents has been measured in oxides with thicknesses between 113.4nm and 814nm, which have the gate area 10$\^$-3/ $\textrm{cm}^2$. The stress induced leakage currents will affect data retention, and the stress current and transient current is used to estimate to fundamental limitations on oxide thicknesses.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2016년도 제50회 동계 정기학술대회 초록집
• /
• pp.421.1-421.1
• /
• 2016

We studied indium-doped zinc oxide (IZO) film grown by atomic layer deposition (ALD) as transparent conductive oxide (TCO). A variety of TCO layer, such as ZnO:Al (AZO), InSnO2(ITO), Zn (O,S) etc, has been grown by various method, such as ALD, chemical vapor deposition (CVD), sputtering, laser ablation, sol-gel technique, etc. Among many deposition methods, ALD has various advantages such as uniformity of film thickness, film composition, conformality, and low temperature deposition, as compared with other techniques. In this study, we deposited indium-doped zinc oxide thin films using diethyl[bis(trimethylsilyl)amido]indium [Et2InN(TMS)2] as indium precursor, DEZn as zinc precursor and H2O as oxidant for ALD and investigated the optical and electrical properties of IZO films. As an alternative, this liquid In precursor would has several advantages in indium oxide thin-film processes by ALD, especially for low resistance indium oxide thin film and high deposition rate as compared to InCp, InCl3, TMIn precursors etc. We found out that Indium oxide films grown by Et2InN(TMS)2 and H2O precursor show ALD growth mode and ALD growth window. We also found out the different growth rate of Indium oxide as the substrate and investigated the effect of the substrate on Indium oxide growth.