• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2000.11a
• /
• pp.197-201
• /
• 2000

In this paper, a MMIC(Monolithic Microwave Integrated Circuit) broadband drive amplifier for wireless communication system has designed using active feedback method. The MMIC brodband amplifier was designed using 0.5$\mu\textrm{m}$ MESFET of ETRI library. Simulation results show that gain is 22 dB, and gain flatness ${\pm}$1 dB. Maximum output power 15 dBm and noise figure 2.5 dB in bandwidth 500 MHz ～3.0 GHz. The MMIC Broadband amplifer's chip area is 14mm${\times}$1.4mm.

• ETRI Journal
• /
• v.33 no.3
• /
• pp.462-465
• /
• 2011

A millimeter-wave (mm-wave) high-linear low-noise amplifier (LNA) is presented using a 0.18 ${\mu}m$ standard CMOS process. To improve the linearity of mm-wave LNAs, we adopted the multiple-gate transistor (MGTR) topology used in the low frequency range. By using an MGTR having a different gate-source bias at the last stage of LNAs, third-order input intercept point (IIP3) and 1-dB gain compression point ($P_{1dB}$) increase by 4.85 dBm and 4 dBm, respectively, without noise figure (NF) degradation. At 33 GHz, the proposed LNAs represent 9.5 dB gain, 7.13 dB NF, and 6.25 dBm IIP3.

• ETRI Journal
• /
• v.38 no.6
• /
• pp.1031-1041
• /
• 2016

This paper presents millimeter-wave (mmWave) propagation characteristics and channel model parameters including path loss, delay, and angular properties based on 28 GHz and 38 GHz field measurement data. We conducted measurement campaigns in both outdoor and indoor at the best potential hotspots. In particular, the model parameters are compared to sub-6 GHz parameters, and system design issues are considered for mmWave 5G Giga communications. For path loss modeling, we derived parameters for both the close-in free space model and the alpha-beta-gamma model. For multipath models, we extracted delay and angular dispersion characteristics including clustering results.

• International journal of advanced smart convergence
• /
• v.8 no.4
• /
• pp.34-39
• /
• 2019

Millimeter-wave (mmWave) and Non-orthogonal multiple access (NOMA) are expected to be the major techniques that lead to the next generation wireless communication. NOMA provides a high spectrum efficiency by sharing of spatial resources among users in the same frequency band. Meanwhile, millimeter-wave gives a huge underutilized bandwidth at extremely high frequency band (EHF) which covers 30GHz to 300GHz. These techniques have been proven in several recent literatures to achieve high data rates. The combination of NOMA and millimeter-wave techniques further improves average sum capacities, as well as reduces the interference compared to conventional wireless communication systems. In this paper, we focus on hybrid NOMA system working in millimeter-wave frequency. We propose a clustering algorithm used for a hybrid NOMA scheme to optimize the usage of wireless resources. The proposed clustering algorithm adds several conditions in grouping users and defining clusters to increase the probability of the successful superposition decoding process. The performance of the proposed clustering algorithm is investigated in hybrid NOMA system and compared with the conventional orthogonal multiple access (OMA) scheme.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.8
• /
• pp.3-10
• /
• 2014

Millimeter wave (mmWave) has attracted great interest recently and the necessity of Millimeter Mobile Broadband (MMB) system has appeared based on the 4 Generation Long Term Evolution-Advanced (LTE-A) Specification. Currently, there are many studies about the mmWave communication channel. And it is subject of interest to analyze the performance in MMB channel environments. In this paper, we design the MMB system for 5th Generation mobile communication and propose channel models through the analysis of the mmWave propagation characteristics. Also, we have analyzed the performance of the MMB system of 28 GHz band in MMB channel environments.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10A
• /
• pp.847-851
• /
• 2011

In this paper, we reported on a high performance MMIC star mixer for millimeter-wave applications. The star mixer was fabricated using drain-source-connected pseudomorphic high electron mobility transistor (PHEMT) diodes considering the PHEMT MMIC full process on 2 mil thick GaAs substrate. The average conversion loss of 13 dB was measured in the RF frequency range of 81 GHz to 86 GHz at LO frequency of 75 GHz with LO power of 10 dBm. The RF-LO isolation characteristics are greater than 30 dB and the input 1-dB compression are approximately 4 dBm. The total chip size is 0.8 mm ${\times}$ 0.8 mm.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.4
• /
• pp.1-6
• /
• 2008

In this paper, millimeter-wave broadband MHEMT (Metamorphic High Electron Mobility Transistor) cascode amplifiers were designed and fabricated. The $0.1{\mu}m$ InGaAs/InAlAs/GaAs MHEMT was fabricated for cascode amplifiers. The DC characteristics of MHEMT are 670 mA/mm of drain current density, 588 mS/mm of maximum transconductance. The current gain cut-off frequency($f_T$) is 139 GHz and the maximum oscillation frequency($f_{max}$) is 266 GHz. To prevent oscillation of the designed cascode amplifiers, a parallel resistor and capacitor were connected to the drain of common gate device. By using the CPW (Coplanar Waveguide) transmission line, the cascode amplifier was designed and matched for the broadband characteristics. The designed amplifier was fabricated by the MHEMT MMIC process that was developed through this research. As the results of measurement, the amplifier was obtained 3 dB bandwidth of 50.37 GHz between 20.76 to 71.13 GHz. Also, this amplifier represents the S21 gain with the average 7.07 dB gain in bandwidth and the maximum gain of 10.3 dB at 30 GHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.11
• /
• pp.63-70
• /
• 2001

We demonstrate the MMIC (monolithic microwave integrated circuit) frequency doublers generating stable and low-cost 29 GHz local oscillator signals from 14.5 GHz input signals. These devices were designed and fabricated by using the M MIC integration process of $0.1\;{\mu}m$ gate-length PHEMTs (pseudomorphic high electron mobility transistors) and passive components. The measurements showed S11 or -9.2 dB at 145 GHz, S22 of -18.6 dG at 29 GHz and a minimum conversion loss of 18.2 dB at 14.5 GHz with an input power or 6 dBm. Fundamental signal of 14.5 GHz were suppressed below 15.2 dBe compared to the second harmonic signal at the output port, and the isolation characteristics of fundamental signal between the input and the output port were maintained above :i0 dB in the frequency range 10.5 GHz to 18.5 GHz. The chip size of the fabricated MMIC frequency doubler is $1.5{\times}2.2\;mm^2$.

• Proceedings of the IEEK Conference
• /
• 2002.07b
• /
• pp.1137-1140
• /
• 2002

A V-band low-noise amplifiers (LNA) based on the Millimeter-wave monolithic integrated circuit (MIMIC) technology were fabricated using high performance 0.1 $\mu\textrm{m}$ $\Gamma$-shaped pseudomorphic high electron mobility transistors (PHEMT＇s), coplanar waveguide (CPW) structures and the integrated process for passive and active devices. The low-noise designs resulted in a two-stage MIMIC LNA with a high S$\sub$21/ gain of 14.9 dB and a good matching at 60 ㎓. 20 dBm of IP3 and 3.9 dB of minimum noise figure were also obtained from the LNA. The 2-stage LNA was designed in a chip size of 2.3 ${\times}$1.4 mm$^2$by using 70 $\mu\textrm{m}$ ${\times}$2 PHEMT’s. These results demonstrate that a good low-noise performance and simultaneously with a high gain performance is achievable with GaAs PHEMT's in the 60 ㎓ band.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.213-217
• /
• 2001

본 논문에서는 CPW 구조를 이용하여 60 GHz 무선 시스템 응용을 위한 V-band용 하향 주파수 혼합기를 설계 및 제작하였다. 하향 주파수 혼합기의 설계 및 제작에 있어서 GaAs PHEMT(Pseudomorphic high electron mobility transistor)를 기반으로 하였으며, 회로설계를 위해 coplanar waveguide(CPW) 라이브러리를 구축하여 이용하였다. 제작된 하향 주파수 혼합기의 변환이득은 국부발진주파수(LO) 입력이 8 dBm일 때 -8.5 dB의 최대 변환이득 특성을 얻었으며 Pl dB는 -3.3 dBm을 얻었다. 제작된 회로의 칩 크기는 1.6$\times$l.6 $\textrm{mm}^2$ 이다.