• Korean Journal of Materials Research
• /
• v.14 no.4
• /
• pp.235-238
• /
• 2004

The LT-MBE (low temperature molecular beam epitaxy) allows to dope GaAs with Mn over its solubility limit. A 75 urn thick GaMnAs layers are grown on a low temperature grown LT-GaAs buffer layer at a substrate temperature of $260^{\circ}C$ by varying Mn contents ranged from 0.03 to 0.05. The typical growth rate for GaMnAs layer is fixed at 0.97 $\mu\textrm{m}$/h and the V/III ratio is varied from 25 to 34. The electrical and magnetic properties are investigated by Hall effect and superconducting quantum interference device(SQUID) measurements, respectively. Double crystal X-ray diffraction(DCXRD) is also performed to investigate the crystallinity of GaMnAs layers. The $T_{c}$ of the $Ga_{l-x}$ /$Mn_{x}$ As films grown by LT-MBE are enhanced from 38 K to 65 K as x increases from 0.03 into 0.05 whereas the $T_{c}$ becomes lower to 45 K when the V/III ratio increases up to 34 at the same composition of x=0.05. This means that the ferromagnetic exchange coupling between Mn-ion and a hole is affected by the growth condition of the enhanced V/III ratio in which the excess-As and As-antisite defects may be easily incorporated into GaMnAs layer.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2004.12a
• /
• pp.42-42
• /
• 2004

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.11a
• /
• pp.78-79
• /
• 2005

We report on optically excited terahertz (THz) omission from low-temperature (LT) grown GaAs. We have used 70 fs titanium-sapphire laser pulses with wavelengths at 800 nm to generate THz radiation pulses. The LT-GaAs layers are grown on semi-insulating GaAs substrates with GaAs buffer layer by molecular beam epitaxy (MBE). The THz emission from the LT-GaAs surface is strong and does not show any significant variation in the strength of the THz emission over several different angles between the polarization of the excitation laser pulse and the crystallographic orientation of the LT-GaAs.

• Journal of the Korean Society for Heat Treatment
• /
• v.29 no.3
• /
• pp.124-131
• /
• 2016

GaN and InN epilayers with nucleation layer (LT-buffer) were grown on (0001) sapphire substrates by radio-frequency plasma-assisted molecular beam epitaxy (RF-MBE). As-grown and annealed GaN and InN nucleation layers grown at various growth condition were observed by reflection high-energy electron diffraction (RHEED). When temperature of effusion cell for III source was very low, diffraction pattern with cubic symmetry was observed and zincblende nucleation layer was flattened easily by annealing. As cell temperature increased, LT-GaN and LT-InN showed typical diffraction pattern from wurtzite structure, and FWHM of (10-12) plane decreased remarkably which means much improved crystalline quality. Diffraction pattern was changed to be from streaky to spotty when plasma power was raised from 160 to 220 W because higher plasma power makes more nitrogen adatoms on the surface and suppressed surface mobility of III species. Therefore, though wurtzite nucleation layer was a little hard to be flattened compared to zincblende, higher cell temperature led to easier movement of III surface adatoms and resulted in better crystalline quality of GaN and InN epilayers.

• Korean Journal of Materials Research
• /
• v.18 no.8
• /
• pp.444-449
• /
• 2008

Samples of GaMnAs, GaMnAs codoped with Be, and GaMnAs simultaneously codoped with Be and Mg were grown via low-temperature molecular beam epitaxy (LT-MBE). Be codoping is shown to take the Ga sites into the lattice efficiently and to increase the conductivity of GaMnAs. Additionally, it shifts the semiconducting behavior of GaMnAs to metallic while the Mn concentration in the GaMnAs solid solution is reduced. However, with simultaneous codoping of GaMnAs with Be and Mg, the Mn concentration increases dramatically several times over that in a GaMnAs sample alone. Mg and Be are shown to eject Mn from the Ga sites to form MnAs and MnGa precipitates.

• Journal of the Korean Vacuum Society
• /
• v.21 no.5
• /
• pp.264-272
• /
• 2012

In this paper, we report THz generation and detection characteristics investigated by InGaAs semiconductor epilayers, as results of a basic study obtained from the InGaAs-based THz transmitter/receiver (Tx/Rx). High-temperature and low-temperature (LT) grown InGaAs epilayers were prepared by the molecular beam epitaxy technique for the characterization of THz generation and detection, respectively, and the surface emission based on the photo-Dember effect was tried for THz generation. THz wave was generated by irradiation of a Ti:Sapphire fs pulse laser (60 ps/83 MHz), and a LT-GaAs Rx was used for the THz detection. The frequency band shown in the spectral amplitudes Fourier-transformed from the measured current signals was ranging in 0.5~2 THz, and the signal currents were exponentially increased with the Tx beam power. The THz detection characteristics of LT-InGaAs were investigated by using an Rx with dipole (5/20 ${\mu}m$) antenna, and the cutoff frequency was ~2 THz.