• Journal of Magnetics
• /
• 제21권2호
• /
• pp.173-178
• /
• 2016

Six-step commutation control widely used in brushless DC (BLDC) motor can be applied to consequent pole permanent magnet (CPPM) belt starter generator (BSG) with trapezoidal back electromotive force (EMF) in the starter state. However, rotor position detection with three Hall sensors in BLDC motor can hardly be employed in CPPM BSG due to asymmetric flux distribution in each pole side of CPPM BSG. This paper presents a low-cost rotor position detection method for CPPM BSG in which six Hall sensors are proposed to be used based on the analysis of flux distribution by 3D FEA. In the method, the six Hall sensors are divided into three groups and two signals in each group are combined through performing logic operations. In addition, offset angle between back EMF and the related Hall signal can be compensated by moving the Hall sensors. Experiments of a 2 kW CPPM BSG prototype have also been performed to verify the proposed method.

• 한국공작기계학회논문집
• /
• 제13권2호
• /
• pp.120-126
• /
• 2004

This study proposed the analysis of mass position detection due to the change of the mass and strifeless of structure by using the original and modified dynamic characteristics. The method is applied to examples of the cantilevers beam and the 3 degrees of freedom system by modifying the mass. The predicted detection of the mass positions and magnitudes are in good agrement with the present study from the structural reanalysis using the modified mass.

• 한국공작기계학회:학술대회논문집
• /
• 한국공작기계학회 2002년도 추계학술대회 논문집
• /
• pp.209-213
• /
• 2002

This study proposed the analysis of mass position detection due to the change of the mass and stiffness of structure by using the original and modified dynamic characteristics. The method is applied to examples of a cantilever and 3 degree of freedom by modifying the mass. The predicted detection of mass positions and magnitudes are in good agreement with these from the structural reanalysis using the modified mass.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 G
• /
• pp.2962-2964
• /
• 1999

We know the traffic information about the velocity and position of vehicle by extraction and tracking vehicle from continuosly obtained road image of camera. The conventional method of vehicle detection indicate increment of error due to headlight and taillight in night road image. This paper show such as vehicle detection of binary, Edge detection. amalgamation of image are applied to extract the vehicle, and Kalman filter is adaptive methods for tracking position and velocity of vehicle.

• 한국정보처리학회:학술대회논문집
• /
• 한국정보처리학회 2016년도 추계학술발표대회
• /
• pp.510-513
• /
• 2016

Detecting of the object in image processing is substantial but it depends on the object itself and the environment. An object can be detected either by its shape or color. Color is an essential for pattern recognition and computer vision. It is an attractive feature because of its simplicity and its robustness to scale changes and to detect the positions of the object. Generally, color of an object depends on its characteristics of the perceiving eye and brain. Physically, objects can be said to have color because of the light leaving their surfaces. Here, we conducted experiment in the aquarium fish tank. Different color of fish robots are mimic the natural swim of fish. Unfortunately, in the underwater medium, the colors are modified by attenuation and difficult to identify the color for moving objects. We consider the fish motion as a moving object and coordinates are found at every instinct of the aquarium to detect the position of the fish robot using OpenCV color detection. In this paper, we proposed to identify the position of the fish robot by their color and use the position data to control the fish robot gathering in one point in the fish tank through serial communication using RF module. It was verified by the performance test of detecting the position of the fish robot.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2000년도 전력전자학술대회 논문집
• /
• pp.709-712
• /
• 2000

In general three position sensors are needed to drive three phases SRM. Single position sensor driving method for three phases Switched Reluctance Motor(SRM) is proposed in this paper. By using single position sensor the cost of SRM is reduced. But position sensor the cost of SRM is reduced. But position detection at the staring is needed for single position sensor driving method. In this paper we propose the active align method to detect the relative position of rotor to three phases and align to the nearest phase. We proved the validity of the method by experiment and compare with other method.

• 한국멀티미디어학회논문지
• /
• 제16권4호
• /
• pp.430-443
• /
• 2013

운전자에게 차량의 현재 위치 및 도로 주변 상황 인지는 안전하고 쾌적한 운전 환경 조성을 위해 반드시 필요한 정보들이다. 본 논문에서는 도로시설물 및 도로표지 등의 도로정보를 모니터링 하고 시각적으로 알리기 위해 도로주행영상 내 좌표정보 결합 및 시점변환 기법을 이용한 도로주행환경 자동인식 기술을 제안한다. 제안한 방법은 차량 내 탑재된 카메라와 GPS를 이용하여 공간정보가 반영된 도로주행영상을 생성한 후, 생성 영상의 시점 변환 및 정합, 도로정보 검출을 수행하여 사용자에게 도로정보를 시각적으로 제공할 수 있도록 한다. 제안한 방법을 도로 주행 영상에서 실험한 결과, 도로주행영상 내 GPS 좌표정보의 결합 시간은 66.5ms, 교통 표지판 검출율은 95.83%, 프레임당 표지판 검출 처리 시간은 평균 227.45ms 이었다. 따라서 15프레임/초 이하의 입력 동영상에 대하여 효과적으로 도로주행환경을 자동으로 인식하는 것이 가능함을 확인하였다.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제54권1호
• /
• pp.26-32
• /
• 2005

Rotor position information is essential in the operation of the switched reluctance motor(SRM) drive for generation the phase current switching signals. When an incremental encoder is used as a rotor position sensor, the initial rotor position can not be detected. Some sensorless rotor position estimation methods also have the same problem. In these systems, to initially align the rotor, the forced alignment method has a delay and reverse rotation before the motor can start. Therefore it can not be acceptable for unidirectional drive systems. So the forced alignment method is not desirable in all drive systems and the research on the SRM drives should be directed to a system without rotor alignment. In this paper, a new detection method of initial rotor position using the rate of change of current is suggested. Firstly, di/dt versus θ/sub R/ reference table, which is the relation between the rate of change of current and rotor position, is generated and then the squared Euclidean distance method is used to estimate the rotor position based on the table. The simulated and experimental results are presented demonstrating the feasibility and accuracy of this method.

• 한국정보통신학회:학술대회논문집
• /
• 한국해양정보통신학회 2009년도 추계학술대회
• /
• pp.713-716
• /
• 2009

본 논문은 컨테이너 위치 측정을 위하여 비전을 기반으로 컨테이너의 홀을 검출하는 방법을 제안한다. 컨테이너는 각 꼭짓점마다 스프레더의 헤드블록과 부착되는 홀이 있기 때문에 서로 대각에 위치한 홀을 찾아서 컨테이너의 위치를 검출하는 방법을 이용한다. 우선, 스프레더에서 촬영된 컨테이너 영상을 입력받고 영상에서 컨테이너를 찾기 위하여 허프 변환을 이용해 직선을 검출한다. 검출된 직선 중에서 서로 직교하는 위치를 찾아서 스프레더의 헤드블록과 접합하는 컨테이너의 꼭짓점 후보로 정하며 정확한 꼭짓점을 찾기 위하여 템플릿 매칭을 수행한다. 제안된 방법을 이용하여 컨테이너의 위치를 검출했을 때 만족할 만한 성능을 나타내는 것을 실험을 통하여 확인하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2015년도 제46회 하계학술대회
• /
• pp.696-697
• /
• 2015

In this paper, the shape of the slit to provide a view of the sensor in such a manner as to encode the rotor position information using a single sensor for studies of economic rotor position and speed detection method for electric motor drive has a special electronic commutator bar-and proposes a robust encoder can produce a rotor position information for each of the woman, and reads out the location information by using the position detection method of the proposed new method compared to traditional DSP Capture function of incremental encoder that its validity was verified through experiments.