• Korean Journal of Optics and Photonics
• /
• v.22 no.2
• /
• pp.72-76
• /
• 2011

We demonstrate a k-domain linearization using a fiber Bragg grating (FBG) array for Fourier domain optical coherence tomography based on a wavelength swept laser. The k-domain linearization is carried out with an interpolation method using a FBG array with five FBGs. The measured signal-to-noise ratio from the point spread function after k-domain linearization is 12 dB improved over that of without k-domain linearization at the 1 mm depth of the sample. Clear OCT imaging of the slide glass with k-domain linearization could be obtained.

• Journal of Electrical Engineering and information Science
• /
• v.3 no.2
• /
• pp.193-201
• /
• 1998

In this paper, the standard Dole, Glover, Khargoneker, and Francis (abbr. : DGKF 1989) H\ulcorner controller (H\ulcornerC) is extended to the nonlinear feedback linearization-H\ulcorner/sliding mode controller (NFL-H\ulcorner/SMC), to tackle the problem of the unmeasurable state variables as in the conventional SMC, to obtain smooth control as the linearized controller in a linear system, and to improve the time-domain performance under a worst scenario. The proposed controller is obtained by combining the H\ulcorner estimator with the nonlinear feedback linearization-sliding mode controller (NFL-SMC) and it does not need to measure all the state variables as in the traditional SMC. The proposed controller is applied as a nonlinear power system stabilizer (PSS) for the improvement of the power system damping characteristics of an single machine infinite bus system (SMIBS) connected through a double circuit line. The effectiveness of the proposed controller is verified by nonlinear time-domain simulation in case of a 3-cycle line-to-ground fault and in case of the parameter variations for the AVR gain K\ulcorner and for the inertia moment M.

• Structural Engineering and Mechanics
• /
• v.66 no.1
• /
• pp.139-149
• /
• 2018

Many practical engineering problems are associated with nonlinear systems subjected to nonstationary random excitations. Equivalent linearization methods are commonly used to seek for approximate solutions to this kind of problems. Compared to various approaches developed in the frequency and mixed time-frequency domains, though directly solving the system equation of motion in the time domain would improve computation efficiency, only limited studies are available. Considering the fact that the orthogonal functions have been widely used to effectively improve the accuracy of the approximated responses and reduce the computational cost in various engineering applications, an orthogonal-function-based equivalent linearization method in the time domain has been proposed in the current paper for nonlinear systems subjected to nonstationary random excitations. In the numerical examples, the proposed approach is applied to a SDOF system with a set-up spring and a SDOF Duffing oscillator subjected to stationary and nonstationary excitations. In addition, its applicability to nonlinear MDOF systems is examined by a 3DOF Duffing system subjected to nonstationary excitation. Results show that the proposed method can accurately predict the nonlinear system response and the formulation of the proposed approach allows it to be capable of handling any general type of nonstationary random excitations, such as the seismic load.

• Journal of the Optical Society of Korea
• /
• v.15 no.4
• /
• pp.386-393
• /
• 2011

In this study, we report an effective k-domain linearization method with a pre-calibrated indexed look-up table. The method minimizes k-domain nonlinear characteristics of a swept source optical coherence tomography (SS-OCT) system by using two arrays, a sample position shift index and an intensity compensation array. Two arrays are generated from an interference pattern acquired by connecting a Fabry-Perot interferometer (FPI) and an optical spectrum analyzer (OSA) to the system. At real time imaging, the sample position is modified by location movement and intensity compensation with two arrays for linearity of wavenumber. As a result of evaluating point spread functions (PSFs), the signal to noise ratio (SNR) is increased by 9.7 dB. When applied to infrared (IR) sensing card imaging, the SNR is increased by 1.29 dB and the contrast noise ratio (CNR) value is increased by 1.44. The time required for the linearization and intensity compensation is 30 ms for a multi thread method using a central processing unit (CPU) compared to 0.8 ms for compute unified device architecture (CUDA) processing using a graphics processing unit (GPU). We verified that our linearization method is appropriate for applying real time imaging of SS-OCT.

• Korean Journal of Computational Design and Engineering
• /
• v.20 no.1
• /
• pp.84-92
• /
• 2015

In this study, we describe a method to analysis dynamic behavior of an offshore wind turbine in the frequency domain and expected effects of the method. An offshore wind turbine, which is composed of platform, tower, nacelle, hubs, and blades, can be considered as multibody systems. In general, the dynamic analysis of multibody systems are carried out in the time domain, because the equations of motion derived based on the multibody dynamics are generally nonlinear differential equations. However, analyzing the dynamic behavior in time domain takes longer than in frequency domain. In this study, therefore, we describe how to analysis the system multibody systems in the frequency domain. For the frequency domain analysis, the non-linear differential equations are linearized using total derivative and Taylor series expansions, and then the linearized equations are solved in time domain. This method was applied to analysis of double pendulum system for the verification of its effectiveness, and the equations of motion for the offshore wind turbine was derived with assuming that the wind turbine is rigid multibody systems. Using this method, the dynamic behavior analysis of the offshore wind turbine can be expected to take less time.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.05b
• /
• pp.54-57
• /
• 2003

This study proposes that the Phase Linearization Interpolation is higher efficency than the existed Orthogonal Frequency Division Multiplexing system in the Multipath channels time-varient. Also, it showed that time domain equalization is better than the existed frequency domain equalization about the calculation and efficency for clear Inter Carrier Interference of the doppler effect.

• Journal of Electrical Engineering and information Science
• /
• v.3 no.2
• /
• pp.184-192
• /
• 1998

In this paper, we present a nonlinear feedback linearization-full order observer/sliding mode controller (NFL-FOO/SMC), to obtain smmoth control as a linearized controller in a linear system (or to cancel the nonlinearity in a nonlinear system), and to solve the problem of the unmeasurable state variables as in the conventional SMC. The proposed controller is obtained by combining the nonlinear feedback linearization-sliding mode control (NFL-SMC) with the full order observer (FOO)and eliminates the need to measure all the state variables in the traditional SMC. The proposed controller is applied to the nonlinear power system stabilizer (PSS) for damping oscillations in a power system. The effectiveness of the proposed controller is verified by the nonlinear time-domain simulations in case of a 3-cycle line-to-ground fault and in case of the parameter variation for the AVR gain K\ulcorner and for the inertia moment M.

• Proceedings of the Korean Society for Language and Information Conference
• /
• 2002.02a
• /
• pp.36-49
• /
• 2002

One main complexity of the copula constructions concerns a mismatch between morphology and syntactic constituency: the copula seems to form a morphological unit with the immediately preceding element, whereas in terms of syntax the copula appears to take this as its syntactic complement. In capturing such mismatches, we show that the copula is treated as an independent verb at the level of tectogrammatical structure (or syntax tree), whereas as a bound morpheme at the level of phonogram-matical structure (or domain tree), in terms of Dowty 1992 (or Reape 1994). This paper, adopting the notion of DOMAIN in HPSG, shows that copula constructions are a subtype of compacting-constructions. These constructions compact the domain value of the copula and that of its preceding element together into one domain unit, eventually making it inert to syntactic phenomena such as scrambling, deletion and pro-form substitution. This construction-based approach provides a clean analysis for the formation of the copula construction and related phenomena.

• Proceedings of the KIEE Conference
• /
• 1998.07c
• /
• pp.970-972
• /
• 1998

In this paper, the standard Dole, Glover, Khargoneker, and Francis (abbr. : DGKF 1989) $H_{\infty}$ controller $(H_{\infty}C)$ is extended to the nonlinear feedback linearization-$H_{\infty}$ /sliding mode controller (NFL-$H_{\infty}$/SMC) to solve the problem associated with the full state feedback for the unmeasurable state variables in the conventional SMC, to obtain the smooth control as the linearized controller for a linear system (or to cancel the nonlinearity for the nonlinear system), and to improve the time-domain performance under worst case.

• Journal of the Society of Naval Architects of Korea
• /
• v.47 no.3
• /
• pp.398-409
• /
• 2010

This paper considers the numerical computation of added resistance on ships in the presence of incident waves. As a method of solution, a higher-order Rankine panel method is applied in time domain. The added resistance is evaluated by integrating the second-order pressure on the body surface. Computational results are validated by comparing with experimental data and other computational results on a hemi-sphere, a barge, Wigley hull models, and Series 60 hull, showing very fair agreements. The study is extended to the comparison between Neumann-Kelvin and double-body linearization approaches, and their differences are discussed.