• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.11C
• /
• pp.1164-1170
• /
• 2002

In the ACE2000 MPLS system, MPLS Interface Module(MIM) is composed of an ATM Interface Module and a HFMA performing a packet forwarding. In the MIM, the HFMA RSAR receive cells from the Physical layer and reassemble the cells. And the IP Lookup controller perform a packet forwarding after packet classification. Forwarded packet is segmented into cells in the HFMA TSAR and transfer to the ALMA for the transmission to an ATM cell switch. When the MIM make use of an ATM Interface Module, it directly connect the ALMA with a PHY layer using the UTOPIA Level2 interface. Then, an ALMA performs Master Mode. Also, the HFMA TSAR performs the Master Mode in the MIM. Therefore, the UTOPIA-L2 Controller of the Slave Mode require for interfacing between an ALMA and a HFHA TSAR. In this paper, we implement the architecture and cell control mechanism for the UTOPIA-L2 Controller supporting Multi-ports.

• Earthquakes and Structures
• /
• v.22 no.1
• /
• pp.1-13
• /
• 2022

When a building suffers damages under moderate to severe loading condition, its physical properties such as damping and stiffness parameters will change. There are different practical methods besides various numerical procedures that have successfully detected a range of these changes. Almost all the previous proposed methods used to work with translational components of mode shapes, probably because extracting these components is more common in vibrational tests. This study set out to investigate the influence of using both rotational and translational components of mode shapes, in detecting damages in 3-D steel structures elements. Three different sets of measured components of mode shapes are examined: translational, rotational, and also rotational/translational components in all joints. In order to validate our assumptions two different steel frames with three damage scenarios are considered. An iterative model updating program is developed in the MATLAB software that uses the OpenSees as its finite element analysis engine. Extensive analysis shows that employing rotational components results in more precise prediction of damage location and its intensity. Since measuring rotational components of mode shapes still is not very convenient, modal dynamic expansion technique is applied to generate rotational components from measured translational ones. The findings indicated that the developed model updating program is really efficient in damage detection even with generated data and considering noise effects. Moreover, methods which use rotational components of mode shapes can predict damage's location and its intensity more precisely than the ones which only work with translational data.

• Journal of The Korean Society of Integrative Medicine
• /
• v.12 no.2
• /
• pp.11-23
• /
• 2024

Purpose : The purpose of this study was to investigate the effect of exercise using a suspension device (sling and total body resistance exercise; TRX) on physical functional performance and postural balance. Methods : An experimental study comparing 2 different suspension exercise was conducted on 16 healthy college students. 16 subjects were assigned to two groups. They were classified into 8 sling group and 8 TRX group. Miniplus was used to evaluate physical functional performance. In this study, isokinetic resistance mode was used to compare and analyze seven movement patterns. Biorescue was used to evaluate postural balance. The intervention exercises in this study are as follows. Standing lean forward (SLF) using a sling and TRX was performed 3 times a week for 3 weeks. The SLF was held for 10 seconds and then rested for 15 seconds, repeated a total of 10 times for 3 sets. Results : In the TRX group, significant increases were observed in physical functional performance (p<.05). Among the differences between groups, significant differences were confirmed on the front of the right arm, the back of the left arm, and the back of the right arm. In the sling group, significant increases were observed in left, right, front, and overall dynamic balance (p<.05). A significant increase in posterior dynamic balance was confirmed in the TRX group (p<.05). There was no significant difference between groups. Conclusion : Based on the results of this study, TRX was effective in improving physical functional performance, while the sling was effective in enhancing postural balance. However, confirming the effectiveness of slings and TRX in the relationship between physical functional performance and postural balance proved inadequate. Therefore, additional research should be conducted to verify the effects of suspension.

• Korean Chemical Engineering Research
• /
• v.46 no.2
• /
• pp.217-221
• /
• 2008

To investigate the enhancing effects in transdermal permeation of drug using newly designed ultrasound apparatus of 500 kHz, the transdermal permeation studies through the hairless mouse skin were conducted with lidocaine. The ultrasound apparatus of 500 kHz frequency and transducer were newly developed. The drug permeation studies were performed according to the ultrasound frequencies such as 1 MHz and 500 kHz at $1W/cm^2$ in intensity in continuous mode or pulsed mode, respectively. The results on transdermal permeation of lidocaine according to ultrasound intensity showed that the drug permeation increased as the intensity was higher.

• Applied Chemistry for Engineering
• /
• v.26 no.6
• /
• pp.746-752
• /
• 2015

This study investigates the effects of aspect ratio (transport length-to-width) on diffusive-convection for physical vapor transport processes of $Hg_2Cl_2-NO$ system. For a system with the temperature difference of 20 K between an interface at the source material region and growing crystal interface, the linear temperature profiles at walls, the total molar fluxes at Ar = 2 are much greater than Ar = 5 as well as the corresponding nonuniformities in interfacial distributions due to the effect of convection. The maximum total molar flux at the gravitational acceleration of 1 $g_0$ is greater twice than at the level of 0.1 $g_0$, where g0 denotes the gravitational acceleration on earth. With increasing aspect ratio from 2 to 5, a diffusive-convection mode is transited into the diffusion mode, and then the strength of diffusion is predominant over the strength of diffusive-convection.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.6A
• /
• pp.558-564
• /
• 2007

3G Long Term Evolution, which aims for various mobile multimedia service provision by enhanced wireless interface, proposes VoIP-based voice service through a Packet Switching (PS) domain. As delay and loss-sensitive VoIP traffic flows through the PS domain, more challenging technical difficulties are expected than in Circuit Switching (CS) domain based VoIP services. Moreover, since 3G LTE, which adopts the OFDM as its physical layer, introduces Physical Resource Block (PRB) as a unit for transmission resources, new types of resource management schemes are needed. This paper proposes a PRB scheduling algorithm of MAC layer for VoIP service in 3G LTE and shows the simulation results. The proposed algorithm has two key parts; dynamic activation of VoIP priority mode to satisfy VoIP QoS requirements and adaptive adjustment of the priority mode duration in order to minimize the degradation of resource utilization.

• Journal of Power System Engineering
• /
• v.22 no.6
• /
• pp.51-57
• /
• 2018

In Korea, the Air Quality Conservation Act and the Petroleum and Petroleum Substitute Fuel Business Act stipulate certain quality standards for fuels distributed in Korea, thereby striving to reduce vehicle performance and emissions. Domestic petroleum products import and produce all the crude oil from each oil refiner so that the quality of the petroleum product is different according to the characteristics of the crude oil. As a result, vehicles have been improved by using the physical properties calculated through the physical property measurement that has tried to improve the accuracy of the measurement of the energy consumption efficiency of the automobile by using standard fuel from abroad. In this study, the same test procedure and method as the test method of domestic gasoline vehicle emission are applied using four samples of gasoline and the latest gasoline vehicle which are actually distributed, and the performance evaluation is performed. The purpose of this study is to contribute to improvement of vehicle technology and fuel quality by collecting necessary basic data and obtaining data on the effect of differences in gasoline property on vehicle emissions. The results of the test showed that the emission of gases (NMOG, CO) from gasoline vehicles was the most influenced by the sulfur content, unlike the previous studies that the vehicles emission had the greatest influence on the distillation characteristics and the specific gravity of aromatic compounds. The catalytic reaction such as the poisoning action of the three-way catalyst which is the abatement device was interfered and the emission was increased. The distillation characteristics and specific gravity of aromatic compounds were found to affect the emission of vehicles. According to the physical properties of the fuel, the emission difference was 28.0% in the urban mode and 17.6 % in the highway mode.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.20 no.2
• /
• pp.235-253
• /
• 2018

Groundwater flow induced by cracks in a buried pipe causes ground loss in the vicinity of it which can lead to underground cavities and sinkhole problems. In this study, the ground collapse mechanism and the failure mode based on an aperture in the pipe located in cohesionless ground were investigated through a series of physical model studies. As the influence parameters, size of the crack, flow velocity in the pipe, groundwater level, ground cover depth and ground composition were adopted in order to examine how each of the parameters affected the behavior of the ground collapse. Influence of every experimental condition was evaluated by the final shape of ground failure (failure mode) and the amount of ground loss. According to the results, the failure mode appeared to be a 'Y' shape which featured a discontinuous change of the angle of erosion when a groundwater level was equal to the height of the ground depth. While in the case of a water table getting higher than the level of ground cover depth, the shape of the failure mode turned to be a 'V' shape that had a constant erosion angle. As the height of the ground depth increased, it was revealed that a mechanism where a vertically collapsed area which consisted of a width proportional to the ground height and a constant length occurred was repeated.

• Corrosion Science and Technology
• /
• v.6 no.4
• /
• pp.198-205
• /
• 2007

The initial stages of electrochemical oxidative CuI film formation on Cu(111), as studied by means of Cyclic Voltammetry (CV), in-situ Scanning Tunneling Microscopy (STM) and ex-situ Synchrotron X-ray Photoemission Spectroscopy (SXPS), indicate a significant acceleration of copper oxidation in the presence of iodide anions in the electrolyte. A surface confined supersaturation with mobile CuI monomers first leads to the formation of a 2D-CuI film via nucleation and growth of a Cu/I-bilayer on-top of a pre-adsorbed iodide monolayer. Structurally, this 2D-CuI film is closely related to the (111) plane of crystalline CuI (zinc blende type). Interestingly, this film causes no significant passivation of the copper surface. In an advanced stage of copper dissolution a transition from the 2D- to a 3D-CuI growth mode can be observed.

• Journal of the Korean Society of Physical Medicine
• /
• v.6 no.4
• /
• pp.437-445
• /
• 2011

Purpose : The purpose of this study was to analysis on diaphragm thickness and lung function of stroke patients by walking ability. Methods : We recruited thirty-five adults after stroke(20 male, 15 female) for our study. The subjects were divided into two groups; independent walking group(11 male, 9 female) and non-independent walking group(9 male, 6 female). Assessment of diaphragm thickness was performed using ultrasound in B-mode with a 7.5 MHz linea probe. During the experiment, the subject was seated in the chair. All subjects performed maximal expiratory flow maneuvers using a spirometer in order to determine the forced expiratory volume in 1 second ($FEV_1$), forced vital capacity(FVC), peak expiratory flow(PEF) and $FEV_1$/FVC. Chest expansion was measured with a tape-measure placed circumferentially around the chest wall at the xiphoid process. The collected data analyzed by independent t-test. Results : The diaphragm thickness were significant differences between the independent walking and nonindependent walking group. Values of forced vital capacity, forced expiratory volume at one second, peak expiratory flow in pulmonary function tests were significant differences between the independent walking and non-independent walking group. However, chest expansion were not significant differences in both of the group. Conclusion : This study showed that walking ability of stroke patients have influenced on diaphragm thickness and pulmonary function.