• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.195-196
• /
• 2008

Doping depth, doping concentration, and resistivity of crystalline silicon solar cell are variables which take important portion in cell's efficiency. To get highly efficient solar cell, PC1D is used to calculate $I_{sc}$, $V_{oc}$, and $P_{max}$. Depth factor, peak doping, and base resistivity was used as variables. As a result, the optimized value of emitter peak doping is $1\times10^{19}cm^{-3}$, depth factor is $1{\mu}m$, and base $\rho$ is $ 0.1\Omega$-cm. Under the optimized condition, the solar cell gets efficiency 19.03(%).

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.11
• /
• pp.2643-2648
• /
• 2015

This paper analyzes the phenomenon of drain induced barrier lowering(DIBL) for doping profiles in channel of asymmetric double gate(DG) MOSFET. The DIBL, the important short channel effect, is described as lowering of source barrier height by drain voltage. The analytical potential distribution is derived from Poisson's equation to analyze the DIBL, and the DIBL is observed according to the change of doping profile to influence on potential distribution. As a results, the DIBL is significantly influenced by projected range and standard projected deviation, the variables of channel doping profiles. The change of DIBL shows greatly in the range of high doping concentration such as $10^{18}/cm^3$. The DIBL increases with decrease of channel length and increase of channel thickness, and with increase of bottom gate voltage and top/bottom gate oxide film thickness.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.8
• /
• pp.1925-1930
• /
• 2014

This paper has analyzed the relation of conduction path and subthreshold swing for doping profile in channel of asymmetric double gate(DG) MOSFET. Since the channel size of asymmetric DGMOSFET is greatly small and number of impurity is few, the high doping channel is analyzed. The analytical potential distribution is derived from Possion's equation, and Gaussian distribution function is used as doping profile. The conduction path and subthreshold swing are derived from this analytical potential distribution, and those are investigated for variables of doping profile, projected range and standard projected deviation, according to the change of channel length and thickness. As a result, subthreshold swing is reduced when conduction path is approaching to top gate, and that is increased with a decrease of channel length and a increase of channel thickness due to short channel effects.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.10a
• /
• pp.713-716
• /
• 2013

The device performances of N-channel Tunneling FET have been characterized with different intrinsic length between drain and gate($L_{in}$), drain and source doping, permittivity and oxide thickness when the total effective channel length is constant. N-channel Tunneling FET of SOI structure have been used in characterization. $L_{in}$ was from 30nm to 70nm, dose concentration of drain and source were from $2{\times}10^{12}cm^{-2}$ to $2{\times}10^{15}cm^{-2}$ and from $1{\times}10^{14}cm^{-2}$ to $3{\times}10^{15}cm^{-2}$, permittivity was from 3.9 to 29, and oxide thickness was from 3nm to 9nm. The device performances were characterized by Subthreshold slope(S-slope), On/off ratio, and leakage current. From the simulation results, the leakage current have been reduced for long $L_{in}$ and low drain doping. S-slope have been reduced for high source doping, high permittivity and thin oxide thickness. With considering the leakage current and S-slope, it is desirable that are long $L_{in}$, low drain doping, high source doping, high permittivity and thin oxide thickness to optimize device performance in n-channel Tunneling FET.

• Journal of the Korean Institute of Navigation
• /
• v.25 no.4
• /
• pp.435-442
• /
• 2001

A new technique to grow a manganese-doped zinc-sulfide(ZnS：Mn) has been proposed using the repeated deposition of the Hot Wall method. The optical characteristics and crystallinity for the ZnS and ZnS：Mn thin films deposited on a quartz glass substrate by the method were investigated. Also, The ZnS：Mn thin film elcetroluminescent devices were fabricated by the method to study luminescence characteristics. All films showed (111)-oriented cubic structure. By the repeated deposition, the deposition rates were decreased, and the optical characteristics and crystalline properties were improved, which clarifies that the method is effective to deposit the thin films with good crystallinity Futhermore, the crystallinity was more improved by the doping of Mn. Only one peak emission at around 585nm originating from Mn luminescent center is observed In the photoluminescent and electroluminescent spectra of ZnS：Mn films and the luminance of the ZnS：Mn-based thin film electroluminescent devices was obtained below 60cd/$m^2$ . The optical and crystalline properties, luminescence characteristics are discussed in terms of the effects of the repeated deposition and Mn-doping.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.457-460
• /
• 1999

The effects of electrical positive stress on n-channel LDD and offset structured poly-Si TFT\`s have been systematically investigated in order to analyze the transfer curve\`s shift mechanism. It has been found that the LDD and offset regions behave as a series resistance that reduce the electric field near drain. Hot carrier effects are reduced because of these results. After electrical stress transfer curve’s shift and variation of the off-current are dependent upon the offset length rather than offset region’s doping concentration. Variation of the subthreshold slope is dependent upon offset region’s doping concentration as well as offset length.

• Membrane Journal
• /
• v.16 no.4
• /
• pp.276-285
• /
• 2006

Acid-doped sulfonated poly(aryl ether benzimidazole) (S-PAEBI) copolymers were synthesized by a direct polymerization technique and a doping with phosphoric acid as a dopant, and the polymer electrolyte membranes were fabricated from them by a solution casting method. To optimize the reaction condition, the degree of sulfonation and doping level were varied in the ranges of $0{\sim}60%\;and\;0.7{\sim}5.7$, respectively. Physiochemical properties of the doped membranes were investigated by AFM, TGA and the measurement of proton conductivity. It was found that proton conductivities depend on doping levels of membranes. Conductivity determined at the condition of $130^{\circ}C$ and no humidity was $7.3{\times}10^{-2}S/cm$ for the $H_3PO_4$-doped PAEBI membrane with a doping level of 5.7.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2006.11a
• /
• pp.110-111
• /
• 2006

In this paper, we investigated resistance characteristic of chalcogenide material for next generation ReRAM nonvolatile memory device with laser irradiation. A AES is used to test Ag doping ratio into a As-Ge-Se-S thin film. A sample resistance was observed in real time with He-Ne laser(632.8nm). As a result, resistance of thermal treated As-Ge-Se-S thin film was $500{\Omega}$ which is smaller than initial $1.3M{\Omega}$. A resistance of non-treated Ag/As-Ge-Se-S thin film was $200{\Omega}$ which is lower than $35M{\Omega}$.

• Journal of Electrochemical Science and Technology
• /
• v.8 no.4
• /
• pp.338-343
• /
• 2017

Activated carbon has lower electrical conductivity and reliability than other carbonaceous materials because of the oxygen functional groups that form during the activation process. This problem can be overcome by doping the material with heteroatoms to reduce the number of oxygen functional groups. In the present study, N, F co-doped activated carbon (AC-NF) was successfully prepared by a microwave-assisted hydrothermal method, utilizing commercial activated carbon (AC-R) as the precursor and ammonium tetrafluoroborate as the single source for the co-doping of N and F. AC-NF showed improved electrical conductivity ($3.8\;S\;cm^{-1}$) with N and F contents of 0.6 and 0.1 at%, respectively. The introduction of N and F improved the performance of the pertinent supercapacitor: AC-NF exhibited an improved rate capability at current densities of $0.5-50mA\;cm^{-2}$. The rate capability was higher compared to that of raw activated carbon because N and F codoping increased the electrical conductivity of AC-NF. The developed method for the co-doping of N and F using a single source is cost-effective and yields AC-NF with excellent electrochemical properties; thus, it has promising applications in the commercialization of energy storage devices.

• 한국초전도학회:학술대회논문집
• /
• v.9
• /
• pp.247-250
• /
• 1999

We have performed $^{63,65}$Cu nuclear quadrupole resonance (NQR) measurements on Zn and Ni doped YBa$_2Cu_3O_7$ (YBa$_2Cu_{3-x}M_xO_7$, M=Zn or Ni, x = 0.00 ${\sim}$ 0.09). Doping effects are markedly different in relaxation rates as well as in superconducting transition temperatures. Both the spin-lattice and the spin-spin relaxation rates decrease for Zn doped YBCO. However, those increase for Ni doped YBCO. This contrast in local electronic dynamics provides a clear microscopic evidence that Zn forms no local moment, while Ni develops a local moment. Consequently, the antiferromagnetic spin fluctuation is suppressed by Zn doping whereas it is preserved by Ni doping.