• Proceedings of the KIPE Conference
• /
• 2019.07a
• /
• pp.77-79
• /
• 2019

Islanding detection is one of the most important issues for the distributed generation (DG) systems connected to the power grid. The conventional passive islanding detection methods inherently have a non-detection zone (NDZ), and active islanding detection methods may deteriorate the power quality of a power system. This paper proposes a novel hybrid islanding detection method based on Digital Lock-In Amplifier with no NDZ by monitoring the harmonics present in the grid. Proposed method detects islanding by passively monitoring the grid voltage harmonics and verify it by injecting small perturbation for only three-line cycles. Unlike FFT for the harmonic extraction, DLA HC have lower computational burden, moreover, DLA can monitor harmonic in real time, whereas, FFT has certain propagation delay. The simulation results are presented to highlight the effectiveness of the proposed technique. In order to prove the performance of the proposed method it is compared with several passive islanding detection methods. The experimental results confirm that the proposed method exhibits outstanding performance as compared to the conventional methods.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.1
• /
• pp.120-125
• /
• 1986

Data analysis methods in lock-in amplifier based DLTS systems were discussed with regards to the signal-to-noise ratio and improvement of resolution of DLTS spectrum. The DLTS system based on wideband two-phase lock-in amplifier is shown to be the most preferabe for the studies in deep levels of low concentration. A single-temperature scanning DLTS methods in lock-in amplifier based system with the improved sensitivity is proposed. The method is tested on the characterization of deep levels in n-GaAs.

• Proceedings of the IEEK Conference
• /
• 2003.07c
• /
• pp.2625-2628
• /
• 2003

Phase locked loops are widely used in many applications such as frequency synthesis, clock/data recovery and clock generation. In nearly all the PLL applications, low jitter and fast locking time is required. Without using adaptive loop filter, this paper proposes very simple method for improving locking time and jitter reduction simultaneously in charge pump PLL(CPPLL) using Daul Phase/Frequency Detector(Dual PFD). Based on the proposed scheme, the lock time is improved by 23.1％, and the jitter is reduced by 45.2％ compared with typical CPPLL.

• International Journal of Contents
• /
• v.11 no.1
• /
• pp.69-72
• /
• 2015

Generally, existing parallel main-memory spatial index structures to avoid the trade-off between query freshness and CPU cost uses light-weight locking techniques. However, still, the lock based methods have some limits such as thrashing which is a well-known problem in lock based methods. In this paper, we propose a distributed index structure for moving objects exploiting the parallelism in multiple machines. The proposed index is a lock free multi-version concurrency technique based on the D-Stream model of Spark Stream. The proposed method exploits the multiversion nature of D-Stream of Spark Streaming.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.6
• /
• pp.807-813
• /
• 1986

Measurements of interface states in a MOS capacitor by DLTS system using wideband monophase lock-in amplifier are discussed. A new signal analysis method that takes into account the bias pulse width and the gate off width is presented to remove the errors in the measured parameters of interface states resulting from the traditional method which neglects the effect of those widths. Theoretical calculations are made for the parameters related to the rate window, signal to noise ratio, and the energy resolution. On the grounds of this discussion, interface states of the MOS capacitor on p-type substrate of (110) orentation are measured with the optimal gate-off width with respect to the S/N ratio and the energy resolution. The results are interface state density of the order of 10**10 (cm-\ulcornereV**-1) to 10**11 (cm-\ulcornereV**-1) in the energy range of Ev+0.15(dV) to Ev+0.5(eV), and constant capture cross section of the order of 10**-16 (cm\ulcorner.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.37 no.2
• /
• pp.75-83
• /
• 2017

In this paper, we investigate the capacity of the lock-in infrared thermography technique for the evaluation of non-uniform top layers of a silicon carbide coating with a nickel based superalloy sample. The method utilized a multilayer heat transfer model to analyze the surface temperature response. The modelling of the sample was done in ANSYS. The sample consists of three layers, namely, the metal substrate, bond coat and top coat. A sinusoidal heating at different excitation frequencies was imposed upon the top layer of the sample according to the experimental procedures. The thermal response of the excited surface was recorded, and the phase angle image was computed by Fourier transform using the image processing software, MATLAB and Thermofit Pro. The correlation between the coating thickness and phase angle was established for each excitation frequency. The most appropriate excitation frequency was found to be 0.05 Hz. The method demonstrated potential in the evaluation of coating thickness and it was successfully applied to measure the non-uniform top layers ranging from 0.05 mm to 1 mm with an accuracy of 0.000002 mm to 0.045 mm.

• Journal of Power Electronics
• /
• v.4 no.4
• /
• pp.228-236
• /
• 2004

This paper describes the optimal current-control of a permanent magnet synchronous motor by the use of robust and simple current controllers, based upon the analytical procedure known as the inverse LQ (ILQ) design method. The ILQ design method is a strategy for finding the optimal gains based on pole assignment without solving the Riccati equation. It is very important to keep the motor in robust servo-lock. By experiments and simulations, we will show that the ILQ optimal servo-system with servo-lock is more insensitive at low speeds to variations in armature inductance than the standard PI servo-system. Variations in armature inductance have the greatest influence on the responses of a servo-system.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.7 no.7
• /
• pp.229-241
• /
• 1999

The paper describes the development of the ABS(Anti-Lock Bracke Sytem) real-time simulator which is composed of the real hydraulic modulator, the brake system, and the control software. This useful too supports the development enviornment of the ABS in great flexible mamer. It offers an efficient and cost-effective method of ABS development which includes the various realistic road conditons, the vehicle characteristics , and the brake characteristics. The performance of the ABS is compared with the normal braking results. Thepresented experimental results are braking on the high friction road, thetransient friction road(high to low , low to high), the split friction road, and the high friction road with steer angle. The paper shows the effectiveness and the safety of the ABS compared with the normal brake system , and the powerful and conventient tool in developing the ABS.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.7
• /
• pp.1141-1148
• /
• 2017

Generally, a thermistor made by sintering a metal oxide is widely used to measure the ambient temperature. This thermistor is widely used not only for industrial use but also for medical use because of its excellent sensitivity, durability, temperature change characteristics and low cost. In particular, the normal body temperature is 36.9 degrees relative to the armpit temperature, and it is most closely related to the circulating blood flow. Previous studies have shown that body temperature changes during biomechanical changes and body temperature changes by anomalous signs or illnesses. Therefore, in this study, we propose a Lock-In-Amp design to detect minute temperature changes of clothing and thermistor wired by a preacher as a method to regularly measure body temperature in daily life. Especially, it is designed to measure the minute resistance change of the thermistor according to body temperature change even in a low-cost microprocessor environment by using a micro-processor-based Lock-In-Amp, and a jacquard and the thermistor is arranged so as to be close to the side, so that the reference body temperature can be easily measured. The temperature was measured and stored in real time using short-range wireless communication for non - restraint temperature monitoring. A baby vest was made to verify its performance through temperature experiments for infants. The measurement of infant body temperature through the existing skin sensor or thermometer has limitations in monitoring infant body temperature for a long time without restriction. However, it can be overcome by using the embroidery fabric based micro temperature monitoring wireless monitoring device proposed in this study.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.25 no.3
• /
• pp.235-241
• /
• 2020

In this paper, we propose the bus/bypass synchronization phase lock loop (B-Sync PLL) method using each phase voltage controller of a parallel UPS inverter. The B-Sync PLL included in each phase voltage control system of parallel UPS inverters has the transient response and the phase synchronization error at grid normal or blackout. The validity of this method is verified by simulation and experiment. As a result, the parallel UPS inverters using the proposed method confirmed that the output phase was continuously synchronized when a grid blackout, improving the transient response characteristics for stable load power supply and equal load sharing.