• Membrane Journal
• /
• v.25 no.4
• /
• pp.320-326
• /
• 2015

In this study, permeation experiments were carried out using the symmetric and asymmetric sinusoidal flux continuous operation (SFCO) modes for the submerged flat sheet membrane in the 0.5 wt% emulsion type cutting oil solution. The effective area and nominal pore size of the used microfiltration membrane were $0.02m^2$ and $0.15{\mu}m$, respectively. The emulsion cutting oil was rejected over 99% based on turbidity. Transmembrane pressure increased lower as the aeration rates increased. The symmetric SFCO mode was a little more effective than the symmetric SFCO mode in low permeate flux between 10 and $15L/m^2{\cdot}h$. However, the symmetric SFCO mode was shown very effectively in high permeate flux between 25 and $30L/m^2{\cdot}h$.

• Membrane Journal
• /
• v.25 no.1
• /
• pp.7-14
• /
• 2015

In this study transmembrane pressure (TMP) was measured with respect to operational time in order to estimate fouling of the submerged membrane in the membrane bioreactor(MBR). The microfiltration flat sheet module which has $0.02m^2$ of effective area and $0.15{\mu}m$ nominal pore size was submerged in the activated sludge solution of MLSS 5,000 mg/L. The permeate experiments were carried out simultaneously to compare TMP of the run/stop (R/S) with that of the sinusoidal flux continuous operation (SFCO). TMP for SFCO mode was up to 93% lower than that of R/S mode, and the effect of TMP drop reduced as permeate flux increased. Also, TMP of the SCFO mode was maintained below 40% of the limited operating TMP 55 kPa until the permeate operational time extended to longer than 5 times for the case as the coagulant $FeCl_3$ was dosed into the activated sludge solution with 500 mg/L concentration.

• Journal of Bio-Environment Control
• /
• v.1 no.1
• /
• pp.21-27
• /
• 1992

The effects of different night temperatures and NO$_3$$^{[-10]}$ : NH$_4$$^{+}$ ratios in nutrient solution on the growth and quality of Chinese white cabbage(B. chinensis L. var. chinensis) and Chinese flat cabbage(B. chinensis L. var. rosularis) were studied. The results were summarized as follows. 1. Fresh weight was increased higher in night temperature 15$^{\circ}C$ than 5, 1$0^{\circ}C$, but content of vitamin C and dry weight ratio were increased as night temperature was lower. 2, The growth of Chinese white cabbage and Chinese flat cabbage was bad extremely in NO$_3$$^{[-10]}$ : NH$_4$$^{+}$(0 : 8), and the others were little different 3. In nutrient solution, the higher NO$_3$$^{[-10]}$ -N concentration was, the more content of vitamin C, and the higher NH$_4$$^{+}$-N concentration was, the more dry weight ratio.ratio.

• Korean Journal of Applied Biomechanics
• /
• v.16 no.4
• /
• pp.189-194
• /
• 2006

The purpose of this study was to identify the relationship of one repetition maximum between flat bench press exercise and incline bench press exercise, and so 40 male students of U-university were sampled purposedly, who were skilled in flat bench press and incline bench press exercises. After measuring lRM of each exercise by free barbell weight, the correlation analysis and the simple regression analysis were examined by using SPSS 120 at a significance level .05. The conclusions were as follows; Firstly, it was identified that 1RM of flat bench press exercise and incline bench press exercise were $89.2{\pm}25.9kg$, $67.1{\pm}22.1kg$ respectively, and the coefficient of correlation between two variables was 0.969, so the relationship was positive correlation. Secondly, it was identified that the regression equation predicted 1RM of incline bench press exercise was significant actually and statistically, so it was expressed that the equation was -6.648 + 0.827 (1RM of flat bench press exercise).

• Asian-Australasian Journal of Animal Sciences
• /
• v.14 no.8
• /
• pp.1051-1056
• /
• 2001

Data for teat number for Landrace (L), Yorkshire (Y), crossbred of Landrace and Yorkshire (LY), and crossbred of Landrace, Yorkshire and Chinese indigenous Min Pig (LYM) were analyzed using Gibbs sampling. In Bayesian inference, flat priors and some informative priors were used to examine their influence on posterior estimates. The posterior mean estimates of heritabilities with flat priors were $0.661{\pm}0.035$ for L, $0.540{\pm}0.072$ for Y, $0.789{\pm}0.074$ for LY, and $0.577{\pm}0.058$ for LYM, and they did not differ (p>0.05) from their corresponding estimates of REML. When inverse Gamma densities for variance components were used as priors with the shape parameter of 4, the posterior estimates were still corresponding (p>0.05) to REML estimates and mean estimates using Gibbs sampling with flat priors. However, when the inverse Gamma densities with the shape parameter of 10 were utilized, some posterior estimates differed (p<0.10) from REML estimates and/or from other Gibbs mean estimates. The use of moderate degree of belief was influential to the posterior estimates, especially for Y and for LY where data sizes were small. When the data size is small, REML estimates of variance components have unknown distributions. On the other hand, Bayesian approach gives exact posterior densities of variance components. However, when the data size is small and prior knowledge is lacked, researchers should be careful with even moderate priors.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2000.04a
• /
• pp.533-538
• /
• 2000

In R.C. flat slab system, a brittle punching failure is a very fatal problem. But there is no generally well-defined answer to the problem and there are wide differences in current practical design codes. therefore, in this study, the factors affecting to punching failure mechanism have been studied to find out the punching shear behavior in R.C. flat slabs by comparing other investigations and practical design codes. Therefore, In this study, the factors affecting to punching failure mechanism have been studied to find out the punching shear behavior in R.C. flat slabs by comparing other investigations and practical design codes. The conclusions in this study are summarized as follows; 1) The factors affecting to punching shear are concrete strength ($f_\alpha$), ratio of column side length to slab depth (c/d), ratio of distance from column center to radial contraflexure (l/d), yield strength of steel ($f_y$), flexural reinforcement ratio ($\rho$) and size effects. 2) It is shown that th use of $\surd{f_{ck}}$in applying($f_\alpha$ to punching shear strength estimation may be more sensitive in high concrete strength. 3) The effects of l/d, ($f_y$, size are no clear in the punching failure mechanism, so in the future, it should be investigated with the effects of various composed load.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.13 no.4
• /
• pp.184-195
• /
• 2005

This paper describes the recent work on advanced technology concepts applied to air cooled heat exchangers for residential air-conditioning. The concepts include vortex generators for the air-side, micro-fin or flat tubes for the refrigerant-side. Advances in understanding of heat transfer mechanisms, predictive models are discussed.

• Current Optics and Photonics
• /
• v.3 no.4
• /
• pp.298-303
• /
• 2019

We propose a photonic quasi-crystal fiber (PQF) for supporting up to 14 orbital angular momentum (OAM) modes with low and ultra-flat dispersion characteristics over the C+L bands. The designed PQF which consists of a large hollow center and quasi structural small air holes in the clad region exhibits low confinement losses and a large effective index separation (>$10^{-4}$) between the vector modes. This proposed fiber could potentially be exploited for mode division multiplexing and other OAM mode applications in fibers.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.38 no.1
• /
• pp.1-5
• /
• 2005

This study investigated and compared chemical properties and biological activities of four commercial sikhae products (three flat-fish, Pleuronectes herzensteini, Sikhae: product A, B, C; one Alaska pollack, Theragra chalcogramma, Sikhae: product D) and Alaska pollack Sikhae (product E). Total acidity, amino nitrogen, salinity and pH in all products were in ranges of $0.47-1.93\;g\%$, $145.94-204.81\;mg\%$, $3.40-4.00\%$ and 4.38-5.55, respectively. All products showed antimicrobial activities against Bacillus ceraus subtilis, B. cereus, Staphylococcus aureus, Listeria monocytogenes, Vibrio parahaemolyticus, except for Salmonella typhimurium. Particularly the activities were more effective with gram positive bacteria than gram negative bacteria. Antioxidative $(EDA_{50};\;14.20\;mg/mL)$ and Fibrinolytic (0.95 plasmin unit/mL) activities of product E were much stronger than commercial Sikhae products (EDA50; 18.87-34.60 mg/mL and 0.69-0.85 plasmin unit/mL).

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.7 no.1
• /
• pp.112-119
• /
• 1995

Measurements of the local heat transfer coeffcients on a spherically concave surface with a round impinging jet are presented. The liquid crystal transient method was used for these measurements. This method, which is a variation on the transient method, suddenly exposes a preheated wall to an impinging jet while video recording the response of liquid crystals for the measurement of the surface temperature. The Reynolds numbers used were 1,000, 23,000 and 50,000 and the nozzle-to-jet distance was L/d=2, 4, 6, 8, 10. Presented results are compared to previous measurements for flat plate. In the experiment, the local heat transfer Nusselt numbers on a concave surface are higher than those on a flat plate. Maximum Nusselt number at all region occured at L/d=6 and second maximum in the Nusselt number occured at R/d=2 for both Re=50,000 and Re=23,000 in case of L/d=2 and for only Re=50,000 in case of L/d=4. All other cases exhibit monotonically decreasing value of the Nusselt number along the curved surface.