• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.37 no.5
• /
• pp.23-30
• /
• 2000

To compensate the nonlinearity of electroabsorption modulator(EAM) resulting from its near exponential transfer function, a semiconductor optical amplifier(SOA) that has a log transfer function is used. Since the transfer function of SOA is inverse to that of EAM, the intermodulation distortion(IMD) of EAM can be reduced by cascading SOA to EAM. Also, the RF gain can be increased by the optical gain of SOA. For these reasons, spurious free dynamic range(SFDR) of EAM is enhanced by connecting SOA to EAM in series and operating in gain salutation region. To improve the nonlinearity compensation of EAM, the increased gain of SOA is required and the slope of gain saturation, the ratio of gain to input SOA power, needs to be steep. However, signal spontaneous beat noise that is the dominant system noise increases in proportion to the gain such that the SFDR of EAM is reduced. The higher the gain of SOA is, the more ASE is increased. Thus the noise level of system is increased and the following SFDR of EAM is decreased. The slope of gain saturation region and ASE of have trade-off relation and the optimization is achieved at 8㏈ optical gain. 9㏈ enhancement of SFDR of EAM is obtained. This scheme is easy to embody the linear EAM and the integration with three components (DFB-LD, EAM and SOA) offers many merits, such as low insertion loss, low chirping and low polarization sensitivity.

• Journal of the Korea Concrete Institute
• /
• v.13 no.4
• /
• pp.314-320
• /
• 2001

In this paper, the properties of an expansive agent (CaO-CaS $O_4$) for dry shrinkage compensation were investigated by a series of experimental program, which might be used at On-Dol heating system as mortar type. The expansion principle of the CaO-CaS $O_4$ was mainly verified. As a result of this study, the correlation between the content of the expansive agent and the compressive strength was obtained in the form of exponential function(Y = A $e^{-x}$), showing that as the content of expansive agent increased as the expansion performance with the compressive strength increased by only a certain amount. Also, as a results of the analysis of a correlation between the expansive performance and the chemical properties which generally accompanied a part of quality management in manufacturing the expensive cement, the expansive performance was relative to only the contents of the F-CaO among chemical properties(Blaine, +44$\mu\textrm{m}$R, F-CaO, S $O_3$,L.O.I). And it was clarified that the results were relative to the second order function, showing that if the contents of the F-CaO increased the expansive performance Increased.d.

• Journal of Aerospace System Engineering
• /
• v.16 no.5
• /
• pp.62-69
• /
• 2022

EHA (Electro-Hydrostatic Actuator) is more energy efficiency than a centralized hydraulic system. In particular, the EHA used for aircraft has a redundant design in preparation for failure scenario. Also, due to the aircraft's internal space limitation, the actuator's length must be optimized. Therefore, a series configuration of double rod and single rod cylinder is advantageous. However, due to the asymmetry of the cross-sectional area of the piston, the force fighting phenomenon between the two cylinder areas occurs during redundant operation with a general control system. In this paper, the force fighting phenomenon of redundant EHA was simulated. A controller with load compensation and a force control-based position controller as a method to suppress its stimulation

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.27 no.6
• /
• pp.22-29
• /
• 2023

In the evaluation of seismic performance for structural materials and components, the loading rate and axial force can have a significant impact. Due to time-delay effects between input and output displacements, It is difficult to apply high-rate displacement in cyclic tests and hybrid simulations. Additionally, the difficulty of maintaining a consistent vertical load in the presence of lateral displacement has limited fast and real-time tests performed while maintaining a constant vertical load. In this study, slow, fast cyclic tests and real-time hybrid simulations were conducted to investigate the rate dependency and the influence of vertical loads of Isolation Bearing. In the experiment, the FLB System including an Adaptive Time Series (ATS) compensation and a state estimator was constructed for real-time control of displacement and vertical load. It was found that the vertical load from the superstructure and loading rate can have a significant impact on the strength of the seismic isolation bearing and its behavior during an earthquake. When conducting experiments for seismic performance evaluation, they must be implemented to be similar to reality. This study demonstrates the excellent performance of the system built and used for seismic performance evaluation and enables accurate and efficient seismic performance evaluation.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.1
• /
• pp.379-387
• /
• 2015

A custom power device provides an integrated solution to the present problems that are faced by the utilities and power distribution. In this paper, a new controller is designed which is connected to a multiconverter unified power quality conditioner (MC-UPQC) for improving the power quality issues adopted modified synchronous reference frame (MSRF) theory with Fuzzy logic control (FLC) technique. This newly designed controller is connected to a source in order to compensate voltage and current in two feeders. The expanded concept of UPQC is multi converter-UPQC; this system has a two-series voltage source inverter and one shunt voltage source inverter connected back to back. This configuration will helps mitigate any type of voltage / current fluctuations and power factor correction in power distribution network to improve power quality issues. In the proposed system the power can be conveyed from one feeder to another in order to mitigate the voltage sag, swell, interruption and transient response of the system. The control strategies of multi converter- UPQC are designed based on the modified synchronous reference frame theory with fuzzy logic controller. The fast dynamics response of dc link capacitor is achieved with the help of Fuzzy logic controller. Different types of fault conditions are taken and simulated for the analysis and the results are compared with the conventional method. The relevant simulation and compensation performance analysis of the proposed multi converter-UPQC with fuzzy logic controller is performed.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.8 no.3
• /
• pp.1-14
• /
• 1971

A relay servo, one of the nonlinear sytsems, is inherently compact compared to a linear system for an equivalent control problem. The power element or actuator is not adjusted proportionally in accordance with an error signals but rather is switched abruptly between several discrete conditions. Usually switched conditions are off, full, forward or full reverse. The relay system is a particularly simple and compact one, but probably more effort has been expended on its analysis and design than on all other systems together. Early studies in the art were made by Goldfarb, austin, Oppelt and Kochenburger on the describing function method, which can be used as an approximate check on the stability of the system. The describing function method is based on the assumption that any periodic wave could be approximated as a fundamental one in wide ranges of practical applications. A relay servo system usually operates on a limit cycle condition as the loop gain increases. The stability analysis compensation or any improvement effort based on the describing function method sometimes may present considerable discrepancies on physically realized practical systems. An approach to exact periodic solutions of a relay servo system is much important for the analysis, design and system improvement. This paper dells with periodic solutions of a relay servo system on the basis of describing function and generalized chopper wave form which is composed of infinite number of harmonic series. Various ways of graphical representation were attempted to get periodic solutions, some of which have shown its validity in rapid approach to exact solutions and also in judgement of system behavior.

• Korean Journal of Social Welfare
• /
• v.58 no.4
• /
• pp.313-339
• /
• 2006

The purpose of this study is to analysis empirically the socio-structural causes of working poor. This study used raw data of of Korea National Statistical Office from 1982 to 2004, and put in operation time series multiple regression analysis to use socio-economic factors of macro-economy environment, labor market, distribution system. Contrary to assertion of growth-concentrated people, economic growth rate has had significantly positive effect on the change of working poor size. In the growth period there has been trickle down effect of economic growth, but in the post-Fordism period there has not been valid circular relation. Recent introduction of the U. S. type capitalism resulted in negative phenomenon like aggravation of income distribution, deterioration of employment quality, enlargement of working poor. And there rise a question on socio-economic durability due to de-compensation on intra-institution. It is necessary to grope transition to the high road social market model - that is stable and sustainable - correspond to Korea that is stable and sustainable.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.19 no.4
• /
• pp.62-70
• /
• 2005

This paper presents the actual conditions and reform measures of voltage and current harmonics being made in low-voltage power systems supplying various loads. The measurements were carried out at the secondary output terminals of 22.9[kV]/380[V]220[V] customer's transformers, and the results were discussed on the basis of the comparison with IEEE and IEC harmonics control standards. The voltage THDs of the power systems employed in this survey were less than $5[\%]$ that is considered to be acceptable. On the contrary, the current distortions were significantly greater than the voltage distortions, and the current THDs were distributed over the wide-range from 15.7 to $60.4[\%]$. In particular, the current distortion on the low voltage power lines of office buildings in which many PC and fluorescent lamps are used is remarkably more serious than that of factory facilities. As a result, the voltage distortion factors are observed within the range of its allowable level or less than the limits, but the current distortion factors are significantly greater than the limits of IEEE and IEC standards.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.6
• /
• pp.1231-1243
• /
• 1997

Digital satellite communication channels have nonlinearities with memory due to saturation characteristics of traveling wave tube amplifier in the satellite and transmitter/receiver linear filters. In this paper, we propose a network structure and a learning algorithm for complex pi-sigma network (CPSK) and exploit CPSN in the problem of equalization of nonlinear satellite channels. The proposed CPSN is a complex-valued extension of real-valued pi-sigma network that is a higher-order feedforward network with fast learning while greatly reducing network complexity by utilizing efficient form of polynomials for many input variables. The performance of the proposed CPSN is demonstrated by computer simulations on the equalization of complex-valued QPSK input symbols distorted by a nonlinear channel modeled as a Volterra series and additive noise. The results indicate that the CPSN shows good equalization performance, fast convergence, and less computations as compared to conventional higher-order models such as Volterra filters.

• Journal of Broadcast Engineering
• /
• v.6 no.2
• /
• pp.121-130
• /
• 2001

We propose an efficient DCT-domain video transcoding algorithm for flexible for bit-rate video communications. Video transcoding provides communication fiexibility by adaptively changing the bit-rate of compressed bit stream. During the transcoding process, adrift error is unavoidable because of the difference between reference images in the series of encoding and decoding. For solving the drift error problem, cascade pixel-domain transcoder (CPDT) has been proposed. CPDT, however, requires highly complex hardware and heavy computational overhead. In this paper we propose a DCT-domain transcoding technique, which enables efficient transcoding without any drift error. The proposed cascade DCT-domain transcoder (CDDT) is realized by new motion compensation and down-sampling methods in the DCT-domain.