• Proceedings of the KOSOMBE Conference
• /
• v.1997 no.05
• /
• pp.64-67
• /
• 1997

In the total artificial heart(TAH), a transcutaneous information transmission system(TITS) is vely important to monitor the TAH status and detect the device failure, and repair the possible problems. First of all, the communication channel(skin) and method were simulated in terms of transmittance, scattering, reflection and absorption, then the system was designed with size reduction including low power consumption and reliability compared to the previous one. The informations are transmitted through the skin(approximately 1cm in depth) by frequency modulated near infrared(NIR) pulses using 780nm laser diodes as transmitters and photodiode as receiver with high speed and high spectral sensitivity. The logic high and low frequencies are 3MHz, 1MHz respectively. The system is a bidirectional data link for more than 38.4Kbps data rate, full-duplex with a bit error rate of less than $10^{-5}$.

• Korean Journal of Optics and Photonics
• /
• v.12 no.3
• /
• pp.212-218
• /
• 2001

We experimentally investigated the dependence of extinction ratio and chirp on bias current which was injected into DFB-LD in a directly modulated 2.5 Obitls transmitter. Through the abnormal dispersion transmission, we found that transmission power penalty is minimized at 8-10 dB extinction ratio (bias current at 1.5-1.8 fold above threshold current). Also, we discussed the relation between extinction ratio and self phase modulation (SPM) through the 240 km abnormal dispersion transmission. When SPM takes effect, we obtained the best receiver sensitivity for specific system configuration at 10.4 dB and 8.4 dB extinction ratio, below and above 200km transmission distance, respectively. ively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.11 no.3
• /
• pp.153-163
• /
• 1986

GaAs, one of the III-V compounding semicondnctors, has been widely employed as base materials for the fabrication of the ultra-high-speed devices in the filelds of DBS, optical communications, MMIC'S and digital IC'S. There have been some reports on 4Kx4bit SRAM by D/E MESFET'S, 4K bit SRAM by HEMT'S, and receiver front ends for X-band by MMIC technologies, respectively. This paper reviews GaAs materials, wafer fabrication processes, device applications, and design aspects, and, finally, descusses the future of the ultra-high-spped-devices.

• Journal of IKEEE
• /
• v.22 no.2
• /
• pp.316-323
• /
• 2018

In this paper, we newly introduce the three-level byte-inversion transmission method for preventing LED flicker in visible light communication (VLC). The VLC transmitter sequentially sends the original signal and the inverted signal in byte units using a three-level LED modulator. The average optical power of the LED is kept constant during data transmission, thus flicker-free. In the VLC receiver, the original data is easily recovered using a simple comparator. This structure is very simple because additional clock or carrier is not required for flicker prevention. The developed flicker prevention scheme could be very useful for constructing the flicker-free indoor VLC system in low cost.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.12
• /
• pp.1-7
• /
• 1998

in this work, we designed and characterized a 10Gb/s clock and regeneration circuit. The circuit was realized by integrating high-speed ICs and microwave circuits on alumina substrates. The quadri-correlation method was used for frequency and phase-locked loop. The frequency locking range was 150MHz and the rms jitter generated by the circuit was measured to be less than 1.0ps. The clock and data regeneration circuit was successfully applied to 10Gb/s optical receiver.

• Journal of IKEEE
• /
• v.24 no.2
• /
• pp.579-585
• /
• 2020

In this study, we used byte-inversion transmission method to prevent the flicker of lighting source in a visible light data communication link. In the transmitter, the non-return-to-zero (NRZ) signal with 9.6 kbps was on-off keying (OOK) modulated with a 100 kHz square wave carrier and byte-inversion signal was added after each byte to make the average optical power of the light-emitting diode (LED) constant. In the receiver, we used a band-pass filter to eliminate the interference of the 120 Hz noise which was induced from the adjacent light lamps, and an OOK demodulator to recover the original NRZ signal This scheme is useful in constructing wireless data networks using the illumination of visible light lamps.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.11
• /
• pp.1190-1196
• /
• 2014

This paper presents the design of a Frequency Modulated Continuous Wave(FMCW) radar altimeter with wide altitude range and low measurement errors. Wide altitude range is achieved by employing the optic delay in the transmitting path to reduce the dynamic range of measuring altitude. Transmitting power and receiver gain are also controlled to have the dynamic range of the received power be reduced. In addition, low measurement errors are obtained by improving the sweep linearity using the Direct Digital Synthesizer(DDS) and minimizing the phase noise employing the reference clock(Ref_CLK) as the offset frequency of the Phase Locked Loop(PLL).

• Proceedings of the Korea Information Processing Society Conference
• /
• 2005.05a
• /
• pp.1641-1644
• /
• 2005

현재의 인터넷과 같은 전자 통신망과 멀티미디어 시스템의 발달은 고속의 대용량 데이터 전송을 필요로 한다. 초고속 통신 시스템에서의 고속 데이터 전송은 주로 광섬유를 사용하는 광통신으로 이루어지고 있다. FTTH(Fiber To The Home)와 같은 광통신 시스템은 멀티미디어 커뮤니케이션을 위해 필요한 큰 데이터 전송률을 제공할 수 있기 때문에 더욱 더 중요성이 높아지고 있으며 이러한 광통신 시스템에서는 통신환경의 영향을 적게 받고 외부 조절이나 부품이 필요하지 않는 수신기 IC 의 개발이 요구되고 있다. 일반적으로 광통신 수신기에는 고속 동작에 적합한 특성을 가진 GaAs-MESFET 가 사용되고 있으나, 본 논문에서는 0.35um CMOS 2-poly 4-metal 공정을 이용하여 5Gbps 광수신기를 설계하였다. 설계된 수신기는 Preamplifier, Main amplifier, ABC 회로로 구성되어 있다. Transimpedance amplifier 형태의 Preamplifier 는 광검출기에 의해 생성된 전류 신호를 전압 신호로 변환한다. ABC 회로는 Peak_Hold 회로와 Bottom_Hold 회로로 구성되어 있다. 기존의 Peak_Hold 회로에서는 다이오드와 hold capacitor 를 이용하여 peak 값을 검출하도록 되어 있는데, 다이오드를 이용하는 경우 작은 입력 신호전압의 Peak 값을 검출하는 데 한계가 있다. 이러한 단점을 보완하고자 전류 거울형태의 Peak_Hold 회로를 설계하였다. 전류거울(current mirror)형태의 출력 신호의 duty error 를 줄이고 비트 에러율(Bit Error Rate)을 개선하는데 효과적이었다. 설계된 광수신기는 30dB 의 입력 dynamic range 와 입력 capacitance 3pF 에서 80MHz 의 대역폭을 가진다. 전력 소비량은 3.3V 전원 전압이 인가된 경우 약 150mW 정도이다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.735-740
• /
• 2004

When optical signal power of ONU differs from each other the requirements of an OLT receiver becomes strict and the stable operation of a total PON system can't be obtained. To solve this problem each ONU channel's signal power is measured at the OLT side and control signals to equalize them are generated and sent to each ONU. The proposed scheme is tested after implementation A digital APC circuit is proposed and tested so that it can start or stop LD operation without delay. It helps other ONU to transmit signals without interference and to reduce consuming power.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.8
• /
• pp.2027-2041
• /
• 2013

In this paper, we propose a novel reversible data hiding scheme in the index tables of the vector quantization (VQ) compressed images based on index set construction strategy. On the sender side, three index sets are constructed, in which the first set and the second set include the indices with greater and less occurrence numbers in the given VQ index table, respectively. The index values in the index table belonging to the second set are added with prefixes from the third set to eliminate the collision with the two derived mapping sets of the first set, and this operation of adding prefixes has data hiding capability additionally. The main data embedding procedure can be achieved easily by mapping the index values in the first set to the corresponding values in the two derived mapping sets. The same three index sets reconstructed on the receiver side ensure the correctness of secret data extraction and the lossless recovery of index table. Experimental results demonstrate the effectiveness of the proposed scheme.