• Journal of the Optical Society of Korea
• /
• v.18 no.6
• /
• pp.809-817
• /
• 2014

The loss in contrast-discrimination ability of the human visual system under high ambient illumination level can cause image quality degradation in mobile phones. In this paper, we propose a perceived contrast compensation method by processing the original displayed image. With consideration that the perceived contrast significantly varies across the image, this method extracts the local band contrast from the original image; it then compensates these contrast components to counteract the perceived contrast degradation. Experimental results demonstrate that this method can maintain most contrast details even in high ambient illumination levels.

• Current Optics and Photonics
• /
• v.2 no.1
• /
• pp.96-100
• /
• 2018

A tunable low-phase-noise microwave generation structure that utilizes an optoelectronic oscillator (OEO) and a fiber Bragg grating (FBG) is proposed and experimentally demonstrated in this article. This structure has no particular requirement for the band width of the laser, and its tunability is realized through adjusting the central frequency of the tunable FBG. A detailed theoretical analysis is established and confirmed via an experiment. A high-purity microwave signal with a frequency tunable from 6 to 12 GHz is generated. The single-sideband phase noise of the generated signal at 10.2 GHz is -117.2 dBc/Hz, at a frequency offset of 10 kHz.

• Current Optics and Photonics
• /
• v.2 no.1
• /
• pp.53-58
• /
• 2018

A novel X-band high speed frequency sweep signal generator based on a tunable optoelectronic oscillator (OEO) incorporating a frequency-swept laser is presented and the theoretical fundamentals of the design are explained. A prototype of the generator with tuning range from 8.8552 GHz to 10.3992 GHz and a fine step about 8 MHz is achieved. The generated radiofrequency signal with a single sideband (SSB) phase noise lower than -100 dBc/Hz@10KHz is experimentally demonstrated within the whole tunable range, without any narrow RF band-pass filters in the loop. And the tuning speed of the frequency sweep signal generator can reach to over 1 GHz/s benefiting from applying a novel dispersion compensation modular instead of several tens of kilometers of optical fiber delay line in the system.

• Transactions on Electrical and Electronic Materials
• /
• v.2 no.2
• /
• pp.16-20
• /
• 2001

Optoelectronic characteristics of the superlattice diode as a function of deposition temperature and annealing conditions have been studied. The multilayer nanocrystalline silicon/adsorbed oxygen (nc/Si/O) superlattice formed by molecular beam epitaxy (MBE) system. Experimental results showed that deposition temperature of 550$^{\circ}C$, followed by hydrogen annealing leads to best results, in terms of optical photoluminescence (PL) and electrical current-voltage (I-V) characteristics. Consequently, the experimental results of multilayer Si/O superlattic device showed the stable photoluminescence and good insulating behavior with high breakdown voltage. This is very useful promise for Si-based optoelectronic devices, and can be readily integrated with conventional silicon ULSI processing.

• Journal of the Optical Society of Korea
• /
• v.18 no.2
• /
• pp.101-109
• /
• 2014

In this paper, four apodization functions are proposed for silicon-on-insulator (SOI) strip waveguides with sidewall-corrugated gratings. The effects of apodization functions on the full width at half maximum (FWHM), the side-lobe level, and the reflectivity of the reflection spectrum are studied using the coupled-mode theory (CMT) and the transfer-matrix method (TMM). The results show that applying proposed apodization functions creates very good filtering characteristics. Among investigated apodized waveguides, the apodization functions of Polynomial and z-power have the best performance in reducing side-lobes, where the side-lobe oscillations are entirely removed. Four functions are also used for precise adjustment of the bandwidth. Simulation results show that the minimum and maximum values of the FWHM are 0.74 nm and 8.48 nm respectively. In some investigated functions, changing the apodization parameters decreases the reflectivity which is compensated by increasing the grating length.

• Journal of the Optical Society of Korea
• /
• v.18 no.5
• /
• pp.453-458
• /
• 2014

A novel high birefringent polymer terahertz (THz) fiber with a suspended elliptical core is proposed in this paper. The introduction of an elliptical core can enhance asymmetry to realize high mode birefringence, and a large porous outer cladding effectively isolates the core-guided mode from interacting with the surrounding environment. A full-vector finite element method(FEM) is used to analyze the characteristics of the THz fiber. Simulation results show that the suspended elliptical fiber exhibits high mode birefringence on a level of $10^{-2}$ over a wide frequency range, and an extremely large mode birefringence(${\approx}0.06226$) is obtained when ellipticity is 0.2. Moreover, a suspended hollow elliptical core fiber is also discussed for the purpose of lower loss, however high mode birefringence and low relative absorption loss can not coexist in such a kind of fiber.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.213-213
• /
• 2010

We investigated the RF sputtering conditions for the deposition of AZO (Al doped ZnO) transparent conducting film on PET using the roll to roll vacuum coater. AZO thin films, sputtered at the various RF powers and working pressures, were studied for their structural, electrical and optical properties.. From the X-Ray diffraction patterns, we calculated the lattice stress using the Bragg equation. The compressive stress tends to decrease with the increase in film thickness. AZO thin film with the thickness of 152nm (1400W, 0.4Pa) exhibit the resistivity of $3.92*10-3{\Omega}/cm$ and the transmittance of 96.9% at 550nm.

• Journal of the Optical Society of Korea
• /
• v.17 no.6
• /
• pp.491-493
• /
• 2013

This paper proposes a frequency-doubling optoelectronic oscillator employing a novel three-arm dual-output Mach-Zehnder modulator (MZM). One output of the MZM generates the fundamental-frequency signal which is recycled by the microwave optical fiber link for oscillation, and the other output can generate the frequency-doubled signal. Experiment was conducted using a commercial two-arm MZM, a phase modulator, and an optical fiber link of 89 meters in length. A 19-GHz frequency-doubled signal was successively obtained with fundamental signal suppression more than 36 dB.

• Current Optics and Photonics
• /
• v.6 no.6
• /
• pp.634-641
• /
• 2022

A frequency stable and tunable optoelectronic oscillator (OEO) incorporating an optical phase shifter and a phase-shifted fiber Bragg grating (PS-FBG) is designed and analyzed. The frequency tunability of the OEO can be realized by using a tunable microwave photonic bandpass filter consisting of a PS-FBG, a phase modulator. The optical phase compensation loop is used to compensate for the phase variations of the RF signal from the OEO by adjusting an optical phase shifter. Simulation results demonstrate that the output RF signals of the OEO can be tuned in a frequency range of 118 MHz to 24.092 GHz. When the ambient temperature fluctuates within ±3.9 ℃, the frequency drifts of the output RF signals are less than 68 Hz, the side-mode suppression ratios are more than 69.39 dB, and the phase noise is less than -92.49 dBc/Hz at a 10 kHz offset frequency.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.3
• /
• pp.215-222
• /
• 2022

Artificial neuromorphic devices are considered the key component in realizing energy-efficient and brain-inspired computing systems. For the artificial neuromorphic devices, various material candidates and device architectures have been reported, including two-dimensional materials, metal-oxide semiconductors, organic semiconductors, and halide perovskite materials. In addition to conventional electrical neuromorphic devices, optoelectronic neuromorphic devices, which operate under a light stimulus, have received significant interest due to their potential advantages such as low power consumption, parallel processing, and high bandwidth. This article reviews the recent progress in optoelectronic neuromorphic devices using various active materials such as two-dimensional materials, metal-oxide semiconductors, organic semiconductors, and halide perovskites