• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.6
• /
• pp.573-582
• /
• 2010

In this paper, X-band transceiver for high resolution wideband SAR systems is designed and fabricated. Also as a technique for enhancing the performance, error compensation algorithm is presented. The transceiver for SAR system is composed of transmitter, receiver, switch matrix and frequency generator. The receiver especially has 2 channel mono-pulse structure for ground moving target indication. The transceiver is able to provide the deramping signal for high resolution mode and select the receive bandwidth for receiving according to the operation mode. The transceiver had over 300 MHz bandwidth in X-band and 13.3 dBm output power which is appropriate to drive the T/R module. The receiver gain and noise figure was 39 dB and 3.96 dB respectively. The receive dynamic range was 30 dB and amplitude imbalance and phase imbalance of I/Q channel was ${\pm}$0.38 dBm and ${\pm}$3.47 degree respectively. The transceiver meets the required electrical performances through the individual tests. This paper shows the pulse error term depending on SAR performance was analyzed and range IRF was enhanced by applying the compensation technique.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.6
• /
• pp.907-915
• /
• 2013

Tire Pressure Monitoring System (TPMS) is an auxiliary safety system for recognizing the condition of tires based on the pressure and temperature data transmitted from the sensor unit installed on a tire of the vehicle. Using TPMS, a driver can frequently check the state of tires and it aids to maintain the optimum running condition of the vehicle. Since TPMS must utilize the wireless communication technique to transmit data from a sensor unit to a signal processing unit installed in the vehicle, it suffers from interference signals caused by various external electrical or electronic devices. In order to suppress high-power interference signals, we employ beamforming techniques based on the uniform linear antenna array. As the number of the antennas is increased, the performance of the interference suppression is improved. However, there is the limit of the number of antennas, installed in the center of a vehicle, because of its size. In this paper, we compare and analyze the performance of the beamformer, when reducing the interelement spacing of antennas, to increase the number of the receiving antennas. For the performance analysis of the beamformers, we consider the switching beamformer and minimum-variance distortionless-response (MVDR) beamformer for TPMS, recently proposed.

• Journal of Advanced Navigation Technology
• /
• v.19 no.6
• /
• pp.552-557
• /
• 2015

Recent performed by recognizing a user's location, various services have been tailored focus on short-range wireless communication technology. A beacon in which is attracting attention as next-generation technology. Beacon is a terminal by utilizing the frequency of the non-audible area can not be bluetooth and human sending and receiving terminals and information, Apple recently iBeacon like a low-power Bluetooth (BLE; bluetooth low energy) based beacon showing a tendency to rise into the mainstream there. Services using a beacon is basically installs the terminal in a certain place indoor. It is characterized by providing the user the services to catch the user's position, even automatically take a separate action. Various types of location-based service provided by the target interior space began to attract attention. A variety of location-based services are provided in the interior space in order to be successfully deployed and provide guidance to the interior space, the movement route and the like are essentially required to build various types of information. In this paper, for efficient indoor positioning by varying the signal strength of the beacon in such areas were measured and analyzed.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.4
• /
• pp.409-417
• /
• 2013

Mu-communication board supported by multi-communication is designed with Atxmega 128A1 which is a low power energy consuming of 8-bit microcontroller. ATxmega128A1 microcontroller consists of 8 UART(Universal asynchronous receiver/transmitter) ports which can be setting appropriate user interface having command line interpreter(CLI) program with each port, 2 kbytes EEPROM, 128 kbytes flash memory, 8 kbytes SRAM. 8 URAT ports are used for the multi communication modem, GPS module, etc. and EEPROM is used for saving a configuration for program running, and flash memory of 128 kbytes is used for storing a Firm Ware, and 8 kbytes SRAM is used for stack, storing memory of global variables while program running. If we uses the hybrid communication of path optimization of VHF, TRS and CDMA to remote control AtoN(aid to navigation), it is able to remove the communication shadow area. Even though there is a shadow area for individual communication method, we can select an optimum communication method. The compatibility of data has been enhanced as using of same data frame per communication devices. For the test, 8640 of data has been collected from the each buoy during 30 days in every 5 minutes and the receiving rate of the data has shown more than 99.4 %.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.7
• /
• pp.656-666
• /
• 2020

This study was a descriptive research study for hemodialysis patients to survey the effects of social support and health literacy on treatment adherence. The subjects of this study were 140 hemodialysis patients aged over 40 years who had been receiving treatment for more 1 year in artificial kidney rooms at two general hospitals in Y city. The data were collected from November 1, 2019 to December 31, 2019 and were analyzed using descriptive statistics, t-tests, one-way ANOVA, Scheffe test, Pearson's correlation coefficients, and multiple regression with the SPSS/WIN 26.0 statistical program. The results of this study show that social support (family, friends, medical staff) and health literacy (functional, communication, critical) were positively correlated with treatment adherence. The variables affecting treatment adherence in hemodialysis patients were identified by social support and health literacy with 69.6% explanatory power. To improve the treatment adherence of hemodialysis patients, it is necessary to develop education programs to improve health literacy based on social support.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.254-260
• /
• 1999

Meteor Burst Communication can provide effective and economical means of communication where long distance VHF NLOS data transmission is needed; often ranges more than 1000 km. It has been, however, so far considered unsuitable for short distance application because of phenomenal decrease in burst durations, which leads to decreation of total duty rate of the system. This paper extensively analyzes characteristics of shot distance MB(Meteor Burst) path and shows the low duty rate may be improved by increasing burst rate through adapting antenna beam width to cover entire hot-spot region in the space and, by compensating effective burst length through cutting down man-made noises introduced by antenna. Based on the analysis, we are developed a small-opening-cavity antenna, especially designed for short distance MB path. In operation, the antenna is to be buried under ground surface so as to improve directivity and reduces noise introduction. The antenna exhibits power gain of 3 dB with 90 degree beam width and thus enables to illuminate entire hot-spot regions with the elevation angle of 8-90 degree which is the case of transmission less than 100 km. Directivity horizontal to earth surface is suppressed to minimum which enables to cut man-made noises from near-by sources down to more than 3 dB from the level reported with conventional 4 element Yagi. A series of experiments performed on 100 km MB paths have conformed that, with the antenna installed at receiving site, the burst rate and duration time have been noticed to increase by 10 and 20 percent respectively from the values obtained by conventional 4-element Yagi antenna under same testing condition.

• Journal of the Korea Society of Computer and Information
• /
• v.17 no.1
• /
• pp.183-192
• /
• 2012

Although underground water resource has relatively less pollution rate compared with surface water, its recovery faces many difficulties due to poor management. Our country monitors underground water to manage it effectively through auxiliary observation network for underground water. In this paper, we suggest water-well auto measure system based on Geosensor for business efficiency increase of water-well management and realtime monitering. In this system is consist of user GUI(Graphic User Interface) composed with water-well information and movement sub-observation network prototype system composed with GPS(Global Positioning System) and wireless sensor node such as water temperature, water level, electrical conductivity. In this system is using the light of the sun for self-power, variety water-well information collected wireless sensor node was a wireless transmitting/receiving a using CDMA(Code Division Multiple Access) module. Also, for promote with user ease, user GUI express that water-well collected in GIS(Geographic Information System) map. For performance evaluation of the proposed system, we perform experiment using sensing information through designed sub-observation network. And we was proved superiority of the proposed system through qualitative evaluation with other paper.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.4
• /
• pp.181-190
• /
• 2014

The underwater acoustic lens system is one of the systems getting high-resolution images on the seafloor by the beam forming method using acoustic lens. The beam forming using acoustic lenses reduces complexity and driving power. When receiving an incoming beam with the acoustic lens array, beam pattern analysis and arrangement problem of the array sensor must be addressed. Introducing SIR (Signal to Interference Ratio), the relationship among sensor interval, beam pattern and image quality would be analyzed. Generally if the sensor interval getting wider, the less effect of the side lobes makes SIR high. If the amplitude of a side lobe is high, SIR is generally getting low. The type of the apodization function changes the width, shape and amplitude of both main lobe and side lobes. Thus an appropriate apodization function can improve SIR. In this paper, SIR is stable at the sensor interval of 13mm with 0-10dB, which is not high relatively. By applying the Chebyshev function, the SIR becomes 80dB over the sensor interval of 37 mm or higher. The Hann and triangular functions demonstrate better SIR when the sensor interval becomes narrower.

• Journal of Korean Society of Forest Science
• /
• v.82 no.1
• /
• pp.1-6
• /
• 1993

This study was conducted to provide a fundamental information for a income raise of agricultural and mountain villagers and a policy planning by analyzing 145 chestnut producing farms in Korea. The results of this study are as follows : 1. Though the proportion of forest by-products in farm household economy was very slight, it is very important for agricultural and mountain villagers who have relatively lower income level to become a valuable income source. 2. As chestnut cultivating orchards have very small-scale that account for 50.0% of 0.5 to 1.0 hectares and 40.3% of 1.0 to 3.0 hectares reaching 90.3% of total farmers, the small-scale ownership makes the normality and rationalization of management difficult, and therefore the economity of scale has to be accomplished. 3. The difficulties on chestnut cultivating management were in order of the following ; Labour-power shortage(38.5%), desease and pest demage(24.8%), economity(15.2%), management(11.7%), inferiority of site condition(5.9%), technical acquirement(3.8%). 4. In the matter of storaging facilities, 87.6% of total surveyed farmers were recognizing the need of storaging facilities, but only 12.4 of surveyed farmers were possessing these facilities, and therefore the measurement has to be considered such as the forest associations invests to cold storaging facilities unable to privately invest, in order to increase a receiving price of producers.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.3 s.94
• /
• pp.246-252
• /
• 2005

A RF microstrip balun having low transmission loss for the balanced receiving dipole antenna is designed and fabricated using a three-section Wilkinson divider and two 3-dB quadrature couplers. It considers two types of the three-section Wilkinson dividers, the Cohn's optimum three-section structure and the miniaturized three-section structure, for wideband power splitting. Also, two 3-dB quadrature couplers for 180 degrees of phase difference adopt a twist-wire coaxial cable. The fabricated first balun having the Cohn's optimum three-section Wilkinson divider has 0.5 dB of transmission loss, $\pm$0.2 dB of amplitude imbalance, and 180$\pm$2.3 degrees of phase imbalance over 400 to 1000 MHz by measurement. The second one using the miniaturized three-section Wilkinson divider shows 1.0 dB of transmission loss, $\pm$0.7 dB of amplitude imbalance, and 180$\pm$8.8 degrees of phase imbalance over the same frequency band.