• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.2 s.105
• /
• pp.171-177
• /
• 2006

A low-cost, high-performance 40 Gb/s clock recovery module using a phase-locked loop(PLL) for a 40 Gb/s optical receiver with the clock-hold function has been designed and implemented. It consists of a clock extractor circuit, an RF mixer and a frequency discriminator for phase/frequency detection, a VC-DRO, a phase shifter, and a clock-hold circuit. The extracted 40 GHz clock is synchronized with a stable 10 GHz VC-DRO. The clock stability and jitter characteristics of the implemented PLL-based clock recovery module are significantly improved as compared with those of the conventional open-loop type clock recovery module with a DR filter. The measured peak-to-peak RMS jitter is about 230 fs. When an input signal is dropped, the 40 GHz clock is maintained continuously by the hold circuit.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.5 no.6
• /
• pp.1143-1150
• /
• 2001

In this paper, we designed a downconverter for K-band satellite multipoint distribution service(SMDS). The designed downconverter consists of a low noise amplifiers, bandpass filter, stable local oscillator, drain mixer and If Amplifiers. Low noise amplifiers show 28㏈ gain and 1.5㏈ noise figure in the frequency range of 19.2㎓~20.2㎓, and a band pass filter has a -l㏈ insertion loss, and 18.25㎓ Stable local oscillator which is dielectric resonant oscillation, We obtained that the output power of the 18.25㎓ oscillation frequency is 0.5㏈m and the phase noise is the -84.67㏈c at 10KHz offset frequency. With the input RF signal the 19.2㎓~20.2㎓, conversion gain of the drain mixer shows 5㏈ at the Intermediate frequency range of 950MHz~1950MHz. We have proved that the designed downconverter satisfied the specification of a K-band satellite multipoint distribution service and it can be applied to the satellite internet receiver.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.2 no.4
• /
• pp.635-641
• /
• 1998

This paper presents development of a small size LNA operating at 824 ∼ 849 MHz used for a receiver of a CELLULAR CDMA Base station and a transponder. Using resistive decoupling circuits, a signal at low frequency is dissipated by a resistor. This design method increases the stability of the LNA and is suitable for input stage matching. The LNA consists of low noise GaAs FET ATF-10136 and internally matched VNA-25. The LNA is fabricated with both the RF circuit and the self-bias circuits in aluminum housing. As a result, the characteristics of the LNA implemented here shows above 35dB in gain and below 0.9dB in noise figure, 18.6dBm P1dB power, a typical two tone IM3, -31.17dB with single carrier backed off 10dB from P1dB.

• Journal of the Korea Computer Industry Society
• /
• v.6 no.5
• /
• pp.675-686
• /
• 2005

This paper proposes a new method of mathematically modeling and computer simulating television ghosts wherein television signals that have undergone multipath fading are generated without using approximations by considering the attenuation, time delay, phase, and timing jitter between consecutive frames. Conventional methods used polynomial interpolation or complex arithmetic to take into account the ghost phase, but our method uses only real arithmetic by employing the Hilbert transform and also reduces the computation time using the FFT (fast Fourier transform) algorithm. Furthermore, it is also possible to observe the transmit waveforms in both RF and IF ranges. Various ghost patterns generated in software provide for essential data required for the development of ghost canceling algorithms, and are deemed to be very useful in analyzing the constituent blocks of the transmitter and receiver chain in television broadcasting. The development of ghost cancelers needs to be preceded by the task of mathematically modeling ghosts and their extensive computer simulations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.42 no.2
• /
• pp.291-298
• /
• 2017

In this paper, we derive the achievable degrees of freedom (DoF) for multiple-input multiple-output (MIMO) Z-interference channels (Z-IC) with reconfigurable antennas at the receivers, assuming that channel state information is not available at the transmitters. We propose a new linear scheme to align interfering signals and to decode desired signals through the designed preset mode switching pattern of reconfigurable antennas at the receivers. The key idea of our scheme is to use interfering signals as a side information at the interfered receiver by being silent at the corresponding transmitter during some time slots. Consequently, it is shown that the reconfigurable antennas at the receivers can bring a DoF gain if the number of preset modes is greater than the number of RF chains at the receivers.

• Journal of IKEEE
• /
• v.1 no.1 s.1
• /
• pp.138-155
• /
• 1997

Wireless optical communication is able to obtain high antenna gain as well as utilize to transmit the high-speed information with large capacity than the RF communication. However, the propagation path (atmosphere) is considered as an attenuator occured turbulence, absorption and scattering. These undesired phenomena diminish the amount of light that is collected at the receiver. To evaluate the effect of the atmospheric turbulance and scattering, this paper perform the ground-to-ground wireless optical LAN experiment by using the (2,1,6) convolutional coder and Viterbi decoder, and analyze numerically the earth-station antenna diameter due to the propagation path condition and upstream/downstream link.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.11 s.102
• /
• pp.1114-1122
• /
• 2005

In this paper, the study of a design, fabrication and measurement of the receiver MMIC LNA, mixer for S-band application is described. The LNA is designed by 2-stage common source. The mixer is composed of active LO and RF balun to integrate on a chip and applied a newly proposed bias circuit to compensate the process variations of active devices. The LNA has 15.51 dB-gain and 1.02dB-Noise Figure at 2.1 GHz. The conversion gain of the mixer is -12 dB, IIP3 is approximately 4.25 dBm and port-to-port isolation is over 25 dB. The newly proposed bias circuit is composed of a few FETs and resistors, and can compensate the variation of the threshold voltage by the process variations, temperature changes and etc. The designed chip size is $1.2[mm]\times1.4[mm]$.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.2
• /
• pp.81-86
• /
• 2020

Ambient backscatter communication has a drawback in which the transmission power is limited because the data is transmitted using the ambient RF signal. In order to improve transmission efficiency between transceiver, a channel estimator capable of estimating channel state at a receiver is needed. In this paper, we consider the K-means algorithm to improve the performance of the channel estimator based on EM algorithm. The simulation uses MSE as a performance parameter to verify the performance of the proposed channel estimator. The initial value setting through K-means shows improved performance compared to the channel estimation method using the general EM algorithm.

• Journal of Sensor Science and Technology
• /
• v.12 no.6
• /
• pp.249-257
• /
• 2003

The bio-telemetry technologies, that use the wireless miniaturized telemetry module implanted in the human body and transmits several biomedical signal from inside to outside of the body, have been expected to solve the problem such as the patient's inconvenience and the limit for diagnosis. In the case of transceiver system using the wireless RF transmission method, the method of three-dimensional localization for implantable miniaturized telemetry module is necessary to detect the exact position of disease. A new method for three-dimensional localization using small loop antenna in the implantable miniaturized telemetry module was proposed in this paper. We proposed a method that can accurately determine the position of telemetry module by analyzing the differences in the strength of signal, which is received at each of the small size RF receiver array installed on the body surface.

• 한국해양학회지
• /
• v.30 no.1
• /
• pp.27-38
• /
• 1995

For the study of oceanic surface current, this work presents a system design which is composed of three parts, a Global Positiong System(GPS) unit, a transmitter with radio frequency (RF) modem and an antenna which are housed in a plastic spherical buoy, and computerised of VHF receiving system. The key idea for this study is to employ a commercially available GPS on a drifting buoy and to utilize the receiver position information from the buoy in determining the Lagrangian motion of surface ocean waters. Great efforts has been paid to the system design which would demand several points in harsh conditions common in the sea surface, that is power supply problems housed inside of a plastic buoy, optimizing transmitting radio frequency which limits transmitting distance to a receiving station. for all these difficulties, the system appears to be promising in future oceanic applications and is considered to economical compared to ARGOS drift buoy which is being used by commercial base. We believe that the system needs to be improved in terms of several aspects such as a longer transmitting distance, a power supply and software. for the test experiments in situ, the system has employed off the coast of Ku Ryong Po int the southeast part of Korea and successfully collected the surface current data. The results are presented for two cases from 21 to 31, March 1994 and 21 to 25, June 1994 in terms of current statistics and trajectories of drifting buoys.