• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 하계학술대회 논문집 Vol.7
• /
• pp.461-462
• /
• 2006

A single-gap and single-gamma transflective liquid-crystal (LC) display using patterned vertical alignment (PVA) mode was designed. In the device, a vertical electric field drives a vertically aligned LC to tilt down to optimize polarization efficiency. Electrodes of transmissive and reflective area were patterned $22.5^{\circ}$ and $45^{\circ}$ with respect to the polarizer so that a tilt-down direction of the LC director was $22.5^{\circ}$ and $45^{\circ}$ in the reflective and transmissive regions, respectively. In the device, the cell gap was the same for both regions, and the gamma curve matched each other in both regions because tilt angle of LC director was the same according to the applied voltage. Moreover, the dark state was irrespective of the cell retardation value at normal direction, which was highly important in massive fabrications. The switching principle and electro-optic characteristics of the device are reported herein.

• Journal of Magnetics
• /
• 제11권1호
• /
• pp.8-11
• /
• 2006

Recently half-metallic full-Heusler alloy films have attracted significant interests for spintronics devices. As these alloys have been known to have a high spin polarization, very large TMR ratio is expected in magnetic tunnel junctions. Among these alloys, $Co_2MnSi$ full-Heusler alloy with a high spin polarization and a high Curie temperature is considered a good candidate as an electrode material for spintronic devices. In this study, the magnetic and structural properties of $Co_2MnSi$ Heusler alloy films were investigated. TMR characteristics of magnetic tunnel junctions with a $Co_2MnSi/SiO_2/CoFe$ structure were studied. A maximum MR ratio of 39% with $SiO_2$ substrates and 27% with MgO(100) substrates were obtained. The lower MR ratio than expectation is considered due to off-stoichiometry and atomic disorder of $Co_2MnSi$ electrode together with oxidation of the electrode layer.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2000년도 하계종합학술대회 논문집(2)
• /
• pp.28-31
• /
• 2000

In this paper, the effects of La addition of PLZT(x/30/70) thin films Prepared by sol-gel method are investigated for NVFRAM application. The tetragonality (c/a), the grain size, and the surface roughness of PLZT thin films decrease with an increase of La concentration. As the La concentration increases, the dielectric constants at 10 kHz increase from 450 to 600, while the loss tangent decrease from 0.075 to 0.025. Also, the leakage current density at 100kV/cm decrease from 5.83$\times$10$^{-7}$ to 1.38$\times$10$^{-7}$ 4/$\textrm{cm}^2$. In the results of hysteresis loops measured at $\pm$170kV/cm, the remanent polarization and the coercive field of PLZT thin films with La concentration from 0 to 10㏖％ decrease from 20.8 to 10.5 $\mu$C/cm and from 54.48 to 32.12kV/cm, respectively. After a fatigue measurement by applying 10$^{9}$ square pulses with $\pm$5V, the remanent polarizations of PLZT thin films with 0 and 10㏖％ La concentration decrease about 64 and 42 ％ from initial state. In the results of retention measurement after 10$^{5}$ s, PLZT thin films with 0 to 10mo1％ La concentration show that the remanent polarization is decreased about 43％ and 9％ from initial state, respectively.

• Journal of Advanced Marine Engineering and Technology
• /
• 제36권8호
• /
• pp.1117-1122
• /
• 2012

연료전지를 선박에 적용하는 연구를 위해서는 연료전지 특성을 고려한 전력 시스템 설계 및 부하 제어에 대한 연구가 필요하다. 하지만 연료전지를 직접 실험하기 위해서는 여러 보조기기들과 복잡한 제어 기술이 필요하다. 이러한 이유로 연료전지 시뮬레이터가 필요하며, 이를 위한 연구가 활발히 진행중이다. 본 논문에서는 자동차, 소형 선박 등에 적용되고 있는 PEMFC에 관하여 LabVIEW를 기반으로 시뮬레이션 하였다. 또한 이러한 시뮬레이션 데이터를 바탕으로 프로그램이 가능한 전력공급장치를 이용하여 시뮬레이터를 제작하여 연료전지의 특성을 구현하였다. 이를 통해 연료전지의 분극화 곡선과 변수에 따른 I-V특성을 확인할 수 있었다.

• 한국정보통신학회논문지
• /
• 제16권12호
• /
• pp.2741-2746
• /
• 2012

본 연구에서는 기존의 질화알루미늄갈륨/질화갈륨 이종접합 구조에서 강한 분극현상으로 인하여 구현하기 어려웠던 상시불통형 소자를 질화알루미늄갈륨 기판 혹은 버퍼층을 이용하여 구현하는 방법을 제안한다. 질화알루미늄갈륨 기판 혹은 버퍼층 위에 더 높은 Al 몰분율을 갖는 장벽층을 성장하고 최상부에 질화갈륨 층을 추가 성장하여 분극전하를 상쇄시키는 방법을 이용하여 선택적으로 게이트 아래의 채널만 공핍시켜 상시불통형 소자를 구현할 수 있다. 이를 통하여 본 연구에서는 상용 전력소자에서 요구하는 게이트 문턱전압 2 V 이상을 갖는 질화알루미늄갈륨 이종접합 전계효과 트랜지스터 에피구조를 제안한다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 추계학술대회 논문집 Vol.19
• /
• pp.292-293
• /
• 2006

We have Investigated dielectric properties depending on bias voltage in organic lightemitting diodes using 8-hydroxyquinoline aluminum($Alq_3$) as an electron transport and emissive material. We analyzed the dielectric properties of organic light emitting diodes using impedance characteristics measurement by the auto-balancing bridge technique and equivalent cirrcuit of ITO/$Alq_3$/Al. Impedance characteristics was measured complex impedance Z and phase ${\theta}$ in the frequency range of 40 [Hz] to $10^8$ [Hz]. We obtained complex electrical conductivity, dielectric constant, and loss tangent ($tan{\delta}$) of the device at room temperature. From these analyses, we are able to interpret a conduction mechanism and dielectric properties contributed by an interfacial and orientational polarization.

• 한국전기전자재료학회논문지
• /
• 제17권12호
• /
• pp.1283-1288
• /
• 2004

Metal-ferroelectric-insulator-semiconductor(WFIS) capacitors using rapid thermal annealed LiNbO$_3$/AlN/Si(100) structure were fabricated and demonstrated nonvolatile memory operations. The capacitors on highly doped Si wafer showed hysteresis behavior like a butterfly shape due to the ferroelectric nature of the LiNbO$_3$ films. The typical dielectric constant value of LiNbO$_3$ film in the MFIS device was about 27, The gate leakage current density of the MFIS capacitor was 10$^{-9}$ A/cm$^2$ order at the electric field of 500 kV/cm. The typical measured remnant polarization(2P$_{r}$) and coercive filed(Ec) values were about 1.2 $\mu$C/cm$^2$ and 120 kV/cm, respectively The ferroelectric capacitors showed no polarization degradation up to 10$^{11}$ switching cycles when subjected to symmetric bipolar voltage pulses of 1 MHz. The switching charges degraded only by 10 % of their initial values after 4 days at room temperature.e.

• Journal of the Optical Society of Korea
• /
• 제20권1호
• /
• pp.135-139
• /
• 2016

I propose a vector passive harmonic mode-locked fiber laser based on topological insulator Bi2Se3 interacting with a fiber taper with a diameter of 7 μm. The particles of topological insulator are deposited uniformly onto the fiber taper with light pressure effect. By incorporating the fabricated saturable absorber into an Er-doped fiber laser cavity, stable mode-locked fiber is obtained. Due to the intense evanescent field of the fiber taper, strong confinement of light enhances the nonlinearity of the laser cavity, and passive harmonic mode-locking is performed. I observe a maximum harmonic mode-locking of 356th, corresponding to a frequency of 3.57 GHz. The pulse duration is 824 fs, and the full width at half maximum of the spectrum is about 8.2 nm. The polarization dependent loss of the saturable absorber is ~ 2.5 dB in the wavelength range of the C band. As the cavity contains no other polarization dependent device, the mode-locked laser is functioning in the vector state. The harmonic order vs pump power is investigated. To the best of our knowledge, this report is the highest frequency mode-locked fiber laser based on Bi2Se3. Experimental results indicate that the topological insulator Bi2Se3 functioning with a thin fiber taper is effective for vector harmonic mode-locking.

• 한국전기전자재료학회논문지
• /
• 제20권3호
• /
• pp.223-227
• /
• 2007

The effect of Eu contents on the ferroelectric properties of $Bi_{4-x}Eu_xTi_3 O_{12}$ (BET) thin films has been investigated. Bismuth Europium titanate thin films with a Eu contents were prepared on the $Pt/Ti/SiO_2/Si$ substrate by metal-organic decomposition technique. The structure and the morphology of the films were analyzed using X-ray diffraction (XRD) and field emission scanning microscopy (FE-SEM), respectively. From the XRD analysis, it was found that BET thin films have polycrystalline structure, and the layered-perovskite phase is obtained when the Eu contents exceeds 0.2 (x > 0.2). Also, the ferroelectric characteristics of the BET thin films were found to be dependent on the Eu content. Particularly, the BET films doped with x = 0.75 show better ferroelectric properties (remanent polarization 2Pr = 60.99 C/$cm^2$ and only a little polarization fatigue up to $3.5{\times}10^9$ bipolar switching cycling) than those doped with other Eu contents.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2005년도 추계학술대회 논문집 Vol.18
• /
• pp.293-294
• /
• 2005

We have investigated dielectric properties depending on frequency in organic light -emitting diodes using 8-hydroxyquinoline aluminum ($Alq_3$) as an electron transport and emissive material. We analyzed the dielectric properties of organic light-emitting diodes using impedance of characteristics. impedance characteristics was measured complex impedance Z and phase $\Theta$ in the frequency range of 40 Hz to $10^8$ Hz. We obtained complex electrical conductivity, dielectric constant, and loss tangent (tan$\delta$) of the device at room temperature. From these analyses, we are able to interpret a conduction mechanism and dielectric properties contributed by an interfacial and orientational polarization.