• Membrane and Water Treatment
• /
• v.8 no.6
• /
• pp.575-590
• /
• 2017

PolyHIPEs membrane prepared with styrene (St), divinylbenzene (DVB), and ethylhexyl acrylate (EHA) can yield a unique pore structure provided by large voids highly interconnected by many small window throats. With the advantageous pore structure, PolyHIPE presents a potential as a support for carrier facilitated transport membrane. Tricaprylmethylammonium chloride (Aliquat 336) can be efficiently incorporated into the PolyHIPE membrane by a two-step solvent-nonsolvent method to obtain an Aliquat 336-immobilized PolyHIPE membrane with good stability. The study of Cr (VI) transport through Aliquat 336-immobilized PolyHIPE membrane indicates that the membrane has high initial flux and maxima stripping flux ($J_f^o=15.01({\mu}mol/m^2s)$, $J_s^{max}=6.15({\mu}mol/m^2s)$). The reusability study shows that the Aliquat 336-immobilized PolyHIPE membrane can maintain high Cr(VI) recovery efficiency even after 15 cycles of operations. The developed membrane was also used in the separation of Cr (VI) from other anions (i.e., $SO_4{^{2-}}$ and $NO_3{^-}$) and other cations (i.e., Ni (II), Mg (II) and Cu (II)) with good selectivity.

• Macromolecular Research
• /
• v.9 no.5
• /
• pp.285-291
• /
• 2001

The polysulfone(PSf)/polyethersulfone(PES) blend membranes were prepared by an immersion precipitation method. N-methyl-2-pyrrolidone(NMP) was used as a solvent and water as a nonsolvent. The composition of the coagulation bath and the dope polymer concentration as well as the blend ratio of two polymers were varied. The membrane morphologies were interpreted on the basis of the phase diagram of the PSf/PES/NMP/water system. As the solvent content in the coagulation bath increased in the single polymer system, the number of macrovoids decreased and the morphology was changed from finger-like to cellular structure. In the given bath condition phase separation occurs earlier for the solutions of PSf/PES blend than for those of single polymer. A horizontally layered structure and horizontal protuberances inside the macrovoid were observed for the membranes formed from PSf/PES blend solutions. This peculiar structure formation can be interpreted by a PSf-rich/PES-rich phase separation followed by a polymer-rich/polymer-lean phase separation during the exchange of solvent and nonsolvent.

• Resources Recycling
• /
• v.26 no.2
• /
• pp.3-10
• /
• 2017

Rare earth elements with high purity are demanded for the manufacture of advanced materials. Light rare earth elements are contained in domestic monazite and Ni-MH batteries. In this paper, solvent extraction to separate the light rare earth elements from hydrochloric acid leaching solutions of these resources was discussed. A mixture of cationic and tertiary amine shows synergistic effect on the extraction of LREEs and the extent of pH decrease during extraction is reduced. The effect of solution pH on the extraction and synergism was reviewed. Acquisition of the operation data with mixer-settler on the separation of LREEs by this mixture is necessary to develop a process.

• Proceedings of the Korean Institute of Resources Recycling Conference
• /
• 2003.10a
• /
• pp.196-200
• /
• 2003

A novel prepurification method was developed aiming at increasing yield and purity, also reducing solvent usage for purification of paclitaxel. The use of a micelle and precipitation in the prepurification process allows for rapid separation of paclitaxel from interfering compounds and dramatically reduces solvent usage compared to alternative methodologies. The prepurification process serves to minimize the size and complexity of the HPLC operations for paclitaxel purification. The process is readily scalable to a pilot plant and eventually to a production environment where multikilogram quantities of material are expected to be produced. As much as possible, the process has been optimized to minimize solvent usage, complexity, and operating costs.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1998.04a
• /
• pp.22-24
• /
• 1998

1. INTRODUCTION : The phase inversion method is widely used to prepare a variety of polymeric membranes ranging from micro-filtration to gas separation. The final morphology obtained by immersion precipitation strongly reflects the thermodynamics and kinetics of the system involved. The equilibrium thermodynamics of the ternary system of polymer/solvent/ nonsolvent is still very important to understand and predict membrane structure. Polysulfone (PSf) and polyethersulfone (PES) are important polymers as membrane materials due to the chemical resistance, mechanical strength, thermal stability and transport properies. There are several reports on the experimental phase diagrams in ternary mixtures of PSf/solvent/nonsolvent, and PES/solvent/nonsolvent. It would be interesting to investigate the solution thermodynamics containing these two polymers since PES is slightly less hyclrophobic than PSf.

• Analytical Science and Technology
• /
• v.20 no.3
• /
• pp.246-250
• /
• 2007

The quantitative determination of chromium(VI) by separation from chromium(III) complex of 8-hydroxyquinoline using solvent extraction has been studied. The reaction conditions for chromium(III) complex of 8-hydroxyquinoline and the solvent extraction of complex were investigated in detail. The chromium(III) complex was extracted with organic solvent (n-hexane) and residual chromium(VI) was determined by ICP-AES in aqueous layer. This technique is quantitative in the pH range of 8-9 and the limitations such as interfering ions were discussed.

• Resources Recycling
• /
• v.23 no.2
• /
• pp.37-45
• /
• 2014

Solvent extraction experiments have been performed to separate Nd and Pr from chloride leaching solution of monazite sand using single Cyanex272 and mixed extractants as PC88A+Cyanex272 and PC88A+TBP. For this purpose, the effect of the concentration of extractants on the extraction and separation of the two metals were studied by varying the pH of aqueous solution. In the experimental ranges conducted in this study, the distribution coefficients of Nd were higher than those of Pr. In Cyanex272 system, our results indicated that concentration of extractant and initial pH did not affect distribution coefficients, but separation factor was increased with increasing initial pH. In binary extractant system, distribution coefficients were lower than those of single PC88A system, whereas separation factor was similar in both mixed and single extractant system.

• Applied Chemistry for Engineering
• /
• v.26 no.6
• /
• pp.631-639
• /
• 2015

Extraction/separation of cobalt by solvent extraction is reviewed. Separation of cobalt using various reagents and also cobalt recovery from scrap using commercial extractant were analyzed. The separation ability for cobalt followed the order of phosphinic > phosphonic > phosphoric acid due to the increasing stabilization of tetrahedral coordination of cobalt complexes with the extractant in the organic phase. Depending upon the solution composition, commercial extractants like Cyanex 272, D2EPHA and PC 88A should primarily be used for commercial extraction processes and also the efficient management of their combination could address various separation issues associated with cobalt bearing scrap.

• Journal of Microbiology and Biotechnology
• /
• v.23 no.7
• /
• pp.942-952
• /
• 2013

Monoliths are functional porous materials with a three-dimensional continuous interconnected pore structure in a single piece. A monolith with uniform shape based on poly(${\gamma}$-glutamic acid) (PGA) has been prepared via a thermally induced phase separation technique using a mixture of dimethyl sulfoxide, water, and ethanol as solvent. The morphology of the obtained monolith was observed by scanning electron microscopy and the surface area of the monolith was evaluated by the Brunauer Emmett Teller method. The effects of fabrication parameters such as the concentration and molecular mass of PGA and the solvent composition have been systematically investigated. The PGA monolith was cross-linked with hexamethylene diisocyanate to produce the water-insoluble monolith. The addition of sodium chloride to the phase separation solvent affected the properties of the cross-linked monolith. The swelling ratio of the cross-linked monolith toward aqueous solutions depended on the buffer pH as well as the monolith fabrication condition. Copper(II) ion was efficiently adsorbed on the cross-linked PGA monolith, and the obtained copper-immobilized monolith showed strong antibacterial activity for Escherichia coli. By combination of the characteristic properties of PGA (e.g., high biocompatibility and biodegradability) and the unique features of monoliths (e.g., through-pore structure, large surface area, and high porosity with small pore size), the PGA monolith possesses large potentials for various industrial applications in the biomedical, environmental, analytical, and separation fields.

• Journal of Environmental Health Sciences
• /
• v.2 no.1
• /
• pp.5-9
• /
• 1975

For analysis of Xanthene dyes according to the developing solvent and adsorbent was applied to Thin-layer chromatography with silicagel and cellulose plate. Silicagel chromato-plate used were prepared under different condition of activation. Using eight developing solvent, the influence of the condition for activation upon the separation of Xanthene dyes was investigated. The results are shown in Table 3. Methyl ethyl ketone+Acetone+$H_2O$ (10:0.1:0.4) mixture and n-butanol+Ammonia water (4:1) mixture gave clear separation for Xanthene dyes, including Fluorescein, Erythrosine Rhodamin B, Eosine, Rose bengale, phloxine and Acid red those Rf values decrease in the described ordor. Methyl ethyl ketone+Acetone+$H_2O$ (10:0.1:0.4) was applied to two adsorbents which were purchased from different manufactures. The results of Chromatograms are obtained Figure 6.