• Journal of Power Electronics
• /
• 제17권3호
• /
• pp.835-847
• /
• 2017

A transmitting coil with an optimal topology and number of turns can effectively improve the performance of the wireless power transfer (WPT) systems for endoscope robots. This study proposes the evaluation parameters of the transmitting coils related to the performance of the WPT system to standardize the design of the transmitting coils. It considers both the quality factor of transmitting coils and the coupling factor between the two sides. Furthermore, an analytical model of transmitting coils with different topologies is built to exactly estimate the evaluation parameters. Several coils with the specified topologies are wound to verify the analytical model and the feasibility of evaluation parameters. In the case of a constant power received, the related evaluation parameters are proportional to the transfer efficiency of the WPT system. Therefore, the applicable frequency ranges of transmitting coils with different topologies are determined theoretically. Then a transmitting coil with a diameter of 69 cm is re-optimized both theoretically and experimentally. The transfer efficiency of the WPT system is increased from 3.58% to 7.37% with the maximum magnetic field intensity permitted by human tissue. Finally, the standardized design of the transmitting coil is achieved by summing-up and facilitating the optimization of the coils in various situations.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.1075-1079
• /
• 2002

This paper presents a result of sound transmitting system with power line communication technique, Sound transmitting system is a transmitter which transmits modulated audio signal to power to power line and receiver which is capable of detesting it with earphone or speaker. It has been evaluated with the frequency characteristics and spectrum analysis. And, from the result of evaluation on the developed system, we confirm the superior sound transmitting characteristics, and the possibility of application on a language laboratory.

• 조명전기설비학회논문지
• /
• 제18권3호
• /
• pp.128-134
• /
• 2004

본 연구에서는 전력선통신 기술을 이용하여 전송주파수에 음성신호를 변조한 후 전력선으로 전송하고 전력선으로부터 수신 및 복조하여 변조된 음성신호를 검출하는 음향전달 시스템을 제작하였다. 제작된 시스템으로부터 변복조 및 주파수 특성을 분석하여, 어학실습 교육을 위한 용도로서의 활용 가능성을 평가하였다. 그 결과 전달된 음향 신호가 최적상태는 아니지만 어학실습 교육용으로 청취하기에 충분한 수준으로 판단되었다.

• 한국전자통신학회논문지
• /
• 제19권2호
• /
• pp.355-360
• /
• 2024

본 논문에서는 4-코일 방식의 자기공진 무선전력전송 시스템을 구현하는 데 있어서, 송전 공진코일의 끝단에서 발생하는 선간 방전현상을 연구하였다. 자기공진 무선전력전송은 급전코일, 송전 공진코일, 수전 공진코일, 부하코일로 구성되어 있다. 여기서 송전 공진코일은 급전코일에서 발생한 자기장을 증폭하여 전방의 수전 공진코일로 전달하는 역할을 한다. 큰 전력을 전송하기 위하여 급전코일에 높은 전류를 흘려주면 송전 공진코일 끝단에 높은 전압이 유기되어 선간 방전현상이 일어나게 된다. 선간 방전현상은 송전기 케이스를 손상시키게 되고, 송전기를 사용할 수 없는 상태로 만든다. 따라서 이러한 선간 방전현상을 제거하기 위하여, 선간 방전을 일으키는 송전 공진코일에 유기되는 전압을 분석하고, 해결 방안을 제시하였다.

• International Journal of Internet, Broadcasting and Communication
• /
• 제14권3호
• /
• pp.69-78
• /
• 2022

In this paper, we propose the new technique adopting power control to MIMO(multi-input multi-output)-OFDMA(orthogonal frequency division multiplexing Access) system with multi-beamformer. The proposed power controlling algorithm for MIMO-OFDMA allocates the transmitting power of each subcarrier based on the CSI(channel state information) and the interference signal. CSI is feedback from base station to mobile station to decide the transmitting power of each subcarrier. Through the proposed technique, we can control iteratively the transmitting power and update the weight of beamformer simultaneously. Therefore, the SNIR of each subcarrier become to converge the target SNIR and the beam is formed toward the desired direction. And the performance of MIMO-OFDMA system with the proposed approach is very improved. The improvement in bit error rate is investigated through computer simulation of a MIMO-OFDMA system with the proposed approach.

• Journal of electromagnetic engineering and science
• /
• 제5권2호
• /
• pp.97-103
• /
• 2005

This paper describes the measured results of sonobuoy transmitting antenna system for anti-submarine warfare (ASW). Since radiation pattern and power density depend on impedance matching between transmitting RF part and antenna with termination resistance, design of matching circuit is very important for sonobuoy system performance. Matching circuit is designed by Smith chart using control of L and C. In standing wave ratio(SWR) measurement using Network Analyzer, SWR of antenna with matching circuit observed 1.5 below at the assigned VHF band. It shows very excellent performance comparison with conversional product that is used for the same object. The measured vertical and horizontal radiation patterns are also shown the satisfaction of military specifications. A drop out of sonobuoy system on the sea is happened when angle of elevation direction is over 10 degrees, and it is conformed that it takes less than I second return to original signal level. The required electric power density is $83\;mW/m^2$ in the military specification, and measured electric power density is observed over average $110\;mW/m^2$ at all frequency bands.

• Journal of electromagnetic engineering and science
• /
• 제2권2호
• /
• pp.93-99
• /
• 2002

The Cartesian loop chip which is one of key devices in narrow-band Walky-Talky transmitter using RZ-SSB modulation method was designed and implemented with 0.35 Um CMOS technology. The reduced size and low cost of transmitter were available by the use of direct-conversion and Cartesian loop chip, which improved the power efficiency and linearity of transmitting path. In addition, low power operation was possible through CMOS technology. The performance test results of transmitter showed -23 dBc improvement of IMD level and -30 dEc below suppression of SSB characteristic in the operation of Cartesian loop chip (closed-loop). At that time, the transmitting power was about 37 dBm (5 W). The main parameters to improve the transmitting characteristic and to compensate the distortion in feed back loop such as DC-offset, loop gain and phase value are interfaced with notebook PC to be controlled with S/W.

• ETRI Journal
• /
• 제44권2호
• /
• pp.339-345
• /
• 2022

This article presents an investigation of the effects on a grounding system of wireless power transfer (WPT) when transmitting over relatively far distances, that is, up to 1.25 m. Conventional two-coil WPT systems are sufficiently commercialized in strong coupling range, but it is important to accomplish the long-range WPT in weak coupling range for further various applications. This system depends on the coupling effect between the two coils that the grounds of the transmitting and receiving coils should be completely separated. However, when evaluating the performance of two-coil systems with the instrument consisting of two ports and one common ground, undesirable problems occur in weak coupling ranges, for example, obtaining disagreeable transmission efficiency and degrading system stability/reliability. We investigate the problems of the leakage power from common ground systems and provide a practical solution to obtain a reliable WPT system by using an isolation transformer. The usefulness of this approach is that it is possible to achieve the stability of the system with relatively far transmitting distances and to determine the exact transmission efficiency.

• 한국초전도ㆍ저온공학회논문지
• /
• 제16권3호
• /
• pp.21-25
• /
• 2014

As wireless power transfer (WPT) technology using strongly coupled electromagnetic resonators is a recently explored technique to realize the large power delivery and storage without any cable or wire, this technique is required for diffusion of electric vehicles (EVs) since it makes possible a convenient charging system. Typically, since the normal conducting coils are used as a transmitting coil in the CPT system, there is limited to deliver the large power promptly in the contactless EV charging system. From this reason, we proposed the combination CPT technology with HTS transmitting antenna, it is called as, superconducting contactless power transfer for EV (SUWPT4EV) system. As the HTS coil has an enough current density, it can deliver a mass amount of electric energy in spite of a small scale antenna. The SUCPT4EV system has been expected as a noble option to improve the transfer efficiency of large electric power. Such a system consists of two resonator coils; HTS transmitting antenna (Tx) coil and normal conducting receiver (Rx) coil. Especially, the impedance matching for each resonator is a sensitive and plays an important role to improve transfer efficiency as well as delivery distance. In this study, we examined the improvement of transmission efficiency and properties for HTS and copper antennas, respectively, within 45 cm distance. Thus, we obtained improved transfer efficiency with HTS antenna over 15% compared with copper antenna. In addition, we achieved effective impedance matching conditions between HTS antenna and copper receiver at radio frequency (RF) power of 370 kHz.

• 전자공학회논문지
• /
• 제51권9호
• /
• pp.46-53
• /
• 2014

본 논문에서는 무인항공기 가시선 데이터링크 Ku 대역 RF 송수신 시스템을 설계하였다. RF 송수신 시스템은 송수신반, RF 전단반, 고출력증폭반으로 구성되어 있다. 송수신반은 주파수 상/하향 변환 기능과 채널 변경 기능을 제공하며, RF 전단반은 송/수신 신호 이중화, 안테나 선택, 소신호 증폭, 수신신호 외 주파수 필터링 기능을 제공한다. 고출력증폭반은 Ku 대역 전력증폭과 송신출력 가변(고/중/저/Mute) 기능을 제공한다. 송수신반의 주파수 상/하향 변환은 슈퍼헤테로다인 방식으로 구현하였다. RF 송수신 시스템은 대용량 고속 데이터의 신뢰성 있는 송수신을 위하여 광대역 고선형 특성을 갖도록 설계하였다. 또한, 무인항공기 운용 환경에 따른 주파수의 선택적 사용을 위하여 채널 변경이 가능하도록 설계하였다.