• Journal of Electrical Engineering and Technology
• /
• v.12 no.5
• /
• pp.1697-1708
• /
• 2017

This paper proposes an algorithm for the differential protection of an Indirect Symmetrical Phase Shift Transformer (ISPST) by considering the different behaviors of the compensated differential current under internal fault and magnetizing inrush conditions. In this algorithm, a criterion function is defined which is based on the difference of amplitude of the wavelet transformation over a specific frequency band. The function has been used for the discrimination between three phase magnetizing inrush and internal fault condition and requires less than a quarter cycle after disturbance. This method is independent of any coefficient or threshold values of wavelet transformation. The merit of this algorithm is demonstrated by the simulation of different faults in series and excitation unit and magnetizing inrush with varying switching conditions on ISPST using PSCAD/EMTDC. Due to unavailability of in-field large interconnected transformers for such a large number of destructive tests, the results are further verified by Real Time Digital Simulator (RSCAD/RTDS). The proposed algorithm has been compared with the conventional harmonic restraint based method that justifies the application of wavelet transform for differential protection of ISPST. The proposed algorithm has also been verified for different rating of ISPSTs and satisfactory results were obtained.

• Proceedings of the KIPE Conference
• /
• 2003.07a
• /
• pp.227-230
• /
• 2003

In this paper, a full bridge edge-resonant zero voltage mode based soft-switching PWM DC-DC power converter with a high frequency center tapped transformer link stage is presented from a practical point of view. The power MOSFETS operating as synchronous rectifier devices are implemented in the rectifier center tapped stage to reduce conduction power losses and also to extend the transformer primary side power MOSFETS ZVS commutation area from the rated to zero-load without a requirement of a magnetizing current. The steady-state operation of this phase-shift PWM controlled power converter is described in comparison with a conventional ZVS phase-shift PWM DC-DC converter using the diodes rectifier. Moreover, the experimental results of the switching power losses analysis are evaluated and discussed in this paper. The practical effectiveness of the ZVS phase-shift PWM DC-DC power converter treated here is actually proved by using 2.5kW-32kHz breadboard circuit. An actual efficiency of this converter is estimated in experiment and is achieved as 97$\%$ at maximum.

• Proceedings of the Korea Contents Association Conference
• /
• 2003.11a
• /
• pp.303-307
• /
• 2003

In this paper, the W(ultra widebend) system is used for high speed transmission applying BPSK(Binary Phase Shift Keying) and QPSK (Quadrature Phase Shift Keying), and utilizing the convolution coding with code rate, 1/2 and constraint length, K=7 in order to reduce the bit error rate. And the performance of system is analyzed in the AWGN(Additive White Gaussian Noise) channel environment by using the Viterbi decoding algorithm and adopting the time-hopping sequence as a multiple access method in order to avoid the multiuser interference.

• Journal of the Korean Electrochemical Society
• /
• v.3 no.2
• /
• pp.109-114
• /
• 2000

The relation between the phase-shift profile fur the intermediate frequencies and the Langmuir adsorption isotherm at the poly-Ir/0.1 M $H_2SO_4$ aqueous electrolyte interface has been studied using ac impedance measurements, i.e., the phase-shift methods. The simplified interfacial equivalent circuit consists of the serial connection of the electrolyte resistance $(R_s)$, the faradaic resistance $(R_F)$, and the equivalent circuit element $(C_P)$ of the adsorption pseudoca-pacitance $(C_\phi)$. The comparison of the change rates of the $\Delta(-\phi)/{\Delta}E\;and\;\Delta{\theta}/{\Delta}E$ are represented. The delayed phase shift $(\phi)$ depends on both the cathode potential (E) and frequency (f), and is given by $\phi=tan^{-1}[1/2{\pi}f(R_s+R_F)C_P]$. The phase-shift profile $(-\phi\;vs.\;E)$ for the intermediate frequency (ca. 1 Hz) can be used as an experimental method to determine the Langmuir adsorption isotherm $(\theta\;vs.\;E)$. The equilibrium constant (K) for H adsorption and the standard free energy $({\Delta}G_{ads})$ of H adsorption at the poly-Ir/0.1 M $H_2SO_4$ electrolyte interface are $2.0\times10^{-4}$ and 21.1kJ/mol, respectively. The H adsorption is attributed to the over-potentially deposited hydrogen (OPD H).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.6B
• /
• pp.689-696
• /
• 2011

In this paper, we propose the result of PSSK(Phase Silence Shift Keying) modulation scheme that is mixed PSK(Phase Shift Keying) modulation and PPM(Pulse Position Modulation) method. The performance of underwater communication systems are influenced underwater channel characteristics. In particular, delay spread can make ISI(Inter Symbol Interference) because of reverberation and multi path. It degrade the performance of the communication system. Also underwater sensor networks consider about power efficient due to the particularities of their operating environment. PSSK modulation method transmit two orthogonal symbol and using silence period in a period so it can reduce the power. Increasing the distance of between modulation symbols, to enhance the performance of BER(Bit Error Rate) as well as to improve power efficient. The result of sea trial, QPSK modulation BER is $3.19{\times}10^{-1}$ and PSSK modulation BER is $2.89{\times}10^{-1}$.

• Journal of IKEEE
• /
• v.25 no.3
• /
• pp.517-527
• /
• 2021

This paper presents the phase-shift full-bridge DC-DC converter using the one-chip micom. The proposed converter primary is the full-bridge power topology that operates with the unipolar pulse-width modulation (PWM) by the phase-shift method, and the secondary is the full-bridge full-wave rectifier composed of four diodes. The control of proposed converter is performed by the one-chip micom and its MOSFET switches are driven by the bootstrap circuit. Thus the total system of proposed converter is simple. The proposed converter achieves high-efficiency using the resonant circuit and blocking capacitor. In this paper, first, the power-circuit operation of proposed converter is explained according to each operation mode. And the power-circuit design method of proposed converter is shown, and the software control algorithm on the micom and the feedback and switch drive circuits operating the proposed converter are described, briefly. Then, the operation characteristics of proposed converter are validated through the experimental results of a designed and implemented prototype converter by the shown design and implementation method in this paper. The highest efficiency in the results was about 92%.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1767_1768
• /
• 2009

4-step 알고리즘을 이용하여 3차원 이미지 위상 정보를 분석하였다. Carre(1966)에 의하여 제시된 위상 분석 기술은 위상이동에 대하여 설명하고 있다. Wyant(1982)에 의한 4-step 알고리즘은 수많은 PSI(Phase-Shift Interferometry)법[1] 중에서 가장 일반적인 내용이다. 그러나 실험장비 설치 시, 매우 어렵다는 단점이 있다. 실험 과정에서 물체의 3차원 형상을 얻기 위해 매우 간단히 실험 설치를 하였다. 간섭 패턴은 추가적인 렌즈, 거울, 모터와 같은 광학장비 없이 랩뷰 프로그램과 비젼 시스템을 사용하여 구축하였다. 4-step method와 컴퓨터 프로그램에 의해 생성된 unwrapping image에 의해 물체의 wrapped된 이미지를 얻었다. 실험에 의하여 얻어진 간섭패턴을 분석 함으로써, 웨이브 프론트, 강도 그래프, 3차원 형상, 상수 데이터와 같은 다양한 정보를 얻을 수 있었다.

• Proceedings of the KIPE Conference
• /
• 1999.07a
• /
• pp.618-621
• /
• 1999

With the advent of the high-speed microprocessor and DSP, the possibility of executing a control strategy in digital domain has become a reality. By the use of the DSP and microprocessor controller, many high power drive system may be enhanced resulting in the improved robustness to EMI, the ability to communicate the operating conditions and the ease of adjusting the control parameters. But, the digital controller using DSP or microprocessor is not applied in the high frequency switching power supplies, especially full bridge DC/DC converter. So, this paper presents the method and realization of designing a digital-to-phase shift PWM circuit for full digital controlled full bridge DC/DC converter with zero voltage switching. The operating principles, simulation and experimental results will be presented.

• Proceedings of the IEEK Conference
• /
• 2007.07a
• /
• pp.337-338
• /
• 2007

The present paper proposes the method which improves a record and remaking efficiency of the optical pickup as applying the mirror where Phase Shift(PS) principle is applied to optical pickup. Plan to get a circularly polarized light quality above quality which is embodied through Existing Quater Wave Plate(QWP) and a function of total reflection mirror as applying PS mirror which integrates QWP with the function of the total reflection to optical pickup. In the present paper, embody circularly polarized light quality through applying PS mirror to optical pickup, and it through, plan to propose to come true the optimization of recording and remaking CD/DVD disc.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.9
• /
• pp.658-665
• /
• 2003

In this paper, we propose an improved image encryption and the shift-tolerance method in the Fourier space using a virtual phase image. The encrypted image is obtained by the Fourier transform of the product of a phase-encoded virtual image, not an original image, and a random phase image. Therefore, even if unauthorized users analyze the encrypted image, we can prevent the possibility of counterfeiting from unauthorized people using virtual image which dose not contain any information from the original image. The decryption technique is simply performed by inverse Fourier transform of the interference pattern between the encrypted image and the Fourier decrypting key, made of proposed phase assignment rule, in frequency domain. We demonstrate the robustness to noise, to data loss and shift of the encrypted image or the Fourier decryption key in the proposed technique.